Anti beta 2glycoprotein I antibodies and lupus anticoagulant in patients with recurrent pregnancy loss: prevalence and clinical significance

Over 2000 electrocution deaths were identified among U.S. construction workers from 1980 to 1991, with the highest mean annual crude mortality rate (2.5 per 100,000 people), and second highest mean age-adjusted rate (2.7 per 100,000 people) of all industries. Although the crude fatality rates showed a downward trend, construction workers are still about four times more likely to be electrocuted at work than are workers in all industries combined. Nearly 40% of the 5083 fatal electrocutions in all industries combined occurred in construction, and 80% were associated with industrial wiring, appliances, and transmission lines. Electrocutions ranked as the second leading cause of death among construction workers, accounting for an average of 15% of traumatic deaths in the industry from 1980 to 1991. The study indicates that the workers most at risk of electrical injury are male, young, nonwhite, and electricians, structural metal workers, and laborers. The most likely time of injury is 11 a.m. to 3 p.m. from June to August. Focusing prevention on these populations and characteristics through better methods of worker and supervisor electrical safety training, use of adequate protective clothing, and compliance with established procedures could minimize the average annual loss of 168 U.S. construction workers.     

A sensorless brushless dc motor system

This paper describes a brushless dc motor system without position or speed sensor. The brushless motor consists of a permanent magnet synchronous motor and a voltage-source inverter capable of controlling the amplitude and frequency of voltage. The rectangular-shaped stator current with a conducting interval of 120° (electrical) is controlled to be in phase with the trapezoidal back electromotive force. This results in producing maximum torque. Variable speed is achieved by adjusting the average motor voltage similarly to chopper control of dc motors. In this paper, two sensorless position detecting methods, i.e., an “indirect method” suited for the lower-speed range and a “direct method” suited for the higher-speed range are proposed. The combination of the two makes it possible to detect the rotor position over a wide-speed range. Furthermore, a speed-sen-sorless PLL control is proposed in applying the principle of the direct method. Experimental results obtained from a prototype brushless dc motor are shown to confirm the validity of the sensorless drive. The starting procedure of the motor also is discussed because it is impossible to detect the rotor position at a standstill.     

Interplay of YBCO and Embedded 211 Particles in Melt-Textured YBCO Superconductors

Local orientations of superconducting YBa₂Cu₃O _x (123) and embedded Y₂BaCuO₅ (211) particles within bulk, melt-textured 123 samples are studied on a local scale by means of electron backscatter diffraction (EBSD). The embedded Y₂BaCuO₅ (211) particles do not show any preferred texture, but their presence within the 123-matrix alters the growth of the 123-phase, independent of the orientation. EBSD enables to analyse the interactions between the 123- and 211-phases in detail.     

Correlations Among Maximum Likelihood and Weighted/Unweighted Least Squares Estimators in Factor Analysis

The asymptotic correlations among maximum likelihood (ML) and various least squares (LS) estimators in factor analysis are derived. The LS estimators include the unweighted (ULS) and weighted estimators for unstandardized variables and the ULS estimators for standardized variables. The derived formulas cover the cases with restrictions on parameters. Numerical examples with simulations are provided to confirm the accuracy of the formulas and the influence of scales on the asymptotic correlations.

     

Synthesis of polyethylene oxide end‐capped with perfluoroalkyl groups/polystyrene prototype brushes

Polystyrene (PS)/poly(ethylene oxide) (PEO) prototype brushes were prepared by alternating free‐radical copolymerization of methacryloyl‐terminated PS and α‐vinylbenzyl‐ω‐hydroxy or α‐vinylbenzyl‐ω‐perfluoroalkyl (R_f) PEO macromonomers with the addition of Lewis acid (SnCl₄). It was found from their dilute‐solution properties that PS/PEO end‐capped with R_f (PBR_f), and PS/PEO having OH groups at terminal ends (PBOH) prototype brushes formed a single molecule in benzene and aggregates in chloroform, respectively. However, the brush PBOH formed a single molecule in N,N‐dimethylformamide. Such aggregation behaviors seemed to be caused by the interaction between hydroxy groups of PEO chain ends. The brush PBOH was also converted into PBR_f‐type brush by chemical modification, using corresponding acid chloride. The substitution of R_f groups was ～70% due to slipping of terminal hydroxy groups into PEO internal domains. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 772–778, 2006     

