全文获取类型
收费全文 | 670篇 |
免费 | 15篇 |
专业分类
电工技术 | 105篇 |
化学工业 | 171篇 |
金属工艺 | 12篇 |
机械仪表 | 17篇 |
建筑科学 | 9篇 |
矿业工程 | 2篇 |
能源动力 | 25篇 |
轻工业 | 80篇 |
石油天然气 | 2篇 |
无线电 | 46篇 |
一般工业技术 | 117篇 |
冶金工业 | 41篇 |
原子能技术 | 17篇 |
自动化技术 | 41篇 |
出版年
2023年 | 5篇 |
2022年 | 8篇 |
2021年 | 18篇 |
2020年 | 6篇 |
2019年 | 9篇 |
2018年 | 10篇 |
2017年 | 2篇 |
2016年 | 14篇 |
2015年 | 21篇 |
2014年 | 12篇 |
2013年 | 50篇 |
2012年 | 34篇 |
2011年 | 40篇 |
2010年 | 33篇 |
2009年 | 37篇 |
2008年 | 44篇 |
2007年 | 41篇 |
2006年 | 33篇 |
2005年 | 20篇 |
2004年 | 21篇 |
2003年 | 28篇 |
2002年 | 14篇 |
2001年 | 8篇 |
2000年 | 10篇 |
1999年 | 14篇 |
1998年 | 21篇 |
1997年 | 21篇 |
1996年 | 10篇 |
1995年 | 9篇 |
1994年 | 8篇 |
1993年 | 12篇 |
1992年 | 5篇 |
1991年 | 2篇 |
1990年 | 6篇 |
1989年 | 5篇 |
1988年 | 3篇 |
1987年 | 4篇 |
1986年 | 6篇 |
1985年 | 5篇 |
1984年 | 4篇 |
1983年 | 7篇 |
1981年 | 7篇 |
1980年 | 2篇 |
1979年 | 1篇 |
1978年 | 4篇 |
1977年 | 3篇 |
1976年 | 5篇 |
1974年 | 1篇 |
1972年 | 1篇 |
1971年 | 1篇 |
排序方式: 共有685条查询结果,搜索用时 15 毫秒
1.
Kazuhiko Miyazaki Hirofumi Kasada Masayuki Ohtsuka 《Journal of Infrared, Millimeter and Terahertz Waves》1994,15(10):1669-1674
We succeeded in observing the continuously tunable, pulsed InSb SFR (Spin-Flip Raman) laser emission in the infrared region of 11~16µm (11.4~16.3µm) from only one InSb device, merely by adjusting the pumping wavelength (11 lines from the infrared NH3 laser) and the applied magnetic field (0~80 kGauss). 相似文献
2.
This paper describes a brushless dc motor system without position or speed sensor. The brushless motor consists of a permanent magnet synchronous motor and a voltage-source inverter capable of controlling the amplitude and frequency of voltage. The rectangular-shaped stator current with a conducting interval of 120° (electrical) is controlled to be in phase with the trapezoidal back electromotive force. This results in producing maximum torque. Variable speed is achieved by adjusting the average motor voltage similarly to chopper control of dc motors. In this paper, two sensorless position detecting methods, i.e., an “indirect method” suited for the lower-speed range and a “direct method” suited for the higher-speed range are proposed. The combination of the two makes it possible to detect the rotor position over a wide-speed range. Furthermore, a speed-sen-sorless PLL control is proposed in applying the principle of the direct method. Experimental results obtained from a prototype brushless dc motor are shown to confirm the validity of the sensorless drive. The starting procedure of the motor also is discussed because it is impossible to detect the rotor position at a standstill. 相似文献
3.
This paper deals with an advanced static Var compensator (ASVC) using quad-series voltage-source PAM inverters. The ASVC consists of four three-phase voltage-source inverters with a common dc capacitor and four three-phase transformers, each primary winding of which is connected in series with each other. Each inverter outputs a square-wave voltage, while the synthesized output voltage of the ASVC has a 24-step wave shape. This results not only in a great reduction of harmonic currents and dc voltage ripples but also in fewer switching and snubbing losses. In this paper, transient analysis is performed with the focus on the response of reactive power and the resonance between the dc capacitor and ac reactors. Experimental results obtained from a small-rated laboratory model of 10 kVA are also shown to verify analytical results based on the p-q transformation. The analytical results help in the design of system parameters such as the capacity of the dc capacitor and feedback gains. 相似文献
4.
Double-stranded DNA is one of functional polymers, but the large amounts of DNA sources, such as salmon milt and shellfish gonads, have been discarded as industrial wastes. Therefore, conversion of this discarded DNA to be a useful material would be beneficial to utilize the unique property of DNA. These materials including DNA have been prepared by mixing with the organic polymers, such as alginic acid, collagen, and chitosan. However, since these materials have consisted from entirely organic components, these do not have the mechanical strength for a material. So, we prepared the organic-inorganic hybrid materials by mixing DNA with silane coupling reagents bis(trimethoxysilylpropyl)amine or bis[(3-trimethoxysilyl)propyl]ethylenediamine. These hybrid materials with the flexibility were water-insoluble and resistant to hydrolysis by nuclease. In addition, the mechanical strength of this hybrid material was approximately twice as high as that of DNA without mixing with silane coupling reagents. Furthermore, the double-stranded DNA in the hybrid materials has been maintained in a B-form structure in aqueous solution. Thus, we demonstrated the utilization of DNA as a functional material. As a result, this material could selectively accumulate harmful DNA-intercalating compounds with the planar structure, such as dibenzo-p-dioxin, dibenzofuran, and ethidium bromide. Organic-inorganic hybrid material including double-stranded DNA has potential to serve as a useful biomaterial for medical, engineering, and environmental applications. 相似文献
5.
