"Significance of serum gamma glutamyl transpeptidase in cholestatic jaundice"

In conclusion, our study showed that serum G.G.T rises in cholestasis, and the rise is significantly higher in extraphepatic cholestasis as compared to intrahepatic cholestasis. Serum G.G.T has not shown any superiority over alkaline phosphatase in the evaluation of cholestatic liver disease. However, two considerations must caution against the use of serum G.G.T. alone for evaluation of hepatobiliary disease. The first of these is the lack of specificity for hepatobiliary disease. Serum G.G.T. activity can be elevated in some non-hepatic disorders such as acute pancreatitis, congestive cardiac failure, myocardial infarction, diabetes mellitus and alcoholism. Determination of serum G.G.T. in these patients is of no value. Second, the possibility that changes in serum G.G.T. activity results from drug administration in man.     

Development of nano indium tin oxide (ITO) grains by alkaline hydrolysis of In(III) and Sn(IV) salts

Indium tin oxide (ITO) nano powders of different compositions (In: Sn = 90: 10, 70: 30 and 50: 50) were prepared by heat treatment (300-450°C) of mixed hydroxides of In(III) and Sn(IV). The hydroxides were obtained by the reaction of aq. NH₃ with mixed aq. solutions of In(NO₃)₃ and SnCl₄. FTIR and TG/DTA studies revealed that powders existed as In(OH)₃H₂O—SnO₃H₂H₂O in the solid state and then they transformed to In₂O₃—SnO₂ via some metastable intermediates after 300°C. Cubic phase of In₂O₃ was identified by XRD for the oxides up to 30% of Sn. Particle size measurements of the solid dispersed in acetone and SEM study for microstructure showed that the oxides were in the nano range (55-75 nm) whereas the size range determined from Debye-Scherrer equation were 11–24 nm.     

A 150 MHz 0.6 μm BiCMOS superscalar microprocessor

An implementation of the Pentium microprocessor architecture in 0.6 μm BiCMOS technology is described. Power dissipation is reduced and performance is enhanced over the previous generation. Processor features, implementation technology, and circuit techniques are discussed. An internal clock rate of 150 MHz is achieved at 3.7 V and -55°C     

Organic‐acid‐catalyzed sol–gel route for preparing poly(methyl methacrylate)–silica hybrid materials

In this study, a series of organic–inorganic hybrid sol–gel materials consisting of a poly(methyl methacrylate) (PMMA) matrix and dispersed silica (SiO₂) particles were successfully prepared through an organic‐acid‐catalyzed sol–gel route with N‐methyl‐2‐pyrrolidone as the mixing solvent. The as‐synthesized PMMA–SiO₂ nanocomposites were subsequently characterized with Fourier transform infrared spectroscopy and transmission electron microscopy. The solid phase of organic camphor sulfonic acid was employed to catalyze the hydrolysis and condensation (i.e., sol–gel reactions) of tetraethyl orthosilicate in the PMMA matrix. The formation of the hybrid membranes was beneficial for the physical properties at low SiO₂ loadings, especially for enhanced mechanical strength and gas barrier properties, in comparison with the neat PMMA. The effects of material composition on the thermal stability, thermal conductivity, mechanical strength, molecular permeability, optical clarity, and surface morphology of the as‐prepared hybrid PMMA–SiO₂ nanocomposites in the form of membranes were investigated with thermogravimetric analysis, differential scanning calorimetry, dynamic mechanical analysis, gas permeability analysis, ultraviolet–visible transmission spectroscopy, and atomic force microscopy, respectively. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Method for crosscorrelating images in the presence of geometric distortion

The conventional crosscorrelation function (XCF) used in temporal and spatial displacement measurement is unable to provide satisfactory results when linear distortion is also present in the signals. A 'nested' correlation function (NCF) is proposed which produces accurate results, when the distortion is dispersive, with negligible computational overhead.<>     

FE3 EPR investigation of PLZT 1/65/35 and 8/65/35

X-band EPR spectra of PLZT 1/65/35 and PLZT 8/65/35 doped with 1% FE³⁺ were recorded at temperature range -175°C to 200°C. Three types of paramagnetic centers were found. Two of them are in strong axial and rhombic crystal field due to neighboring oxygen and lead vacancies. The other center has symmetry determined by polarization and oxygen octahedra tilt. EPR spectra of PLZT 8/65/35 are in agreement with its glassy behavior.     

