An important factor affecting synergism on coprocessing of Taiheiyo coal with Athabasca oil sand bitumen

A series of mixtures of Japanese subbituminous Taiheiyo coal and Athabasca oil sand bitumen (AOB) with various coal concentrations (0–100 wt%) was coprocessed in a 70 ml autoclave at 420°C for 1 h in the presence of H₂ (50 kg/cm² at room temperature) and sulfided Ni---Mo/Al₂O₂ catalyst. The mixture containing 2 wt% coal produced the largest amount of hexane soluble fraction (HS) and the smallest amount of benzene insoluble fraction (BI). Thus, a synergistic liquid production occurred for this mixture with 2 wt% coal by suppressing the retrogressive reactions which proceeded for pure AOB. The HS obtained from mixtures with 2–30 wt% showed higher H/C ratios and lower heteroatom contents than those obtained from pure AOB and the mixtures with more than 30 wt% coal. The amounts of transferable hydrogen contained in the mixtures were estimated using anthracene as a hydrogen acceptor. The mixtures with 2–10 wt% coal contained higher amounts of donor hydrogen than pure AOB. The HS yield from the various mixtures was correlated with the amount of donor hydrogens contained in the mixtures, except for the mixture with 10 wt% coal. Thus, the important factor which results in synergism is suggested to be the amount of donor hydrogens contained in the feed mixtures.     

Effect of the ACAT inhibitor, HL-004, on cholesterol metabolism in macrophages

The effects of a novel acyl-CoA: cholesterol acyltransferase (ACAT) inhibitor, HL-004, on cholesterol metabolism were examined in mice peritoneal macrophages. Cholesteryl ester-rich foam cells were induced by incubating macrophages with acetylated LDL. HL-004 prevented the accumulation of cholesteryl ester in the presence of the cholesterol acceptor, HDL. In the absence of HDL, HL-004 generated large amounts of free cholesterol in the cell. Moreover, HL-004 stimulated the efflux of cholesterol from preestablished foam cells in the presence of HDL. These results suggest that the inhibition of foam cell formation and the stimulation of foam cell regression by HL-004 are attributed to intracellular ACAT inhibition, and that HL-004 would be expected to exhibit an antiatherosclerotic effect through direct action on arterial wall.     

X-ray Photoelectron Spectroscopy Investigation on the Low-Temperature Degradation of 2 mol% Y2O3-ZrO2 Ceramics

2 mol% Y₂O₃-ZrO₂ polycrystals were annealed in water and under vacuum to highlight the effect of the presence of H₂O on the low-temperature degradation transformation. The specimen surfaces with monoclinic phases transformed during annealing in the different environments were analyzed by X-ray photoelectron spectroscopy with special interest on the electron binding energy change of the constituent ions of the 2 mol% Y₂O₃-ZrO₂ ceramics after the degradation transformation. It was found that no change occurred for the electron-bonding energies of core levels of zirconium ions after the transformation, whereas Y-OH bonds were formed during annealing in water. This result suggested a possibility that the preferred hydration of yttrium took place at the surface of Y₂O₃-partially-stabilized ZrO₂, which is likely to be the reason for the low-temperature degradation accelerated by the presence of H₂O.     

An image processing system using Image Signal Multiprocessors (ISMPs)

This paper describes an image processing system using Image Signal Multiprocessors (ISMPs) adapted to gray-level image preprocessing for image analysis and image enhancement. It is composed of four ISMPs, five 1H-delay-lines, two 512×512×8-bit frame memories, a video timing controller (VTC), two 256-word ×8-bit ×8-table Look Up Tables (LUTs) and 80 nsec/sampling A/D and D/A converters. This multiprocessor system performs convolution operations such as spatial filters, contrast enhancement, and binarization for gray-level images, thinning, thickening, pattern matching etc. for binary images, and image quality improvement for moving images such as T.V. images. Otherwise, it performs feature extraction operations such as area calculations, fillet coordination, and moment calculations for objective image data. Moreover, this system is capable of applying color image processing by using a multiboard system.     

An XPS study of passive films on Nickel and alloy 600 in acids

Compositions of surface films formed on nickel and Alloy 600 in I M HCI, 0.5 M H₂SO₄ and I/3 M H₃PO₁ solutions were investigated as a function of polarization potential. The main constituent of surface films formed on Ni in 0.5 M H₂SO₄ or 1/3 M H₃PO₄ solution was hydrated nickel oxyhydroxide, in which the ratio of O₂ to OH⁻ increased when passivation occurred. The surface films formed on Ni and Alloy 600 at lower potentials in 0.5 M H₂SO₄ solution contain S² ions other than SOP_4²⁻ ions, whereas S²⁻ ions were not incorporated in the passive film. Passivation of Alloy 600 took place by the formation of hydrated chromium oxyhydroxide. Pitting led to no substantial change in the average composition of the film.     

