Benchmark experiment of large-angle scattering reaction cross section of iron at 14 MeV using two shadow bars – Comparison of experimental results with ENDF/B-VIII –

ABSTRACT

It is important to perform neutron transport simulations with accurate nuclear data in the neutronics design of a fusion reactor. However, absolute values of large-angle scattering cross sections vary among nuclear data libraries even for well-examined nuclide of iron. Benchmark experiments focusing on large-angle scattering cross sections were thus performed to confirm the correctness of nuclear data libraries. The series benchmark experiments were performed at a DT neutron source facility, OKTAVIAN of Osaka University, Japan, by the unique experimental system established by the authors’ group, which can extract only the contribution of large-angle scattering reactions. This system consists of two shadow bars, target plate (iron), and neutron detector (niobium). Two types of shadow bars were used and four irradiations were conducted for one experiment, so that contribution of room-return neutrons was effectively removed and only large-angle scattering neutrons were extracted from the measured four Nb reaction rates. The obtained experimental results were compared with calculations for five nuclear data libraries including JENDL-4.0, JEFF.-3.3, FENDL-3.1, ENDF/B- VII, and recently released ENDF/B-VIII. It was found from the comparison that ENDF/B-VIII showed the best result, though ENDF/B-VII showed overestimation and others are in large underestimation at 14 MeV.     

Fundamental Evaluation of Power Supply and Rectifiers for Wireless Power Transfer Using Magnetic Resonant Coupling

This paper provides a fundamental analysis of a power supply and rectifiers for wireless power transfer using magnetic resonant coupling (MRC). MRC enables efficient wireless power transfer over middle‐range transfer distances. MRC for wireless power transfer should operate at a high frequency in the industry science medical band, such as 13.56 MHz, because the size of the transfer device decreases at higher transfer frequencies. Therefore, the output frequency of the power supply on the transmitting side should be 13.56 MHz. In addition, the rectifier on the receiving side is operated at a high frequency. This paper focuses on the reflected power in the power supply and rectifiers. Thus, the parametric design method is clarified for the power supply, including a low‐pass filter to match the output, the impedance of the power supply with the characteristic impedance of the transmission line. In addition, the effects on the rectifiers of silicon carbide and gallium nitride diodes are confirmed by performing an experiment and a loss analysis.     

Spontaneous disappearance of traumatic macular holes in young patients

PURPOSE: To report the disappearance of traumatic macular hole in three eyes of three patients. METHODS: Clinical data of the patients were reviewed. RESULTS: The three patients were relatively young, ranging in age from 12 to 18 years old. In one eye of each patient, a small traumatic macular hole was observed at the first visit. Visual acuities ranged from 20/100 to 20/40. The macular holes resolved spontaneously 3 to 4 months after the trauma, and final visual acuity improved to 20/20 in all patients. CONCLUSION: Small traumatic macular holes in young patients can resolve spontaneously, and this can be associated with good visual recovery.     

A cross-sectional analysis on relationships between maximum oxygen uptake and risk factors for cardiovascular diseases

We examined the relationships between maximum oxygen uptake (Vo2max) and cardiovascular risk factors including age (year), systolic blood pressure (mmHg), diastolic blood pressure (mmHg), serum total cholesterol level (mg/dl), serum high-density lipoprotein level (mg/dl), serum triglyceride level (mg/dl), blood glucose level (mg/dl), serum uric acid level (mg/dl), body fat (%bw), Body Mass Index (BMI), alcohol (points/day), cigarettes (/day), and physical activity (METs.exercise time/30 days). The alcohol point was defined as follows: beer 633ml = a glass of whiskey and water - sake 180ml = 1 point, and totaled at 30 days. The subjects of our study were 162 males (aged 40.6 +/- 13.1) and 133 females (aged 41.3 +/- 11.1) who underwent medical and physical examinations at the Fukui Industrial Health Center from April, 1991 to June, 1992. As a result of simple correlation analysis in males, Vo2max had significantly negative correlations with age (r = -0.223, p < 0.01), systolic blood pressure (r = -0.228, p < 0.01), diastolic blood pressure (r = -0.239, p < 0.01), or serum triglyceride level (r = -0.258, p < 0.001), serum uric acid level (p < 0.05), body fat (r = -0.230, p < 0.01), and BMI (r = -0.312, p < 0.001), and was positively correlated with physical activity (r = -0.249, p < 0.01). On the other hand, in females, age (r = -0.224, p < 0.01), systolic blood pressure (r = -0.222, p < 0.01), diastolic blood pressure (r = -0.267, p < 0.01), serum triglyceride level (r = -0.261, p < 0.001), body fat (r = -0.280, p < 0.01), and BMI (r = -302, p < 0.001), had significantly negative correlations with VO2max. However, partial correlations were tested after controlling body fat, BMI, cigarette, alcohol, physical activity, and age, none of the factors correlated with VO2max significantly. These findings suggest that the risk factors for cardiovascular diseases are related to VO2max, and the life style has an influence on these correlations. Thus, VO2max may be a comprehensive indicator for health promotion among the working population. Furthermore a longitudinal study is required to determine whether the increase in VO2max is related to the improvement in the risk of cardiovascular diseases.     