Dynamic distributed lanes: motion planning for multiple autonomous vehicles

Unorganized traffic is a generalized form of travel wherein vehicles do not adhere to any predefined lanes and can travel in-between lanes. Such travel is visible in a number of countries e.g. India, wherein it enables a higher traffic bandwidth, more overtaking and more efficient travel. These advantages are visible when the vehicles vary considerably in size and speed, in the absence of which the predefined lanes are near-optimal. Motion planning for multiple autonomous vehicles in unorganized traffic deals with deciding on the manner in which every vehicle travels, ensuring no collision either with each other or with static obstacles. In this paper the notion of predefined lanes is generalized to model unorganized travel for the purpose of planning vehicles travel. A uniform cost search is used for finding the optimal motion strategy of a vehicle, amidst the known travel plans of the other vehicles. The aim is to maximize the separation between the vehicles and static obstacles. The search is responsible for defining an optimal lane distribution among vehicles in the planning scenario. Clothoid curves are used for maintaining a lane or changing lanes. Experiments are performed by simulation over a set of challenging scenarios with a complex grid of obstacles. Additionally behaviours of overtaking, waiting for a vehicle to cross and following another vehicle are exhibited.     

Effect of thiophosphoryl compounds as accelerators and coupling agents on the vulcanization of NR‐XNBR blend

The effect of a number of thiophosphoryl compounds [viz., bis(isobutyl) thiophosphoryl di‐, tri‐, and tetrasulfides and bis(dicyclohexyl) thiophopsphoryl di‐, tri‐, and tetrasulfides] on natural rubber (NR)‐carboxylated nitrile rubber (XNBR) blend was studied. All these thiophosphoryl compounds are capable of forming interrubber links leading to covulcanized blends which exhibit a fair degree of synergism with respect to physical properties, the maximum being obtained at the 25% NR and 75% XNBR blend composition. This is an obvious claim that the blend under investigation is technologically compatible, having some degree of interrubber interaction which is enhanced in case of two‐stage vulcanization. The existence of interrubber interaction is judged by the swelling experiment. The blend morphology assessed by SEM micrographs corroborates the foregoing observations and accounts for the significant improvement in physical properties of the blend vulcanizates, particularly in two‐stage vulcanization. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 86: 3286‐3299, 2002     

Liquid-Phase Catalytic Hydroxylation of Phenol Using Cu(II), Ni(II) and Zn(II) Complexes of Amidate Ligand Encapsulated in Zeolite-Y as Catalysts

Copper(II), nickel(II) and zinc(II) complexes of amidate ligand 1,2-bis(2-hydroxybenzamido)ethane(H₂hybe) encapsulated in the super cages of zeolite-Y have been prepared and characterized by spectroscopic studies and thermal as well as X-ray diffraction (XRD) patterns. These complexes catalyze the liquid-phase hydroxylation of phenol with H₂O₂ to catechol as a major product and hydroquinone as a minor product. Considering the concentration of substrate and oxidant, amount of catalyst, temperature of the reaction and volume of solvent, a best-suited reaction condition has been optimized to get maximum hydroxylation. Under the optimized reaction conditions, [Cu(hybe)]-Y has shown the highest conversion of 40% after 6h, which is followed by [Ni(hybe)]-Y with 37% conversion and [Zn(hybe)]-Y has shown the poorest performance with 33% conversion. All these catalysts are more selective towards catechol formation (90%), irrespective of their catalytic performance.     

Early detection of heart diseases using a low-cost compact ECG sensor

Multimedia Tools and Applications - Heart disease patients are continuously increasing. The patients face the problem of a delayed diagnosis as the subjects do not undergo routine tests and consult...