Broad-band MMICs based on modified loss-compensation method using 0.35-/spl mu/m SiGe BiCMOS technology

Using the concept of loss compensation, novel broad-band monolithic microwave integrated circuits (MMICs), including an amplifier and an analog multiplier/mixer, with LC ladder matching networks in a commercial 0.35-mum SiGe BiCMOS technology are demonstrated for the first time. An HBT two-stage cascade single-stage distributed amplifier (2-CSSDA) using the modified loss-compensation technique is presented. It demonstrates a small-signal gain of better than 15 dB from dc to 28 GHz (gain-bandwidth product=157 GHz) with a low power consumption of 48 mW and a miniature chip size of 0.63 mm² including testing pads. The gain-bandwidth product of the modified loss-compensated CSSDA is improved approximately 68% compared with the conventional attenuation-compensation technique. The wide-band amplifier achieves a high gain-bandwidth product with the lowest power consumption and smallest chip size. The broad-band mixer designed using a Gilbert cell with the modified loss-compensation technique achieves a measured power conversion gain of 19 dB with a 3-dB bandwidth from 0.1 to 23 GHz, which is the highest gain-bandwidth product of operation among previously reported MMIC mixers. As an analog multiplier, the measured sensitivity is better than 3000 V/W from 0.1 to 25 GHz, and the measured low-frequency noise floor and corner frequency can be estimated to be 20 nV/sqrt(Hz) and 1.2 kHz, respectively. The mixer performance represents state-of-the-art result of the MMIC broad-band mixers using commercial silicon-based technologies     

Still No Evidence for Perfect Timesharing With Two Ideomotor-Compatible Tasks: A Reply to Greenwald (2003).

For 30 years, A. G. Greenwald and H. G. Shulman's (1973) psychological refractory period (PRP) study has been cited as evidence for perfect timesharing with ideomotor (IM)-compatible tasks. Recently, M.-C. Lien, R. W. Proctor, and P. A. Allen (2002) failed to replicate these results and concluded that IM compatibility is neither necessary nor sufficient to eliminate the PRP effect. A. G. Greenwald (2003) attributed Lien et al.'s nonreplication to the use of (a) a non-IM-compatible task, (b) varied trial spacing, and/or (c) inappropriate instructions. The authors of the present article argue that the first 2 factors are not critical and that instructions merely affect the criterion for speed versus accuracy. In each of Greenwald's experiments, dual-task costs were evident on response time or error rates. Furthermore, the small dual-task costs in his study are consistent with a bottleneck model. Thus, Greenwald (2003) does not provide evidence that IM-compatible tasks enable perfect timesharing. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Effects of free convection and mass transfer on the flow past an impulsively moving infinite vertical circular cylinder

The effects of free convection and mass transfer are taken into account for the Stokes' problem of the flow near an impulsively moving infinite vertical circular cylinder. Expressions of the velocity, temperature, concentration and skin friction of the fluid in closed form are obtained by the Laplace transform technique. The results based on various values of the parameters Gr (Grashof number), Gm (modified Grashof number), Sc (Schmidt number) and Pr (Prandtl number) are given in graphical form. It will be seen that there is a rise in the velocity due to the presence of a foreign mass. But higher Sc yields the lower velocity and skin friction. As the radius of the circular cylinder approaches to infinite, the results presented in this paper agree with those of V.M. Soundalgekar's and C.K. Chen's etc. for the flow past an impulsively moving infinite vertical plate.     

Tunneling injection quantum-dot lasers with polarization-dependent photon-mediated carrier redistribution and gain narrowing

