Breakdown characteristics of oil and paper insulation for a very fast transient voltage

This paper describes the dielectric breakdown characteristics of oil and oil‐impregnated paper for very fast transient (VFT) voltages. Blumlein circuits generate VFT voltages of 60 and 300 ns in a pulse width that simulates disconnecting switching surges in gas‐insulated switch gears. We measured the breakdown voltages of needle‐to‐plane, plane‐to‐plane oil gaps and several pieces of paper between plane electrodes for VFT and lightning impulse voltages. The measured data were formulated in V‐t characteristics and Weibull probability distributions. The inclination n of V‐t characteristics of insulating paper is 150, which is less than n = 13.7 of the plane‐to‐plane oil gap in the VFT time range. The shape parameters of Weibull distribution obtained in this study show that the scattering of breakdown voltages of paper is much less than that of oil. © 2002 Wiley Periodicals, Inc. Electr Eng Jpn, 141(4): 16–24, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10043     

Effect of starting particle size on hot-pressing of magnesium oxide powder prepared by vapour-phase oxidation process

Effect of starting particle size on hot-pressing of magnesium oxide (MgO) powder was examined using seven kinds of MgO powders prepared by a vapour-phase oxidation process; the average primary particle sizes were 11, 25, 32, 44, 57, 107 and 261 nm. These compressed powders (compacts) were hot-pressed at a temperature between 900 and 1300°C. The densifications of these compacts during the hot-pressing proceeded via (i) the sintering of primary particles within secondary particles and the rearrangement of secondary particles/grains (900°C), (ii) the gradual grain growth controlled by the pore migration (900∼1100°C) and (iii) the rapid grain growth due to the active mass transfer (1300°C); the grain sizes of MgO compacts hot-pressed at and below 1100°C were <1 μm, while those at 1300°C attained 20∼30 μm. The transluscent compact with the relative density of 99.7% could be obtained when the compressed powder with the average primary particle size of 44 nm was hot-pressed at a temperature as low as 1100°C for 1 h. This revised version was published online in November 2006 with corrections to the Cover Date.     

Structure and surface properties of diaminocyclohexane plasma polymer films

Plasma polymers of three isomers of diaminocyclohexane (DACH) were deposited on polyethylene, SiO₂, and mica at 20°C. The deposition rate was measured as a function of plasma density and power; a maximum was observed in the latter function. The deposition rate was highest for the monomer with the highest flow rate. The film refractive index was observed to increase with both power density and the degree of fragmentation in the plasma. Film composition was measured by elementary analysis, and was found to be almost identical for each of the three isomers; a mechanism for the polymerization reaction is proposed. The percentage of primary amino groups decreased with increasing power density and with film thickness. Surface force measurements of the thickness and refractive index agreed well with the corresponding ellipsometry values in dry air, and am adhesive force, independent of power density, was measured. When the film was exposed to water vapor, it swelled considerably and the adhesion was determined by capillary forces. Associated with swelling, at high power, was an extremely regular 2-ply rope pattern of protruding material. © 1993 John Wiley & Sons. Inc.     

Practical method for generation expansion planning based on dynamic programming

This paper presents an efficient method which provides the optimal generation mix and the optimal generation construction process. The approximation method in which the dynamic programming technique and gradient method are combined is applied to determine the optimal generation mix with hydropower generation technologies. The successive approximations dynamic programming (SADP) technique, which is very suitable for high-dimensional multistage decision process problems, is used for obtaining the optimal generation construction process. The effectiveness and feasibility of the developed technique are demonstrated on a practical power system model which has five types of generation technologies including a hydropower generation technology.     

Differential activity of the G protein beta5 gamma2 subunit at receptors and effectors

The G protein beta5 subunit differs substantially in amino acid sequence from the other known beta subunits suggesting that beta gamma dimers containing this protein may play specialized roles in cell signaling. To examine the functional properties of the beta5 subunit, recombinant beta5 gamma2 dimers were purified from baculovirus-infected Sf9 insect cells using a strategy based on two affinity tags (hexahistidine and FLAG) engineered into the N terminus of the gamma2 subunit (gamma2HF). The function of the pure beta5 gamma2HF dimers was examined in three assays: activation of pure phospholipase C-beta in lipid vesicles; activation of recombinant, type II adenylyl cyclase expressed in Sf9 cell membranes; and coupling of alpha subunits to the endothelin B (ETB) and M1 muscarinic receptors. In each case, the efficacy of the beta5 gamma2HF dimer was compared with that of the beta1 gamma2HF dimer, which has demonstrated activity in these assays. The beta5 gamma2HF dimer activated phospholipase C-beta with a potency and efficacy similar to that of beta1 gamma2 or beta1 gamma2HF; however, it was markedly less effective than the beta1 gamma2HF or beta1 gamma2 dimer in its ability to activate type II adenylyl cyclase (EC50 of approximately 700 nM versus 25 nM). Both the beta5 gamma2HF and the beta1 gamma2HF dimers supported coupling of M1 muscarinic receptors to the Gq alpha subunit. The ETB receptor coupled effectively to both the Gi and Gq alpha subunits in the presence of the beta1 gamma2HF dimer. In contrast, the beta5 gamma2HF dimer only supported coupling of the Gq alpha subunits to the ETB receptor and did not support coupling of the Gi alpha subunit. These results suggest that the beta5 gamma2HF dimer binds selectively to Gq alpha subunits and does not activate the same set of effectors as dimers containing the beta1 subunit. Overall, the data support a specialized role for the beta5 subunit in cell signaling.     

