A pre-heating vaporization technology of coal-water-slurry for the gasification process

A pre-heating vaporization technology of coal water slurry, CWS, was developed to increase the efficiency of coal gasification with the reduction of oxygen consumption. A CWS pre-heating experimental unit having a capacity of 2.0 tons-coal/day was manufactured. After the CWS was heated to 573 K at about 10 MPa, water in CWS was continuously vaporized in a tube of which the diameter increased gradually (2–10 mm I.D.), and dry coal particles with steam were atomized and fed to a vessel. No aggregation of coal particles was observed in the atomized samples. The temperature and the pressure distributions of the fluid were calculated with empirical heat transfer and pressure drop correlations. The calculated results well corresponded to the experimental data measured in some test points. Using the calculation model, a large scale apparatus of 100 tons-coal/day was designed using KNO₃ + NaNO₂ + NaNO₃ molten salt as a heating medium.     

Soft magnetic properties of NiFeTa thin films for biasing film applications in magnetoresistive elements

The effects of Ta addition on the magnetic properties of permalloy thin films have been investigated. The alloy compositions on a weight basis are (Ni₈₁Fe₁₉)_1-x Ta _x with 0 x 0.105, and the films are sputtered onto a glass substrate at between room temperature and 300 C. The saturation magnetization and anisotropic magnetic field decrease with increasing Ta content. The saturation magnetization is 0.75 T at 5 wt % Ta. The coercivity remains constant at 125 Am^-1. The electrical resistivity increases linearly with increasing Ta content, then saturates at approximately 7.5 wt% Ta. The saturation resistivity is approximately 1.00 m. The magnetoresistivity ratio (/) decreases with increasing Ta content, mainly due to increased electrical resistivity (). The magnetostriction changes from negative to positive with increasing Ta content and reaches nearly zero at 2 wt% Ta. The NiFeTa films containing 5–6 wt% Ta have potential for use as the soft-biasing film in magnetoresistive elements.     

Defect distribution near abraded surface of III–V compound semiconductors

Microstructures of damaged layers near the abraded surface of GaP, GaAs_0.6P_0.4 and GaAs single crystals have been observed with a transmission electron microscope. The damage due to 0.3 m Al₂O₃ abrasion consists of dislocations. Dislocation densities in the abrasion band and other regions are larger than 5×10¹¹ cm^–2 and about 10¹¹ cm^–2, respectively. Dislocation density decreases with increasing distance (depth) from the abraded surface. The depths of the damage layers for GaP, GaAs_0.6P_0.4 and GaAs are about 0.4, 0.55, and 0.8 m, respectively. The Burgers vector of dislocations is a/2[1 1 0], and A and B dislocations are observed. During annealing, the dislocations are rearranged and eliminated by the reaction of the dislocations with different Burgers vectors and climbing motion. The rearrangement temperatures for dislocations in GaP and GaAs are about 500 and 450° C, respectively. Electrical resistance changes in the damaged layer of GaP are recognized by electrical resistance measurements.     

Highly specific enzyme immunoassay for human chorionic gonadotropin

A highly specific enzyme immunoassay for determining hCG was established by using beta-D-galactosidase as label. In order to increase the specificity of the assay, an antiserum against whole hCG was purified on a column of hCG beta carboxyl-terminal peptide (residues 123-145) covalently linked to Sepharose 4B. The antibody (N101S) thus prepared showed a weak cross-reactivity with human LH in an assay using hCG-enzyme conjugate, but the slight cross-reactivity was virtually avoided when an hCG beta carboxyl-terminal peptide was used as a peptide in the enzyme conjugate. N101S antibody was compared with antiserum (B1B) directed against a carboxyl-terminal peptide (123-145). In hCG measurement N101S gave about 30 times higher sensitivity than B1B, although the former antibody was less sensitive to carboxyl-terminal peptides of hCG beta. The enzyme immunoassay using a combination of N101S antibody and a carboxyl-terminal peptide (130-145)-enzyme conjugate was able to detect as little as 0.25 mIU of hCG without the interference of LH. The performance and validity of this assay were comparable to those of conventional radioimmunoassay.     

Elasto-plastic analysis of orthogonally stiffened plates with initial imperfections under uniaxial compression

In general, the stiffened plates consisting of steel plate elements are unavoidably accompanied by initial imperfections such as residual stresses and initial deflections, which have considerable effects on their ultimate strength. Therefore, it is needed for designing them to develop more rational method taking the ultimate strength influenced by initial imperfections into account rather than the conventional design method being on the basis of the linear elastic buckling theory.From this point of view, this study aims to evaluate rigorously the ultimate strength of orthogonally stiffened plate with initial imperfections under uniaxial in-plane compression. The elasto-plastic finite element method is applied to attain this purpose. By a happy combination of modal analytical technique and conventional finite element method, much reduction of the degree of freedom can be expected to be realized herewith. Some numerical calculations are performed by means of this rigorous method to examine the exactness of the analysis. Moreover, the numerical results are compared with the experimental ones.     