Importance of initial surface film in the degradation of stainless steels by atmospheric exposure

The surface compositions of stainless steels types 304, 316, 430, and 444 combined with four types of surface finishes, 2B finish, hairline polishing, mirror polishing, and bright annealing, were measured by ICP-AES, EPMA, and XPS before exposure. The surface finish that most enriched the chromic species in the surface film was mirror polishing, followed by bright annealing, 2B finish, and hairline polishing. The order of corrosion-resistance was type 444, type 316, type 304, and type 430. The surface compositions were correlated with the rating number and pitting depth after exposure to atmospheric environments. The rating number had a high positive correlation with the concentration of Cr in the surface film, and had a slight correlation with the near-surface composition measured by EPMA at 12 kV, but did not show any correlation with bulk composition within the composition range covered in the present work. This same trend was observed for pitting depth. It was concluded that the cationic concentration of Cr in the surface film before atmospheric exposure is the prime factor in controlling the resistance of stainless steels to atmospheric corrosion.     

Comparison of coal hydroliquefaction catalysed by ZnCl2-MCln (CuCl,CrCl3 and MoCl5) and ZnCl2 melts

Hydrogenation of four bituminous coals impregnated with 5 wt% of either mixtures of ZnCl₂-MCl_n (CuCl, CrCl₃ and MoCl₅) systems or ZnCl₂ was carried out using a batch autoclave system at 400° for 3 h at 9.8 MPa of initial hydrogen pressure. The ZnCl₂-MoCl₅ system showed the highest yield of the hexane-soluble (HS) fraction compared with the other systems irrespective of the coal used. The difference between the yields of HS fractions using the ZnCl₂-MoCl₅ and other systems was most marked for coals of fairly low volatile matter content, though the conversion was relatively low (47–66%), whilst for coals of high volatile matter content HS yields with the binary melt systems were high (86–91% conversion). Elemental analyses of the HS fractions indicated that the ZnCl₂-MoCl₅ system is most favourable in decreasing the average molecular weight and the heteroatom content of HS, this characteristic trend being confirmed also with five HS fractions separated by Chromatographic techniques. Both elemental analyses and molecular weights of asphaltene (benzene-soluble materials, BS) indicated that the ZnCl₂-MoCl₅ system is also most effective in cracking coal structure.     

The surface film formed on amorphous Pd-Ti-P alloy by anodic polarization in 2 m NaCl solution

X-ray photoelectron spectroscopy was used to investigate the effect of the composition and thickness of surface film on the electrocatalytic properties for chlorine gas evolution on amorphous Pd-Ti-P alloy in NaCl solution. The amount of charge for gas evolution exhibited a wavy change with an increase in polarization potential. The gas evolution became active with an increase in palladium content of the surface film and slowed down with increases of titanium and phosphorus contents of the film. However, despite the fact that the formation of surface film consisting mainly of titanium as a cation in the potential region higher than 1.6 V (sce), the catalytic activity for gas evolution increased, suggesting the change in the gas evolution mechanism in the higher potential region.     

Anodic characteristics of amorphorous palladium-base alloys in sodium chloride solutions

The anodic characteristics of a variety of amorphous palladium-base alloys were examined with a view to their use for the production of sodium hypochlorite by electrolysis of dilute sodium chloride solutions at ambient temperature. The corrosion resistance of palladium-metalloid alloys was obtained by alloying with platinum group metals and/or valve metals. Among these alloys, rhodium-containing alloys showed high electrocatalytic activities for chlorine evolution. Surface activation treatment was, however, necessary to obtain sufficiently high activities for chlorine evolution at low overpotentials. Surface-activated amorphous alloys possessed considerably higher current efficiency for chlorine evolution in comparison with currently used anodes.     

Structural study of hexane-soluble products from hydroliquefaction of three Yallourn brown coal lithotypes over molten salt catalysts

The hexane-soluble fractions of hydroliquefied products from three Yallourn brown coal lithotypes have been separated into five fractions by combined silica-alumina packed column chromatography. Analyses of various fractions by g.c.-m.s. permitted the identification of ≈50 components in the saturate fraction and 40 components in the diaromatic fraction, together with 30 components in the monoaromatics. The components identified were quite similar among hexane-soluble portions of all three lithotypes. A marked predominance of even carbon number alkane (C₂₃-C₂₉) was observed in the hydrocarbon fractions from pale lithotype over $\text{ZnCl}{}_2\text{KCl}$, and medium light lithotype over both pure ZnCl₂ and $\text{ZnCl}{}_2\text{KCl}$. However, medium dark lithotype over both melt catalysts produced a saturate fraction with an odd carbon number(C₂₂-C₂₈) preference. Based on spectral methods, Soxhlet extracts obtained from untreated lithotypes (hexane and benzene solubles) were characterized as complex mixtures of higher molecular weight(300–1000) aliphatic hydrocarbons, which were supposed to be a precursor of the saturates produced from the corresponding lithotype in the catalytic hydroliquefaction.