Capacitance behavior of activated carbon fibers with oxygen-plasma treatment

Modified activated carbon fibers (ACFs) were used as the electrodes of an electric double-layer capacitor and showed an enhanced capacitance effect after a RF-plasma treatment. The capacitance and the surface functional groups of the ACFs were studied. For the plasma-treated ACFs having a specific surface area of 1500 m² g⁻¹, the capacitance increased by 28% compared to the untreated sample and the highest electric capacitance value of 142 F g⁻¹ was achieved with an oxygen feed concentration of 10 vol.%. The Brunauer-Emmett-Teller (BET) surface area was 2103 m² g⁻¹, which was 34% higher than that of the untreated sample. The pore volume was similarly increased to 483.1 cm³ g⁻¹ STP, and from the pore distribution plot, quantities of mesopores of 10 nm or less and micropores also increased. However, in order to enhance the capacitance, the quinone functional group had a significant influence in addition to the BET surface area. The correlation between the capacitance and the number of quinone functional groups was confirmed because quinone is an electron acceptor.     

Lysozyme requires fluctuation of the active site for the manifestation of activity

Mutations around His15 which lie far away from the active site,stimulated glycol chitin activity of lysozyme at physiologicaltemperature. Del-Argl4Hisl5 lysozyme, a mutant lysozyme whoseArgl4 and Hisl5 were deleted together, and has the highest activityamong these mutant lysozymes, had a similar binding abilityto a trimer of N-acetyl-glucosamine, a substrate analogue, relativeto native lysozyme. This suggests that the increased activitywas due to an increased k_cat in the catalysis reaction. TheH-D exchange rate of the N-1 proton in the Trp63 which is locatedin the active site cleft, was enhanced in the Del-Argl4Hisl5lysozyme, while 2-D proton NMR analysis revealed no conformationalchange around Trp63. We conclude that some sort of fluctuationat the active site might be required for the manifestation ofactivity. This theory is supported by the finding that the Del-Argl4Hisl5lysozyme showed a shift in temperature dependency of activityto lower temperatures compared with that of native lysozyme.     

Larval osmeterial secretions of the swallowtails (Papilio)

The larval osmeterial secretions of sixPapilio species examined displayed a remarkable qualitative change at the fourth larval ecdysis. The secretions of 4th (penultimate) instar larvae ofP. machaon, P. memnon, P. helenus, P. bianor, andP. maackii principally comprised mono- and/or sesquiterpenoids. The compounds identified from these species included -pinene, sabinene, -myrcene, limonene, -phellandrene, (Z)--ocimene, (E)--ocimene, -elemene, -caryophyllene, (E)--farnesene, -selinene, (E,E)--farnesene, germacrene-A, germacrene-B, caryophyllene oxide, methyl 3-hydroxy-n-butyrate, and acetic acid. In contrast, the secretion of 4th larval instar ofP. xuthus, although containing similar terpenic compounds, was accompanied by large amounts of aliphatic acids and their esters: isobutyric acid, 2-methylbutyric acid, methyl isobutyrate and methyl 2-methylbutyrate. On the other hand, the osmeterial secretions of 5th (last) instar larvae varied little in quality among the six species, and the identified compounds consisted of isobutyric acid, 2-methylbutyric acid, methyl isobutyrate, ethyl isobutyrate, methyl 2-methylbutyrate, ethyl 2-methylbutyrate, and isovaleric acid, the last of which was specific toP. bianor andP. maackii. The chemical alteration of osmeterial exudate synchronized at the final larval ecdysis with the larval morphological change (particularly in body coloration) that appears to be of defensive significance against predators.