Research and development of liquid hydrogen (LH2) temperature monitoring system for marine applications

Monitoring the temperature in liquid hydrogen (LH₂) storage tanks on ships is important for the safety of maritime navigation. In addition, accurate temperature measurement is also required for commercial transactions. Temperature and pressure define the density of liquid hydrogen, which is directly linked to trading interests. In this study, we developed and tested a liquid hydrogen temperature monitoring system that uses platinum resistance sensors with a nominal electrical resistance of approximately 1000 Ω at room temperature, PT-1000, for marine applications. The temperature measurements were carried out using a newly developed temperature monitoring system under different pressure conditions. The measured values are compared with a calibrated reference PT-1000 resistance thermometer. We confirm a measurement accuracy of ±50 mK in a pressure range of 0.1 MPa–0.5 MPa.     

Preparation of a Near-Infrared Ray Absorption Film from N-Phenylthiocarbamoyl Chitosan Derivative

We recently observed that the decanoylation of N-phenylthiocarbamoyl chitosan (2) with a mixture of decanoic anhydride and pyridine at 60 °C for 24 h afforded N,N-(decanoyl)phenythiocarbamoyl-/2-isothiocynato chitosan decanoate (3b) rather than the expected product N,N-(decanoyl)phenylthiocarbamoyl chitosan decanoate (3a). This result suggested that some of the N,N-(decanoyl)phenylthiocarmbamoyl groups had been converted to isothiocyanate groups during the decanoylation process. The subsequent reaction of compound 3b with aniline gave N,N-(decanoyl)phenylthiocarbamoyl/N-phenylthiocarbamoyl chitosan decanoate (4) in high yield. A solution of compound 4 in CHCl₃ was then added to a solution of copper decanoate (5) in the same solvent, and the resulting mixture was cast onto a glass plate to give a cast film. The film was annealed at 200 °C in an oven to give a greenish film, which showed good near-infrared absorption characteristic in the range of 800–2200 nm.     

Driving voltage reduction in a two-phase CCD by suppression ofpotential pockets in inter-electrode gaps

This study reports an optimum design for a two-phase charge-coupled device (CCD) and limitations on its driving voltage reduction. The two-phase CCD to be used as a horizontal-CCD (H-CCD) in a CCD image sensor requires low-voltage and high-speed operation. Reducing the driving voltage, however, may induce potential pockets in the channel under the inter-electrode gaps which results in a fatal decrease in charge-transfer efficiency. In this case it is necessary to optimize the CCD design to be free of pocket generation. For this requirement, we conducted two-dimensional (2-D) device simulations for the two-phase CCD, whose potential barriers are formed by boron ion-implantation. Our simulations indicated that the edge position of the potential barrier region and the dose of boron-ion implantation would be important parameters for controlling the size of potential pockets. At an optimum edge position and a boron dose, the minimum driving voltage appears to be reducible to 1.1 V. Characteristics of potential pockets and methods of their suppression are also discussed     

Breakdown of oil films and formation of residual films

The breakdown processes of oil films under quasi-static loading have been investigated by using a newly developed steel-oil-mercury system. The relationship between the thickness and breakdown ratio of a hexadecane film is represented by a single master curve independently of the indentation speed, indentation load, and temperature. The master curve shows that the breakdown process of hexadecane includes two stages; one is the decrement of the thickness without breakdown and the other is the decrement of the thickness with a drastic progress of breakdown. By solving a small amount of fatty acid in hexadecane, the thickness increases and the breakdown ratio decreases noticeably; a multilayer residual film supporting normal load is formed between two metal surfaces. Experiments at different temperatures reveal a negative relationship between the temperature and thickness of residual film, which indicates that the residual film is organized by physical interaction rather than chemical interaction. At least under a lower concentration, the residual film appears to consist of not only fatty acid molecules but also hexadecane molecules.     

Post-lunch nap as a worksite intervention to promote alertness on the job.

A worksite study was conducted to examine whether a 15-min nap during a post-lunch rest period would affect subsequent alertness, performance, and nocturnal sleep in eight factory workers under a 3-week protocol. Subjects were asked to take the nap at 12:30 h on a reclining chair during the nap week, and to remain awake during the no-nap week. The order of these 2 weeks was counterbalanced between the subjects. During the third, follow-up week, each subject determined whether or not she/he would nap. Alertness on the job and nocturnal sleep were assessed using a sleep diary. Wrist activity was also recorded during sleep at night. Choice reaction time task (RT) was performed at 10:00 and 15:00 h every day of the nap week and every other day of the no-nap and follow-up weeks. Perceived alertness was significantly higher in the afternoon after nap than after no nap at the end of the week. Similar effects were observed during the follow-up week where almost half of the subjects napped. No significant differences between the three weeks were found for RT performance or nocturnal sleep. Workers' attitudes toward the nap were favourable. Although further intervention research is required, our results suggest that post-lunch napping may have the potential to promote daytime alertness at work.     

Studies of the influence of alloying elements on the growth of ferrite from austenite under decarburization conditions: Fe-C-Nl alloys

We have evaluated controlled decarburization as a method for probing the effect of alloying elements on ferrite growth from austenite. The technique permits the exploration of longer-time ferrite layer growth; it minimizes the effects of interface structure on ferrite growth; and it permits the isolation of the effects of temperature and alloying element concentration on ferrite/austenite interface motion. The study of the decarburization of initially homogeneous Fe-C-Ni alloys was complemented by experiments using specimens with a controlled nickel concentration gradient. Although the decarburization method yields consistent results at longer times, it is found to be less appropriate for the study of initial ferrite growth. Nucleation in the gas/solid interface region, coupled with uncertainties about the precise time of decarburization, leads to large relative errors at the earliest times. For these reasons, the method is considered a valuable complement to studies based on precipitation boundary conditions. This article is based on a presentation given in the symposium “The Effects of Alloying Elements on the Gamma to Alpha Transformation in Steels,” October 6, 2002, at the TMS Fall Meeting in Columbus, Ohio, under the auspices of the McMaster Centre for Steel Research and the TMS-ASM Phase Transformations Committee.     

