Benchmark experiment of large-angle scattering reaction cross section of iron at 14 MeV using two shadow bars – Comparison of experimental results with ENDF/B-VIII –

ABSTRACT

It is important to perform neutron transport simulations with accurate nuclear data in the neutronics design of a fusion reactor. However, absolute values of large-angle scattering cross sections vary among nuclear data libraries even for well-examined nuclide of iron. Benchmark experiments focusing on large-angle scattering cross sections were thus performed to confirm the correctness of nuclear data libraries. The series benchmark experiments were performed at a DT neutron source facility, OKTAVIAN of Osaka University, Japan, by the unique experimental system established by the authors’ group, which can extract only the contribution of large-angle scattering reactions. This system consists of two shadow bars, target plate (iron), and neutron detector (niobium). Two types of shadow bars were used and four irradiations were conducted for one experiment, so that contribution of room-return neutrons was effectively removed and only large-angle scattering neutrons were extracted from the measured four Nb reaction rates. The obtained experimental results were compared with calculations for five nuclear data libraries including JENDL-4.0, JEFF.-3.3, FENDL-3.1, ENDF/B- VII, and recently released ENDF/B-VIII. It was found from the comparison that ENDF/B-VIII showed the best result, though ENDF/B-VII showed overestimation and others are in large underestimation at 14 MeV.     

Ammonia production using iron nitride and water as hydrogen source under mild temperature and pressure

Ammonia generation was studied in the reaction between water and nitrogen-containing iron at 323 K and atmospheric pressure. Similar to metallic Fe, the interstitial compound Fe₃N reduced water through Fe oxidation to produce hydrogen gas, while the N combined with atomic hydrogen to produce ammonia as a byproduct. The addition of carbon dioxide to this system accelerated the reaction with concomitant consumption of carbon dioxide. The promoted ammonia production upon addition of carbon dioxide can be attributed to the generation of atomic hydrogen from the redox reaction of carbonic acid and Fe, as well as removal of used Fe from the reaction system through the formation of a soluble carbonato complex. When carbonate was added to the reaction system, the production rates of ammonia and hydrogen increased further. The results here confirmed that ammonia can be synthesized from iron nitride under mild conditions by utilizing carbon dioxide.     

Molecular Targeted Therapy for the Bone Loss Secondary to Pyogenic Spondylodiscitis Using Medications for Osteoporosis: A Literature Review

Pyogenic spondylodiscitis can cause severe osteolytic and destructive lesions in the spine. Elderly or immunocompromised individuals are particularly susceptible to infectious diseases; specifically, infections in the spine can impair the ability of the spine to support the trunk, causing patients to be bedridden, which can also severely affect the physical condition of patients. Although treatments for osteoporosis have been well studied, treatments for bone loss secondary to infection remain to be elucidated because they have pathological manifestations that are similar to but distinct from those of osteoporosis. Recently, we encountered a patient with severely osteolytic pyogenic spondylodiscitis who was treated with romosozumab and exhibited enhanced bone formation. Romosozumab stimulated canonical Wnt/β-catenin signaling, causing robust bone formation and the inhibition of bone resorption, which exceeded the bone loss secondary to infection. Bone loss due to infections involves the suppression of osteoblastogenesis by osteoblast apoptosis, which is induced by the nuclear factor-κB and mitogen-activated protein kinase pathways, and osteoclastogenesis with the receptor activator of the nuclear factor-κB ligand-receptor combination and subsequent activation of the nuclear factor of activated T cells cytoplasmic 1 and c-Fos. In this study, we review and discuss the molecular mechanisms of bone loss secondary to infection and analyze the efficacy of the medications for osteoporosis, focusing on romosozumab, teriparatide, denosumab, and bisphosphonates, in treating this pathological condition.     

Crosslinked acrylic pressure‐sensitive adhesives. II. Effect of humidity on the crosslinking reaction

The effect of humidity during storage on the crosslinking reactions of isocyanate groups was investigated with attenuated total reflectance Fourier transform infrared spectroscopy with pressure‐sensitive adhesives composed of poly[ethyl acrylate‐co‐(2‐ethylhexyl acrylate)‐co‐(2‐hydroxyethyl methacrylate)] as a base resin and polyisocyanate as a crosslinker. A peak‐resolving analysis of the amide II region revealed four bands. According to an analysis of the Fourier transform infrared spectra of the model compounds, these four bands were assigned to free urethane linkages, hydrogen‐bonded urethane linkages, free urea linkages, and hydrogen‐bonded urea linkages. As expected, storage under humid conditions led to the formation of free and hydrogen‐bonded urea linkages corresponding to the promotion of isocyanate consumption. Peak resolution of the amide II region was found to be a reasonable way of monitoring urethane and urea linkages during crosslinking reactions. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 3039–3045, 2003     

Reduction mechanism of tioglycolic acid on keratin fibers using microspectrophotometry and FT-Raman spectroscopy

In order to investigate the reduction mechanism of thioglycolic acid (TG) on the keratin fibers, cross-sectional samples of white human hair treated with TG were prepared. The heterogeneous reaction between TG and keratin fibers involving the diffusion of TG into human hair was analyzed at the molecular level using microspectrophotometry and FT-Raman spectroscopy. The diffusion of TG into human hair clearly increased by increasing the treatment time and by raising pH. The TG relative concentration and the disconnected relative concentration of disulfide (–SS–) groups at various depths of the hair samples with pH 9.0 were in good agreement, indicating that the reaction rate (the disconnection of –SS– groups) was faster than the diffusion rate of TG into human hair. From these experiments, we demonstrated that TG diffuses gradually beyond the cuticle region, and toward the inside of the cortex region along with the disconnection of –SS– groups.     

