Photocatalytic oxidation of low concentration 2,4-D solution with new TiO2 fiber catalyst in a continuous flow reactor.

Environmental pollution by low concentrations of 2,4-Dichlorophenoxyacetic acid (2,4-D) is a concern these days due to ever increasingly stringent regulations. Photocatalysis with immobilized TiO2 fiber is a promising oxidation method. Laboratory experiments on photocatalytic degradation of 0.045 mmol l(-1) 2,4-D with the world's first high-strength TiO2 fiber catalyst were carried out in a continuous flow reactor in which the degradations were, in general, similar to those with high 2,4-D concentrations investigated elsewhere. Degradation and mineralization of 2,4-D were significantly enhanced with no initial pH adjustments. The rate constants for total organic carbon (TOC) without pH adjustment were about two-fold bigger than the pH adjustment cases. CO2 gas measurement and carbon mass-balance were carried out for the first time, where about 34% organic carbon converted into CO2 gas during four-hour oxidation. 2,4-Dichlorophenol (2,4-DCP), phenol, benzyl alcohol and two unknowns (RT = 2.65 and 3.78 min.) were detected as aromatic intermediates while Phenol was the new aromatic in HPLC analysis. Dechlorination efficiencies were high (> 70%) in all the cases, and more than 90% efficiencies were observed in chloride mass balance. Bigger flow rates and solution temperature fixed at 20 degrees C without pH adjustment greatly enhanced 2,4-D mineralization. These results can be an important basis in applying the treatment method for dioxin-contaminated water and wastewater.     

Improved visible-light responsive photocatalytic activity of N and Si co-doped titanias

Thermal reaction of titanium tetraisopropoxide and tetraethyl orthosilicate in 1,4-butanediol afforded nanocrystalline silica-modified titanias having large surface area and superior thermal stability. In this study, the thus-obtained silica-modified titanias were treated in an NH₃ flow at high temperatures, and their physical and photocatalytic properties were investigated. Compared with NH₃-treated TiO₂ without silica modification, the NH₃-treated silica-modified titanias showed a stronger absorption in the visible region (400–500 nm) and had a larger peak at 396 eV in the N 1s XPS spectrum. These results indicate that a larger amount of nitrogen was stably doped in the silica-modified titania. The obtained products exhibited a high photocatalytic activity for degradation of Rhodamine B and decomposition of acetaldehyde under visible light irradiation. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Aging and availability of binocular disparity and pictorial depth cues in 3D graphics contents

Some stereoblind observers do not perceive depth of 3D stimuli that depends on binocular disparity. These individuals, who have no disabilities, comprise over 5% of the general population. In addition, 17–30% of nonstereoblind young and young–middle people do not use disparity information in certain 3D environments, a phenomenon known as pseudo‐stereoblindness. This study aimed to investigate the relationship between aging and the proportion of pseudo‐stereoblindness in the general population. In an experiment, 134 nonstereoblind participants, ranging in age from 17 to 83 years, judged subjective depth of 3D stimuli containing binocular disparity and pictorial depth cues. Results showed that the proportion of pseudo‐stereoblindness among young (17–24 years old) and young–middle aged observers (25–39 years old) was 29%, in both cases. However, the proportion of pseudo‐stereoblind observers increased in older populations: 65% and 82% in the middle (40–54 years old) and senior (55–83 years old) age groups, respectively. These results suggest that a number of people, especially in elderly populations, have trouble perceiving depth from binocular disparity in 3D graphic contents despite their essential ability to use disparity information.     

Selection of parameters in the design of real-time spectral analysis

A new analytical method with high speed processing in the time-frequency domain is presented. In this method, sine and cosine waves with an established frequency and multiple periods are used, and we call these waves “cutting-out waves.” We all the frequency the “established frequency,” and we call the number of periods of the cutting-out wave the “number of periods.” The inner product of the cutting-out wave and the signal are calculated, and a signal element with a frequency near the established frequency is detected. We call the unit that detects the signal element an “auditory cell.” There are many auditory cells, and they have an established frequency which differs very little. The design of this method is the arrangement of the auditory cells. There are three parameters in the design, and these parameters are a sampling frequency, the number of periods, and the increasing rate of the established frequencies. In this article, we show the selection of these parameters.     

