Right atrial contractile performance in patients with myocardial infarction

To evaluate right atrial (RA) contractile performance in patients with myocardial infarction, we validated a cineangiographic method of RA volume measurement, and investigated RA volume change in 'normal' individuals and patients with a previous myocardial infarction. Sixteen silicone rubber RA casts made from human cadavers were filmed in the postero-anterior and left lateral projections. The cast volumes calculated following Simpson's rule were in good agreement with those measured by water replacement (r = 0.992, P < 0.01). At cardiac catheterization, biplane RA cineangiography was performed in 19 'normal' individuals (N group), in 14 patients with a previous antero-septal infarction (AMI group) and in seven patients with a previous inferior infarction (IMI group). The RA volume-time curve was constructed at 20-40 ms intervals for one cardiac cycle. RA volume at the beginning of the atrial contraction (RAVd), which was defined as the 'preload' of the RA, tended to be larger in both the AMI and IMI groups compared with 'normal' individuals. The RA ejection volume was significantly larger in both the AMI (18.4 +/- 2.1 ml.m-2, P < 0.01) and IMI groups (19.4 +/- 2.8, P < 0.01) than in the N group (14.5 +/- 1.9), even for a comparable level of RAVd (range from 26 to 36 ml.m-2) (18.6 +/- 2.1, P < 0.01, 18.2 +/- 2.0, P < 0.01, 14.7 +/- 1.9, respectively). These results suggest that RA contraction increases in patients with myocardial infarction by increasing both the 'preload' and 'contractility' of the RA.     

Forensic toxicological application of TOXI-LAB screening for biological specimens in autopsy cases and emergency cares

Using the TOXI-LAB drug detection system, emergency toxicological screening was performed in autopsy cases and emergency cares. In 280 autopsy cases (male 182 cases 65%, female 98 cases 35%), drug positive cases were 28 cases of male (15%) and 24 cases of female (24%). The age groups which showed higher rate of drug positive cases were 10s-40s in male (approximately 20%) and 20s in female (67%). In the 238 cases of emergency care (male 129 cases 54%, female 104 cases 44%, unknown 5 cases 2%), drugs were positive in 29 cases of male (22%) and 32 cases of female (30%). The age groups which showed relatively higher rate of drug positive cases were 40s in male (64%), 20s (71%) and 30s (89%) in female. Forty-four different kinds of drugs were detected in TOXI-LAB positive cases, in which the psychotropic drugs and the sedative-hypnotic drugs amounted to approximately 70%. Methamphetamine and amphetamine, which were the main abused drugs showing a socially important problem, were detected in total 15 cases. TOXI-LAB was based on thin-layer chromatography (TLC); however, from the extraction to development, coloration and detection have been accelerated (about 50 min) and simplified. In order to perform the forensic toxicological practice in Japan, it becomes more useful that TOXI-LAB is used in autopsy cases and emergency cares, if the drugs, which have caused poisoning cares in Japan, are added to TOXI-LAB. The present study describes the advantage and problem of TOXI-LAB drug detection system through demonstrating the practical cases of autopsy cases and emergency cares.     

Correlates and prognosis in relation to intellectual dysfunction in a community-residing elderly population

To estimate the risk factors for intellectual dysfunction and examine its prognosis in a community-residing (non-institutionalized) elderly population, a randomly selected sample of 1,473 elderly people aged 65 years and over living in S city, Osaka Prefecture, was studied in October 1992, and data were obtained from 1,383, a response rate of 93.9%. A cohort of 1,383 was followed for 42 months and follow-up was completed for 1,300 (94.0%). The main results were as follows: 1) The prevalence of intellectual dysfunction did not differ significantly between sexes, and there was an increasing prevalence of intellectual dysfunction with age in both sexes. The prevalence of severe intellectual dysfunction was found to increase highly at age 85 and over. 2) By univariate analysis, odds ratios for age older than 75 years, low Activities of Daily Living (ADL), urinary and fecal incontinence, and no participation in social activities were significantly higher than 1 in any level of mild, moderate, and severe intellectual dysfunction. In the multivariate analysis using logistic regression, age older than 75 years and urinary and fecal incontinence showed significant higher odds ratios than 1 for severe intellectual dysfunction, and low ADL and treatment for hypertension also showed significant higher odds ratios than 1 for moderate intellectual dysfunction. 3) From analysis using the Kaplan-Meier method, the cumulative survival rates decreased with a decline in intellectual functioning in both age groups of 65-74 and 75 years and older. 4) Application of the Cox proportional hazards model resulted in adjusted hazard ratio for severe intellectual dysfunction of 1.79 (95% confidence interval, 1.02-3.12), controlling for other factors such as sex, age, general health status, incontinence and social activities.     

Mutations in the N-terminal globular domain of the type X collagen gene (COL10A1) in patients with Schmid metaphyseal chondrodysplasia

STATEMENT OF PROBLEM: Improved dental stone has been widely used for producing dies for the fabrication of restorations with the lost-wax technique. Improved dental stone is used for several reasons, but it is selected most often because of its reasonable cost, ease of use, and ability to produce consistent results. PURPOSE: This study evaluated the ability of an epoxy resin die material and a type IV dental stone to dimensionally reproduce a custom-fabricated metal die. MATERIAL AND METHODS: Dies were fabricated and measurements were made from three reference lines. Measurements were repeated three times for the master die and for the specimen dies. A mean measurement and percent relative change for each dimension was calculated. RESULTS: A significant difference in the relative change for die height was found between the groups studied (p < 0.003). CONCLUSIONS: This epoxy die system will provide a degree of dimensional accuracy comparable to gypsum when used with addition silicone impression material.     