The development of MHD cold wall channels in the oil-fired condition

The durability of a cold wall MHD generator consisting of metal electrodes and alumina-coated peg insulators was experimentally examined in the oil-fired MHD condition with the additive of SO₂ corresponding to S = 0.54 wt%. The structure of the electrode wall and various anode and cathode materials were tested, with particular reference to developing long-life electrodes. It was clarified that Pt, SHOMAC (28.8 Cr−1.9 Mo) and SUS-304 as anodes and W---Cu (70 W−30 Cu) and WC---Ag (60 WC−40 Ag) alloys as cathodes were promising for durability and that the structure of an anode divided into two elements connected to each other with an SnO₂ resistor was very useful for uniformity of the anode corrosion pattern and the inter-anode voltages. It is reasonable to expect, from the test results, that the lifetime of a cold wall MHD generator in an oil-fired commercial plant will be over 4000 h, and therefore, a foundation for its commercial use has been established.     

Septic cholangitis occurring 11 years after inadvertent ligation of the right hepatic duct during cholecystectomy: a case report

We report a case of acute cholangitis caused by the inadvertent ligation of the right hepatic duct during a cholecystectomy performed 11 years before. When the condition of the right hepatic duct or accessory bile duct ligation persists for more than several years, resulting in atrophy of the relevant part of the liver, bile duct ligation will rarely cause severe clinical problems. However, acute cholangitis may occur, as in our patient, so long-term follow-up of the patient is warranted.     

Accumulation of triosephosphate isomerase, with sequence homology to Beta amyloid peptides, in vessel walls of the newborn piglet hippocampus

We investigated whether beta-amyloid (Abeta)-like immunoreactivity was seen in the brains of newborn piglets. The immunoreactivity for Abeta(1-42) and Abeta(1-40) proteins, but not Abeta precursor protein, was present in CD68-positive perivascular cells of the hippocampus and in parts of the meninges. It was colocalized with immunoreactivity for receptor for advanced glycation end product and tumor necrosis factor-alpha. The protein with a molecular mass of 27 kDa, which was recognized by the Abeta antibodies, was identified as triosephosphate isomerase (TPI) with sequence homology to Abeta peptides by N-terminal amino acid sequencing, mass fingerprint analysis using matrix-associated laser desorption/ionization mass spectrometry, and Western blotting. Western blotting assay also revealed that detectable expression of Abeta proteins were not seen in the piglet brains. These findings indicate that TPI with sequence homology to Abeta peptides accumulates in perivascular cells of the microglia/macrophage lineage located around arterial vessels of the newborn piglet hippocampus.     

A novel bistable reflective display using quick‐response liquid powder

Abstract— We have developed new powder materials that exhibit liquid behavior, which can lead to the realization of novel bistable and reflective displays having paper‐white appearance, high contrast, and quick response. Two types of display were demonstrated, one had 160 × 160 array of pixels and the other had 320 × 320 in a 3.1‐in.‐diagonal viewable image size corresponding to 66 and 132 dpi, respectively. These displays were driven by passive‐matrix addressing. The displays showed a reflectivity of more than 41%, a contrast more than 1:10, and a pixel response time of less than 0.2 msec. The seven‐segment display for use in clocks was also demonstrated.     

Dynamic Power Integrity Control of ATE for Eliminating Overkills and Underkills in Device Testing

This paper proposes a power integrity control technique for dynamically controlling power supply voltage fluctuations for a device under test (DUT), and demonstrates its effectiveness for eliminating the overkills/underkills due to the difference of power supply impedance between an automatic test equipment (ATE) and a practical operating environment of the DUT. The proposed method injects compensation currents into the power supply nodes on the ATE system in a feed-forward manner such that the ATE power supply waveform matches with the one on the customer’s operating environment of the DUT. A method for calculating the compensation current is also described. Experimental results show that the proposed method can emulate the power supply voltage waveform under a customer’s operating condition and eliminate 95 % of overkills/underkills in the maximum operating frequency testing with 105 real silicon devices. Limitations and applications of the proposed method are also discussed.     

Alignment control of liquid crystals in a 1.0‐μm‐pitch spatial light modulator by lattice‐shaped dielectric wall structure

We achieved uniform liquid crystal (LC) alignment in lattice‐shaped dielectric walls 1 μm in pitch; this is a prerequisite when driving the individual pixels of spatial light modulators, facilitating the development of practical electronic holographic displays with a wide field of view. In lattice‐shaped dielectric walls, LC alignment becomes unstable, particularly on the bottom and the walls; the LC directors tend to align parallel to the walls. To overcome this problem, we created lattice‐shaped walls featuring partition plates that allow uniform LC alignment. When the plates confine LCs to small regions exhibiting spatial anisotropy, the LC elastic effect and wall anchoring forces align the LC directors parallel to the long anisotropic axis. We found that pixels 0.5 μm × 1.0 μm in pitch formed if the partition plates were sufficiently thick to allow shielding of electric field leakage.