A CMOS multichannel 10-Gb/s transceiver

We describe a CMOS multichannel transceiver that transmits and receives 10 Gb/s per channel over balanced copper media. The transceiver consists of two identical 10-Gb/s modules. Each module operates off a single 1.2-V supply and has a single 5-GHz phase-locked loop to supply a reference clock to two transmitter (Tx) channels and two receiver (Rx) channels. To track the input-signal phase, the Rx channel has a clock recovery unit (CRU), which uses a phase-interpolator-based timing generator and digital loop filter. The CRU can adjust the recovered clock phase with a resolution of 1.56 ps. Two sets of two-channel transceiver units were fabricated in 0.11-/spl mu/m CMOS on a single test chip. The transceiver unit size was 1.6 mm /spl times/ 2.6 mm. The Rx sensitivity was 120-mVp-p differential with a 70-ps phase margin for a common-mode voltage ranging from 0.6 to 1.0 V. The evaluated jitter tolerance curve met the OC-192 specification.     

Experimental study of venous circulatory disturbance by dural sinus occlusion

Using a newly devised model of dural sinus occlusion, we investigated the pathophysiology of venous haemorrhage as well as venous circulatory disturbance. The superior sagittal sinus (SSS) and diploic veins (DV) were occluded in 16 cats. Intracranial pressure (ICP), cerebral blood volume (CBV) and regional cerebral blood flow (rCBF) were measured for 12 hours after the occlusion. At the end of the experiment, cerebral water content was estimated. In another 8 cats additional occlusions of cortical veins were carried out. In both groups, the blood-brain barrier permeability was evaluated with Evans blue or horseradish peroxidase. The SSS and DV occlusion produced a significant increase in ICP and CBV concomitant with a significant decrease in rCBF. Cerebral water content also increased significantly. However, there was no transition of Evans blue and horseradish peroxidase through the cerebral vessels, and no haemorrhages could be observed. In contrast, the additional occlusion of cortical veins produced haemorrhagic infarctions with Evans blue extravasation in 6 out of the 8 cats. These data suggest that dural sinus occlusion may lead to an increase in CBV and cerebral water content resulting in intracranial hypertension and decreased rCBF. The brain oedema in this model seemed to be mainly hydrostatic oedema, and might also be contributed by cytotoxic oedema. The additional occlusion of cortical veins might be essential in the development of haemorrhage in this model, and the blood-brain barrier was also disrupted in these areas.     

Oxidation of Fe (II) in sulfuric acid solutions with dissolved molecular oxygen

The oxidation of Fe(II) with dissolved molecular oxygen was studied in sulfuric acid solutions containing 0.2 mol . dm^-3 FeSO₄ at temperatures ranging from 343 to 363 K. In solutions of sulfuric acid above 0.4 mol . dm^-3, the oxidation of Fe (II) was found to proceed through two parallel paths. In one path the reaction rate was proportional to both [Fe²⁺]² and po₂, exhibiting an activation energy of 51.6 . kJ mol^-1. In another path the reaction rate was proportional to [Fe²⁺]², [SO_4-], and po₂ with an activation energy of 144.6 kJ . mol^-1. A reaction mechanism in which the SO_4- ions play an important role was proposed for the oxidation of Fe(II). In dilute solutions of sulfuric acid below 0.4 mol . dm^-3, the rate of the oxidation reaction was found to be proportional to both [Fe(II)]² and Po₂, and was also affected by [H⁺] and [SO_2- ⁴]. The decrease in [H⁺] resulted in the increase of reaction rate. The discussion was further extended to the effect of Fe (III) on the oxidation reaction of Fe (II).     

Damage tolerance of glass mat/epoxy laminates hybridized with flexible resin under static and impact loading

This study deals with the impact property and damage tolerance of matrix hybrid composite laminates with different laminate constitution. The matrix hybrid composite laminates consisted of the laminae with a conventional epoxy resin and the laminae with a flexible epoxy resin modified from the conventional resin to avoid the interlaminar delamination. The impact energy absorption ratio greatly depended on the matrix resin placed at the impact face. The energy absorption was almost constant if the conventional resin was placed at the impact surface layer, while it increased exponentially with the increasing fraction of the flexible resin if the flexible resin was placed at the impact face. The impact energy was absorbed by the damage development and propagation in the laminate with conventional resin laminae as the impacted face, while it was absorbed by both the recoverable deformation of the flexible resin and the damage propagation in the laminate with flexible resin laminae as the impacted face.     

