Mass transfer in polycrystalline ytterbium monosilicate under oxygen potential gradients at high temperatures

Mass transfer in polycrystalline Yb₂SiO₅ wafers with precise composition control was evaluated and analyzed by oxygen permeation experiments at high temperatures using an oxygen tracer. Oxygen permeation proceeded due to mutual grain boundary diffusion of oxide ions and Yb ions without synergistic effects such as acceleration or suppression. The oxygen shielding properties of Yb₂SiO₅ were compared with those of the other line compounds such as Yb₂Si₂O₇ and Al₂O₃ based on the determined mass transfer parameters. It was found that the more preferentially an oxide ion diffuses in the grain boundary compared to the interior of the grain, the greater the effect of suppressing the movement of the oxide ion by applying an oxygen potential gradient becomes.     

Effects of SO2 on selective catalytic reduction of NO with NH3 over a TiO2 photocatalyst

The effect of SO₂ gas was investigated on the activity of the photo-assisted selective catalytic reduction of nitrogen monoxide (NO) with ammonia (NH₃) over a TiO₂ photocatalyst in the presence of excess oxygen (photo-SCR). The introduction of SO₂ (300 ppm) greatly decreased the activity of the photo-SCR at 373 K. The increment of the reaction temperature enhanced the resistance to SO₂ gas, and at 553 K the conversion of NO was stable for at least 300 min of the reaction. X-ray diffraction, FTIR spectroscopy, thermogravimetry and differential thermal analysis, x-ray photoelectron spectroscopy (XPS), elemental analysis and N₂ adsorption measurement revealed that the ammonium sulfate species were generated after the reaction. There was a strong negative correlation between the deposition amount of the ammonium sulfate species and the specific surface area. Based on the above relationship, we concluded that the deposition of the ammonium sulfate species decreased the specific surface area by plugging the pore structure of the catalyst, and the decrease of the specific surface area resulted in the deactivation of the catalyst.     

Systematic packaging design tools integrating functional and environmental consequences on product life cycle: Case studies on laundry detergent and milk

This study presents systematic packaging design tools integrating functional and environmental consequences on product life cycle. To design packaging for sustainability, the trade-offs between functional and environmental aspects of packaging throughout the product life cycle should be considered. However, it is difficult for packaging designers to understand the overall trade-offs because the extent of the design consequences on the entire life cycle of packaging and its contents is unclear. We developed two tools for packaging design: the Life Cycle Association Matrix (LCAM) and the Function Network Diagram (FND). The following three steps, based on literature reviews and interviews with industrial experts, were applied. Firstly, we listed the product functions and design variables related to the functions as the attributes allocated to the product life cycle. Secondly, the attributes were connected appropriately based on causal relationships. Lastly, we identified the factors to support decision making in the packaging design procedure. As a result, the LCAM depicts the design consequences on the life cycle, and the FND determines the stakeholders affected by the design consequences. Two case studies were demonstrated to analyze the trade-offs by using our tools. In the case studies, a liquid laundry detergent bottle and a milk carton were redesigned. The tools identified the design consequences and stakeholders affected by the redesign of the usability and protective function for the detergent and milk cases, respectively. The results showed the significance of understanding the design consequences on the product life cycle by integrating the functional and environmental aspects.     

Contribution of metal vapor mass at periphery part of pulsed arc to electromagnetic force in weld pool

The arc welding has been used in various welding methods because it is inexpensive and high in strength after welding. However, it is a problem that accidents such as collapse of the bridge occur because of the welding defects. The welding of low cost and high productivity is required without the welding defects. The pulsed TIG welding is inexpensive and capable of high‐quality welding. The electromagnetic force contributing to penetration changes because the transient response of arc temperature and iron vapor generated from anode occurs. However, the analysis of pulsed TIG welding with metal vapor has been elucidated only metal vapor concentration near anode with transient phenomenon and heat flux. Thus, the theoretical elucidation of penetration depth with control factor has not been researched. In this paper, the contribution of metal vapor mass at the periphery part of pulsed arc to the electromagnetic force in the weld pool is elucidated. As a result, the iron vapor mass at periphery part decreased with increasing the frequency. The iron vapor was stagnated at axial center within one cycle. The electromagnetic force to the penetration depth direction in weld pool increased at axial center. Therefore, the metal vapor mass at periphery part plays an important role for the electromagnetic force increment at axial center.     

Aqueous One-pot Synthesis of Glycopolymers by Glycosidase-catalyzed Glycomonomer Synthesis Using 4,6-Dimetoxy Triazinyl Glycoside Followed by Radical Polymerization

Glycopolymers have attracted increased attention as functional polymeric materials, and simple methods for synthesizing glycopolymers remain needed. This paper reports the aqueous one-pot and chemoenzymatic synthesis of four types of glycopolymers via two reactions: the β-galactosidase-catalyzed glycomonomer synthesis using 4,6-dimetoxy triazinyl β-D-galactopyranoside and hydroxy group-containing (meth)acrylamide and (meth)acrylate derivatives as the activated glycosyl donor substrate and as the glycomonomer precursors, respectively, followed by radical copolymerization of the resulting glycomonomer and excess glycomonomer precursor without isolating the glycomonomers. The resulting glycopolymers bearing galactose moieties exhibited specific and strong interactions with the lectin peanut agglutinin as glycoclusters.     

