Electric field-assisted and field-depressed segregation of reactive metals to the bonding interface in braze alloy joining

Segregation of reactive metals at the bonding interface has been observed in various ceramic and/or metal joints bonded with reactive metal-bearing braze alloys. When a d.c. of 20 mAcm⁻² is applied to the ceramic/braze/ceramic system at a brazing temperature of, say, 1373 K, the electric field assists the segregation at the braze-ceramic interface on the cathode side and suppresses the segregation at the interface on the anode side. This may imply that reactive metal atoms in the braze can migrate as a cation. E.m.f. measurement on the ceramic (AIN or ZrB₂)-metal foil systems with increasing temperature shows that a negative e.m.f. to the ceramic pole appears from about 900 K for AIN and from 500 K for ZrB₂, as does the thermally stimulated current in polymers. These temperatures coincide well with those where the electrical conductivity of AIN and ZrB₂, respectively, begins to increase with increasing temperature. Therefore, it is considered that the polarization of the ceramics may take place and assist the migration, and consequently segregation, of reactive metals in braze alloys to the braze-ceramic interface during brazing.     

Comparison of isolation methods using commercially available kits for obtaining extracellular vesicles from cow milk

Extracellular vesicles (EV) are important for delivering biologically active substances to facilitate cell-to-cell communication. Milk-derived EV are widely known because of their potential for immune enhancement. However, procedures for isolating milk-derived EV have not been fully established. To obtain pure milk-derived EV and accurately reveal their function, such procedures must be established. The aim of the present study was to compare methods using commercially available kits for isolating milk-derived EV. Initially, we investigated procedures to remove casein, which is the major obstacle in determining milk-derived EV purity. We separated whey using centrifugation only, acetic acid precipitation, and EDTA precipitation. Then, we isolated milk-derived EV by ultracentrifugation, membrane affinity column, size exclusion chromatography (SEC), polymer-based isolation, or phosphatidylserine-affinity isolation. Using EV count per milligram of protein, which is a good indicator of purity, we determined that acetic acid precipitation was the best method for removing casein. Using nanoparticle tracking analysis, protein quantity analysis, and RNA quantity analysis, we comprehensively compared each isolation method for its purity and yield. We found that SEC-based qEV column (Izon Science) could collect purer milk-derived EV at higher quantities. Thus, a combination of acetic acid precipitation and qEV can effectively isolate high amounts of pure extracellular vesicles from bovine milk.     

Mechanical properties of molybdenum neutron-irradiated at a high temperature

Molybdenum specimens prepared by two processes, powder-metallurgy (PM) and electron-beam melting (EB), were irradiated to a fast neutron fluence of 2.74 × 10²⁴n/m² (E_n? 1 MeV) at about 600°C (873 K), and their mechanical properties were studied in detail. It was shown that the degree of irradiation embrittlement in EB-Mo was smaller than that in PM-Mo, which might be caused by stronger grain-boundaries and probably smaller irradiation-hardening in the former. From the relation between the recovery of ductility and microstructural changes in post-irradiation annealed PM-Mo at 800 (1073 K), 1000 (1273 K) and 1200°C (1473 K), it was concluded that the recovery resulted from a decrease of irradiation hardening due to a rearrangement and a disappearance of depleted-zones, dislocation-loops and voids in order with increasing annealing temperature. An anomalous mode of fracture was observed in as-irradiated specimens, which consisted of inhomogeneous deformation, then brittle fracture not at the center but at the root of the deformation neck. This mode was observed in a narrow temperature range near the DBTT. A possible mechanism is discussed.     

Improvement of thermal characteristics of latent heat thermal energy storage units using carbon-fiber brushes: experiments and modeling

Brushes made of carbon fibers with a high thermal conductivity are inserted on the shell side of a heat exchanger to enhance the conductive heat transfer rates in phase change materials. The experimental results show that the brushes essentially improve the heat exchange rate during the charge and discharge processes even when the volume fractions of the fibers are about one percent. A three-dimensional model describing the heat transfer in the heat exchanger is numerically solved. The model predicts well the experimental outlet fluid temperatures and the local temperatures in the composite.     

Analysis for microbial contamination in production of Japanese-style confectionery "Monaka"

Food hygiene in Japanese-style confectionery factories is hard to practice because the businesses are small. In a supporting system of voluntary-based hygienic management in this field, we microbiologically investigated the production processes of "Monaka" in a workshop in Tokyo. We microbiologically assessed the processing environments as well as the products in the workshop, then proposed some improvements in the production of the confectionery. After the improvements, microbial contamination of the processing environments was reduced and no microbial contamination was found in the sugared bean, or "An" produced, though the product "Monaka" was still contaminated, especially by molds. It was clarified that the molds came from contaminated baked wheat shells, or "Kawa" and further that the wheat shells were contaminated by molds during storage.     

Pathogenicity of Haemophilus parasuis serovars 4 and 5 in contact-exposed pigs

The pathogenicities of Haemophilus parasuis strains SW124 (serovar 4) and Nagasaki (serovar 5) were examined by contact-exposure of specific pathogen-free (SPF) pigs. Ten pigs were divided into three groups. Two of four pigs in the first group were inoculated intranasally (IN) with 2 x 10(8) CFU of strain SW124, and the other two pigs were mingled with these IN-exposed ones. All the four pigs were subclinically infected in this group. The four pigs of the second group were likewise exposed to strain Nagasaki (two IN-inoculated pigs with 3 x 10(8) CFU of strain Nagasaki). All four pigs in this group died of Gl?sser's disease. Two pigs kept as controls showed neither abnormality nor positive H. parasuis isolation.