A Fuzzy Expert System for Damage Assessment Using Genetic Algorithms and Neural Networks

Abstract: An efficient knowledge-acquisition support method is required for improvement and maintenance of the knowledge base in durability evaluation of an RC bridge deck. Such a method is proposed in this paper to automatically acquire fuzzy production rules. This method makes joint use of genetic algorithms and a neural network. Using a neural network as a subsystem, the evaluation function of genetic algorithms can be provided with the weights of the neural network. Introducing a neural network into genetic algorithms, it is possible to acquire new knowledge so that the method is useful when it is difficult to acquire knowledge in the field.     

Accumulation of amplified target DNAs using thiol/biotin labeling, S1 nuclease, and ferrocene-streptavidin-magnetic system and a direct detection of specific DNA signals with screen printed gold electrode

Combinations of PCR-based amplification platform using 5′ thiolated and biotinylated specific primers, S1 nuclease-PCR products treatment, ferrocene-streptavidin (Fc-Stv)-magnetic binding for DNA accumulation, and screen printed gold electrode for the DNA allocation, were applied to Hoechst 33258-induced DNA aggregation and signals induction system for direct signals detection and DNA quantification in food samples. Thiolated and biotinylated at each 5′ terminus enabled DNA purification through S1 nuclease treatment for primers and non-specific DNA elimination and enabled DNA trapping with a ferrocene-streptavidin-magnetic system. This facilitated the accumulation of target DNAs at higher concentration, resulting in enhanced signals. After allocation of DNA on the surface of gold electrode via thiol binding, intensity of DNA signals through these treatments could be measured directly after being induced by Hoechst 33258. Wider amplitude changes in anodic current peaks between negative and positive samples (increasing from 3.70 to 10.10 μA) compared with those applied with no treatment combinations (decreasing from 3.92 to 1.23 μA) were observed. This enhancement of the signals allowed a greater efficiency of DNA quantification. When this combination was used for GMOs content estimation in reference samples, results revealed an improved accuracy from 66% to 96%. The combined biosensor system, although more costly than the standard Hoechst 33258/carbon electrode system, provided an alternative choice for DNA quantification, offering labor-free immobilization of probe onto electrode surface, easy test administration, and efficient semi-quantitative test without expensive instruments.     

Yttria Doping and Sintering of Submicrometer-Grained α-Alumina

The sintering behavior of α-alumina powders doped with magnesia (500 or 1500 ppm) and yttria (0, 500, or 1500 ppm) was investigated using constant-heating-rate dilato-metric experiments. The apparent activation energies for the intermediate stage of sintering were 740, 800, and 870 kJ/mol for 0, 500, and 1500 ppm yttria doping levels, respectively; these were independent of magnesia doping. Yttria-doped powder compacts exhibited systematic anomalous second peaks in the densification rate curves at certain grain sizes which were determined only by yttria doping levels. Before the anomalous peak, with lower yttrium contents at grain boundaries, yttrium in an atomic state delays densification and raises the apparent activation energy. Beyond the peak, with higher yttrium contents at grain boundaries, yttria-rich precipitation delays the densification. Within the peak, yttrium segregation near the saturation level enhances densification.     

Protein modification by a Maillard reaction intermediate methylglyoxal. Immunochemical detection of fluorescent 5-methylimidazolone derivatives in vivo

Methylglyoxal (MG), an endogenous metabolite that increases in diabetes, is a common intermediate in nonenzymatic glycation (Maillard reaction) in vivo. Here we describe the immunochemical approach to the detection of MG adducts in proteins in vitro and in atherosclerotic lesions of human aorta in vivo. The reaction of protein (bovine serum albumin) with MG led to selective loss of arginine and lysine residues, accompanied by the formation of 5-methylimidazolone (N delta-(5-methylimidazolon-2-yl)ornithine) and imidazolysine (1,3-di-lysino-4-methylimidazole) derivatives, respectively. The anti-5-methylimidazolone antibody was prepared by immunizing rabbits with a MG-keyhole limpet hemocyanin conjugate and purifying the serum on an affinity gel prepared by covalent attachment of the 5-methylimidazolone derivative. The antibody cross-reacted with the proteins treated with not only MG but trioses, such as hydroxyacetone, dihydroxyacetone, and glyceraldehyde. The immunohistochemical analysis revealed that atherosclerotic lesions of human aorta contained 5-methylimidazolone derivatives whose distributions were identical to those of advanced glycation end products (AGEs) detected by the anti-AGE antibody.