Grafting onto polyester fibers. III. Electrokinetic properties of acrylic acid and acrylonitrile-grafted polyester fibers in the presence of cationic dyes

The electrokinetic properties such as zeta potential, surface charge density, and surface conductivity of polyester fibers grafted with acrylic acid and acrylonitrile were measured when cationic dye solutions were streamed through. The presence of the cationic dyes on the surface of the fibers and their specific adsorption at the carboxylic groups in the acrylic acid graft copolymer produce lowering of zeta potential. The decrease in surface charge density as the percent graft increases is due to the decrease in surface area of the fibers due to the adsorption of the cationic dyes. The same trend is observed with acrylonitrile-grafted fibers. The surface conductivity of the acrylonitrile-grafted polyester fibers increases with increase in dye concentration of the streaming solution. The results for the 27.4% grafted sample differed from those of the 7.32% and 12.1% grafts, which is indicative of the formation of a three-dimensional network causing change in both the physical structure as well as the chemical nature of the surface of the substrate.     

Volatilisation and catalytic effects of alkali and alkaline earth metallic species during the pyrolysis and gasification of Victorian brown coal. Part III. The importance of the interactions between volatiles and char at high temperature

A novel two-stage fluidised-bed/fixed-bed reactor was designed to investigate the effects of volatile-char interactions on the volatilisation of alkali and alkaline earth metallic (AAEM) species during the pyrolysis of Victorian brown coal at 900 °C. With the two-stage reactor configuration, the AAEM-free volatiles generated from the pyrolysis of the H-form coal in the fluidised bed came into direct contact with the char from NaCl-loaded or Na-form coals in the fixed bed. The results indicated that the interactions between the volatiles, especially free radicals in the volatiles, and the char particles enhanced the volatilisation of Na from the char drastically. However, such radical-char interactions resulted in little volatilisation of Mg and Ca, indicating the importance of valence of the AAEM species. The degree of the volatile-char interactions was also related to the ageing of the char and the chemical form of AAEM species in the coal substrate. The volatiles interacted more strongly with the nascent char than the aged char, indicating that the AAEM species existed in the aged char in more stable forms than in the nascent char.     

Atom-probe for FinFET dopant characterization

With the continuous shrinking of transistors and advent of new transistor architectures to keep in pace with Moore's law and ITRS goals, there is a rising interest in multigate 3D-devices like FinFETs where the channel is surrounded by gates on multiple surfaces. The performance of these devices depends on the dimensions and the spatial distribution of dopants in source/drain regions of the device. As a result there is a need for new metrology approach/technique to characterize quantitatively the dopant distribution in these devices with nanometer precision in 3D.In recent years, atom probe tomography (APT) has shown its ability to analyze semiconductor and thin insulator materials effectively with sub-nm resolution in 3D. In this paper we will discuss the methodology used to study FinFET-based structures using APT. Whereas challenges and solutions for sample preparation linked to the limited fin dimensions already have been reported before, we report here an approach to prepare fin structures for APT, which based on their processing history (trenches filled with Si) are in principle invisible in FIB and SEM. Hence alternative solutions in locating and positioning them on the APT-tip are presented. We also report on the use of the atom probe results on FinFETs to understand the role of different dopant implantation angles (10° and 45°) when attempting conformal doping of FinFETs and provide a quantitative comparison with alternative approaches such as 1D secondary ion mass spectrometry (SIMS) and theoretical model values.     

Conjugation of curcumin with PVP capped gold nanoparticles for improving bioavailability

Curcumin, a natural polyphenolic compound, has astounding therapeutic applications but lacks in bioavailability mainly due to its poor solubility in water. Polyvinyl pyrrolidone (PVP) which is a proven drug carrier has been used to facilitate the conjugation of curcumin with gold nanoparticles and to improve the solubility of curcumin in water. In this conjugate diaryl heptanoid chromophore group of curcumin which is a much needed group in biomedical applications remains intact as observed from FTIR and UV–vis spectroscopy analysis. The work shows good promise for such conjugates as therapeutic-cum-imaging materials in biomedical field.     

