Structure of microporous polypropylene sheets containing CaCO3 filler

The microporous polypropylene sheets were prepared by biaxially stretching polypropylene sheets containing CaCO₃ filler (particle size, 0.08–3.0 μm), when the CaCO₃ filler content was 59% by weight and the stretching ratio was 2.8 × 1.8. The microstructure of the sheets were investigated in relation to the CaCO₃ particle size by a N₂ gas permeation method. (1) Effective porosity increases with decreasing mean particle size of filler. (2) The tortuosity factor of the pore is in the range of 25–40 and becomes relatively smaller with decreasing mean particle size of filler. (3) The equivalent pore size becomes relatively smaller with decreasing mean particle size of filler.     

TRVs and fault clearing stresses in extra-high-voltage radial networks

To cope with the high rate of increase of power demand in the main industrialized districts in Japan, 550-kV transmission systems covering the districts have been reinforced, with most of the main power plants connected directly to these systems. Through 550-/300-kV substations, the majority of power to the districts is supplied by 300-kV systems. To limit the excess short-circuit capacity in the 300-kV systems, they tend to be reconstructed as so-called radial networks. In radial networks with high short-circuit capacity and relatively small number of transmission lines connected to the substation busbars, the rate of rise of TRV can be far higher than standard value. This paper analyzes the transient recovery voltages (TRV) in such extra-high-voltage radial networks in Japan, together with the relevant stresses to circuit-breakers during fault clearings. Future system conditions have also been introduced. As the typical rate of rise of the TRV values, more than twice that of today's standard ones are probable.     

Optical Energy Gap and Below Gap Optical Absorption of Fullerene Films Measured by the Constant Photocurrent Method and Photothermal Deflection Spectroscopy

The CPM spectra of fullerene films was measured to obtain the below gap absorption. The optical energy gap E_o was obtained by using the Tauc's plots. E_o did not change greatly with intercalated impurities. The absorption due to intercalated impurities was found below 1.6eV.     

Identification of Tumor Suppressive Genes Regulated by miR-31-5p and miR-31-3p in Head and Neck Squamous Cell Carcinoma

We identified the microRNA (miRNA) expression signature of head and neck squamous cell carcinoma (HNSCC) tissues by RNA sequencing, in which 168 miRNAs were significantly upregulated, including both strands of the miR-31 duplex (miR-31-5p and miR-31-3p). The aims of this study were to identify networks of tumor suppressor genes regulated by miR-31-5p and miR-31-3p in HNSCC cells. Our functional assays showed that inhibition of miR-31-5p and miR-31-3p attenuated cancer cell malignant phenotypes (cell proliferation, migration, and invasion), suggesting that they had oncogenic potential in HNSCC cells. Our in silico analysis revealed 146 genes regulated by miR-31 in HNSCC cells. Among these targets, the low expression of seven genes (miR-31-5p targets: CACNB2 and IL34; miR-31-3p targets: CGNL1, CNTN3, GAS7, HOPX, and PBX1) was closely associated with poor prognosis in HNSCC. According to multivariate Cox regression analyses, the expression levels of five of those genes (CACNB2: p = 0.0189; IL34: p = 0.0425; CGNL1: p = 0.0014; CNTN3: p = 0.0304; and GAS7: p = 0.0412) were independent prognostic factors in patients with HNSCC. Our miRNA signature and miRNA-based approach will provide new insights into the molecular pathogenesis of HNSCC.     

Conductive Papers Containing Metallized Polyester Fibers for Electromagnetic Interference Shielding

Conductive papers were developed for preventing or reducing electromagnetic interference (EMI), and their shielding efficiency was evaluated. This type of conductive paper consists of wood pulp, synthetic pulp and metallized polyester fibers (0.5–2.0 mm long and 14 m in diameter) whose surfaces are coated with nickel alone (Ni-PET) or copper and nickel double layers (Ni-Cu-PET) by electroless plating. In this report, the effect of the characteristics of these metallized fibers, such as their conductivity, geometry and the concentration of fibers in paper, which lead to high efficiency for shielding effectiveness is discussed. For instance, one of the conductive papers (80 g/m2) which was prepared by mixing 40% Ni-Cu-PET and 60% synthetic polyethylene pulp showed over 40 dB shielding effectiveness between 10 MHz and 1 GHz.     

Studies on relationship between activity and electron density on carbonyl oxygen in sex pheromone mimics of the American cockroach,part XI

From the relationship between structures of the 2-substituents of verbanyl analogs and their sex pheromone activities to the American cockroach, electron density of the carbonyl oxygen atom in the substituent, as estimated by the [¹⁷O]NMR chemical shift, was estimated to be an important factor which influenced the activity, in addition to length of the substituent and the position of the carbonyl group. (+)-Verbanyl methylcarbonate (XX), possessing the highest electron density on the carbonyl oxygen atom, showed the strongest activity among the analogs.For Part X, see Manabe et al., 1983. J. Chem. Ecol. 9:533–549.     

