Study of the synergistic effect of boron nitride and carbon nanotubes in the improvement of thermal conductivity of epoxy composites

The enhancement of the thermal conductivity, keeping the electrical insulation, of epoxy thermosets through the addition of pristine and oxidized carbon nanotubes (CNTs) and microplatelets of boron nitride (BN) was studied. Two different epoxy resins were selected: a cycloaliphatic (ECC) epoxy resin and a glycidylic (DGEBA) epoxy resin. The characteristics of the composites prepared were evaluated and compared in terms of thermal, thermomechanical, rheological and electrical properties. Two different dispersion methods were used in the addition of pristine and oxidized CNTs depending on the type of epoxy resin used. Slight changes in the kinetics of the curing reaction were observed in the presence of the fillers. The addition of pristine CNTs led to a greater enhancement of the mechanical properties of the ECC composite whereas the oxidized CNTs presented a greater effect in the DGEBA matrix. The addition of CNTs alone led to a marked decrease of the electrical resistivity of the composites. Nevertheless, in the presence of BN, which is an electrically insulating material, it was possible to increase the proportion of pristine CNTs to 0.25 wt% in the formulation without deterioration of the electrical resistivity. A small but significant synergic effect was determined when both fillers were added together. Improvements of about 750% and 400% in thermal conductivity were obtained in comparison to the neat epoxy matrix for the ECC and DGEBA composites, respectively. © 2019 Society of Chemical Industry     

Evaluation of Atmospheric and Vacuum Residues Using Molecular Distillation and Optimization

The term atmospheric residue describes the material at the bottom of the atmospheric distillation tower having a lower boiling point limit of about 340°C; the term vacuum residue (heavy petroleum fractions) refers to the bottom of the vacuum distillation, which has an atmospheric equivalent boiling point (AEBP) above 540°C. In this work, the objective is to evaluate the behavior of different kinds of Brazilian atmospheric and vacuum residues using molecular distillation. The Falling Film Molecular Distillator was used. For the results obtained through this process, a significant range of temperature can be explored avoiding the thermal decomposition of the material. So these results are very important to the refinery decisions and improvements. The Experimental Factorial Design results showed that the temperature has more influence on the process than the feed flow rate, when a higher percentage of distillate is required.     

Retrograde Amnesia Induced by Drugs Acting on Different Molecular Systems.

The gamma aminobutyric acid-A (GABAA) agonist, muscimol, the glutamate N-methyl-D-aspartate (NMDA) receptor antagonist, D-2-amino-5-phosphonopentanoic acid (AP5), and the inhibitor of the extracellularly regulated kinases (ERKs), UO 126, cause retrograde amnesia when administered to the hippocampus. In the present study, the authors found that they all cause retrograde amnesia for 1-trial inhibitory avoidance, not only when infused into the dorsal CA1 region of the hippocampus, but also when infused into the basolateral amygdala or the entorhinal, parietal, and posterior cingulate cortices. The posttraining time course of the effect of each drug was, however, quite different across brain structures. Thus, in all of them, NMDA receptors and the ERK pathway are indispensable for memory consolidation, and GABAA receptor activation inhibits memory consolidation: but in each case, their influence is interwoven differently. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Quasi-analytical static solution for the generalized boxed coplanar waveguide

A quasi-analytical method for computing the quasi-static-TEM parameters of the generalized coplanar waveguide (GCPW) is reported. The structure is assumed to be enclosed in a rectangular frame and embedded in a layered medium. Essentially, the method is an analytically enhanced spectral domain formulation. Its application leads to virtually exact results in very short CPU times, making it suitable for CAD purposes. Although the method is somewhat more time consuming than conformal mapping approaches, it is a useful alternative because of its exactness and ability to deal with multilayer structures. © 1994 John Wiley & Sons, Inc.     

Capture of Airborne Particulate Using Surface Applied Emulsions: Potential for Postdetonation Dirty Bomb Cleanup

Recent research has proposed the use of asphalt and tall-oil-pitch emulsions for stabilizing radioactive contamination deposited on surfaces in urban areas. The objective of this project was to investigate whether surface applied emulsions could capture airborne radioactive particulate. Laboratory experiments included wind-blown particulate capture studies using an acrylic column and particulate retainment experiments using a wind box capable of producing wind speeds of 96?km/h. A probe methodology was developed to relate particulate retainment to a tack force on the emulsion surface. Experiments were also performed to determine the potential for such emulsions to absorb particulate matter into their emulsion matrix. Tall-oil-pitch emulsions outperformed asphalt emulsions in terms of particulate retention, tack force, and the ability to absorb magnesium silicate. Both tall-oil-pitch and asphalt emulsions were capable of extracting 22–24?g?m?2 of powder from particulate-laden airflow. Tall-oil-pitch emulsions were capable of retaining as much as 5–10% of magnesium silicate powder applied (i.e., retainment densities of 10–20?g?m?2) even after seven?days of curing and after applying 96.5?km/h (60?mph) wind. Tall-oil-pitch emulsions were able to absorb surface-applied magnesium silicate (approximately 0.1–0.2?g of magnesium silicate per 1.0?g of emulsion within three?days) into their emulsion matrix, preventing the magnesium silicate from being exposed to the external environment. Initial results with these five different emulsion formulations suggested particulate capture was feasible. Future emulsion formulations (i.e., longer curing times with greater acid concentrations) should be tested to optimize this postdetonation response strategy.     

