介绍两种画中画插入播出器

介绍画中画插入播出器的工作原理及设计思想，并给出了实际的电原理图。     

Chebyshev multilevel absorber design concept

Pyramidal- and wedge-absorber materials are used extensively in anechoic measurement chambers to attenuate stray signals. Typical absorber layouts result in large absorber walls in which the absorber tips and bases are roughly aligned in the same plane. Such a quasi-periodic configuration produces a strong coherent specular reflection which dominates the absorber scattered field. Based on the multisection impedance transformer concept, one can divide absorber elements into different levels (layers) so that this coherence can be destroyed to reduce the specular absorber scattering level. The synthesis of this desired behavior can be implemented by the Chebyshev transformer technique, which provides the largest bandwidth given a passband ripple threshold. The resulting reflected field is then the product of the original absorber response times the Chebyshev reduction factor, which is independent of polarization and absorber properties. Various measured results are used to show that more than a 10-dB improvement can be achieved at the critical low end of the frequency band using this approach. This improvement cannot be achieved using conventional design concepts unless the absorber size is doubled     

大庆油田水平井分流压裂技术

水平井分流压裂的技术原理是将水平井的水平段分成若干个单元，在每个单元的最佳部位进行射孔，每段的射孔数由孔径、单元数、设计施工排量等参数决定，射孔方案为压裂方案的有机组成部分。大庆油田已有5口水平井实施分流压裂，根据油层厚度分为两类：裂缝限制在油层内和裂缝穿透隔层贯穿多个薄油层。通过肇57-平35井和肇57-平33井进行的分流压裂贯穿多个油层现场试验，介绍了大庆油田水平井分流压裂的设计方法、压裂液体系、现场施工控制方法和效果分析方法。微地震裂缝监测结果表明，在最大施工排量7．5m^3／mim条件下，一次施工形成3～4条裂缝，加砂量最大达到75m^3（陶粒），平均砂比达到35％以上。水平井采用分流压裂技术施工后，初期产能可达到相邻直井压裂后产能的2．0倍以上。如何检测裂缝是否穿透了隔层并贯穿多个油层，是指导水平井分流压裂技术的选井选层，提高压裂效果的关键技术。图8表2参2。     

Location management of correlated mobile users in the UMTS

In this paper, we propose concurrently searching for correlated mobile users in mobile communications networks. Previous work either focuses on locating a single mobile user or assumes that the locations of mobile users are statistically independent. We first propose a mobility model in which the movements of mobile users are statistically correlated. Next, we use the theory of Markov chain to derive the joint probability density function of the locations of mobile users. In addition, we propose a novel approach to discover the correlations among the locations of mobile users without explicitly calculating the joint probability density function. Our simulation results indicate that exploring the correlations among the locations of mobile users could significantly reduce the average paging delay and increase the maximum stable throughput.     

Sleep problems of junior high school students in Taipei

The objective of this work was to study the relationship between daily sleep time and characteristics of students, e.g. grade level, gender, and academic program. A sleep habit questionnaire was designed to survey students at two junior high schools, one from northern Taipei and the other from southern Taipei. The impact of shortened duration of sleep on daily function was also evaluated. A total of 965 students and their parents were selected randomly in December 1993 for the questionnaire study. The response rate was 96.4% (930) for students and 88.6% (855) for parents. The self-reported daily sleep time of students declined, and daytime sleepiness and moodiness increased in the higher grades. The girls slept fewer hours than the boys and did not show an increase in daytime sleepiness. Those students not taking the senior high school joint entrance examination slept more hours at night and maintained more alertness in the daytime than those who were taking the examination. The more academic pressures that adolescents faced, the fewer hours they slept. Students not participating in the joint entrance examination seemed to show a healthier sleep pattern. Little sleep at night made the students feel sleepy in the daytime and tired, drowsy, moody and difficult at arising in the morning. The reason why girls slept less than boys needs further investigation.     