Fabrication of piezoelectric multilayer thin-film actuators

In this study, we fabricated multilayer ceramics (MLCs) composed of multilayered Pb(Zr,Ti)O₃ (PZT) piezoelectric thin films with internal electrodes and evaluated their dielectric and piezoelectric properties. The stack of PZT ferroelectric layers (550 nm) and SrRuO₃ (SRO, 80 nm) electrodes were alternatively deposited on Pt/Ti-coated silicon-on-insulator substrates by radio-frequency magnetron sputtering. The MLCs composed of one, three, and five PZT layers were fabricated by the alternate sputtering deposition of PZT ferroelectric layers and SRO electrodes through the movable shadow mask. The capacitances of MLCs were proportionally increased with the number of PZT layers, while their relative dielectric constants were almost same among the each MLC. The MLCs exhibited symmetric and saturated P–E hysteresis loops similar to the conventional PZT thin films. We estimated that the piezoelectric properties of MLCs by FEM simulation, and confirmed that the effective transverse piezoelectric coefficients (d _31,eff ) increased with the number of PZT layers. The piezoelectric coefficients calculated to be d _31,eff  = ?2964 pC/N at 25 PZT layers, which is much higher than those of conventional single-layer piezoelectric thin films.     

Proteomics integrated with Escherichia coli vector-based vaccines and antigen microarrays reveals the immunogenicity of a surface sialidase-like protein of Propionibacterium acnes

Proteomics is a powerful tool for the identification of proteins, which provides a basis for rational vaccine design. However, it is still a highly technical and time‐consuming task to examine a protein's immunogenicity utilizing traditional approaches. Here, we present a platform for effectively evaluating protein immunogenicity and antibody detection. A tetanus toxin C fragment (Tet‐c) was used as a representative antigen to establish this platform. A cell wall‐anchoring sialidase‐like protein (SLP) of Propionibacterium acnes was utilized to assess the efficacy of this platform. We constructed an Escherichia coli vector‐based vaccine by overexpressing Tet‐c or SLP in E. coli and utilized an intact particle of E. coli itself as a vaccine (E. coli Tet‐c or SLP vector). After ultraviolet (UV) irradiation, the E. coli vector‐based vaccines were administered intranasally into imprinting control region mice without adding exogenous adjuvants. For antibody detection, we fabricated antigen microarrays by printing with purified recombinant proteins including Tet‐c and SLP. Our results demonstrated that detectable antibodies were elicited in mice 6 weeks after intranasal administration of UV‐irradiated E. coli vector‐based vaccines. The antibody production of Tet‐c and SLP was significantly elevated after boosting. Notably, the platform with main benefits of using E. coli itself as a vaccine carrier provides a critical template for applied proteomics aimed at screening novel vaccine targets. In addition, the novel immunogenic SLP potentially serves as an antigen candidate for the development of vaccines targeting P. acnes‐associated diseases.     

Full Band Monte Carlo Study for Two-Dimensional Hole Transport in Strained Si p-MOSFETs

Transport properties of the two-dimensional hole gas in inversion layer of strained Si/SiGe p-MOSFETs are investigated using the full-band Monte Carlo simulator based on the nonlocal pseudopotential calculation. The hole mobility is significantly enhanced by the strain in the case of Ge content of ≥20%. Moreover, we also present the high-field transport characteristics of 2D holes. In contrast to the low-field mobility, the hole saturation velocity does not significantly enhanced by the strain.     

In-Situ Observation of SiC Bulk Single Crystal Growth by XRD System

In-situ analysis for SiC bulk single crystal growth was reported using vertical X-ray diffractometer system. A furnace for SiC sublimation growth combined with the XRD system which possessed three kinds of functions including topography, rocking curve measurement and crystal growth rate monitoring was developed. These functions could contribute as a powerful tool finding the optimum growth condition by dynamic observation in the crucible. In this study, the in-situ X-ray topographs succeeded to capture dynamic elongation of defects and dislocation generated in the SiC growing crystals. The in-situ rocking curve measurement reviled appearance of mosaic structure in the SiC crystal grown with high growth rate. The in-situ growth rate monitoring also succeeded very precisely using the direct X-ray beam absorption. On the base of findings and facts obtained by the in-situ observations, the importance for the SiC growth was discussed.