Detection of back-side pit on a ferrous plate by magnetic flux leakage method with analyzing magnetic field vector

We have developed a magnetic flux leakage (MFL) system using magnetic resistive (MR) sensors for detecting two dimensional magnetic field components, and an induction coil that generates low magnetic field strengths and extremely low frequencies. The signal at each scanned measurement point (i) was divided by the signal strength M_mes,i and phase α_i by a lock-in amplifier. Using the strength M_mes,i and phase α_i, we calculated the imaginary part of the signal using the common phase β. By optimization of the common phase β to the imaginary part, the analyzed scanning data curve was shown to be effective in estimating the size (depth and diameter) of back-side pits on a ferrous plate. Comparing the two dimensional magnetic field components of leakage, the imaginary part of the y-component parallel to the induced magnetic field was found to be suitable for detecting the back-side pits.     

Growth of Lactobacillus bulgaricus in milk. 2. Characteristics of purine nucleotides, pyrimidine nucleotides, and nucleic acid synthesis

Lactobacillus bulgaricus incorporated exogenous guanine only into guanine nucleotides and not into adenine nucleotides. Lactobacillus bulgaricus lacks the ability to interconvert adenine nucleotides and guanine nucleotides. Biosynthesis of pyrimidine nucleotides from orotic acid was depressed by addition of guanosine monophosphate or adenosine monophosphate. Some step in pyrimidine biosynthesis from orotic acid may be negatively regulated by the intracellular amount of purine nucleotides. Lactobacillus bulgaricus could not grow in milk from which orotate was removed. This indicates that the activity of de novo pyrimidine synthesis is very low in this organism. When the intracellular amount of purine or pyrimidine base was limited, ribonucleic acid synthesis was markedly depressed, resulting in cell elongation, whereas deoxyribonucleic acid synthesis was not so much affected.     

Difference in the detection limits of flaws in the depths of multi-layered and continuous aluminum plates using low-frequency eddy current testing

We examined the difference in the detection limits of flaws in the depths of multi-layered and continuous aluminum plates using low-frequency eddy current testing. The detection limits were measured by using a magneto-resistive sensor. Comparing the frequency of an applied magnetic field, the detection limit at 50 Hz is deeper than that at 1 kHz. Comparing the sample structure, the detection limit in the multi-layered samples is deeper than that in the continuous samples. These results are likely due to the differences in the skin depth and conductivity of the sample.     

Approximate method of estimating seismic performance of high‐rise buildings with oil‐dampers

When subjected to long‐period ground motions, many existing high‐rise buildings constructed on plains with soft, deep sediment layers experience severe lateral deflection, caused by the resonance between the long‐period natural frequency of the building and the long‐period ground motions, even if they are far from the epicenter. This was the case for a number of buildings in Tokyo, Nagoya, and Osaka affected by the ground motions produced by the 2011 off the Pacific coast of Tohoku earthquake in Japan. Oil‐dampers are commonly used to improve the seismic performance of existing high‐rise buildings subjected to long‐period ground motion. This paper proposes a simple but accurate analytical method of predicting the seismic performance of high‐rise buildings retrofitted with oil‐dampers installed inside and/or outside of the frames. The method extends the authors' previous one‐dimensional theory to a more general method that is applicable to buildings with internal and external oil‐dampers installed in an arbitrary story. The accuracy of the proposed method is demonstrated through numerical calculations using a model of a high‐rise building with and without internal and external oil‐dampers. The proposed method is effective in the preliminary stages of improving the seismic performance of high‐rise buildings.     

Supercritical CO2 extraction of pigment components with pharmaceutical importance from Chlorella vulgaris

BACKGROUND: Chlorella vulgaris is a green microalgae that contains various pigment components of carotenoids and chlorophylls. Supercritical CO₂ is widely used for extraction of pharmaceutical compounds because it is non‐oxic and easily separated from extracted material by simply depressurizing. In this work, pharmaceutical compounds from Chlorella vulgaris have been extracted using supercritical CO₂ with or without entrainer at various extraction conditions. RESULTS: Based on high performance liquid chromatography (HPLC) analysis, the extracts contained pigment components, such as lutein, β‐carotene, chlorophyll a and b. Higher extraction pressure and temperature promoted higher lutein extraction by supercritical CO₂. The optimum pressure and temperature for extraction were obtained as 50 MPa and 80 °C. Ethanol as an entrainer was more effective than acetone for the extraction of pigment components. Pigment components in the extract obtained by supercritical CO₂ with and without entrainer were compared with the extract obtained by a conventional extraction method. CONCLUSION: Supercritical CO₂ has been successfully applied for the extraction of pigment components from Chlorella vulgaris. Supercritical CO₂ enabled high selectivity for lutein extraction; however, the lutein yield was lower than that obtained by extraction using supercritical CO₂ with ethanol and soxhlet. Copyright © 2008 Society of Chemical Industry