基于信号增强的缓慢泄漏检测方法

目前管道泄漏检测方法可有效检测突发泄漏，对于缓慢泄漏则存在检测灵敏度低、定位不准确等问题。基于此，提出了一种基于信号增强的缓慢泄漏检测方法。通过信号压缩（抽取及移位）克服缓慢泄漏压力信号下降平缓的缺点；根据声波信号具有波形尖锐突出、对突发泄漏敏感的优点，通过建立以压力为输入、虚拟声波为输出的声波信号变送器模型，将压力信号转换为声波信号，克服了泄漏压力信号容易被淹没在管道压力波动及背景噪声中的缺点，实现了缓慢泄漏信号的增强；利用临近插值方法重构虚拟声波信号，基于延时互相关分析实现了缓慢泄漏的准确定位。实验结果表明，该方法具有显著的信号增强效果和定位精度，实现了缓慢泄漏的准确检测。     

Flame characteristics of premixed H2-air mixtures explosion venting in a spherical container through a duct

The explosion venting duct can effectively reduce the hazard degree of a gas explosion and conduct the venting energy to the safe area. To investigate the flame quantitative propagation law of explosion venting with a duct, the effects of hydrogen fraction and explosion venting duct length on jet flame propagation characteristics of premixed H₂-air mixtures were analyzed through experiment and simulation. The experiment results under initial conditions of room temperature and 1 atm show that when hydrogen fraction was high enough, part of the unburned hydrogen was mixed with air again to reach an ignitable concentration, resulting in the secondary combustion was easier produced and the duration of the secondary flame increased. With the increase of venting duct length, the flame front distance and propagation velocity increased. Meanwhile, the spatial distribution of pressure field and temperature field, and the propagation process and mechanism of the flame venting with a duct were analyzed using FLUENT software. The variation of the pressure wave and the pressure reflection oscillation law in the explosion venting duct was captured. Therefore, in the industrial explosion venting design with a duct, the hazard caused by the coupling of venting pressure and venting flame under different fractions should be considered comprehensively.     

几种酚类抗氧剂在润滑油中的应用

采用旋转氧弹法、高压差示扫描量热法等方法研究了5种酚类抗氧剂对6种润滑油基础油氧化安定性的改善效果。结果表明:向加氢基础油中加入0.25%(质量分数)抗氧剂2246-S和RHY510(含硫酚类抗氧剂),可使HVIWH125,HVIWH150,HVIWH500,KN4006,KN40105种润滑油基础油的诱导期由27～88min提高到226～397min;使HVIWH125,HVIWH150,HVIWH300,HVIWH500,KN4006,KN40106种润滑油基础油的起始氧化温度由193.34～198.90℃提高到205.48～230.27℃。     

含氮化合物对NiW体系催化剂芳烃加氢性能的影响

以γ-Al2O3、B改性的γ-Al2O3、F改性的γ-Al2O3、SiO2-Al2O3为载体制备Ni、W含量相同的四种催化剂，通过程序升温还原表征考察活性金属与不同载体的相互作用。利用氮含量不同、四氢萘含量相同的四种原料考察含氮化合物对同种NiW体系催化剂四氢萘加氢的影响以及对活性金属与载体相互作用不同的催化剂四氢萘加氢的影响。结果表明，以γ-Al2O3或SiO2-Al2O3载体制备的催化剂的金属组分与载体相互作用较强，B或F改性的γ-Al2O3能显著削弱活性金属与载体的相互作用；含氮化合物对四氢萘加氢具有强烈的抑制作用，使四氢萘加氢反应的表观活化能增加；在实验研究的四种催化剂中，金属组分与载体相互作用较弱的催化剂受含氮化合物的抑制较强。     

金属换热器选用经济分析

本文以系统节能和提高综合经济效益的观点，分析了金属换热器传热系数的影响因素及提高途径；气流阻力与动力消耗；传热面积与投资的定量关系。为正确选用不同结构金属换热器及其性能提供了依据。     

丙烷脱沥青装置掺炼RFCC油浆对沥青质量的影响

介绍了前郭炼油厂丙烷脱沥青装置掺炼ＦＲＣＣ油浆的情况，分析了原料组成的改变对抽提效率的影响：引起沥青组成的变化，提高了沥青延伸度和抗氧化性能     

工业锅炉群集散控制系统

介绍了XMC-3000工业热水锅炉群集散控制系统的硬件组成及特点,描述了锅炉燃烧系统、定压系统的控制方案和系统供热调节模型,最后给出了系统的主要功能。     

Electrical characteristics of the ITO/HgInTe photodiodes

Photodiodes designed to be sensitive in the region 0.5–1.7 μm and obtained by vacuum magnetron sputtering of the ITO (SnO₂ + In₂O₃) layer on the surface of the Hg₃In₂Te₆ single crystal are studied. The electrical characteristics, measured at 265–333 K, indicate that the mechanism of charge transport in the diodes under study is thermionic. The current-voltage characteristic and its temperature variations are described quantitatively based on the energy diagram and the found parameters of the heterojunction. Original Russian Text ? L.A. Kosyachenko, I.M. Rarenko, E.F. Sklyarchuk, I.I. German, Sun Weiguo, 2006, published in Fizika i Tekhnika Poluprovodnikov, 2006, Vol. 40, No. 5, pp. 568–571.     

Equivalent Conditions for Convergence of Splittings of Non-Hermitian Indefinite Matrices

We present some sufficient and necessary conditions for convergent splitting of a non-Hermitian indefinite matrix. Some sufficient conditions to determinate a matrix with a (strongly) dominant symmetric part for a class of boundary value problem are also obtained. These results are applicable to identify the convergence of iterative methods for solving large sparse systems of linear equations.     

流延法制作AlN陶瓷基片工艺

研究出一种用流延法制作ＡＩＮ陶瓷基片的工艺。制备出性能优良的ＡＩＮ基片。经１６５０℃，保温２ｈ无压烧结制得的基片，其热导率达１３０Ｗ／（ｍ·Ｋ）、密度为３．３４ｇ／ｃｍ￣３，表面光滑平整，瓷体结构均匀，性能达到用干压法制备的同类基片的性能。