Liquid Marble Patchwork on Super-Repellent Surface

Liquid marble (LM) is a droplet that is wrapped by hydrophobic solid particles, which behave as a non-wetting soft solid. Based on these properties, LM can be applied in fluidics and soft device applications. A wide variety of functional particles have been synthesized to form functional LMs. However, the formation of multifunctional LMs by integrating several types of functional particles is challenging. Here, a general strategy for the flexible patterning of functional particles on droplet surfaces in a patchwork-like design is reported. It is shown that LMs can switch their macroscopic behavior between a stable and active state on super-repellent surfaces in situ by jamming/unjamming the surface particles. Active LMs hydrostatically coalesce to form a self-sorted particle pattern on the droplet surface. With the support of LM handling robotics, on-demand cyclic activation–manipulation–coalescence–stabilization protocols by LMs with different sizes and particle types result in the reliable design of multi-faced LMs. Based on this concept, a single bi-functional LM is designed from two mono-functional LMs as an advanced droplet carrier.     

Transmittance and cathodoluminescence of AlN ceramics sintered with Ca3Al2O6 as sintering additive

Aluminum nitride ceramics were prepared by sintering with 0–4.8 mass% of Ca₃Al₂O₆ (C₃A) as a sintering additive. The transmittance in the range of 260–550 nm increased with increasing amount of C₃A. The cathodoluminescence intensity attributed to oxygen-induced defects decreased with increasing amount of C₃A. From the results, the increase of the transmittance in the range of 260–550 nm was considered to be related to the decrease of the oxygen-induced defect density.     

Effects of Seismically Induced Pounding at Expansion Joints of Concrete Bridges

This paper presents the result of a study on the effect of pounding at expansion joints on concrete bridge response to earthquake ground motions. An engineering approach, rather than continuum mechanics approach, is emphasized. First, the dynamic behavior of a damped multidegree-of-freedom bridge system separated by an expansion joint involving an impact is examined by means of the finite element method. Second, the sensitivity analysis of the stiffness in gap elements is performed. Third, usefulness of the analysis method for simulation of pounding phenomena is demonstrated and the effect of pounding on the ductility demands measured in terms of the rotation of column ends is investigated. Two-dimensional finite element analysis using a bilinear hysterestic model for bridge substructure joints and a nonlinear gap element for the expansion joint is performed on a realistic bridge with an expansion joint. The effects of the primary factors on the ductility demand such as gap sizes and characteristics of earthquake ground motion are investigated through a parametric study. The major conclusions are (1) the effect of impact most directly depends on the size of momentum (or pounding magnitude); and (2) the pounding effect is generally found to be negligible on the ductility demand for wide practical ranges of gap size and peak ground acceleration, but is potentially significant at the locations of impact.     

Hydrogen absorption by Pd-coated ZrNi prepared by using Barrel-Sputtering System

To improve the durability of hydrogen storage materials against surface poisoning by impurity gases, effectiveness of Pd-coating layer prepared by using a Barrel-Sputtering System was examined for ZrNi powder. The effectiveness of Pd-coating was evaluated by activation temperature, at which Pd/ZrNi poisoned by air could be activated to absorb hydrogen. Characterization of Pd-coated ZrNi (denoted as Pd/ZrNi) by scanning electron microscopy, electron probe microanalysis and X-ray diffraction showed that a uniform Pd-coating layer was formed with the barrel-sputtering system. It was found that the poisoned Pd/ZrNi sample could be activated even at 423 K to absorb hydrogen at room temperature. This exhibits remarkable contrast to bare ZrNi, which could be only activated appreciably above 1073 K. It is concluded that the Pd-coating by barrel sputtering is quite effective to avoid the effect of surface poisoning of powdery hydrogen storage materials. However, the activation at excessively high temperature resulted in the loss of high activity to absorb hydrogen. It was concluded that this phenomenon was associated with reactions between Pd and ZrNi to form PdZr and other byproducts.     

R & D Needs - Drying of Ceramics

New research and development needs for the drying of ceramics are prooosed. The researches on the ceramic drying are briefly reviewed and the role of the drying in the ceramic production process iS summarized. The drying must deal with molded materials and the problem is of significant difference from another drying with particulate materials. It means that the drying must be performed with keeping the molded feature and the insufficient completion of drying and the careless operation influence directly on the product quality The importnance of the R & D on the heat and moisture transfer. shrinking mechanism. the deformation behavior and the strain-stress formation in the molded clay issuggested. The subjects are also pointed out for the further improvement of the ceramic drying process and the precise design of molding with high quality.     

