Some experimental findings in compression-after-impact (CAI) tests of CF/PEEK (APC-2) and conventional CF/epoxy flat plates

Compression-after-impact (CAI) tests have been conducted for quasi-isotropic thick plates with 48 plies by using the NASA method and on plates with 32 plies by using the SACMA method. Specimens are made of CF/PEEK (APC-2) and conventional CF/epoxy for the NASA plates and CF/epoxy for the SACMA plates. In the NASA CAI tests, the sequence of delamination buckling and its propagation is clearly revealed through various experimental techniques. One major technique is moiré topography, and the other is thermo-mechanical stress analysis with a high-accuracy infrared sensor. The arrest of delamination propagation just before catastrophic failure due to high fracture toughness is clearly captured by the moiré camera. This behavior provides good CAI values of CF/PEEK. The initial buckling properties of the delaminated region by the impact are then extensively discussed. Numerical predictions of initial buckling stress have been obtained by modelled geometry of the delaminated region simplified from its precise structure clarified by ultrasonic C-scanning. They agree fairly well with the experimental results. The in-plane stress distribution in the delaminated region before initial buckling is measured by an infrared stress graphic system. This compared favorably with finite element predictions. Two types of symmetric buckling modes with respect to the central plate surface, twin and single peak ones, are experimentally captured.     

Kinetics and mechanism of carbothermic reduction of magnesia

The reaction between MgO and graphite powders under flowing argon atmosphere was studied using a dynamic thermogravimetric method. In the temperature range 293 to 1973 K, the effects of compacting pressure, magnesia/carbon ratio, heating rate, Ar carrier-gas flow rate, and CO-partial pressure were investigated. An experimentally determined reaction mechanism was proposed and discussed. The reduction process could be divided into two stages. The first stage includes the direct reaction between MgO and graphite particles and partial gas-solid reaction at relatively low temperature (below 1750 K). The overall reaction rate depends on the solid phase-boundary reaction between magnesia and carbon particles. The second stage is the gas-solid reaction between CO and MgO, which determines the overall reaction rate. The apparent activation energies of the two stages were estimated to be 208.29 and 374.13 kJ/mol, respectively.     

Contributions of distinct prefrontal neuron classes in reward processing

The prefrontal cortex(PFC)is thought to be involved in higher order cognitive functions,such as in working memory,abstract categorization,and reward processing.It has been reported that two distinct neuron classes(putative pyramidal cells and interneurons)in the PFC played different functional roles in neural circuits involved in forming working memory and abstract categories.However,it remains elusive how the two types of neurons process reward information in the PFC.To investigate this issue,the activity of single neurons was extracellularly recorded in the PFC of the monkey performing a reward predicting task.PFC neurons were classified into putative pyramidal cells and interneurons,respectively,based on the waveforms of action potentials.Both the two types of neurons encoded reward information and discriminated two reward conditions(the preferred reward condition vs.the nonpreferred reward condition).However,the putative pyramidal neurons had better and more reliable discriminability than the putative interneurons.Also,the pyramidal cells represented reward information in the preferred reward condition,but not in the nonpreferred reward condition by raising their firing rates relative to the baseline rates.In contrast,the interneurons encoded reward information in the nonpreferred reward condition,but not in the preferred reward condition by inhibiting their discharge rates relative to the baseline rates.These results suggested that the putative pyramidal cells and interneurons had complementary functions in reward processing.These findings may help to clarify individual functions of each type of neurons in PFC neuronal circuits involved in reward processing.     

Effect of temperature on friction observed between a Si3N4 tip and a dodecanethiol self-assembled monolayer on Au(1 1 1)

Recent computational studies (Phys. Rev. Lett. 70 (1993) 1960; Phys. Rev. B 62 (2000) 17055) predicted that friction of ordered organic monolayer had characteristic dependence on temperature, where the maximum friction was observed around rotator transition point of the monolayer. This remained to be confirmed experimentally. Using a friction force microscope (FFM) combined with a temperature regulation module, we attempted to investigate such dependence on temperature (130 K-room temperature) on a self-assembled monolayer of dodecanethiol prepared on Au(1 1 1). The observed friction showed strong dependence on temperature and good agreement with the computational prediction.     

Conditional transformation of immunoglobulin mutation pattern from gene conversion into point mutation by controlling XRCC3 expression in the DT40 B cell line

A hypermutating B cell line DT40 is useful for screening antibodies and improving affinity of the selected antibodies in vitro. To perform affinity maturation efficiently, we generated an engineered DT40 line whose immunoglobulin mutation pattern can be transformed from gene conversion into point mutation by conditional suppression of XRCC3 expression.     

Reduction of Ripple Current Loss by Electromagnetic Coupling of Air‐Core Reactors

To reduce the loss due to ripple current in a multiphase current‐reversible chopper, we investigated electromagnetic coupling of an air‐core reactor. We derived the relationship between the amplitude of the ripple current, the duty factor, and the electromagnetic coupling coefficient, and used the results to estimate the effects of electromagnetic coupling in the design of a train energy storage system. We built reactors with electromagnetic coupling coefficients of 0.93 and 0.60. These reactors employed a new winding structure that provides an optimal electromagnetic coupling coefficient. The mass of the former type of reactor was increased by 4.4% over the conventional design, and that of the latter type of reactor was decreased by 17%. Finally, we tested the new reactors. When the chopper employs the former type of reactor and operates with equal‐phase switching and cumulative coupling, the loss due to ripple current is decreased by 11%. When the chopper employs the latter type of reactor and operates with shift‐phase switching and differential coupling, the loss is decreased to 31%. The test showed that the calculated relationships agreed with the measured values.