6.
Takaaki Tsurumi Young-Bae Kil Kouhei Nagatoh Hirofumi Kakemoto Satoshi Wada Sadayuki Takahashi 《Journal of the American Ceramic Society》2002,85(8):1993-1996
The material coefficients of "soft" and "hard" lead zirconate titanate (PZT) ceramics were determined as complex values by the nonlinear least-squares-fitting of immittance data measured for length-extensional bar resonators. The piezoelectric d -constant should be a complex value to obtain a best fitting between observed and calculated results. Because the elastic, dielectric, and piezoelectric losses determined in this process were not "intrinsic" losses, a calculation process to evaluate the "intrinsic" losses was proposed. It was confirmed that the intrinsic losses were smaller than the corresponding extrinsic losses. The intrinsic piezoelectric loss existed in both soft and hard PZTs; ∼50% of the loss of piezoelectric d -constant was derived from the elastic and dielectric losses. The most notable difference between the soft and hard PZTs was observed in their elastic losses. 相似文献
7.
Kazunori Sakata Kosuke Nakano Hirofumi Miyahara Yasuhiro Matsubara Keisaku Ogi 《Journal of Thermal Spray Technology》2007,16(5-6):991-997
This article describes microstructure control aimed for wear-resistance improvement of Co-based (Co-Cr-W-B-Si) self-fluxing
alloy coating by diffusion treatment. The diffusion treatments of thermally sprayed Co-based self-fluxing alloy coating on
steel substrate were carried out at 1370-1450 K for 600-6000 s under an Ar gas atmosphere. Microstructural variations of the
coating and the interface between the substrate and the coating were investigated in detail. A proper diffusion treatment
precipitates two kinds of fine compounds in Co-based matrix. X-ray diffractometer (XRD) and electron probe microanalyzer (EPMA)
analysis revealed these precipitates to be a chromium boride dissolving cobalt and a tungsten boride containing cobalt and
chromium. The size of each precipitate became larger with increasing treatment temperature and time. A coating with the proper
size borides showed a superior wear-resistance.
This article is an invited paper selected from presentations at the 2007 International Thermal Spray Conference and has been
expanded from the original presentation. It is simultaneously published in Global Coating Solutions, Proceedings of the 2007 International Thermal Spray Conference, Beijing, China, May 14-16, 2007, Basil R. Marple, Margaret M. Hyland, Yuk-Chiu Lau, Chang-Jiu Li, Rogerio S. Lima, and Ghislain
Montavon, Ed., ASM International, Materials Park, OH, 2007. 相似文献
8.
Recently, we revealed a standard pattern of a macroscopic molecular network for controlling morphogenetic processes such as the development of organs, including blast, mesoderm, heart, and hands during about sevenfold cell divisions and a standard bio-chemical clock like the circadian one (Naitoh in Artif Life Robot 13, 2008; Japan J Ind Appl Math 28(1), 2011; J Phys Conf Ser 344, 2012; Artif Life Robot 17, 2012) A network model derived logically based on experimental observations is described by a nonlinear differential equation for predicting time evolutions of six macroscopic molecular groups: three gene groups and three enzyme groups, which include promoting and suppressing factors. Here, the macroscopic model extended for also describing aging processes shows various types of cycles and reveals the physical condition for determining whether or not living beings such as humans can survive after getting ill. It is stressed that, after becoming ill, living systems with overly fast generation of information molecules such as various genes end in death, whereas relatively fast production of enzymes leads to recovery. This may also explain an essential feature underlying carcinogenic processes. 相似文献
9.
Yoshihisa Shinya Kenji Kamiya Tomoyuki Toyoda Yasumi Endo Nelly Soudakova Hirofumi Kondo 《Journal of the Society for Information Display》2009,17(4):331-336
Abstract— The display used in current cell phones has an air gap between the cover glass and the liquid‐crystal‐display (LCD) module to prevent the LCD glass from being damaged. Reflections at the boundaries of the air gap cause a reduction in the LCD luminance and contrast. To address this problem, a newly proposed LCD structure has been investigated. The “Super View Resin (SVR),” a transparent elastic resin which improves the shock resistance and visibility of the LCD, has been developed. Filling the air gap between the cover glass and LCD module with a refractive‐index‐matching resin solves the light‐reflection problem inherent in the use of a reinforced cover‐glass lens. Moreover, the elastic filler works as a damper, reducing any external shock, which prevents not only the cover glass and LCD module from being damaged, but also the glass from being shattered when it is broken. 相似文献
10.
Yuko Kizu Ray Hasegawa Isao Amemiya Shuichi Uchikoga Hirofumi Wakemoto 《Journal of the Society for Information Display》2009,17(8):647-658
Abstract— A 9‐in. full‐color polymer‐stabilized OCB TFT‐LCD with stable bend alignment in the absence of an electric field was developed. The condition of the polymer stabilization, the characteristics of UV‐curable monomers, and their influence on the configurations of the polymer network in the cell were studied. Possible models of the configuration were proposed and their relationship to the electro‐optical properties was analyzed using a novel simulation method considering the distribution of anchoring effects from both alignment surfaces and the polymer network. It was suggested that a good performance such as high contrast ratio and fast response could be expected in the polymer network originating from newly developed monomers composed of multifunctional LC acrylates due to a relatively weak‐anchoring effect and presumably its localization near the alignment surfaces. By using the newly developed monomers under the optimized polymer‐stabilizing process, a high contrast ratio of 250:1 and fast response nearly equal to that of a conventional OCB cell were achieved. 相似文献