Structural analysis of Ti-Fe thin films prepared by pulsed laser deposition

Titanium iron oxide (Ti-Fe-O) thin films have been successfully deposited by pulsed laser deposition (PLD). Experiments were carried out by using some targets. One was a Ti-50 at.% Fe-sintered target, while the others were Ti and Fe plates with various surface area ratio [S_R=S_Fe/(S_Fe+S_Ti)] from 30 to 70%. The thin films were analyzed by X-ray diffractometry, Rutherford backscattering spectroscopy (RBS) and transmission electron microscopy (TEM). From XRD analysis, the main phase in the thin films deposited at S_R=30 and 50% was β-Ti (Fe). By increasing S_R to 70%, the main phase of the thin film changed to TiFe. By phase diagram, composition of TiFe must be between Ti-47.5-50.3 at.% Fe at a temperature of 1085 °C. However, the composition of the thin film deposited at S_R=70% was found to be Ti_0.15Fe_0.62O_0.23. Thus, the composition of Fe in the thin film was much greater than the solubility limit. This fact suggests two possibilities. One is that the thin films, which we have deposited, were in a metastable state. The other is that metal oxides of amorphous state could be contained in the thin film.     

Polypropylene plasticization and photodegradation with a TiO2/poly(ethylene oxide)/methyl linoleate paint photocatalyst system

The photodegradation of polypropylene (PP) film was performed by a TiO₂/polyethylene oxide (PEO)/plant oil paint photocatalyst system. The photodegradation underwent two stages of development as follows: Initially PP reacted with linoleic acid radical originated from the photoreaction of plant oil component. Second, the linoleic acid graft‐polymer was decomposed, and then PP chain scission was caused. The process was studied using methyl linoleate (ML) in detail. The melting point of the 24 h‐photodegraded PP slightly decreased, and those of the 48 h‐ and 96 h‐ones drastically did as compared with the pristine PP. The crystallinity (χ_c) decreased at the 48 h photodegradation time and drastically increased at the 96 h one. The 24 h‐photodegraded PP showed the 77% Young's modulus, 88% tensile strength, and 103% strain at break values to those of the pristine PP. The ML graft‐polymerization and decomposition brought about the PP plasticizing and chemi‐crystallization, causing the PP degradation. © 2013 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2014 , 131, 39909.     

Analog Circuit Design Methodology in a Low Power RISC Microprocessor

There are various kinds of analog CMOS circuits in microprocessors. IOs, clock distribution circuits including PLL, memories are the main analog circuits. The circuit techniques to achieve low power dissipation combined with high performance in newest prototype chip in the Super H RISC engines are described. A TLB delay can be decreased by using a CAM with a differential amplifier to generate the match signal. The accelerator circuit also helps to speed up the TLB circuit, enabling single-cycle operation. A fabricated 96-mm² test chip with the super H architecture using 0.35-m four metal CMOS technology is capable of 167-MHz operation at 300 Dhrystone MIPS with 2.0-W power dissipation.     

Microstructure and phase relations for Ti-Mo-Al alloys

The influence of aluminum additions to a Ti-7 at. pet Mo alloy on the phase equilibria was investigated. The microstructures of the alloys, Ti-7 pct Mo-7 pct Al and Ti-7 pct Mo-16 pct Al, were determined by light and electron microscopy. It was found that with increasing aluminum concentration the formation of the metastable w phase was suppressed. In the Ti-7 pct Mo-16 pct Al alloy the β phase decomposed upon quenching by precipitating coherent, ordered particles having a B2 type of crystal structure (β₂). At low temperatures the equilibrium phases for this alloy were β + α+ β ₂, whereas at high temperature (850° to 950°C) the Ti₃Al phase was in two-phase equilibrium with the β phase. The four-phase equilibrium which exists at a temperature of about 550°C involves the reaction β + Ti₃Al ⇌ α + β₂. G. LUETJERING, formerly Staff Member Materials Research Center, Allied Chemical Corp., Morristown, N. J.,     

High-Speed X-Cut Thin-Sheet LiNbO3 Optical Modulator With Folded Structure

We propose a small-footprint X-cut thin-sheet lithium niobate optical modulator with high-speed and low-driving-voltage characteristics. Since an optical waveguide is folded by a mirror placed at one edge of the modulation chip, the chip can be shortened by about half. In addition, a wide modulation bandwidth can be achieved, because the path-length difference between the optical waveguide and the coplanar-waveguide (CPW) electrode is decreased to as short as possible by placing the CPW electrode as far as possible along the optical waveguide in the folded portion, and the microwave effective index is set to realize effective velocity matching between the lightwave and the microwave. A small footprint of 1.78 times 29 mm, a low half-wave voltage of 2.0 V at dc, and a 3-dBe modulation bandwidth of 20 GHz were obtained.     