Multi-rigid-body dynamics and online model predictive control for transformable multi-links aerial robot*

Transformable multi-links aerial robots have great potentials in application relying on the transformable features to change its shape during the flight. Compared to traditional quadrotor robots, transformable multi-links robots are equipped with servo motor between links. To simplify the non-linear dynamic system, the previous work restricts the robot to transform in very slow speed so that the robot could be approximated as a quadrotor robot at each time point. However, tradeoff comes as the dynamic performance is given up. In this paper, we come up with a new framework combining of computationally efficient non-linear model predictive controller and motion primitive to optimize thrust force and joints trajectory of the multi-links aerial robot. Finally, we verify our framework with fast transformation motions and table tennis task which requires dynamic performance.     

Processing of ethanol fermentation broths by Candida krusei to separate bioethanol by pervaporation using silicone rubber‐coated silicalite membranes

BACKGROUND: Pervaporation employing ethanol‐permselective silicalite membranes as an alternative to distillation is a promising approach for refining low‐concentration bioethanol solutions. However, to make the separation process practicable, it is extremely important to avoid the problems caused by the adsorption of succinate on the membrane during the separation process. In this work, the pervaporation of an ethanol fermentation broth without succinate was investigated, as well as the influence of several fermentation broth nutrient components. RESULTS: Candida krusei IA‐1 produces an extremely low level of succinate. The decrease in permeate ethanol concentration through a silicone rubber‐coated silicalite membrane during the separation of low‐succinate C. krusei IA‐1 fermentation broth was significantly improved when compared with that obtained using Saccharomyces cerevisiae broth. By treating the fermentation broth with activated carbon, bioethanol was concentrated as efficiently as with binary mixtures of ethanol/water. The total flux was improved upto 56% of that obtained from the separation of binary mixtures, compared with 43% before the addition of activated carbon. Nutrients such as peptone, yeast extract and corn steep liquor had a negative effect on pervaporation, but this response was distinct from that caused by succinate. CONCLUSION: For consistent separation of bioethanol from C. krusei IA‐1 fermentation broth by pervaporation, it is useful to treat the low nutrient broth with activated carbon. To further improve pervaporation performance, it will be necessary to suppress the accumulation of glycerol. Copyright © 2009 Society of Chemical Industry     

Estimating the burden of acute gastroenteritis and foodborne illness caused by Campylobacter, Salmonella, and Vibrio parahaemolyticus by using population-based telephone survey data, Miyagi Prefecture, Japan, 2005 to 2006

Most cases of acute gastroenteritis and foodborne disease are not ascertained by public health surveillance because the ill person does not always seek medical care and submit a stool sample for testing, and the laboratory does not always test for or identify the causative organism. We estimated the total burden of acute gastroenteritis in Miyagi Prefecture, Japan, using data from two 2-week cross-sectional, population-based telephone surveys conducted in 2006 and 2007. To estimate the number of acute gastroenteritis illnesses caused by Campylobacter, Salmonella, and Vibrio parahaemolyticus in Miyagi Prefecture, we determined the number of cases for each pathogen from active laboratory-based surveillance during 2005 to 2006 and adjusted for seeking of medical care and submission of stool specimens by using data from the population-based telephone surveys. Monte Carlo simulation was used to incorporate uncertainty. The prevalence of acute gastroenteritis in the preceding 4 weeks was 3.3% (70 of 2,126) and 3.5% (74 of 2,121) in the winter and summer months, yielding an estimated 44,200 episodes of acute gastroenteritis each year in this region. Among people with acute gastroenteritis, the physician consultation rate was 32.0%, and 10.9% of persons who sought care submitted a stool sample. The estimated numbers of Campylobacter-, Salmonella-, and V. parahaemolyticus -associated episodes of acute gastroenteritis were 1,512, 209, and 100 per 100,000 population per year, respectively, in this region. These estimates are significantly higher than the number of reported cases in surveillance in this region. Cases ascertained from active surveillance were also underrepresented in the present passive surveillance, suggesting that complementary surveillance systems, such as laboratory-based active surveillance in sentinel sites, are needed to monitor food safety in Japan.     

Difference in the outdoor performance of bulk and thin-film silicon-based photovoltaic modules

Differences in the outdoor performances of bulk (multi- and single-crystalline Si) and thin-film (amorphous Si(a-Si), a-Si/micro-crystalline Si and a-Si/a-SiGe/a-SiGe) photovoltaic (PV) modules are analyzed. The influence of module temperature and solar spectrum distribution on the PV output is clarified. The PV outputs almost only depend on module temperature in bulk-type Si PV modules while that depend both module temperature and spectrum distribution in thin-film ones. Also, the PV outputs of the bulk-type Si PV modules at most frequent condition at outdoor are lower than that at the standard test condition; in contrast, it was the other way round for thin-film ones.