Dissolution of phase-separated domains after a jump to a temperature in the single-phase region

Phase-separated domains prepared in the two-phase region were dissolved at a temperature in the single-phase region, and their dissolution dynamics was studied by using the time-resolved light scattering (TRLS) technique and a scanning electron microscope (SEM). The time t_ps of preparation of domains was chosen to be long enough for phase separation to proceed into the late stage. The scattered light intensity at small wavenumbers increased before it attenuated. As t_ps increased, the increase at smaller wavenumbers became more significant and the peak intensity decreased only slightly with dissolution time. The characteristic wavenumber q_m evaluated from TRLS and SEM followed the power-law relation q_mt^−0.3.     

Involvement of specific mechanism in plasmid DNA uptake by mouse peritoneal macrophages

Lamina-associated polypeptide (LAP)2, which directly interacts with B-type lamins and chromosomes, is an integral membrane protein specifically distributed along the inner nuclear membrane of the nuclear envelope. Multiple regions of its large nucleoplasmic domain promote this localization, including the first (residues 1-296) and the second (residues 298-409) halves of the LAP2 N terminus. The second half is involved in LAP2 association with the nuclear lamina [Furukawa, K., Panté, N., Aebi, U. & Gerace, L. (1995) EMBO J. 14, 1626-1636]. In this study to further define its role, we examined which domain of B-type lamin interacts with LAP2 by means of a binding assay with bacterially expressed proteins and a yeast two-hybrid system. We found that amino acids in the region of residues 78-258 of the lamin B1 rod domain directly bound with LAP2. The data suggest that LAP2 may modulate the assembly of nuclear lamins.     

Interfacial tension of demixed polymer solutions near the critical temperature: polystyrene + methylcyclohexane

Interfacial tension between demixed solutions of polystyrene + methylcyclohexane has been measured near the critical temperature as a function of temperature using polystyrenes with molecular weights 9000 ～ 1.26 × 10⁶. The critical exponent for the interfacial tension was determined to be about 1.30 for the lower molecular weight systems. However, for higher molecular weights the exponent could not be obtained because the system departed from critical behaviour. Magnitudes of the interfacial tension were proportional to about N^?0.44, where N is the polymerization index. Experimental results were compared with the recently-proposed theories and found to be in qualitative agreement. The tricritical theory of polymer solutions was also compared with the experimental results.     

Association and physical gelation of ABA triblock copolymer in selective solvent

Association behavior and physical gelation mechanism of ABA triblock copolymer dissolved in B-selective solvent have been studied systematically from dilute to moderately concentrated solutions. Static and dynamic light scattering and nuclear magnetic resonance measurements for dilute solutions of poly(methyl methacrylate)-block-poly(tert-butyl acrylate)-block-poly(methyl methacrylate) (PMMA-PtBuA-PMMA) in 1-butanol (PtBuA selective solvent) indicated that PMMA-PtBuA-PMMA chains are molecularly dissolved above 50 °C. With decreasing temperature, the triblock copolymers form associated micelles consisting PMMA associated core and PtBuA shell. Linear dynamic viscoelastic measurements for solutions with moderate concentration (3.9-12.0 wt%) revealed that the system was viscous sol state at 60 °C. Drastic increase of shear storage modulus (G′) occurred with decreasing temperature, and at 25 °C, G′ showed rubbery plateau with weak frequency dependency, means the formation of elastic physical gel. The consistency between the temperature for micelle formation and that at the increase in G′ indicates that the physical gelation is owing to the network formation as the result of the association of PMMA chains and the bridging PtBuA chains connecting the PMMA cores. Master curves for the dynamic moduli were derived by time-temperature superposition along the frequency axis. Just above sol-gel transition concentration (C_gel), the master curves suggest the existence of fairy amount of aggregate that is not incorporated in the macroscopic network. With the increase in polymer concentration, the master curves become to reveal Maxwell-type viscoelasticity with narrow relaxation time distribution, suggesting the formation of transient network with easily generation and destruction of crosslinks. Concentration dependency of the plateau modulus is stronger than the theoretically expected, means the macroscopic transient network grows with polymer concentration by increasing the fraction of elastically effective bridging PtBuA chain above C_gel.     