High-speed and low-driving-Voltage thin-sheet X-cut LiNbO/sub 3/ Modulator with laminated low-dielectric-constant adhesive

We present a novel thin-sheet X-cut LiNbO/sub 3/ optical modulator structure which can be fabricated by precise polishing and lapping to obtain a thinner LiNbO/sub 3/ substrate for a lower driving voltage in addition to velocity matching and impedance matching. We demonstrated that the fabricated modulator had a driving voltage V/spl pi/ of 2 V and zero chirp for 40-Gb/s operation and had a high potential for suppressed dc drift, and long-term reliability.     

Indoor air pollution and its impact on children under five years old in Bangladesh

Indoor air concentrations of volatile organic compounds (VOCs), carbon monoxide (CO), carbon dioxide (CO2), nitrogen dioxide (NO2), and dust particles were measured for 49 biomass and 46 fossil fuel users in urban slums of Dhaka, Bangladesh. The health impacts of these pollutants were assessed on 65 and 51 children under five years old from families who use biomass and fossil fuel as main source of energy, respectively. Mean concentrations of CO were found to be significantly higher in biomass fuel users (P = 0.010), while geometric mean concentrations of benzene, xylene, toluene, hexane, total VOCs, and NO2 were significantly higher (P < 0.01) in the fossil fuel users. Symptoms such as redness of eyes, itching of skin, nasal discharge, cough, shortness of breath, chest tightness, wheezing, or whistling chest were found to be associated with the choice of biomass fuel, with the odds ratio ranging from 4.0 to 6.3. No significant association of use of biomass fuel with respiratory diseases, eczema, diarrhea, or viral fever was observed after adjustment for potential confounders. These results suggest a significant association between the biomass fuel-using population and respiratory symptoms. These symptoms may not be due to the pollutants only, as some other underlying causes may be present. PRACTICAL IMPLICATIONS: The health of children under five years old in Bangladesh, especially those living in poor socioeconomic conditions, is considered to be worsening because of indoor air pollution. It is commonly suggested that biomass fuel should be replaced by fossil fuel, as pollution levels are believed to be higher with biomass fuel. Our findings, however, suggest that pollution can be higher with fossil fuels, and indicate that a switch in fuel from biomass to fossil does not necessarily improve the children's health. Awareness programs should therefore be undertaken to avoid the unnecessary use of gas. Clean fuels and clean stoves should also be ensured to reduce emissions of indoor air pollutants.     

Impact of family history on the risk of breast cancer among the Japanese

OBJECTIVE: The serum concentration of the high-affinity growth hormone-binding protein (GHBP) is increased in obesity but the mechanisms are poorly understood. This study assessed the physiological mechanisms involved in the regulation of GHBP in adiposity. SUBJECTS AND MEASUREMENTS: We tested a number of obesity specific parameters for their association with GHBP. In this study, 199 normal or overweight children and adolescents (101 boys, 98 girls, aged (mean +/- s.d.): 13.7 +/- 2.3 y) underwent an anthropometric evaluation (circumference measurements and bioimpedance analysis) combined with blood withdrawal for the measurement of insulin-like growth factor-I (IGF-I), insulin, leptin and GHBP (by specific RIA), uric acid, triglycerides and cholesterol. RESULTS: By linear regression analysis GHBP correlated significantly (P < 0.001) with percent body fat mass (r = 0.71), waist (r = 0.73) and hip (r = 0.69) circumference, weight (r = 0.61) waist hip ratio (WHR) (r = 0.54), as well as with the serum concentrations of leptin (r = 0.64), uric acid (r = 0.54), insulin (r = 0.45), LDL-cholesterol (r = 0.43), cholesterol (r =0.33), LDL/HDL ratio (r = 0.47), triglycerides (r = 0.30) and with height standard deviations scores (SDS) (r = 0.23). Age, gender and pubertal stage had no impact on GHBP. In a multiple regression analysis containing age and gender, as well as the anthropometric variables, percent fat mass and waist circumference, as independent variables, associations between GHBP and leptin (P < 0.001), cholesterol (P < 0.01), LDL-cholesterol (P = 0.01), LDL/HDL ratio (P = 0.02), triglycerides (P = 0.01) remained significant. In a final model using the stepwise analysis involving age, gender and all the independent predictors of GHBP, waist circumference (P < 0.001), accounted for 49.5% of the 60.0% total variability in GHBP, while the implication of leptin (P < 0.001), age (P < 0.01) and cholesterol (P < 0.05) increased the predicted variability for 7.5%, 1.9%, and 1.0%, respectively. Serum GHBP was significantly reduced in a subgroup of 104 overweight or obese patients during a diet-induced weight loss programme, the coefficient of correlation between GHBP and leptin after (r = 0.45, P < 0.001) and before weight reduction (r = 0.41, P < 0.001) were comparable. CONCLUSION: Waist circumference, an indicator of abdominal body fat mass, is a major determinant of GHBP levels during childhood, while leptin may be one candidate for a signal linking adipocytes to the growth hormone receptor related GHBP release. Additionally, elevated serum levels of GHBP may reflect metabolic disturbances of adiposity.