全文获取类型
收费全文 | 117篇 |
免费 | 13篇 |
专业分类
综合类 | 30篇 |
化学工业 | 19篇 |
金属工艺 | 3篇 |
矿业工程 | 55篇 |
无线电 | 8篇 |
一般工业技术 | 11篇 |
冶金工业 | 2篇 |
自动化技术 | 2篇 |
出版年
2023年 | 1篇 |
2021年 | 1篇 |
2019年 | 5篇 |
2018年 | 2篇 |
2017年 | 1篇 |
2015年 | 1篇 |
2014年 | 4篇 |
2013年 | 9篇 |
2012年 | 7篇 |
2011年 | 12篇 |
2010年 | 3篇 |
2009年 | 11篇 |
2008年 | 15篇 |
2007年 | 13篇 |
2006年 | 4篇 |
2005年 | 8篇 |
2004年 | 9篇 |
2003年 | 14篇 |
2002年 | 1篇 |
2000年 | 2篇 |
1998年 | 1篇 |
1997年 | 2篇 |
1996年 | 2篇 |
1995年 | 1篇 |
1992年 | 1篇 |
排序方式: 共有130条查询结果,搜索用时 93 毫秒
1.
Flotation column is widely used as the separation equipment for fine mineral due to its high selectivity. However, this device may be unsuitable for the coarse particle flotation and has high handling ability. A two-stage flotation column with dimensions of 2 000 mm× 1 000 mm×4 000 mm was designed to enhance the column flotation process. The energy input was modified by adjusting the flow rate and the head of circulating pump. The flotation column was designed with low energy input in the first stage (speed flotation stage) to recover easy-to-float materials quickly, and high energy input in the second stage (recovery stage) to recover difficult-to-float minerals compulsorily. Contrast experiments on the throughput and coarse coal recovery of high ash coal from the Kailuan Mine were conducted using conventional single-stage flotation column and the two-stage flotation column. The results show that the combustible matter recovery of the two-stage flotation column is 5.25% higher than that of the conventional single-stage flotation column. However, the ash contents of clean coal for both columns are similar. Less coarse coals with low ash are obtained using the two-stage flotation column than that using the single-stage column flotation with the same handling ability. The two-stage flotation column process can enhance coal flotation compared with the conventional single-stage column flotation. 相似文献
2.
3.
4.
5.
6.
7.
8.
分别采用LiF和2,9-二甲基-4,7-二苯基-1,10-菲咯啉(BCP)作为聚3-己基噻吩(P3HT)/[6,6]-苯基-C61-丁酸甲脂(PCBM)体系聚合物光伏电池阴极界面层,研究了高温后退火处理对不同界面层器件性能的影响。研究发现,LiF界面层的引入,在活性层和阴极界面之间形成了较强的偶极作用,从而改善了电池的性能,进一步高温热退火处理后仍能保持良好的界面作用,使器件的能量转换效率得到了进一步的提高。然而BCP界面层的引入,虽然阻挡了金属电极Al到PCBM的电子转移,导致复合减小,提高了器件的开路电压,但是在进一步高温后退火之后,BCP界面层的完整性遭到破坏,因此使得器件的能量转换效率降低。 相似文献
9.
通过难沉降煤泥水絮凝试验及相关分析,其结果表明,絮体分形维数与上清液浊度和浑液面平均沉速均显著相关,因此可作为反映絮凝沉降效果的指标。试验研究了K+、Na+、Ca2+三种离子对絮体分形维数和絮凝效果的影响,结果表明:3种离子对分形维数的影响趋势均为随离子浓度增加,分形维数先增加后降低,3种离子对应絮体的最大分形维数分别为2.01、1.94和2.41。在此基础上,利用氯化钙作凝聚剂,考察了单独使用长链絮凝剂、凝聚剂配合长链絮凝剂、凝聚剂与短链絮凝剂配合长链絮凝剂3种药剂制度对煤泥水絮体分形维数和絮凝效果的影响,结果表明:3种药剂制度的最大分形维数分别为2.18、2.41和2.63,3种药剂配合使用的絮凝效果最优。 相似文献
10.