A theoretical and experimental study of a particular transverse-electric (TE) mode lasing mechanism of a tunneling injection InP quantum-dot (QD) laser is reported. In the experiment, the TE mode lasing action takes place at the first excited state of InP biaxially compressively strained QDs. This QD state is coupled to the ground state of two tensile-strained InGaP quantum wells (QWs) although the tensile-strained QW structure favors the transverse-magnetic (TM) polarization light emission. The measured TE and TM modal gain spectra show a typical QW gain evolution behavior at low injection currents, which can be theoretically modeled by the quasi-equilibrium of carrier distribution. When the injection current is increased near threshold, a TE gain narrowing and a simultaneous TM gain pinning are observed in the measured modal gain spectra, which cannot be explained via the quasi-equilibrium model. We propose a polarization-dependent photon-mediated carrier redistribution in the QD-coupled-QW structure to explain this TE and TM gain evolution behavior. When the injection current is just below threshold, the strong carrier depletion via stimulated emission due to coupling between the InP QD and InGaP QW states plays an important role in carrier redistribution, which depends on the optical transition energy and polarization. This concept of the polarization-dependent photon-mediated carrier redistribution explains the TE gain narrowing and TM gain pinning behavior. In addition, a coupled rate equation model is established, and the calculated polarization power ratio based on the coupled rate equations explains the experimental observation.     

Relationship between dietary supply of long-chain fatty acids and membrane composition of long- and very long chain essential fatty acids in developing rat photoreceptors

The present study was designed to determine if dietary supply of long-chain fatty acid (LCFA, C20∶4n-6, and/or C22∶6n-3), reflecting levels that might be incorporated into infant formulas, influences the fatty acid composition of the visual cell membrane. The rod outer segment (ROS) of the retina was analyzed from rats fed diets varying in the ratio of 18∶2n-6 to 18∶3n-3 with or without 20∶4n-6 [arachidonic acid (AA)] and 22∶6n-3 (docosahexaenoic acid) from birth to six weeks of age. The level of very long chain fatty acids (VLCFA, C₂₄−C₃₆) was identified using gas chromatography and gas chromatography-mass spectrometry. In the ROS, the highest relative percent of AA was attained in phosphatidylcholine (PC) and phosphatidylethanolamine (PE) of animals fed 1% AA diet, whereas feeding 0.7% docosahexaenoic acid (DHA) diet significantly increased the DHA level in PC, phosphatidylserine, and phosphatidylinositol compared to feeding diets containing AA. VLCFA of n-6 and n-3 up to C₃₆ were found in PC, with the most abundant fatty acids being C₃₂ and C₃₄. In PC, phosphatidylserine and PE, the n-6 tetraenoic VLCFA level was highly increased in animals fed 1% AA compared to other dietary groups. This study suggests that dietary fat containing small amounts of AA or DHA is an important factor influencing membrane fatty acid composition of the visual cell during development. Based on a presentation at the AOCS Annual Meeting & Expo in San Antonio, Texas, May 7–11, 1995.     

Isothermal crystallization kinetics and melting behavior of nylon/saponite and nylon/montmorillonite nanocomposites

DSC thermal analysis and X‐ray diffraction have been used to investigate the isothermal crystallization behavior and crystalline structure of nylon 6/clay nanocomposites. Nylon 6/clay has prepared by the intercalation of ε‐caprolactam and then exfoliating the layered silicates by subsequent polymerization. The DSC isothermal results reveal that introducing saponite into the nylon structure causes strongly heterogeneous nucleation induced change of the crystal growth process from a two‐dimensional crystal growth to a three dimensional spherulitic growth. But the crystal growth mechanism of nylon/montmorillonite nanocomposites is a mixed two‐dimensional and three‐dimensional spherulitic growth. The activation energy drastically decreases with the presence of 2.5 wt % clay in nylon/clay nanocomposites and then slightly increases with increasing clay content. The result indicates that the addition of clay into nylon induces the heterogeneous nucleation (a lower ΔE) at lower clay content and then reduces the transportation ability of polymer chains during crystallization processes at higher clay content (a higher ΔE). The correlation among crystallization kinetics, melting behavior, and crystalline structure of nylon/clay nanocomposites is also discussed. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 94: 2196–2204, 2004     

Synthesis and characterization of a positive‐working,aqueous‐base‐developable photosensitive polyimide precursor