Suppression control method for torque vibration of three-phase HB-type stepping motor utilizing feedforward control

This paper proposes a method to reduce the vibration of the three-phase HB-type stepping motor with cogging torque by the feedforward compensation control. The compensation signal to suppress the vibration of the motor frame is obtained by the repetitive controller installing an online Fourier transformer and utilizing an acceleration sensor attached to the motor frame or an acoustic sensor such as a microphone placed close to the frame. The sensor is used only for the acquisition of the feedforward compensation data. The feedforward compensation signal at an arbitrary operating point is derived from the amplitude and phase data of the frequency components and the operating point data. Compensation data obtained by the repetitive controller is applied to the operating point changed by reference frequency and load condition in steady state. The compensation signal for the new operating point will be generated from compensation data utilizing polynomial equation approximation and linear interpolation method. The effectiveness of this proposed method is confirmed by the experimental results.     

Preparation of gold nanoparticles (GNP) aqueous suspensions by a new method involving Tiron

A new method is proposed to produce gold nanoparticles (GNP) by in situ reduction of a gold salt dissolved in water. The reducing agent used is Tiron instead of the citrate anion most often mentioned in literature. The influence of various parameters has been investigated, such as the content of Tiron with respect to that of the precursor of gold HAuCl₄, or the initial pH of the solution after mixing of reactants. It is shown that Tiron also exerts a positive influence as a dispersant, which impedes agglomeration of gold nanoparticles. The typical average size of GNP synthesized in the present work is close to 7 nm.     

Characteristics of a far-infrared molecular laser optically pumped by a high-power CO2 laser

A molecular far-infrared (FIR) laser optically pumped by a high-power CO₂ laser, which is a powerful source for testing detectors and mixers and for FIR spectroscopy, is constructed and the performance is examined through experiments. At frequencies between 580GHz and 4.25THz, FIR output power is more than 20～30m W by pumping power of 35～81W. Amplitude stability of ±3% is obtained at 100m W output at 2.52THz for over 30 minutes when the FIR tube is cooled at 5°C by a chiller. As an application to testing mixers, FIR laser lines up to 4.25 THz are detected by Schottky barrier diodes (SBD). Further, using a SBD, performance of absolute frequency stability at 693GHz of HCOOH oscillation is measured by harmonic mixing with a 115.5GHz millimeter wave from a phase-locked Gunn oscillator. The resultant center-frequency stability is 100kHz per 10 minutes.     

Moisture migration in idealized bilayer systems: relationships among water-associated properties, structure, and texture

The effects of composition and thermal treatment on the water sorption and diffusional properties of idealized protein gels arranged in bilayer configurations were determined; these water binding/migration properties were related to the mechanical characteristics of the gels. Samples were prepared from whey protein concentrate (WPC), they consisted of water:WPC ratios of 1.5 to 5.67, and were thermally set for 20–60 min. Moisture migration rates from samples interfaced with filters were determined, as were moisture sorption capacities of samples immersed in water. The physical properties of the gels were assessed by uniaxial compression and microscopy. Results showed that gel strength and consequent extent of protein interaction—as affected by thermal treatment—controlled the ability of the gel structure to absorb water. Sorption was exponentially correlated with gel modulus and linearly correlated with a function of protein content, heating time, and immersion time. Rates of diffusion from interfaced gels were dependent solely on water content. It was concluded that the degree of protein interaction, whether influenced by concentration or thermal treatment, affected network extensibility and thus the capacity of the gels to act as receptors of moisture. Results have implications for the functionality of shelf-stable sandwiches and other multicomponent foods.     

Ossifying epithelioid hemangioendothelioma

A case of small epithelioid hemangioendothelioma encapsulated by an egg-shaped bony shell composed of newly formed mature lamellar bone is presented. A nodule measuring 10 x 5 x 5 mm was excised from inside of the right cheek muscle of a 46-year-old man. Histopathologically, the nodule consisted mainly of round-to-short spindled epithelioid cells with round nuclei and occasional cytoplasmic vacuoles associated with some foci of osseous metaplasia. Characteristically, egg shell-like lamellar bone enclosed this lesion showing well-circumscribed appearance. The main component cells were immunohistochemically stained positive for factor VIII-related antigen, CD 34, UEA-1, and vimentin, and proved to be vascular endothelial cells. The term ossifying epithelioid hemangioendothelioma is proposed for this unique lesion. This type of epithelioid hemangioendothelioma has not been previously reported to our knowledge, and differentiation from ossifying fibromyxoid tumor of soft parts is considered to be important.