Containerless solidification of highly undercooled mullite melts: Crystal growth behavior and microstructure formation

A mullite (3Al₂O₃·2SiO₂) sample has been levitated and undercooled in an aero-acoustic levitator, so as to investigate the solidification behavior in a containerless condition. Crystal-growth velocities are measured as a function of melt undercoolings, which increase slowly with melt undercoolings up to 380 K and then increase quickly when undercoolings exceed 400 K. In order to elucidate the crystal growth and solidification behavior, the relationship of melt viscosities as a function of melt undercoolings is established on the basis of the fact that molten mullite melts are fragile, from which the atomic diffusivity is calculated via the Einstein-Stokes equation. The interface kinetics is analyzed when considering atomic diffusivities. The crystal-growth velocity vs melt undercooling is calculated based on the classical rate theory. Interestingly, two different microstructures are observed; one exhibits a straight, faceted rod without any branching with melt undercoolings up to 400 K, and the other is a feathery faceted dendrite when undercoolings exceed 400 K. The formation of these morphologies is discussed, taking into account the contributions of constitutional and kinetic undercoolings at different bulk undercoolings.     

Preparation of SiC particles coated with alumina hydrate: Effect of reaction condition on particle coalescence

Alumina-hydrate-coated SiC particles were prepared via a homogeneous precipitation method using urea, and the conditions for uniform coating and less coalescence of the particles were investigated. Coalescence of coated particles could be said to occur by collision and agglomeration followed by deposition of alumina hydrate on the agglomerated particles. Coalescence of coated particles was suppressed by use of low reaction temperature, low concentration of aluminium sulfate, high concentration of urea, intensive stirring, and a flow reactor.     

Tunable laser for sensing atmospheric transmission in the infrared region of 11 ∼ 16 µm

We succeeded in observing the continuously tunable, pulsed InSb SFR (Spin-Flip Raman) laser emission in the infrared region of 11～16µm (11.4～16.3µm) from only one InSb device, merely by adjusting the pumping wavelength (11 lines from the infrared NH₃ laser) and the applied magnetic field (0～80 kGauss).     

Permeation of Zidovudine and Probenecid from Oily Bases Containing Alcohols Through Rat Skin

Permeation of zidovudine (3'-azido-3'-deoxythymidine, AZT) and probenecid from oily bases containing an alcohol through rat skin was examined. Isopropyl myristate (IPM), as an oily vehicle, showed a penetration enhancing effect for AZT and probenecid. Ethanol, n-propanol, and n-butanol were used as additives in IPM and were examined for their own permeation and the enhancing effect on the permeation of AZT and probenecid. The skin permeation of AZT and probenecid from IPM was enhanced by addition of the alcohol in IPM. The degree of the enhancement was decreased with increasing lipophilicity of the alcohol used. me permeation rate of the drug from those systems was shown to be governed by penetration-enhancing effects of the oily base and alcohol, and the penetration of the alcohol itself through the skin.     

An investigation of water-gas transport processes in the gas-diffusion-layer of a PEM fuel cell by a multiphase multiple-relaxation-time lattice Boltzmann model

In order to study water-gas transport processes in the gas-diffusion-layer (GDL) of a proton exchange membrane (PEM) fuel cell system, a multiphase, multiple-relaxation-time lattice Boltzmann model is presented in this work. The model is based on the mean-field diffuse interface theory and can handle the multiphase flows with large density ratios and various viscosities. By using the standard bounce back boundary condition and an approximate average scheme for the non-slip and wetting boundary walls, respectively, detailed liquid-gas transportation in the GDL, in which exact boundary condition is difficult to be implemented, can be simulated. Unlike most of lattice Boltzmann methods based on the Bhatnagar–Gross–Krook collision operator, the present model shows a viscosity-independent velocity field, which is very important in simulating multiphase flows where various viscosities coexist. We validate our model by simulating a static droplet on a wetting wall and compare with theoretical predictions. Then, we simulate a water-gas flow in the GDL of a PEM fuel cell and investigate the saturation-dependent transport properties under different conditions. The results are shown to be qualitatively consistent with the previous numerical and theoretical works.     

