THz Direct Detector and Heterodyne Receiver Arrays in Silicon Nanoscale Technologies

Journal of Infrared, Millimeter, and Terahertz Waves - The main scope of this paper is to address various implementation aspects of THz detector arrays in the nanoscale silicon technologies...     

Energy Efficiency Trade-Off Between Duty-Cycling and Wake-Up Radio Techniques in IoT Networks

Wireless Personal Communications - For robust monitoring, control and proper energy management of renewable energy sources (RES), wireless sensing networks (WSNs) are proved to be a vital solution....     

Flux Jumps and H-T Diagram of Instability for MgB2

We present a study of magneto-thermal instabilities in polycrystalline MgB₂ superconductor, by magnetic hysteresis loop measurements and by investigations of magnetic flux dynamics with a miniature Hall probe. Temperature and magnetic field ranges where the flux jumps may be observed have been determined. On the basis of measurements of the magnetic flux dynamics, an average magnetic diffusivity describing the process of the flux jump is estimated. This parameter is compared with the thermal and magnetic diffusivities calculated on the basis of available data for thermal conductivity, heat capacity and resistivity. It is shown that the estimated value of the field of the first flux jump is influenced significantly by the field dependence of specific heat. In order to explain the observed phenomenon, the temperature reached by the sample during the flux jump at different magnetic fields is calculated.     

Simulation of Temperature Distribution in Stored Wheat without Aeration

A neural-deterministic simulation model applied for calculating distributions of temperatures and moisture content in a bed of wheat stored in a steel silo without aeration is presented in the article. The model consists of differential equations of heat and moisture transfer, initial and boundary conditions, and three artificial neural networks used during simulated ambient air conditions. Experiments and computer simulations were carried out in order to determine temperature fields in wheat grain stored in a steel silo for two months. The computer simulations were carried using MATLAB and FEMLAB software. The difference between measured and simulated temperature in grain near the silo wall at a height of 2.5 m from the bottom was less than 3.0°C. On the basis of the analysis performed it was concluded that the temperature distributions obtained with the model were consistent with the measured results obtained for grain stored in a steel silo without aeration.     

Performance evaluation of the R-BTMA protocol in a distributedmobile radio network context

A reservation multiple-access protocol for mobile communication in a decentralized environment is proposed and investigated both analytically and by simulation. The reservation-busy-tone multiple access (R-BTMA) is a fully distributed and reservation-based protocol. It is a medium access control (MAC) protocol designed for short-range communications between vehicles in a decentralized context (i.e., without a base station). The specificity of this protocol relies on the utilization of two different characteristic channels. Information is transmitted on the data channel (DC), whereas the busy-tone channel (BTC) is used for signalling traffic. The range of the BTC is typically longer than the DC one. The throughput and access delay performance are studied in the particular context of two cells sharing a common BTC. The traffic between the vehicles is supposed to be regular and is parameter sharing. The comparison of the model analysis results to those obtained by the simulative approach shows a satisfactory matching     

Inverse Analysis of Axisymmetrical Compression of HSLA Steel

The objective of the present work is to further explore the problem of selection of the flow stress function which will give the best agreement with experiments for a wide range of the Zener‐Hollomon parameter. Analysis of various flow stress functions was performed, with particular emphasis on the Zerilli‐Armstrong model. Inverse analysis was successfully applied to identify the flow stress model for microalloyed steels deformed in ferrite, two‐phase and austenite regions. Inverse method is applied to interpret the results of the axisymmetrical compression tests performed for HSLA steel samples on a Gleeble 3800 and Split Hopkinson Pressure Bar. Sensitivity analysis is performed based on local and global methods. The objective of the sensitivity analysis in the present study is the evaluation to what extent the selected coefficients in the rheological model influence the result of simulations. In the considered tests this result is represented by two dependent variables, the load and the shape of the sample (barrelling). It is confirmed that the Zerilli‐Armstrong equations should be applied at very high strain rates. Physical meaning is an advantage of this model. Difficulties with identification are the main disadvantage.