Efficacy of interferons in treating children with chronic hepatitis C

Twenty-two children with chronic hepatitis serologically positive for hepatitis C virus (HCV) were treated with interferon-alpha (IFN-alpha). Liver biopsy showed chronic active hepatitis in 13 and chronic persistent hepatitis in 9 patients. A sustained clearance of HCV was observed in 8/22 children 12 months after the administration of IFN-alpha for 26 weeks, associated with normalization of HCV core antibody. Of these eight patients six had HCV genotype III and two HCV genotype II or IV. Hepatitis relapsed in seven other patients after completion of IFN-alpha with an increase in HCV core antibody titre, five with HCV genotype II, and two with HCV genotype III or IV. A second course of IFN-alpha suppressed the reactivation of HCV in all seven patients. Three of seven responders who relapsed after the first course remained negative for HCV RNA 12 months after their second course of IFN-alpha. However, the remaining four patients with HCV genotype II again relapsed after completing their second course of IFN-alpha. Seven children with the HCV genotype II resistant to IFN, including 8 weeks of IFN-beta administration, and showed no significant reduction in HCV core antibody titre. CONCLUSION: The genotype of HCV (III) and a reduction in the core antibody titre appear to be useful parameters for predicting the response to IFN-alpha therapy.     

A novel brain-derived member of the epidermal growth factor family that interacts with ErbB3 and ErbB4

The availability of an analgesic compound devoid of the side effects associated with the commonly used opioid and nonsteroidal antiinflammatory drugs would be useful during the perioperative period. Although adenosine has analgesic and anesthetic-sparing properties, it also produces dose-dependent cardiovascular depression. Inhibitors of adenosine kinase may be able to provide analgesia without producing acute cardiovascular or respiratory depression. This preliminary study investigated the effects of a novel adenosine kinase-inhibiting drug, GP683, on the minimum alveolar anesthetic concentration (MAC) of desflurane in dogs. Seven mongrel dogs were administered one of three different GP683 dose regimens (or the solvent) by intravenous infusion on separate occasions according to a cross-over study design. After determining the baseline desflurane MAC value, GP683 was infused at 75, 150, or 300 microg x kg(-1) x min(-1) for 5 min as a loading dose, followed by 15, 30, or 60 microg x kg(-1) x min(-1) for an additional 85 min to maintain a stable plasma drug level. The desflurane MAC was redetermined 30-90 min after starting the study drug or vehicle infusion, and 30-90 min and 120-180 min after termination of the infusion. Cardiovascular variables and plasma concentrations of GP683 were determined at specific intervals before, during, and after the MAC determinations. The three GP683 dose regimens produced 22%, 31%, and 50% decreases in the desflurane MAC, respectively. In addition, there was good correlation between the decrease in desflurane MAC and the plasma GP683 concentration (r = -0.78). Although the mean arterial pressure (MAP) was decreased up to 25% by the highest infusion rate of GP683, adjustments in the desflurane concentration to an equi-MAC value resulted in normalization of the MAP values. Furthermore, GP683 produced no changes in heart rate. In conclusion, the adenosine kinase-inhibiting drug, GP683, produced dose-dependent decreases in the desflurane MAC of dogs without producing untoward hemodynamic changes. IMPLICATIONS: An investigational drug (GP683) that can increase the levels of an important endogenous substance in the body (adenosine) has been found to decrease the anesthetic requirement in dogs without producing adverse effects on the cardiovascular system.     

Acetazolamide challenge and technetium-99m-ECD versus iodine-123-IMP SPECT in chronic occlusive cerebrovascular disease

We compared the acetazolamide challenge test using 99mTc-ECD SPECT and 123I-IMP SPECT images in patients with chronic occlusive cerebrovascular disease. We also evaluated the usefulness of linearization correction for acetazolamide challenge test of 99mTc-ECD SPECT. METHODS: Twenty patients with unilateral chronic occlusive cerebrovascular disease (10 patients had middle cerebral arterial lesion and 10 had internal carotid lesion) were included in the study. Split-dose (a dose fractioning was 1:2), and sequential SPECT technique was used for 99mTc-ECD SPECT studies while only acetazolamide challenge test studies for 123I-IMP SPECT were performed. Permeability surface area product model (PS model) and back-diffusion model (Lassen's correction) were used for linearization correction of acetazolamide challenge with 99mTc-ECD SPECT. RESULTS: Six of 16 patients with reduced vasodilatory capacity in 123I-IMP SPECT were underestimated by 99mTc-ECD SPECT acetazolamide challenge test. Relative ECD uptake normalized by cerebellar uptake compared with IMP uptake showed a nonlinear relationship, indicating relatively less uptake in high flow range. The underestimations of limited vasodilatory capacity observed in 99mTc-ECD SPECT without linearization correction was modified by linearization algorithm. However, the effect of correction based on PS model was superior than that of Lassen's correction. The corrected 99mTc-ECD uptake ratio, based on PS model, and IMP uptake ratio demonstrated a better linear relationship than that of Lassen's correction. CONCLUSION: Technetium-99m ECD SPECT corrected based on the PS model is a better method of linearization for evaluating cerebrovascular reserve using acetazolamide challenge.