Cost-Efficient Traffic Aggregation Employing Cross-Layer Shared Protection

Shared protection/restoration is a promising solution for reducing protection resources and is supported at each layer of the current multi-layer networks. Software-defined networking is expected to reduce equipment cost as well as operational cost by orchestrating these shared protection functionalities. However, although protection resource sharing improves link utilization, it sometimes increases the required equipment. Meanwhile, traffic re-aggregation at each layer is an important technique for low volume traffic to utilize the underlying link capacity more efficiently, but re-aggregation also makes it difficult to share protection resources with traffic at lower layers. In this paper, we present multi-layer network design strategy and method that reduce equipment cost by means of both traffic re-aggregation at each layer and protection resource sharing among multiple service traffic at different layers. The strategy first prioritizes traffic re-aggregation at each layer, and then maximally delegates shared protection to lower layers as long as it does not increase the required capacity at the lower layer. Evaluation results from the example three-layer networks confirm that the proposed method can effectively reduce equipment cost compared to the conventional design method. Cost reduction is achieved by leveraging shared protection functions at multiple layers.     

Construction of human monoclonal single-chain Fv antibodies against small-cell lung cancer by phage display libraries derived from cell-immunized SCID mice engrafted with human peripheral blood lymphocytes

In this study, we describe a phage display strategy to obtain human monoclonal single-chain Fv (scFv) antibodies binding target cancer cell surface proteins. By developing a cancer cell immunization protocol for SCID mice engrafted with human peripheral blood lymphocytes in combination with an antibody phage display method, we have isolated phage antibodies binding small-cell lung cancer cell line H889 by subtractive selection. One of the isolated scFv antibodies, 12EAb, recognized the E2 component of pyruvate dehydrogenase complex (PDC-E2) by immunoprecipitation according to MALDI-TOF MS analysis. Furthermore, we have confirmed the plasma membrane localization of PDC-E2 in small-cell lung cancer cells by immunocytochemistry and cell surface protein biotinylation, although PDC-E2 is usually located in the mitochondrial matrix. These results, including unique localization of identified antigens, were obtained by proteomic approaches. The present methods can be applied to generate human monoclonal scFv antibodies against tumor cells and to identify new molecular targets for immunotherapy and markers for diagnosis.     

Small crack behavior and fracture of nickel-based superalloy under ultrasonic fatigue

Fracture and small crack behavior in the very high cycle domain of 10⁹ cycles were investigated with a nickel-based superalloy under ultrasonic fatigue in ambient air at room temperature. The influence of ultrasonic frequency is examined by comparing the results with those in conventional low frequency fatigue. It is found that fatigue strength increases as frequency is raised up to 19.5 kHz and the most of fatigue life is consumed in nucleating and propagating small cracks up to 100 μm. Transition of fracture mode from transgranular ductile fracture to cleavage-dominated fracture occurs beyond a critical stress intensity factor range of approximately , leading to the catastrophic failure under ultrasonic fatigue.     

Synthesis and characterization of propylene‐α‐olefin random copolymers with isotactic propylene sequence. II. Propylene–hexene‐1 random copolymers

A series of novel hexene‐1–propylene random copolymers with isotactic sequence of propylene was synthesized with a MgCl₂‐supported Cr(acac)₃ catalyst. The molecular weight distribution of copolymers and homopolymers was considerably narrower than that of typical polyolefins produced by heterogeneous Ziegler–Natta catalysts. The crystallizability of the copolymers having a propylene‐unit content of more than 50 mol % drastically decreased with decreasing propylene‐unit content, and the copolymers with a propylene content of less than 50 mol % were completely amorphous. In the present novel type of random copolymers with crystallizable and noncrystallizable units, a single glass transition was observed between pure polypropylene and polyhexene‐1, and a major component was found to govern the final morphology and the mechanical characteristics. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 92: 2949–2954, 2004