全文获取类型
收费全文 | 1820篇 |
免费 | 47篇 |
国内免费 | 2篇 |
专业分类
电工技术 | 145篇 |
综合类 | 3篇 |
化学工业 | 449篇 |
金属工艺 | 48篇 |
机械仪表 | 52篇 |
建筑科学 | 34篇 |
矿业工程 | 1篇 |
能源动力 | 104篇 |
轻工业 | 126篇 |
水利工程 | 3篇 |
无线电 | 190篇 |
一般工业技术 | 344篇 |
冶金工业 | 170篇 |
原子能技术 | 48篇 |
自动化技术 | 152篇 |
出版年
2023年 | 10篇 |
2022年 | 25篇 |
2021年 | 30篇 |
2020年 | 14篇 |
2019年 | 15篇 |
2018年 | 25篇 |
2017年 | 19篇 |
2016年 | 48篇 |
2015年 | 26篇 |
2014年 | 45篇 |
2013年 | 104篇 |
2012年 | 87篇 |
2011年 | 96篇 |
2010年 | 85篇 |
2009年 | 84篇 |
2008年 | 89篇 |
2007年 | 77篇 |
2006年 | 77篇 |
2005年 | 68篇 |
2004年 | 49篇 |
2003年 | 58篇 |
2002年 | 46篇 |
2001年 | 33篇 |
2000年 | 27篇 |
1999年 | 33篇 |
1998年 | 88篇 |
1997年 | 77篇 |
1996年 | 54篇 |
1995年 | 44篇 |
1994年 | 27篇 |
1993年 | 31篇 |
1992年 | 21篇 |
1991年 | 28篇 |
1990年 | 23篇 |
1989年 | 18篇 |
1988年 | 18篇 |
1987年 | 16篇 |
1986年 | 17篇 |
1985年 | 14篇 |
1984年 | 19篇 |
1983年 | 21篇 |
1982年 | 17篇 |
1981年 | 16篇 |
1980年 | 7篇 |
1979年 | 15篇 |
1978年 | 7篇 |
1977年 | 6篇 |
1976年 | 5篇 |
1975年 | 3篇 |
1971年 | 2篇 |
排序方式: 共有1869条查询结果,搜索用时 0 毫秒
1.
Yoshihiro Iida Toshikatsu Tsuyuki Takao Mashima Takeo Takashima Kunito Okuyama 《亚洲传热研究》2002,31(1):28-41
This paper presents a series of experimental results on a passive augmentation technique of boiling heat transfer by supplying solid particles in liquid. A cylindrical heater 0.88 mm in diameter is placed in saturated water, in which a lot of mobile particles exist, and the nucleate and film boiling heat transfer characteristics are measured. Particle materials used were alumina, glass, and porous alumina, and the diameter ranged from 0.3 mm to 2.5 mm. Particles are fluidized by the occurrence of boiling without any additive power, and the heat transfer is augmented. The maximum augmentation ratio obtained in this experiment reaches about ten times the heat transfer coefficient obtained in liquid alone. The augmentation ratio is mainly affected by the particle material, diameter, and the height of the particle bed set at no boiling condition. The augmentation mechanism is discussed on the basis of the experimental results. © 2001 Scripta Technica, Heat Trans Asian Res, 31(1): 28–41, 2002 相似文献
2.
Yoshihiro Yajima 《时间序列分析杂志》1985,6(3):187-201
Abstract. We shall investigate the asymptotic behaviour of the sample autocorrelations and partial autocorrelations of a multiplicative ARIMA process and derive their limiting distributions. Some simulations are presented to illustrate the results obtained. 相似文献
3.
Hideo Sawada Hiroshi Kakehi Masashi Koizumi Yoshihiro Katoh Masashi Miura 《Journal of Materials Science》2007,42(17):7147-7153
Fluoroalkyl end-capped N-(1,1-dimethyl-3-oxobutyl)acrylamide oligomer [RF-(DOBAA)
n
-RF] reacted with tetraethoxysilane (TEOS) and silica nanoparticles in the presence of low-molecular weight biocides such as
hibitane, hinokitiol, and hinokioil under alkaline conditions to afford RF-(DOBAA)
n
-RF/silica nanocomposites-encapsulated these biocides in excellent to moderate isolated yields. Fluoroalkyl end-capped N,N-dimethylacrylamide oligomer [RF-(DMAA)
n
-RF] and acrylic acid oligomer [RF-(ACA)
n
-RF]/silica nanocomposites-encapsulated hibitane were obtained under similar conditions. Dynamic light scattering measurements
showed that the size of these fluorinated nanocomposites-encapsulated biocides thus obtained is nanometer size-controlled.
Additionally, these fluorinated nanocomposites were shown to have a good dispersibility and stability in methanol and water.
Of particular interest, these fluorinated nanocomposites-encapsulated biocides were found to have a good antibacterial activity
against Staphylococcus aureus, and these nanocomposites were applied to the surface modification of traditional organic polymers such as poly(methyl methacrylate). 相似文献
4.