Improved performance of subcarrier multiplexed multichannel AM-VSBvideo signal transmission using Pr3+-doped fluoride fibreamplifier

The performance of 40 channel AM-VSB video signal transmission using a Pr³⁺-doped fluoride fibre amplifier (PDFA) was examined. The PDFA improves the loss budget by 10 dB for 52 dB CNR, and distortion levels almost satisfy the CATV trunk line specifications. The video quality degradation after PDFA amplification was `imperceptible' in subjective tests     

Safety evaluation on the depressurization accident in the gas turbine high temperature reactor (GTHTR300)

Japan Atomic Energy Agency has been developing a gas turbine high temperature reactor (GTHTR300) with electric power of approximately 300 MW. One of the unique safety design concepts of this system is that events with frequency of occurrence of higher than 10⁻⁸/reactor-year are evaluated as design basis events in order to show that the frequency of large amount of FP release is less than 10⁻⁸/reactor-year. According to this concept, a depressurization accident by a large break of helium piping is postulated as a design basis event. This accident is one of the most serious accidents in the high-temperature gas-cooled reactors from the viewpoint of loss of coolability. The safety evaluation on the accident was conducted based on the actual design of the system. The short-term and long-term behaviors of fuel temperature after occurrence of the accident, internal pressure of the reactor building, oxidation behavior of fuels and graphite structures were evaluated and exposure dose of general public was also estimated using the results of evaluation of fuel temperature and fuel failure by oxidation. All of the evaluation results meet the safety criteria and feasibility of the GTHTR300 was shown by this study.     

Thermal Transformation of Ring-Opened [2 2] C60 Dimer into a Wide-Bridged C120 Isomer. A Computational Evaluation of Fulvalene-Naphthalene Rearrangements

As a continuation of the studies on thermal transformation of the [2+2] C₆₀ dimer (1), the consequence of the pyracylene-rearrangement-like valence isomerization of the fulvalene partial structure at the bridge of the ring-opened product from 1, namely 2, was searched by dynamic reaction coordinate /AM1 semiempirical MO calculations. It is predicted that the fulvalene bridge of 2 rearranges into naphthalene partial structure by the concerted 'in-plane' mechanism to give a wide-bridged C₁₂₀ intermediate having twenty five-membered rings and two ten-membered rings (3). The computed energy of activation (145 kcal/mol) is 40 kcal/mol lower than those computed for pyracylene rearrangements. In contrast, the recently reported analogous rearrangement of indigo (13) to dibenzonaphthyridindione (14) is computed to occur by the stepwise 'sp³' mechanism.     

Theory and characteristics of novel variable reluctance 1X resolver

Although brushless resolvers have been used widely as angular position transducers, they are expensive due to their intricate construction, involving a rotary transformer to supply the exciting coils wound on the rotor poles with the current. It is shown theoretically in this paper that the resolver without rotary transformer or brushes can be realized by simple construction, which consists of the stator core with both 4-poles exciting windings and 2-poles output ones and the rotor core carrying no windings. In this resolver the rotor core has minimum gap at one side and a maximum gap at another side of the diameter. It is characterized by an outer surface form that makes the fluctuation part of gap permeance very in proportion to cos θ, where θ represents the angular position of a point in the air gap with respect to the origin on the rotor, the point of minimum air gap. The method determining the rotor form to embody the aforementioned gap permeance variation is also shown. It has been confirmed not only by simulation but also experiment that the 2-phase output voltages of a model designed based on the theory have sinusoidal waveforms with very small harmonic contents. Moreover, the rotor position detected by processing the output voltages through the conventional resolver/digital converter was within acceptable engineering accuracy.