Evaluation of intraductal ultrasonography in the diagnosis of pancreatic cancer

An intraductal ultrasound (IDUS) probe which is inserted via the papilla into the main pancreatic duct (MPD) was evaluated in the diagnosis of 20 patients with pancreatic cancer. The examination was successfully performed with the probe in 17 of the patients (85%). Due to its high frequency (30 MHz) the probe only allowed visualization of the ductal wall and the immediate periductal vicinity (up to about 10 mm). In 15 of the 20 patients the tumors were surgically resected and IDUS scanning was also performed in vitro on the resection specimens, the results being compared to those of histopathological examination. Of these 15 patients, 13 were found to have ductal adenocarcinomas and all but one had been unequivocally diagnosed as having such by ultrasonography (US), computed tomography (CT), endoscopic retrograde cholangiopancreatography (ERCP) and endoscopic ultrasonography (EUS). IDUS showed an echorich area (corresponding to cancerous canaliculi on histopathological examination), surrounded by an echopoor area (abundant stroma). This pattern was classified as type I. In two patients with intraductal papillary carcinomas in whom a conclusive diagnosis was not established on US, CT, EUS or ERCP, IDUS showed tumorous tissue with an inhomogeneous echopattern outside (type II) or within (type III) the duct. These results show that IDUS offers valuable diagnostic information complementary to ERCP especially in cases of intraductal papillary tumors. Whether the high resolution imaging of the duct and the paraductal tissue can be used to differentiate between the different forms of pancreatic lesions (inflammation, neoplasms) has to be investigated further.     

Drying-Induced Strain and Stress: A Review

This paper is to review the works on strains and suesses in materials during drying.The strains and suesses are caused when temperature and moisture gradients are generated in mterials whose volume changes with heating and moisture removal. In such materials. failure and irregular deformion may be generated which affect considerably the qudity of the products after drying. In the first part. modeling procedure is introduced for the analysis of the strain-stress behavior in elaslic. viscous and visccelastic materials combined with heat and moisture transfer. An overview of the works on swains and stresses and drying characteristics are presented for malerials such as porous media. clay. sol-gels. agricultural products and foods in the second part. There are some materials that show both elasticity of the solid phase and viscosity of the fluid phase ( water or solvena∥ or viscoelasticiry. The suesses are often correlated with a suction pressure of fluids in pores and the flow rate is based on Dacy's equation for the elastic and viscous tnedia and a kind of viscoelastic media. The general canstitulive equalions. for suains and svesses are often analyzed with the stain behavior given by a function of moisturr for some media ai well. The emohasis is on the inuoduclion of comprehensive criteria for undersunding the problems of strain and stress development in materials subjected to drying.     

Current collecting efficiency of micro tubular SOFCs

In this study, current collecting efficiency of the micro tubular solid oxide fuel cell (SOFC) was estimated to determine optimum size of the micro tubular SOFC. Two models for collecting current from single terminal (ST) and double terminal (DT) of anode tube were proposed and used to calculate the current collecting efficiency as functions of anode thickness, tube length and operating temperature. It was shown that design of the cell geometry and current correcting method are significantly important to achieve high performance micro tubular SOFC stacks. The efficiency loss estimated from the DT model was about 2–4-fold lower than those of obtained from the ST model. The DT model was shown to be more effective for higher operating temperature and the tube length.     

Changes of biochemical markers during fracture healing

Clinical diagnosis of canine nasal mite (Pneumonyssoides caninum) infection is difficult due to the mite's location in the caudal nasal cavity and frontal sinuses. The current study was performed to evaluate the efficacy of milbemycin oxime in treating dogs with nasal mite infection. A prospective open uncontrolled study included 20 dogs with case histories indicating possible nasal mite infection. Inclusion criteria consisted of either nasal mites being demonstrated (group 1, four dogs), or suspicious clinical signs with no other apparent causes, combined with eosinophilia (group 2, 16 dogs). Milbemycin oxime 1 mg/kg was given orally three times at 10-day intervals. In 17 (85 per cent) dogs, clinical signs resolved completely following milbemycin therapy; within 10 days of the first treatment in 13 cases (group 1, four dogs; group 2, nine dogs) and within 14 days in four cases. In the remaining three dogs clinical signs persisted but were diminished.     

Hyper-gourd theory: solving simultaneously the mysteries in particle physics, biology, oncology, neurology, economics, and cosmology

The inevitability of various particle masses for hadrons, quarks, leptons, atoms, biological molecules, liquid droplets of fossil fuel and water, living cells including microorganisms and cancers, multi-cellar systems such as organs, neural systems, and the brain, stars, galaxies, and the cosmos is synthetically revealed. This is possible because each flexible particle is commonly generated by a mode in which a larger particle breaks up into two smaller ones through a gourd shape with two lumps. These masses, sizes, frequencies, and diversity dominated by super-magic numbers including the silver ratio, in fractal nature can be derived by the fusion of the quasi-stability principle defined between absolute instability and neutral stability, the indeterminacy principle extended for quantum, statistical, and continuum mechanics, and the spherical Lie group theory. The analyses also result in a new mathematical definition of living beings and non-living systems and further explain the standard network patterns of various particles and also the relation between information, structure, and function, because the proposed theory based on gourds posits a new hyper-interdisciplinary physics that explains a very wide range of scales, while the Newton, Schr?dinger, and Boltzmann equations describe only a narrow range of scales.