A dual-mode bandpass filter with enhanced capacitive perturbation

A dual-mode ring bandpass filter with two pairs of capacitors has been designed. The capacitors are used to control the location of the even- and odd-mode frequencies independently, allowing weak coupling for narrow-band filter design with realizable capacitance values. Theoretical expressions have been derived for these frequencies. A 4% bandwidth bandpass filter centered at 1.9 GHz was designed and tested with good agreement between theoretical and measured results.     

Static and Dynamic Spins in Superconducting La2−x Sr x CuO4: The Risø Years

One important area of modern condensed matter research is the investigation of the nature of the superconducting cuprates. Much progress in this field has been obtained with the technique of neutron scattering. We here present a review of neutron scattering studies of the high-temperature superconductor La_2?xSr_xCuO₄, performed at Risø National Laboratory. We review the work on the mapping of the incommensurate spin fluctuations, the investigation of the gap in the fluctuation spectrum, the magnetic properties of the vortices appearing in an applied field, and the quantum critical behaviour of the system. We discuss our findings in the light of results of neutron scattering from other groups, on other cuprate systems, and results from other experimental methods, e.g. NMR, μSR, STM, X-ray diffraction, and ARPES. We end with a discussion on the implications of the experimental results for the progress in the general understanding of high-temperature superconductivity. PACS numbers: 61.12.Ex, 74.20.Mn, 74.72.Dn, 75.25.+z, 78.70.Nx.     

Pollutant dispersion over two-dimensional hilly terrain

Numerical prediction of the wind flow and pollutant dispersion over two-dimensional hilly terrain is presented. The wind tunnel experiments are conducted to validate the numerical results of the flow field. Measured mean velocity profiles, turbulence characteristics, and surface pressure distributions show good agreement with the numerical predictions. The hypothesis of Reynolds number independency for an atmospheric boundary layer flow over aerodynamically rough terrain is numerically confirmed. The linear theory provides generally good prediction of speed-up characteristics for gently sloped low hills. The effect of two-dimensional double hills on the dispersion of pollutants from continuously or temporally released line source of different emission heights and locations is also investigated. The ground-level concentrations are considerably reduced as emission heights are increased. The variances of ground-level concentration with respect to time from a temporally released source are strongly influenced by the flow separation.     

Thermal properties and crystalline structure of liquid crystalline poly(ethylene terephthalate‐co‐2(3)‐chloro‐1,4‐phenylene terephthalate)

Thermal properties and crystalline structure of liquid crystalline (LC) poly(ethylene terephthalate‐co‐2(3)‐chloro‐1,4‐phenylene terephthalate) [copoly(ET/CPT)] were investigated using differential scanning calorimetry (DSC), thermogravimetry (TGA), limiting oxygen index (LOI) measurement, electron dispersive X‐ray analysis (EDX), X‐ray diffractometry, and infrared spectrometry (IR). The thermal transition temperatures of copoly(ET/CPT) were changed with the composition. Copoly(ET/CPT) showed two thermal decomposition steps and the residues at 700°C and LOI values of copoly(ET/CPT) were almost proportional to its chlorine content. The activation energy of thermal decomposition of LC units was very low compared to that of poly(ethylene terephthalate)(PET) units. Crystal structure of copoly(ET/CPT) (20/80) was of triclinic system with the lattice constants of a = 9.98 A?, b = 8.78 A?, c = 12.93 A?, α = 97.4°, β = 96.1°, and γ = 90.8°, which is very close to that of poly(chloro‐p‐phenylene terephthlate) (PCPT) with the lattice constants of a = 9.51 A?, b = 8.61 A?, c = 12.73 A?, α = 96.8°, β = 95.4°, and γ = 90.8°. When copoly(ET/CPT)(50/50) was annealed at 220°C in vacuum, crystallization induced sequential reordering (CISR) was not observed but the heat of fusion was slightly increased due to the increase of the trans isomer content in PET units. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 84: 1286–1294, 2002; DOI 10.1002/app.10451     

Preparation and characterization of syndiotactic polystyrene/ethylene‐propylene copolymer blends

The reactive compatibilization of syndiotactic polystyrene (sPS)/oxazoline‐styrene copolymer (RPS)/maleic anhydride grafted ethylene‐propylene copolymer (EPR‐MA) blends is investigated in this study. First, the miscibility of sPS/RPS blends is examined by thermal analysis. The cold crystallization peak (T_cc) moved toward higher temperature with increased PRS, and, concerning enthalpy relaxation behaviors, only a single enthalpy relation peak was found in all aged samples. These results indicate that the sPS/RPS blend is miscible along the various compositions and RPS can be used in the reactive compatibilization of sPS/RPS/EPR‐MA blends. The reactive compatibilized sPS/RPS/EPR‐MA blends showed finer morphology than sPS/EPR‐MA physical blends and higher storage modulus (G') and complex viscosity (η*) when RPS contents were increased. Moreover, the impact strength of sPS/RPS/EPR‐MA increased significantly compared to sPS/EPR‐MA blend, and SEM micrographs after impact testing show that the sPS/RPS/EPR‐MA blend has better adhesion between the sPS matrix and the dispersed EPR‐MA phase. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 85: 2084–2091, 2002     