Graded evolution of anisotropic microstructure during sintering from crystal-oriented powder compact

Anisotropic sintering, including shrinkage and grain growth, was examined for c-axis-oriented (Sr,Ca)₂NaNb₅O₁₅ (SCNN) ceramics, which were prepared by colloidal processing under a magnetic field. In the c-axis-oriented SCNN powder compact, shrinkage and grain growth along the c-axis were higher than those along the a-axis. The anisotropic microstructural development was clearly associated with anisotropic sintering shrinkage. X-ray diffraction, scanning electron microscopy, and energy back scattering diffraction showed that the grain growth of oriented particles by including random grains contribute to the development of the oriented microstructure. Finally, the highly crystal-oriented SCNN ceramics with a densified microstructure were obtained through anisotropic sintering. These results clearly showed the potential to develop a well-defined anisotropic microstructure during sintering by designing and controlling the particle packing structure in a powder compact.     

Carcinoembryonic antigen in diagnosis and monitoring of colorectal cancer]

Female SJL mice are more susceptible than male mice to experimental autoimmune encephalomyelitis (EAE) induced by myelin basic protein (MBP)-specific T lymphocytes. In the present study, we examined mechanisms involved in this gender-related difference in disease susceptibility. MBP-specific T lymphocytes derived from spleens of males during the effector phase of adoptive EAE produced significantly higher levels of IL-10, an anti-inflammatory cytokine in EAE. A protective effect of testosterone was then shown. Females implanted with dihydrotestosterone pellets demonstrated a significantly less severe course of EAE as compared with females implanted with placebo pellets. Finally, MBP-specific T lymphocytes derived from dihydrotestosterone-implanted females produced significantly higher levels of IL-10 than those from placebo. Together these data indicate that testosterone exerts a protective effect in EAE that is mediated at least in part by enhanced production of IL-10 by autoantigen-specific T lymphocytes.     

Effects of 17 beta-estradiol on nitric oxide and ventricular myocardium metabolism

BACKGROUND: Arrhythmias are frequent pathology in patients with chronic hemodialysis. We evaluated whether a relatively new technique, signal averaging, could be useful in predicting the development of complex arrhythmias in these patients. METHODS: Thirty-three patients, 18 male and 15 female, subjected to thrice weekly chronic hemodialytic treatment with various dialysis techniques, were studied. Exclusion criteria were the presence of antiarrhythmic and inotropic treatment. The following examinations were carried out in all patients: a Holter dynamic electrocardiography for a duration of 24 hours, begun on the day of dialysis, high resolution ECG pre- and post-dialysis to find out if there were any ventricular late potential (VLP). Four hundred beats were examined in order to obtain a background noise of less than 0.7 microV and a better definition of the signal. The following parameters were considered significant for the presence of VLP: a) filtered QRS duration > 120 msec; b) the root mean square of the signal expressed in the terminal portion of QRS (RMS) < 25 microV) high frequency low amplitude signals duration (HFLA) > 40 msec. A positive value in two of these parameters was considered indicative of the presence of VLP. In addition various pre and post-dialysis indices of dialytic efficiency and a mono and two-dimensional echocardiogram with pulsed and color Doppler were carried out. Of the 33 patients studied, ten were excluded because they presented too high a background noise at the high resolution ECG. Of the remaining 23 patients, 13 (56%) presented VLP and nine of these (69%) presented complex arrhythmias. Of the ten patients without VLP, 5 (50%) presented complex arrhythmias. The incidence of arrhythmias was highest during the last two hours of dialysis and in the two hours following it. The patients were then divided into two groups (A and B) according to the ejection fraction (EF) found at the echocardiogram. Group A was composed of 17 patients of whom 8 (47%) presented complex arrhythmias; group B (EF < 45%) was composed of the remaining six patients, who all presented complex arrhythmias. In group A nine patients (53%) out of 17 had LVP, in group B four out of six (66%) had it. All the patients except one presented an increase in the thickness of the ventricular wall and alterations of Doppler transmitral filling rate. Left ventricular hypertrophy was diagnosed in 22 out of the 23 patients. Four patients also had chronic ischaemic heart disease; of these three had LVP. There was no correlation between the presence of LVP and the hemodialytic indices and between the latter and complex arrhythmias. CONCLUSIONS: Our study showed that arrhythmias are more frequent in patients with LVP before dialysis than in those without. The difference was statistically significant (p < 0.006); the incidence of arrhythmias was higher in patients with FE < 45% (p < 0.001). The majority of patients (95%) had left ventricular hypertrophy; only four (17%) had ischaemic heart disease too. It is highly probable that the presence of LVP in our patients can be attributed to hypertension and subsequent left ventricular hypertrophy. As patients with LVP at the end of dialysis had a greater incidence of arrhythmias than those without LVP, we suggest that this method could be useful as a first screening in dialysed patients.     

OTDM transmitter using WDM-TDM conversion with an electroabsorptionwavelength converter

An all-optical multiplexing technique using wavelength division multiplexing (WDM)-time division multiplexing (TDM) conversion with an electroabsorption wavelength converter has been proposed and demonstrated. The effectiveness of this WDM-TDM conversion technique for various pulsewidth settings was experimentally investigated. The fluctuation of the signal performance, which was inevitably caused by the coherent crosstalk between adjacent pulses in the conventional optical time division multiplexing (OTDM) technique, were successfully suppressed, even in the case of wide pulse duration. High Q-factor performance has been maintained for a wide range of duty ration from 36% to 74%. By introducing this technique to the optical time division multiplexer, a highly stable and high-quality 40-Gb/s optical signal can be effectively produced without generating the short pulse or setting two tributaries at orthogonal polarization states, and without introducing high-speed electronics for signal multiplexing. The WDM-TDM conversion with an electroabsorption wavelength converter was extended to 60-Gb/s operation by using three 20-Gb/s tributaries. A clear eye opening was confirmed for a waveform after the WDM-TDM conversion of the 60-Gb/s signal