Surface integrity characterization of manufactured component is very important as it significantly affects the in-service performance of the component. Till now, surface integrity was evaluated using conventional measurement technique like microhardness tester, X-ray diffraction, optical microscopy and surface roughness tester. But, this technique being laboratory based cannot be used for in-service monitoring of the surface integrity. The present study focuses on the characterization of surface integrity upon electric discharge machined sample using non-destructive magnetic Barkhausen noise technique. Electric discharge machining was performed in die-sinking mode on die steel using copper–tungsten electrode (negative polarity). Experiment was performed by selecting different levels of peak current, gap voltage and pulse on time. Surface integrity characteristics like microhardness change, residual stress, microstructural alteration and surface roughness were analysed using microhardness tester, X-ray diffraction, optical microscopy and surface roughness tester, respectively, and were then correlated with magnetic parameter like root mean square value and peak value obtained from Barkhausen noise signal. The results show a good correlation between magnetic parameter (RMS and Peak value) of Barkhausen noise with the microhardness and surface roughness of the machined sample.
Semiconductors - In the present paper, analytical modeling of surface potential and drain current for hetero-dielectric double gate tunnel FET (HDG-TFET) has been done. The two dimensional (2D)... 相似文献
Journal of Mechanical Science and Technology - An experimental study is performed to explore the effect of swirl and number of swirler vanes on combustion characteristics of methane inverse... 相似文献
Polymer Bulletin - Jute and glass composites of epoxy resin of (2E, 6E)-bis(4-hydroxybenzylidene)cyclohexanone (EBHBC) were prepared by compressing molding technique using three different hardeners... 相似文献
The present study was aimed to utilize low‐cost alumina (Al2O3) nanoparticles for improving the heat transfer behavior in an intercooler of two‐stage air compressor. Experimental investigation was carried out with three different volume concentrations of 0.5%, 0.75%, and 1.0% Al2O3/water nanofluids to assess the performance of the intercooler, that is, counterflow heat exchanger at different loads. Thermal properties such as thermal conductivity and overall heat transfer coefficient of nanofluid increased substantially with increasing concentration of Al2O3 nanoparticles. Specific heat capacity of nanofluids were lower than base water. The intercooler performance parameters such as effectiveness and efficiency improved appreciably with the employment of nanofluid. The efficiency increased by about 6.1% with maximum concentration of nanofluid, that is, 1% at 3‐bar compressor load. It is concluded from the study that high concentration of Al2O3 nanoparticles dispersion in water would offer better heat transfer performance of the intercooler. 相似文献
The Psychiatric Assessment Schedule for Adults with Developmental Disability (PAS-ADD) is a semi-structured interview for use with respondents who have learning disability and for key informants. This report investigates the ability of the instrument to detect symptoms that had been found to exist during routine clinical assessment of the patients. Field trials involved 95 referred patients with learning disability and a key informant for each sample member. Clinical opinions of the referring psychiatrists were sought using a symptom checklist. Referrer checklist symptoms and PAS-ADD data were both factor analysed. Validity testing involved (a) computation of correlations between PAS-ADD factors and checklist data and (b) comparison of PAS-ADD and referrers' diagnoses. Results indicated good validity for the PAS-ADD in relation to psychotic symptoms and depressive symptoms. Anxiety symptom identification was not well validated, probably due to small numbers. Expansive mood identified by the referrers was not detected by the PAS-ADD because there is currently no corresponding section in the interview. Where the PAS-ADD produced a diagnosis (in 58 members of the sample), 44 were in agreement with the referrer. Probability of diagnosis by PAS-ADD increased with the number of relevant active symptoms identified by the referrer. The PAS-ADD has been shown in a previous report to have the sensitivity to detect mental disorders not known to psychiatric services. For psychotic and depressive conditions, our results showed that symptom detection was in good agreement with the information provided by the referring psychiatrists on their patients. The PAS-ADD needs a section on hypomania and further investigation of its detection of anxiety disorders. 相似文献
In this paper, the application of high control authority piezostack actuators (PSAs) for active vibration control of large-scale flexible structures is studied. The idea is to add PSAs at appropriate locations of a flexible structure in order to strengthen its stiffness characteristics. In this regard, a flexible link of a macro-micro manipulator system actuated with PSAs is considered. The design of a mechanism for converting the force produced by a PSA to a bending moment is presented and a model for a system consisting of a flexible beam and a PSA is obtained. To this end, the solution of the governing partial differential equation with nonhomogeneous boundary conditions is obtained. Using singular value decomposition of the controllability Grammian of the system, optimum values for actuator parameters are obtained. The experimental results confirm that the suggested method can open up new possibilities in active vibration control of large-scale structures that require a large amount of control authority. 相似文献