Preparation of pH‐sensitive poly(vinyl alcohol‐g‐methacrylic acid) and poly(vinyl alcohol‐g‐acrylic acid) hydrogels by gamma ray irradiation and their insulin release behavior

A series of pH‐responsive hydrogels were studied as potential drug carriers for the protection of insulin from the acidic environment of the stomach before releasing in the small intestine. Hydrogels based on poly(vinyl alcohol) networks grafted with acrylic acid or methacrylic acid were prepared by a two‐step process. Poly(vinyl alcohol) hydrogels were prepared by gamma ray irradiation (50 kGy) and then followed by grafting either acrylic acid or methacrylic acid onto these poly(vinyl alcohol) hydrogels with subsequent irradiation (5–20 kGy). These graft hydrogels showed pH‐sensitive swelling behavior and were used as carriers for the controlled release of insulin. The in vitro release of insulin was observed for the insulin‐loaded hydrogels in a simulated intestinal fluid (pH 6.8) but not in a simulated gastric fluid (pH 1.2). The release behavior of insulin in vivo in a rat model confirmed the effectiveness of the oral delivery of insulin to control the level of glucose. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 91: 636–643, 2004     

Preparation of alginate/poly(N‐isopropylacrylamide) semi‐interpenetrating and fully interpenetrating polymer network hydrogels with γ‐ray irradiation and their swelling behaviors

Semi‐interpenetrating polymer network (semi‐IPN) and fully interpenetrating polymer network (full‐IPN) hydrogels composed of alginate and poly(N‐isopropylacrylamide) were prepared with γ‐ray irradiation. The semi‐IPN hydrogels were prepared through the irradiation of a mixed solution composed of alginate and N‐isopropylacrylamide (NIPAAm) monomer to simultaneously achieve the polymerization and self‐crosslinking of NIPAAm. The full‐IPN hydrogels were formed through the immersion of the semi‐IPN film in a calcium‐ion solution. The results for the swelling and deswelling behaviors showed that the swelling ratio of semi‐IPN hydrogels was higher than that of full‐IPN hydrogels. A semi‐IPN hydrogel containing more alginate exhibited relatively rapid swelling and deswelling rates, whereas a full‐IPN hydrogel showed an adverse tendency. All the hydrogels with NIPAAm exhibited a change in the swelling ratio around 30–40°C, and full‐IPN hydrogels showed more sensitive and reversible behavior than semi‐IPN hydrogels under a stepwise stimulus. In addition, the swelling ratio of the hydrogels continuously increased with the pH values, and the swelling processes were proven to be repeatable with pH changes. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 4439–4446, 2006     

Template‐Free Fabrication of Mesoporous Alumina Nanospheres Using Post‐Synthesis Water‐Ethanol Treatment of Monodispersed Aluminium Glycerate Nanospheres for Molybdenum Adsorption

This work reports the template‐free fabrication of mesoporous Al₂O₃ nanospheres with greatly enhanced textural characteristics through a newly developed post‐synthesis “water‐ethanol” treatment of aluminium glycerate nanospheres followed by high temperature calcination. The proposed “water‐ethanol” treatment is highly advantageous as the resulting mesoporous Al₂O₃ nanospheres exhibit 2–4 times higher surface area (up to 251 m² g^?1), narrower pore size distribution, and significantly lower crystallization temperature than those obtained without any post‐synthesis treatment. To demonstrate the generality of the proposed strategy, a nearly identical post‐synthesis “water treatment” method is successfully used to prepare mesoporous monometallic (e.g., manganese oxide (MnO₂)) and bimetallic oxide (e.g., CuCo₂O₄ and MnCo₂O₄) nanospheres assembled of nanosheets or nanoplates with highly enhanced textural characteristics from the corresponding monometallic and bimetallic glycerate nanospheres, respectively. When evaluated as molybdenum (Mo) adsorbents for potential use in molybdenum‐99/technetium‐99m (⁹⁹Mo/^99mTc) generators, the treated mesoporous Al₂O₃ nanospheres display higher molybdenum adsorption performance than non‐treated Al₂O₃ nanospheres and commercial Al₂O₃, thereby suggesting the effectiveness of the proposed strategy for improving the functional performance of oxide materials. It is expected that the proposed method can be utilized to prepare other mesoporous metal oxides with enhanced textural characteristics and functional performance.