Experimental Thermal Performance Characterization of Flat Grooved Heat Pipes

ABSTRACT

The thermal characterization of aluminum flat grooved heat pipes is performed experimentally for different groove dimensions. Three heat pipes with groove widths of 0.2?mm, 0.4?mm, and 1.5?mm are used in the experiments. The effect of the amount of the working fluid is extensively studied for each groove width. The results reveal that, although all three succeed in dissipating the heat input through the phase change of the working fluid by continuous evaporation and condensation, the effectiveness of the heat transfer increases with reduced groove width. Furthermore, it is observed that there exists an optimum operating point, where the temperature difference between the heating and cooling sections is at a minimum, and the magnitude of this temperature difference is a strong function of the groove width. To the best of the authors’ knowledge, the combined effects of groove dimensions and the amount of the working fluid, from fully flooded to dry, is reported for the first time for aluminum flat grooved heat pipes.     

3D Hair sketching for real-time dynamic & key frame animations

Physically based simulation of human hair is a well studied and well known problem. But the “pure” physically based representation of hair (and other animation elements) is not the only concern of the animators, who want to “control” the creation and animation phases of the content. This paper describes a sketch-based tool, with which a user can both create hair models with different styling parameters and produce animations of these created hair models using physically and key frame-based techniques. The model creation and animation production tasks are all performed with direct manipulation techniques in real-time.     

Beam test of the CsI(Tl) calorimeter for the BELLE detector at the KEK-B factory

We studied the performance of a prototype electromagnetic calorimeter for the BELLE detector at the KEK proton synchrotron for an energy range of 0.25–3.5 GeV. The prototype consisted of an array of 6 × 5 CsI(Tl) crystals with 30 cm length (16.2 radiation lengths) and about 6 cm × 6 cm cross section. The scintillation light of each CsI(Tl) crystal was read out by two large-area PIN photodiodes and charge-sensitive preamplifiers attached at the rear face of the crystal. We measured the energy and position resolution for electrons and the e/π separation for two sets of matrix configurations: one corresponded to the center and the other to the edge of the barrel calorimeter. The overall performance measured by the test proves that the prototype calorimeter is satisfactory for the use in the BELLE detector.     

Forecasting of Turkey's net electricity energy consumption on sectoral bases

In this study forecast of Turkey's net electricity energy consumption on sectoral basis until 2020 is explored. Artificial neural networks (ANN) is preferred as forecasting tool. The reasons behind choosing ANN are the ability of ANN to forecast future values of more than one variable at the same time and to model the nonlinear relation in the data structure. Founded forecast results by ANN are compared with official forecasts.     

Mesa-isolated GaAs Schottky-barrier photodiodes

The design, fabrication and characterisation of GaAs Schottky-barrier photodiodes with evaporated, free-standing-metal airbridges is reported. The photodiodes were fabricated using all dry-etching techniques. Anisotropic chemically assisted ion beam etching was used to etch vertical sidewall mesas, and isotropic reactive ion etching was used to etch a lateral tunnel. A free-standing-metal airbridge created by the lateral tunnel etch results in isolation of the active area at the same time providing free-standing-metal interconnection to the contact pad.<>