Binary Adsorption Isotherms of Water and Ethyl Acetate Vapor for Materials Contained in a Box of a Tobacco Product

An experimental study has been carried out on the characteristics of binary adsorption isotherms of water and volatile flavor for typical materials used in a box of a tobacco product or cigarettes. Ethyl acetate chosen as a model for water-soluble volatile flavor. Binary adsorption isotherms for the tobacco, papers, filters, and activated carbons were measured with a flow-type multi-component adsorption system under the canstant conditions of temperature a t 303 K and vapor pressure of water a t 2.5 kPain the vapor pressure range of ethyl acetate from 0 to 4.2 kPa. A linear equation was applied to express the binary adsorption isotherms for the tobacco, papers and filters, while a Dubinin-Astakhov equation was applied for the activated carbons. The binary adsorption was characterized into three groups, depending on the selectivity as well as the mechanism of adsorption; i.e.(l) for tobacco and papers, water was adsorbed much greater rather than ethyl acetate, (2) for filters, ethyl acetate was adsorbed on the surface as great as water, (3) for activated carbons, ethyl acetate was adsorbed much greater onto their micropores rather than water. The results showed that ethyl     

Development of 170 GHz/500 kW gyrotron

A development of 170GHz/500kW level gyrotron was carried out as R&D work of ITER. The oscillation mode is TE_31,8. In a short pulse experiment, the maximum power of 750kW was achieved at 85kV/40A. The efficiency was 22%. In the depressed collector operation, 500kW/36%/50ms was obtained. The maximum efficiency of 40% was obtained at P_RF=470kW whereas the power decrease by the electron trapping was observed. Pulse extension was done up to 10s at P_RF=170kW with the depressed collector operation. The power was limited by the temperature increase of the output window.     

Construction of a control system for disturbance rejection using a dual observer

A well‐known control system which can reduce the adverse effects of disturbances is a disturbance observer. However, in many cases of mechanical systems, system disturbances which do not satisfy the matching condition may be imposed. Therefore, it may be difficult to reduce the adverse effects of the disturbances by the traditional disturbance observer. In this paper, a method of control system synthesis for disturbance rejection using a dual observer is proposed. This method is based on the zeroing induced by the disturbance localization problem. This problem may be solved by dividing the state space into observable subspace and unobservable subspace. As compared with an H_∞ controller based on perfect observation, the usefulness of the proposed control system for disturbance rejection is demonstrated by numerical simulations for a two‐mass spring system. © 2002 Scripta Technica, Electr Eng Jpn, 138(4): 50–60, 2002; DOI 10.1002/eej.1138     

Zeolite synthesis from paper sludge ash with addition of diatomite

BACKGROUND: This study aimed to investigate the synthesis of zeolites from paper sludge ash (PSA) with added diatomite to remove both NH₄⁺ and PO₄^3? for water purification. The PSA had low Si and significant Ca contents. Four types of diatomite: white (T‐W) and brown (T‐B) from deposits of marine origin in Takanosu, and white (S‐W) and gray (S‐G) from lacustrine deposits in Shonai, were added to NaOH solution to increase the Si content and thereby synthesize zeolites with high cation exchange capacity (CEC). RESULTS: The order of the amounts of Si extracted from the diatomite to the alkali solution was S‐W > T‐W = T‐B > S‐G, which correlates with the amorphous SiO₂ content of diatomite. The original ash without addition of diatomite yielded hydroxysodalite with CEC of about 1.0 mmol g^?1. For all samples, the addition of diatomite to the solution yielded zeolite‐P with a higher CEC, but the addition of excess Si inhibited the synthesis of zeolite‐P, and the CEC of the product was low. A product with high CEC including zeolite‐P was obtained in a solution with around 500 mmol L^?1 of Si concentration, and had the ability to remove both NH₄⁺ and PO₄^3?. CONCLUSION: Diatomite has the potential for used as an additive for the synthesis of high CEC zeolite from PSA. The product with zeolite‐P exhibited relatively high CEC, capacity for NH₄⁺ uptake, and the ability to remove PO₄^3? by precipitation, which is preferable for water purification applications. Copyright © 2008 Society of Chemical Industry     

Quasi-optical waveguide-mode converters using a pair of phase correction mirrors

This paper describes a quasi-optical method for the conversion of modes transmitted through highly oversized circular waveguides. A waveguide-mode is radiated once from a waveguide cut in the form of a radiation beam, which is then properly shaped by two curved mirrors and directed back into the waveguide. The curved mirror shapes are iteratively and automatically determined for given propagation distances using the design technique for phase correction mirrors. The proposed method gives favorable results in designing a waveguide expander/reducer, a TE₀₁-TE₀₂ mode converter, and a TE₀₁-HE₁₁ mode converter.     

An apparent ensemble effect in the oxidative coupling of methane on hydroxyapatites with incorporated lead

The introduction of small quantities of lead into calcium hydroxyapatite catalysts produces marked increases in the selectivity to C₂₊ hydrocarbons, while the conversion of methane remains relatively constant. Small surface concentrations of lead are sufficient to achieve C₂₊ selectivities of 80 and 90%, with oxygen and nitrous oxide, respectively, in contrast with 18 and 46%, respectively, obtained in the absence of lead. Since surface concentration of lead species sufficient to stabilize pairs of methyl radicals in close proximity to each other would be expected to facilitate the formation of C₂ hydrocarbons, an ensemble effect appears to be extant.     

Microporous carbons prepared from cationic surfactant-resorcinol/formaldehyde composites

Microporous carbons have been synthesized by the carbonization of cationic surfactant-resorcinol/formaldehyde (RF) composites, which were themselves formed by electrostatic organic-organic interaction. The porous structure produced by the decomposition of the surfactant plays an important role for the gasification of the RF polymer at higher temperatures. The pore size of the carbon prepared from tetrapropylammonium bromide (TPAB)-RF, cetyltrimethylammonium bromide (C₁₆TAB)-RF and decyltrimethylammonium bromide (C₁₀TAB)-RF mixtures can be estimated as 0.53 nm from the Horvath-Kawazoe method using N₂ adsorption isotherms. Their pore size distributions were very narrow, showing that the microporous carbons derived from surfactant-RF mixture may have promise as adsorbents and membrane materials.