Electron transport in direct methanol fuel cells

A three-dimensional (3D), two-phase, isothermal model of direct methanol fuel cells (DMFCs) was employed to investigate effects of electron transport through the backing layer and the land in bipolar plates. It was found that the electronic resistance of the backing layer, affected by backing layer electronic conductivity, backing layer thickness and flow channel width, played a relatively important role in determining the current density distribution and cell performance. In order to ignore the electron transport effect on the average current density, the minimum electronic conductivity of the backing layer has to be 1000 S m⁻¹, with the relative error in the average current density less than 5%, under the given conditions.     

Effects of poly(methyl methacrylate)‐based low‐profile additives on the properties of cured unsaturated polyester resins. II. Volume shrinkage characteristics and internal pigmentability

The effects of three series of self‐synthesized poly(methyl methacrylate) (PMMA)‐based low‐profile additives (LPAs), including PMMA, poly(methyl methacrylate‐co‐butyl acrylate), and poly(methyl methacrylate‐co‐butyl acrylate‐co‐maleic anhydride) with different chemical structures and MWs on the volume shrinkage characteristics and internal pigmentability for low‐shrink unsaturated polyester (UP) resins during curing were investigated by an integrated approach of static phase characteristics of the ternary styrene (ST)/UP/LPA system, reaction kinetics, cured‐sample morphology, microvoid formation, and property measurements. The relative volume fraction of microvoids generated during the cure was controlled by the stiffness of the UP resin used, the compatibility of the uncured ST/UP/LPA systems, and the glass‐transition temperature of the LPAs used. On the basis of the Takayanagi mechanical model, the LPA mechanism on volume shrinkage control, which accounted for phase separation and microvoid formation, and factors leading to both a good volume shrinkage control and acceptable internal pigmentability for the molded parts are discussed. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 91: 3388–3397, 2004     

Distributed topology control algorithm on broadcasting in wireless sensor network

Topology control can enhance energy efficiency and prolong network lifetime for wireless sensor networks. Several studies that attempted to solve the topology control problem focused only on topology construction or maintenance. This work designs a novel distributed and reliable energy-efficient topology control (RETC) algorithm for topology construction and maintenance in real application environments. Particularly, many intermittent links and accidents may result in packet loss. A reliable topology can ensure connectivity and energy efficiency, prolonging network lifetime. Thus, in the topology construction phase, a reliable topology is generated to increase network reachable probability. In the topology maintenance phase, this work applies a novel dynamic topology maintenance scheme to balance energy consumption using a multi-level energy threshold. This topology maintenance scheme can trigger the topology construction algorithm to build a new network topology with high reachable probability when needed. Experimental results demonstrate the superiority of the RETC algorithm in terms of average energy consumption and network lifetime.     

无双线性对双向认证密钥协商协议

为提高公钥密码体制下身份认证协议的性能,将杂凑函数结合到认证过程中,提出一种高性能的交互认证密钥协商协议.协议设计认证双方通过两次信息交换即可实现双向认证,显著降低通信代价.协议的运算复杂度与传统公钥密码体制下身份认证协议相当.通过针对已知攻击形式化推演的方法和数学推导证明了协议能抵御拒绝服务攻击、内部攻击在内的各种已知攻击.协议还设计了登录认证成功后的一次性对称会话密钥协商机制.     

Predictive multicast polling for wireless networks with multipacket reception and queuing

In this paper, we propose the predictive multicast polling scheme for medium access control in wireless networks with multipacket reception capability. We concentrate on the case in which the packet arrival process is general and the maximum queue size is finite but larger than one. We derive both analytical results and simulation results. We use the theory of discrete-time Markov chain to analyze the evolution of the system state. In addition, we propose to use Markov reward processes to calculate the exact value of the network throughput. Furthermore, we obtain the average system size, the packet blocking probability, and the average packet delay. We show that our numerical results are consistent with simulation results. We also use simulation results to justify the usage of the proposed approach. Our study shows that the system performance can be significantly improved with a few additional buffers in the queues.