Late complication of laparoscopic salpingoophorectomy: retained foreign body presenting as an acute abdomen

The technique of immunocytochemistry was used to identify myoglobin in kidney, confirming a diagnosis of neuroleptic malignant syndrome following an otherwise obscure autopsy in a decomposed body. The features of neuroleptic malignant syndrome are reviewed with a differential diagnosis of myoglobin renal casts. The report emphasizes a thorough and detailed assessment of deaths which occur during treatment with neuroleptic drugs.     

Arthroscopic lysis in knee arthrofibrosis

OBJECTIVE: To compare the efficacy and toxicity of three patient-controlled analgesia (PCA) morphine regimens. DESIGN: A prospective, randomized, pilot study of three PCA morphine regimens: (1) 1 mg with 6-minute lockout (n = 10), (2) 2 mg with 12-minute lockout (n = 12), and (3) 2 mg with 20-minute lockout (n = 12). SETTING: Large teaching institution. PARTICIPANTS: Thirty-four patients undergoing cholecystectomy or hysterectomy. MAIN OUTCOME MEASURES: Pain scores (0 = no pain, 1 = mild pain, 2 = moderate pain, 3 = severe pain), sedation scores, analgesic consumption, and patient attempts (patient activation of PCA device) and injections (doses actually delivered) were evaluated using analysis of covariance. Distribution of pain and sedation scores and adverse effects were assessed using Fisher's exact test. RESULTS: Data on 24 patients were evaluable. Six patients withdrew for poor pain control (2 in group 1, 1 in group 2, and 3 in group 3). Three other patients withdrew because of adverse effects and 1 withdrew because of pump problems. Mean morphine consumption did not differ significantly among the groups. Distribution of pain and sedation scores and the number of patients with nausea were similar across treatment groups. The mean injection to attempt ratio was significantly smaller in group 3 (0.71 +/- 0.11) compared with groups 1 and 2 (0.9 +/- 0.06 and 0.83 +/- 0.09, respectively; p = 0.001). Adverse events occurred similarly among treatment groups. CONCLUSIONS: No significant differences in the efficacy or toxicity of the three morphine PCA regimens were identified.     

In-laboratory removal of femoral sheath following protamine administration in patients having intracoronary stent implantation

Two hundred twenty-eight patients with successful coronary stent implantation were randomized either to protamine administration and femoral sheath removal (group I, n = 117) or no heparin neutralization and delayed sheath removal (group II, n = 111). The hospital stay after treatment was shorter in patients receiving protamine; therefore, protamine use for neutralizing circulating heparin may be safely administered immediately after stent implantation.     

Natural convection from narrow horizontal plates at moderate Rayleigh numbers

The present work deals with the natural convection flow and heat transfer from a horizontal plate cooled from above. Experiments are carried out for rectangular plates having aspect ratios between φ=0.036 and 0.43 and Rayleigh numbers in the range 290?Ra_w?3.3×10⁵. These values of Ra_w and φ have been selected below those commonly considered in previous research in view of a future application to the design of printed circuit boards. The plates are made of two different metals, copper and steel. The choice of a metal is relevant to the present problem because the plates are heated by means of an electric current. Important variations of the surface temperature are observed along the transverse direction for the steel plates. The surface of the copper plates is almost isothermal because of the high thermal conductivity of the metal.Calculations for a semi-infinite plate are carried out to predict the transverse profiles of the surface temperature and heat flux and to visualize the structure of the flow. Three-dimensional calculations are also used at a qualitative level to observe the changes in the flow structure due to the finite length of the plate. Present results are compared with both previous experimental work and analyses that are based on boundary layer theory. It is shown that analyses for an infinite boundary layer are not completely applicable to the present problem because of its different physics. The most relevant feature of the natural convection flow, which is not predicted by boundary layer analyses, is a thermal plume rising near the center of the plate.Present heat transfer results differ from previous experimental work because of the lower Rayleigh numbers and aspect ratios investigated here. The Nusselt number is found to depend on Ra_wⁿ, with the exponent n=0.17 being lower than most of the values reported in the literature. This comparatively low value is related to the transverse conduction of heat through the air, which becomes increasingly significant as Ra_w approaches zero. It is shown that such a low-Ra_w effect can be accounted for in a physically consistent manner by adding a constant term to the heat transfer correlation. On the other hand, it is found that the Nusselt number does not significantly depend on the aspect ratio in the range of φ investigated contrary to what has been previously reported for wider plates.