Adsorption of urea,creatinine, and uric acid from three solution types using spherical activated carbon and its recyclability

In this paper, we propose that the urinary toxins from the wastewater be adsorbed on an adsorbent such as spherical activated carbon and the latter be regenerated by subjecting it to high temperatures to recycle activated carbon and also to recycle the water used in dialysis. We studied the adsorption of artificial waste dialysate, which is a mixed solution of urea, creatinine, and uric acid, and the separate solutions for each of these and found that their extents of adsorption onto the spherical activated carbon material were nearly identical. The amount of adsorption was approximately 1.4 mg·g^-1 for urea, 18 mg·g^-1 for creatinine, and 20 mg·g^-1 for uric acid. The urea, creatinine, and uric acid adsorbed onto the spherical activated carbon decomposed on heat treatment at 500℃, and the adsorption capacity of the spherical activated carbon was regenerated. Our study successfully demonstrated that the spherical activated carbon can be recycled in the waste dialysate treatment process.     

Influence of ammonium salt on electrowinning of copper from ammoniacal alkaline solutions

In order to develop an energy-saving copper recycling process from wastes, electrochemical measurements were conducted in ammoniacal alkaline solutions containing Cu(I) ions and an ammonium salt of sulfate, chloride or nitrate. The results of each system were then compared. The polarization measurements suggested that the voltage required for the electrode process is lower in the chloride and nitrate systems than that in the sulfate system. The cathode current efficiency during the copper electrodeposition varied from 39 to 97% and increased with current density in the chloride and sulfate systems. In the nitrate system, the lowest cathode current efficiency of 30% was observed because of nitrate ion reduction. Based on these results, the power consumption required for the electrowinning stage of the copper recycling process was calculated. Among these three systems, the chloride system showed the lowest power consumption of 500 kWh t⁻¹ at the current density of 200 A m⁻², which is about 25% of the conventional copper electrowinning process from a copper sulfate-sulfuric acid solution.     

Conformational studies of poly(N-methyl-l-alanine) by n.m.r. spectroscopy

Nuclear magnetic resonance (n.m.r.) and circular dichroism of $\text{poly}\text{(N-}\text{methyl-}\text{l}\text{-alanine}\text{)}$ in methylene $\text{chloride}\text{-d}{}_2\text{dichloroacetic acid}$ were investigated. In methylene chloride-d₂$\text{poly}\text{(N-}\text{methyl-}\text{l}\text{-alanine}\text{)}$ was found to consist of nearly all-trans amide bonds and assume a stable secondary structure. Trace amounts of cis amide bonds were also present. The addition of dichloroacetic acid destroyed the secondary structure and induced a drastic change of the n.m.r. spectrum, which was similar to that observed with the monomeric amide, $\text{N-}\text{acetyl}\text{-N-}\text{methyl-}\text{l}\text{-alanine}$ dimethylamide. In comparison of the polymer with the monomeric amide, it was concluded that the transition of $\text{poly}\text{(N-}\text{methyl-}\text{l}\text{-alanine}\text{)}$ was caused by the isomerization of amide bonds. The complex n.m.r. spectrum was interpreted in terms of the distribution along the polymer chain of various non-planar amide links as well as planar cis and trans amide links. The difference of the mechanism of conformational transition between poly(amino acid) and poly(imino acid) is also discussed.     

High‐resolution technology for FPD manufacturing

Using shorter wavelength for exposure light is one way to achieve high resolution while keeping sufficient depth of focus. We show exposure results for high resolution to confirm the effect of deep UV exposure light. With deep UV light, 1.2‐µm line and space pattern and 1.8‐µm contact hole pattern are resolved while keeping sufficient depth of focus.     

Discussions of worker ants’ rule-based CHC dealing with changing environments

Contrary to popular belief, biologists discovered that worker ants are really not all hardworking. It has been found that in three separate 30-strong colonies of black Japanese ants (Myrmecina nipponica), about 20% of worker ants are diligent, 60% are ordinary, and 20% are lazy. That is called 20:60:20 rule. Though they are lazy, biologists suggested that lazy worker ants could be contributing something to the colony that is yet to be determined. In our last research, we used CHC (cross generational elitist selection, heterogeneous recombination, and cataclysmic mutation) with the worker ants’ rule (WACHC) aiming at solving optimization problems in changing environments. CHC is a nontraditional genetic algorithm (GA) which combines a conservative selection strategy that always preserves the best individuals found so far with a radical (highly disruptive) recombination operator. In our last research, we verified that WACHC performs better than CHC in only one case of fully changing environment. In this paper, we further discuss our proposed WACHC dealing with changing environment problems with varying degree of difficulty, compare our proposal with hypermutation GA which is also proposed for dealing with changing environment problems, and discuss the difference between our proposal and ant colony optimization algorithms.