Takeshi Shiofuku Norihiro Abe Yoshihiro Tabuchi Hirokazu Taki Shoujie He 《Artificial Life and Robotics》2008,13(1):290-293
This paper presents an approach of measuring in real-time the vector of finger that is pointing to an object. DSP is used
in the operation processing unit in order to do the real-time processing. The steps include the extraction of flesh-colored
regions from an image, the labeling of the flesh-colored regions, and the detection of two characteristic positions on the
finger so that the direction that the finger is pointing at will be calculated. The entire process takes about 29 msec, which
makes it possible to have the frame rate of 34 fps. With this frame rate, this measurement approach is considered real-time
and promising to be merged into other application systems.
This work was presented in part at the 13th International Symposium on Artificial Life and Robotics, Oita, Japan, January
31–February 2, 2008 相似文献
5.
The incidence of Campylobacter jejuni and Campylobacter coli in broiler farms was 33.9% (19/56). C. jejuni-positive flocks accounted for 20.0% (17/85) and C. coli-positive ones was 4.7% (4/85). There were 14 patterns (fla type) of restriction fragment length polymorphism (RFLP) of flagellin A gene among these 22 strains of C. jejuni and C. coli including the standard strain C. jejuni ATCC 33560. Different fla types of Campylobacter were isolated from broilers in different growing cycles on the same farms. Four strains of C. jejuni were isolated from four breeder farms and four fla types of C. jejuni were detected from their progenies reared on growing farms. Three fla types of C. jejuni detected from the progenies were different from those of each breeder. Also, the other three fla types of C. jejuni were detected from different progenies of each growing farm during the next growing cycle. These findings indicate that the RFLP analysis may contribute to epidemiological studies of C. jejuni and C. coli contamination of broilers and suggest the risk of contamination with different types of Campylobacter in every growing cycle of broilers on the farm even on the same farm. They also supported that there was little likeliness of the vertical transmission of C. jejuni and C. coli from breeders to broilers. 相似文献
6.
A serious problem in motion control is the occurrence of torque ripple. Since a direct drive (DD) motor with a magnet rotor uses a rare-earth magnet, the torque ripple is more serious than that of conventional servomotors. This paper presents an auto-compensation of torque ripple using a software-implemented torque observer. The frequency and amplitude of torque ripple can be obtained in the controller by using the estimated torque from an observer, and the autonomous generation of a compensating current component for a torque ripple is possible. The proposed algorithm has been verified by experiments. 相似文献
7.
A compact, high-resolution analog-to-digital converter (ADC) especially for sensors is presented. The basic structure is a completely digital circuit including a ring-delay-line with delay units (DUs), along with a frequency counter, latch, and encoder. The operating principles are: (1) the delay time of the DU is modulated by the analog-to-digital (A/D) conversion voltage and (2) the delay pulse passes through a number of DUs within a sampling (= integration) time and the number of DUs through which the delay pulse passes is output as conversion data. Compact size and high resolution were realized with an ADC having a circuit area of 0.45 mm/sup 2/ (0.8-/spl mu/m CMOS) and a resolution of 12 /spl mu/V (10 kS/s). Its nonlinearity is /spl plusmn/0.1% FS per 200-mV span (1.8-2.0 V), for 14-b resolution. Sample holds are unnecessary and a low-pass filter function removes high-frequency noise simultaneously with A/D conversion. Thus, the combination of this ADC and a digital filter that follows can eliminate an analog prefilter to prevent the aliasing before A/D conversion. Also, both this ADC can be shrunk and operated at low voltages, so it is an ideal means to lower the cost and power consumption. Drift errors can be easily compensated for by digital processing. 相似文献
8.
A demonstrative study for the wind and solar hybrid power system 总被引:1,自引:0,他引:1
In March 1995, a small scale wind and solar hybrid power system was installed at Ashikaga Institute of Technology. Until now, the authors have acquired the data of the output of the hybrid power plant along with wind speed, wind direction, and the solar radiation, in order to demonstrate a complementary relationship between solar energy and wind energy.After nine months operation of the system, the authors confirmed that there exists a complementary relationship between solar energy and wind energy. We also found, however, that the power output by wind does not have much prospect compared to that by solar cell especially in summer season in Ashikaga area. 相似文献
9.
We propose combined distributed-feedback/Fabry-Perot (DFB/FP) structures for surface-emitting semiconductor lasers. The analysis is based on coupled-wave equations modified for surface-emitting lasers. The proposed structures, which exhibit enhanced resonance due to a matching between the gain and field distributions resulting in a reduced threshold compared with simple FP structures, are formed by placing the DFB structure between two DBR mirrors of an FP resonant cavity and introducing phase layers between the DFB region and the mirrors. It was found that the periodic-gain structures are a special case of the combined DFB/FP structures in which the index coupling effect is assumed to be negligible due to a small fill factor or a small refractive-index difference. The effect of complex (gain and index) coupling on the design and the threshold characteristics of the structures is clearly illustrated. Some important design considerations that were neglected in the previous papers are addressed 相似文献
10.
The beam divergence in the vertical direction from a graded index separate confinement heterostructure (GRINSCH) multiquantum-well (MQW) laser has been studied. It is demonstrated both theoretically and experimentally that a circular beam MQW laser can be produced by choosing appropriate thicknesses for the GRINSCH layers, while maintaining other desired laser characteristics. The beam divergence is found to be more affected by the index change induced by injected carriers than by strain in the MQW active layer. Theoretical results are in good agreement with the measurements for 1.3-μm InGaAsP strained MQW lasers 相似文献