Lattice Distortion Analysis Directly from High Resolution Transmission Electron Microscopy Images—the LADIA Program Package

Direct strain mapping from high resolution transmission electron microscopy images is possible for coherent structures.At proper imaging conditions the intensity peaks in the image have a constant spatial relationship with the projected atom columns.This allows the determination of the geometry of the projected unit cell without comparison with image simulations.The fast procedure is particularly suited for the analysis of large areas.The software package LADIA is written in the PV-WAVE code and provides all necessary tools for image processing and analysis.Image iintensity peaks are determined by a cross-correlation technique,which avoids problems from noise in the low spatial frequency renage.The lower limit of strain that can be detected at a sampling rate of 44 pixels/nm is ≈2%.     

Investigation of iron oxide reduction by TEM

An “environmental cell” located in a high voltage transmission electron microscope has been used to study the reduction of single crystal iron oxides by hydrogen and hydrogen-argon mixtures. The cell enables a direct observation of the solid during reaction, thus permitting the nucleation and growth of solid reaction products to be observed. Hematite was reduced at temperatures in the range 387 to 610°C with gas pressures up to 5.3 kP. Reduction with pure hydrogen was considerably faster than when argon was present. Lath magnetite which rapidly transforms to porous magnetite and thence (more slowly) to porous iron was observed. The reduction of magnetite and of wustite single crystals was observed in the temperature range 300 to 514°C using both hydrogen and hydrogen-argon mixtures at gas pressures up to 6.6 kP. Incubation periods were found for magnetite reduction; during these periods faceted pits formed in the oxide. Iron formed in the early stages was epitaxial with the host magnetite; at later stages the epitaxy was lost and fissures frequently formed in the metal. The morphology of the iron differed between the gas mixtures. Disproportionation accompanied the reduction of wustite, producing intermediate polycrystalline magnetite despite reducing conditions. The disproportionation appeared to be promoted by the reduction reaction. For both oxides, reduction in the hydrogen-argon mixture was slower than in pure hydrogen.     

Efficacy of morantel tartrate in a sustained release bolus on the control of subclinical gastrointestinal parasitism in first-year grazing dairy replacements

Thirty-four heifers (24 Holstein, 8 Ayrshire, 2 Jersey) and 12 Holstein steer calves were grouped into 23 blocks of 2 animals each according to breed, sex, and body weight. Animals in each block were randomly assigned to control or treated groups. The treated group received an anthelmintic bolus containing morantel tartrate before they were permitted access to pasture. A 2.6 ha pasture was divided in half with a double fence; the resulting two pastures had separate feed and water troughs. Steer calves were slaughtered upon termination of the trial to ascertain gastrointestinal parasite burdens. Two worm-free tracer calves were placed on each pasture every 2 mo and slaughtered after 4 wk of grazing to determine parasite infectivity of pastures. Herbage samples were obtained monthly and analyzed for infective larvae. The trial was conducted for 141 d during the grazing season. Treatment resulted in 90% reduction in infective larvae on pasture, 74% reduction in fecal worm-eggs, 91% reduction in adult worm burdens, and a trend toward reduced worm burdens in tracer calves by 52%. An overall average daily gain of .68 and .88 kg was obtained for control and treated animals. Reproductive data for the heifers remaining in the herd from the trial showed that treatment resulted in 44 less days to first breeding.     

The Determination of the Level of Bicarbonate, Carbonate, or Carbon Dioxide in Aqueous Solutions

A rapid and convenient method for the measurement of bicarbonate, carbonate, or carbon dioxide in water was developed using fourier transform infrared spectroscopy (FTIR). Bicarbonate and carbonate are converted to carbon dioxide by lowering the pH of the solution, then the absorbance of the dissolved carbon dioxide at 2345 wavenumbers is measured using a liquid sample cell. If the measurement of dissolved carbon dioxide is the objective, the pH is not adjusted, and the carbon dioxide in the free form can be measured without interference from low levels of carbonates. The method is linear from 10.48 ppm to a minimum of 366.8 ppm carbon dioxide (r squared = 0.9996). The coefficient of variation at 10.48 ppm (LOD 3 signal/noise), 52.4 ppm, and 262 ppm is 45.6, 4.0, and 3.9, respectively. The average percent recovery at 10.48 ppm, 52.4 ppm, and 262 ppm is 74.5, 104.2, and 104.0, respectively.     