Syngas fermentation in a 100-L pilot scale fermentor: Design and process considerations

Fermentation of syngas offers several advantages compared to chemical catalysts such as higher specificity of biocatalysts, lower energy costs, and higher carbon efficiency. Scale-up of syngas fermentation from a bench scale to a pilot scale fermentor is a critical step leading to commercialization. The primary objective of this research was to install and commission a pilot scale fermentor, and subsequently scale-up the Clostridium strain P11 fermentation from a 7.5-L fermentor to a pilot scale 100-L fermentor. Initial preparation and fermentations were conducted in strictly anaerobic conditions. The fermentation system was maintained in a batch mode with continuous syngas supply. The effect of anaerobic fermentation in a pilot scale fermentor was evaluated. In addition, the impact of improving the syngas mass transfer coefficient on the utilization and product formation was studied. Results indicate a six fold improvement in ethanol concentration compared to serum bottle fermentation, and formation of other compounds such as isopropyl alcohol, acetic acid and butanol, which are of commercial importance.     

Observation of diameter dependent carrier distribution in nanowire-based transistors

The successful implementation of nanowire (NW) based field-effect transistors (FET) critically depends on quantitative information about the carrier distribution inside such devices. Therefore, we have developed a method based on high-vacuum scanning spreading resistance microscopy (HV-SSRM) which allows two-dimensional (2D) quantitative carrier profiling of fully integrated silicon NW-based tunnel-FETs (TFETs) with 2 nm spatial resolution. The key elements of our characterization procedure are optimized NW cleaving and polishing steps, the use of in-house fabricated ultra-sharp diamond tips, measurements in high vacuum and a dedicated quantification procedure accounting for the Schottky-like tip-sample contact affected by surface states. In the case of the implanted TFET source regions we find a strong NW diameter dependence of conformality, junction abruptness and gate overlap, quantitatively in agreement with process simulations. In contrast, the arsenic doped drain regions reveal an unexpected NW diameter dependent dopant deactivation. The observed lower drain doping for smaller diameters is reflected in the device characteristics by lower TFET off-currents, as measured experimentally and confirmed by device simulations.     

Volatilisation and catalytic effects of alkali and alkaline earth metallic species during the pyrolysis and gasification of Victorian brown coal. Part IV. Catalytic effects of NaCl and ion-exchangeable Na in coal on char reactivity

The purpose of this study is to investigate the catalytic effects of Na as NaCl or as sodium carboxylates (-COONa) in Victorian brown coal on the char reactivity. A Na-exchanged coal and a set of NaCl-loaded coal samples prepared from a Loy Yang brown coal were pyrolysed in a fluidised-bed/fixed-bed reactor and in a thermogravimetric analyser (TGA). The reactivities of the chars were measured in air at 400 °C using the TGA. The experimental data indicate that the Na in coal as NaCl and as sodium carboxylates (-COONa) had very different catalytic effects on the char reactivity. It is the chemical form and dispersion of Na in char, not in coal, that govern the catalytic effects of Na. For the Na-form (Na-exchanged) coal, the char reactivity increased with increasing pyrolysis temperature from 500 to 700 °C and then decreased with pyrolysis temperature from 700 to 900 °C. The increase in reactivity with pyrolysis temperature (500-700 °C) is mainly due to the changes in the relative distribution of Na in the char matrix and on the pore surface. For the NaCl-loaded coals, when Cl was released during pyrolysis or gasification, the Na originally present in coal as NaCl showed good catalytic effects for the char gasification. Otherwise, Cl would combine with Na in the char to form NaCl during gasification, preventing Na from becoming an active catalyst. Controlling the pyrolysis conditions to favour the release of Cl can be a promising way to transform NaCl in coal into an active catalyst for char gasification.     

Angiosarcoma at unusual sites. A report of two cases with aspiration cytology and diagnostic pitfalls

BACKGROUND: Angiosarcomas are uncommon soft tissue neoplasms with a predilection for skin and superficial soft tissues. CASES: Two cases of angiosarcoma occurred at unusual sites, the parotid gland and lung. The parotid lesion was characterized by malignant cells present singly, in loose groups, in tight three-dimensional aggregates and in acinar formation initially misinterpreted as an adenocarcinoma. The lung mass showed malignant cells in association with vascular endothelium, suggestive of angiosarcoma. Both cases were negative for Ulex europaeus and Factor VIII-related protein but demonstrated strong immunopositivity for CD31, a highly specific endothelial marker. CONCLUSION: In the absence of vasoformative structures, important diagnostic pitfalls are pseudovascular adenoid squamous cell carcinoma, poorly differentiated adenocarcinoma, melanoma and lymphoma. Immunocytochemical studies and clinical history are essential to the correct diagnosis.