Au/Pt/Ti/Ni ohmic contacts to p-ZnTe

Ohmic contacts of Au/Pd/Ti/Ni to p-ZnTe show a minimum specific contact resistance of 10^-6 Ωcm² for a p-type doping level of 3×10¹⁹ cm^-3 and at an annealing temperature of 300°C. The Ni and Ti layers are very effective in improving the electrical properties of these contact     

A semi-static complementary gain cell technology for sub-1 V supplyDRAM's

A new semi-static complementary gain cell for future low power DRAM's has been proposed and experimentally demonstrated. This gain cell consists of a write-transistor and its opposite conduction type read-transistor with a heating gate as a storage node which causes a shift in the threshold voltage. This gain cell provides a two orders of magnitude larger cell signal output and higher immunity to noise on the bitlines when compared with a conventional one-transistor DRAM cell without increasing the storage capacitance even at a supply voltage of 0.8 V. The 0.87 μm² cell size is achieved by using a 0.25 μm design rule with a polysilicon thin-film transistor built in the trench and phase shifted i-line lithography     

A Study of Shadowing on Indoor Visible-Light Wireless Communication Utilizing Plural White LED Lightings

White LED is considered as a strong candidate for the future lighting technology. We have proposed an optical wireless communication system that employs white LEDs for indoor wireless networks. In this system, LED is used not only as a lighting device, but also as a communication device. The transmitter has large optical power and large emission characteristics to function as lighting device. And the system has specific wireless channel impulse response differing from infrared wireless communication. In this paper, we discuss about shadowing effect on the system utilizing plural LED lightings including the performance of ISI based on the impulse response. We consider the downlink transmission based on TDMA and evaluate the shadowing effect caused by pedestrians with computer simulation. When the shadowing often occurs at 800 Mb/s, the performance of outage call duration rate and blocking rate are improved by using 3 LED lightings compared with 1 or 2 LED lightings. And, we show that the system with the optimal number of the LED lighting is robust against shadowing and can accommodate more calls. Toshihiko Komine was born in Shizuoka, Japan, on November 17, 1978. He received the B.E. and M.E. degrees in Information and Computer Science from Keio University, Yokohama, Japan, in 2001 and 2003 respectively. He is currently studying for the Ph.D. degree at Department of Information and Computer Science, Keio University. His current research interests are optical wireless communications and LED communications. Shinichiro Haruyama is a professor at Department of Information and Computer Science, Faculty of Science and Technology, Keio University, Yokohama, Japan. He received an M.S. in engineering science from University of California at Berkeley in 1983 and a Ph.D. in computer science from the University of Texas at Austin in 1990. He worked for Bell Laboratories of AT{&}T and Lucent Technologies, U.S.A from 1991 to 1996, and for Sony Computer Science Laboratories, Inc. from 1998 to 2002. His research interests include reconfigurable system, system design automation, wireless communication, and visible light communication. Masao Nakagawa was born in Tokyo, Japan in 1946. He received the B.E., M.E. and Ph.D. degrees in electrical engineering from Keio University, Yokohama, Japan, in 1969, 1971 and 1974 respectively. Since 1973, he has been with the Department of Electrical Engineering, Keio University, where he is now a Professor. His research interests are in CDMA, consumer Communications, Mobile communications, ITS (Intelligent Transport Systems), Wireless Home Networks, and Visible light Communication. He received 1989 IEEE Consumer Electronics Society Paper Award, 1999-Fall Best Paper Award in IEEE VTC, IEICE Achievement Award in 2000, IEICE Fellow Award in 2001. He was the executive committee chairman on International Symposium on Spread Spectrum Techniques and Applications in 1992 and the technical program committee chairman of ISITA (International Symposium on Spread Spectrum Techniques and Applications) in 1994. He is an editor of Wireless Personal Communications and was a guest editor of the special issues on “CDMA Networks I, II, III and IV” published in IEEE JSAC in 1994 (I and II) and 1996 (III and IV). He chairs the Wireless Home Link sub-committee in MMAC (Multimedia Mobile Access Communication Promotion Committee).     

Suppression of photo-induced dilation in cyanide treated hydrogenated amorphous silicon films

Effects of cyanide (CN) treatment with hydrogenated amorphous silicon (a-Si:H) films have been investigated. The decrease of ΔV/V was observed in cyanide treated a-Si:H films and the successive thermal annealing at 200°C after CN treatment induced the further reduction of the ΔV/V. XPS spectra show the indirect evidence that the cyanide species is present within 10 nm from the hydrogenated amorphous silicon surface. The results of CN treatment with a-Si:H solar cells are demonstrated.