Significance of serum beta-hCG as a tumor marker for stomach carcinoma

We performed BAEP study to evaluate acoustic nerve involvement in 102 patients affected by peripheral neuropathies of different etiology, predominantly hereditary and inflammatory acquired neuropathies. Prolonged latency of early waves, indicative of slowing in VIII nerve conduction, was found in a high percentage of cases. Abnormalities were far more frequent (44% vs 14%) and severe in patients with demyelinating rather than axonal neuropathy. Among demyelinating neuropathy, the most severe latency delay was found in Hereditary Motor and Sensory Neuropathy type III. The pattern of acoustic nerve involvement differed slightly between Hereditary Motor and Sensory Neuropathy type I and acquired inflammatory demyelinating polyradiculoneuropathy, perhaps reflecting different pathogenetic mechanisms and different sites of VIII nerve demyelination.     

Dyspnea resulting from phrenic nerve paralysis after interscalene brachial plexus block in an obese male--a case report

While current psychiatric taxonomies recognise a classification of amphetamine dependence, derived from the notion of an alcohol dependence syndrome, little research has validated that such a condition exists for this drug. Current amphetamine users (N = 331), were interviewed using the World Health Organization operationalisation of DSM-III-R substance dependence criteria, and a measure of the psychological components of dependence. Structural analyses indicated that a unidimensional dependence syndrome as assessed by DSM-III-R and DSM-IV criteria exists for amphetamine, and that physiological, psychological and behavioural indicators were all important in accounting for the variance in responses. It was demonstrated that the concept of a dependence syndrome is applicable to amphetamine, and that the inclusion of the amphetamine dependence syndrome in DSM-III-R and DSM-IV is valid.     

Kinetik der polykondensation von natriumsulfidhydrat und 1,4-dichlorbenzol zu poly(thio-1,4-phenylen)

The kinetics of the polycondensation of sodium sulfide hydrate and 1,4-dichlorobenzene to poly(thio-1,4-phenylene) in 1-methyl-2-pyrrolidone as solvent was studied in a differential scanning calorimeter at temperatures between 220 and 280°C. This polycondensation shows an autocatalytic behavior and the kinetics can be modelled by a first order reaction up to complete conversion. This is explained by the low solubility of sodium sulfide in l-methyl-2-pyrrolidone. The concentration of sodium sulfide is regarded as being constant during the whole course of the reaction. The autocatalytic effect can be explained by the increase of the condensation rate constant at the beginning of polycondensation due to the higher reactivity of the oligomers compared to the monomers. The number- and the weight-average molecular weight of the products formed during the course of the polycondensation can be modelled by means of stochastic methods. A simple model with only two different rate constants of the condensation process is assumed. The concentration of sodium sulfide in the reactive phase is found to be 2–5% of the value of dichlorobenzene at the beginning of the reaction and remains constant nearly until the end of polycondensation.     

A Study of Surface Deformation during Wire‐Rod Rolling of High Speed Steels using Experimental and Computational Techniques

The evolution of surface defects during shape rolling of high‐speed steel billets is studied using longitudinal surface defects prepared by machining and welding. The reduction of the defects during rolling in a production mill is compared to the total area reduction of the billets. Samples are collected after pass 4, 6, 8, 14, 19 and the final pass, 28, representing the finished 5.5mm wire. By inspecting the cross sections, the rotation of the billets from pass to pass is evaluated. Results from FE simulations on solid billets are compared to the experimental results. Generally, simulations predict less reduction than observed experimentally. In most cases cracks reduce most effectively followed by carbon steel welds and stainless steel welds.     

Reducing energy-related CO2 emissions using accelerated weathering of limestone

The use and impacts of accelerated weathering of limestone (AWL; reaction: CO₂+H₂O+CaCO₃→Ca²⁺+2(HCO₃⁻) is explored as a CO₂ capture and sequestration method. It is shown that significant limestone resources are relatively close to a majority of CO₂-emitting power plants along the coastal US, a favored siting location for AWL. Waste fines, representing more than 20% of current US crushed limestone production (>10⁹ tonnes/yr), could provide an inexpensive or free source of AWL carbonate. With limestone transportation then as the dominant cost variable, CO₂ mitigation costs of $3-$4/tonne appear to be possible in certain locations. Perhaps 10–20% of US point–source CO₂ emissions could be mitigated in this fashion. It is experimentally shown that CO₂ sequestration rates of 10⁻⁶ to 10⁻⁵ moles/sec per m² of limestone surface area are achievable, with reaction densities on the order of 10⁻² tonnes CO₂ m⁻³day⁻¹, highly dependent on limestone particle size, solution turbulence and flow, and CO₂ concentration. Modeling shows that AWL would allow carbon storage in the ocean with significantly reduced impacts to seawater pH relative to direct CO₂ disposal into the atmosphere or sea. The addition of AWL-derived alkalinity to the ocean may itself be beneficial for marine biota.