A positive‐working, aqueous‐base‐developable photosensitive polyimide precursor based on poly(amic ester)‐bearing phenolic hydroxyl groups and a diazonaphthoquinone photosensitive compound was developed. The poly(amic ester) was prepared from a direct polymerization of 2,2′‐bis‐(3‐amino‐4‐hydroxyphenyl)hexafluoropropane and bis(n‐butyl)ester of pyromellitic acid in the presence of phenylphosphonic dichloride as an activator. Subsequently, the thermal imidization of the poly(amic ester) precursor at 300°C produced the corresponding polyimide. The inherent viscosity of the precursor polymer was 0.23 dL/g. The cyclized polyimide showed a glass‐transition temperature at 356°C and a 5% weight loss at 474°C in nitrogen. The structures of the precursor polymer and the fully cyclized polymer were characterized by Fourier transform infrared spectroscopy and ¹H‐NMR. The photosensitive polyimide precursor containing 25 wt % diazonaphthoquinone photoactive compound showed a sensitivity of 150 mJ/cm² and a contrast of 1.65 in a 3 μm film with 1.25 wt % tetramethylammonium hydroxide developer. A pattern with a resolution of 10 μm was obtained from this composition. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 86: 352–358, 2002     

Extraction of genomic DNA and detection of single nucleotide polymorphism genotyping utilizing an integrated magnetic bead-based microfluidic platform

This study presents a new magnetic bead-based microfluidic platform, which integrates three major modules for rapid leukocytes purification, genomic DNA (gDNA) extraction and fast analysis of genetic gene. By utilizing microfluidic technologies and magnetic beads conjugated with CD_15/45 antibodies, leukocytes in a human whole blood sample can be first purified and concentrated, followed by extraction of gDNA utilizing surface-charge switchable, DNA-specific, magnetic beads in the lysis solution. Then, specific genes associated with genetic diseases can be amplified by an on-chip polymerase chain reaction (PCR) process automatically. The whole pretreatment process including the leukocytes purification and gDNA extraction can be performed in an automatic fashion with the incorporation of the built bio-separators consisting of microcoils array within less than 20 min. The detection of single nucleotide polymorphism (SNP) genotyping of methylenetetra-hydrofolate reductase (MTHFR) C677T region associated with an increased risk of genetic diseases was further performed to demonstrate the capability of the proposed system. The extracted gDNA can be transported into a micro PCR chamber for on-chip fast nucleic acid amplification of detection genes with minimum human intervention. Hence, the developed system may provide a powerful automated platform for pretreatment of human leukocytes, gDNA extraction and fast analysis of genetic gene.     

High-capacity reversible data hiding by maximum-span pairing

In this paper, we propose a reversible data hiding method for ordered dithered halftone images. To achieve reversibility and high capacity, the proposed method decomposes an ordered dithered halftone into a maximal number of subimage pairs with the same characteristic, and then hides data with a subimage-swapping operation, which converts a subimage pair into a subimage pair with opposite characteristic. Besides, this method maintains good visual quality by exchanging neighboring pixels instead of flipping individual pixels. Experimental results show that this method has the highest capacity among the existing reversible data hiding methods. A reversible authentication watermarking system is also proposed using this reversible watermarking method and it shows better visual quality compared to an existing method.     

Numerical simulation of detonation using an adaptive Cartesian cut-cell method combined with a cell-merging technique

A second-order accurate scheme for the Cartesian cut-cell method developed previously by the authors [Ji H, Lien F-S, Yee E. Comput. Methods Appl. Mech. Eng. 198 (2008), 432] is generalized for application to both two- and three-dimensional inviscid compressible flow problems. A cell-merging approach is used to address the so-called “small cell” problem that has plagued Cartesian cut-cell methods. In the present cell-merging approach, the conservative variables are stored at the cut-cell centroid (including the non-merged and merged cut-cells) rather than at the Cartesian cell center. Although this approach results in a more complicated search algorithm for the determination of the neighbor cells (required for the computation of the spatial gradients of the conservative variables), this approach enables the straightforward formulation of a higher than first-order accurate discretization scheme in the vicinity of the (complex and irregular) internal boundaries of the flow domain. Six test cases (including detonation problems) are used to demonstrate the accuracy and capability of the adaptive cut-cell method, for which both mesh refinement and derefinement techniques are employed in the case of an unsteady shock diffraction problem.