A 0.25-/spl mu/m CMOS quad-band GSM RF transceiver using an efficient LO frequency plan

This paper describes a single-chip CMOS quad-band (850/900/1800/1900 MHz) RF transceiver for GSM/GPRS applications. It is the most important design issue to maximize resource sharing and reuse in designing the multiband transceivers. In particular, reducing the number of voltage-controlled oscillators (VCOs) required for local oscillator (LO) frequency generation is very important because the VCO and phase-locked loop (PLL) circuits occupy a relatively large area. We propose a quad-band GSM transceiver architecture that employs a direct conversion receiver and an offset PLL transmitter, which requires only one VCO/PLL to generate LO signals by using an efficient LO frequency plan. In the receive path, four separate LNAs are used for each band, and two down-conversion mixers are used, one for the low bands (850/900 MHz) and the other for the high bands (1800/1900 MHz). A receiver baseband circuit is shared for all four bands because all of their channel spaces are the same. In the transmit path, most of the building blocks of the offset PLL, including a TX VCO and IF filters, are integrated. The quad-band GSM transceiver that was implemented in 0.25-/spl mu/m CMOS technology has a size of 3.3/spl times/3.2 mm/sup 2/, including its pad area. From the experimental results, we found that the receiver provides a maximum noise figure of 2.9 dB and a minimum IIP3 of -13.2dBm for the EGSM 900 band. The transmitter shows an rms phase error of 1.4/spl deg/ and meets the GSM spectral mask specification. The prototype chip consumes 56 and 58 mA at 2.8 V in the RX and TX modes, respectively.     

Reversible energy recovery logic circuit without non-adiabaticenergy loss

The authors propose a reversible energy recovery logic (RERL) circuit for ultra-low-energy consumption, which consumes only adiabatic energy loss and leakage current loss by completely eliminating non-adiabatic energy loss. It is a dual-rail adiabatic circuit using the concept of reversible logic with a new eight-phase clocking scheme. Simulation results show that at low-speed operation, the RERL consumes much less energy than the complementary static CMOS circuit and other adiabatic logic circuits     

Exact controllability for semilinear parabolic equations with Neumann boundary conditions

This paper studies the problem of exact boundary controllability of second-order semilinear parabolic equations when the control is under Neumann's boundary conditions. For a nonlinear term with a sublinear growth we prove the global null-controllability and for the superlinear growth case we prove the local exact controllability of the equations.     

The prevalence of clinically significant anaemia and haemoglobinopathy in children requiring dental treatment under general anaesthesia: a retrospective study of 1000 patients

There is little information on the possible value of screening children who are liable to haemoglobinopathies as part of pre-operative assessment for dental treatment under general anaesthesia. The present retrospective investigation examined, first, the number of patients having low haemoglobin levels among 1000 patients who had undergone haematological investigation prior to general anaesthesia in a dental outpatient unit, and, secondly, the subsequent clinical management of these patients. Haemoglobin levels of 10.0 g/dl or less were found in 31 children: 13 Asian, 7 Afro-Caribbean, 5 Mediterranean, 3 Arabic, 1 white Caucasian and 2 Oriental children. In addition, 17 patients had sickle-cell trait and 2 had beta-thalassaemia trait, but there was no relationship between the presence of haemoglobinopathy and low levels of haemoglobin. The planned general anaesthesia was undertaken for 22 of the 31 children who had low levels of haemoglobin and for the 19 children with haemoglobinopathy. Only 6 children ultimately did not undergo general anaesthesia, all failing to return. It is concluded that pre-anaesthetic haematological assessment of children needing minor dental surgery is rarely of any significant clinical value.     

Highly Cooperative Tetrametallic Ruthenium-mu-Oxo-mu-Hydroxo Catalyst for the Alcohol Oxidation Reaction

The tetrametallic ruthenium-oxo-hydroxo-hydride complex {[(PCy(3))(CO)RuH](4)(mu(4)-O)(mu(3)-OH)(mu(2)-OH)} (1) was synthesized in two steps from the monomeric complex (PCy(3))(CO)RuHCl (2). The tetrameric complex 1 was found to be a highly effective catalyst for the transfer dehydrogenation of alcohols. Complex 1 showed a different catalytic activity pattern towards primary and secondary benzyl alcohols, as indicated by the Hammett correlation for the oxidation reaction of p-X-C(6)H(4)CH(2)OH (rho = -0.45) and p-X-C(6)H(4)CH(OH)CH(3) (rho = +0.22) (X = OMe, CH(3), H, Cl, CF(3)). Both a sigmoidal curve from the plot of initial rate vs [PhCH(OH)CH(3)] (K(0.5) = 0.34 M; Hill coefficient, n = 4.2+/-0.1) and the phosphine inhibition kinetics revealed the highly cooperative nature of the complex for the oxidation of secondary alcohols.     

Synthesis and characterization of new aromatic polyimides containing well‐defined conjugation units

A series of aromatic polyimides composed of well‐defined conjugation units were synthesized form 5,5′‐bis(4‐aminophenyl)‐2,2′‐bifuryl (PFDA) and 2,2′‐bis(furyl) benzidine (FurylBZ) with various dianhydrides. The synthesized polyimides emit blue to green light with a quantum yield of 7.3–14.9%, depending on the polymer backbone. In particular, PFDA‐based polymers exhibit extremely narrow photo‐luminescence. The structure, thermal stability, refractive index and dielectric properties of the polymer films were also determined.     

Improved mechanical properties of shape‐memory polyurethane block copolymers through the control of the soft‐segment arrangement

High‐performance shape‐memory polyurethane block copolymers, prepared with two types of poly(tetramethylene glycol) (PTMG) used as soft segments, were investigated for their mechanical properties. Copolymers with a random or block soft‐segment arrangement had higher stresses at break and elongations at break than those with only one kind of PTMG. Random copolymers with fewer interchain interactions showed higher elongation than block copolymers. All the copolymers had shape‐recovery ratios higher than 80%. In dynamic mechanical testing, the glass‐transition behavior clearly depended on the soft‐segment arrangement: random copolymers had only one glass‐transition peak, whereas block copolymers showed two separate glass‐transition peaks. Overall, the control of the soft‐segment arrangement plays a vital role in the development of high‐performance shape‐memory polyurethane. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 93: 2410–2415, 2004     

Molecular simulation of hydrogen adsorption in organic zeolite

The adsorption of molecular hydrogen on model zeolites has been simulated employing Grand Canonical Monte Carlo (GCMC) procedure. The effects of cation type, available volume, surface area, temperature, pressure and pre-adsorbed organics such as benzene on the hydrogen uptake are analyzed. The hydrogen adsorption can be affected mainly by the available volume and surface area per g-zeolite at the same temperature and pressure. Increase of temperature results in the decrease of sorption intensity and capacity. The adsorption capacity correlates well with the pressure with high linearity at room temperature. Adsorption is lowered by the pre-adsorbed benzene molecule. The orientation and the number of benzene molecule in zeolite affect the adsorption capacity. The organic zeolite with larger available volume shows larger adsorption capacity.     

Improvement of cyclodextrin glucanotransferase as an antistaling enzyme by error-prone PCR

In an effort to improve the properties of cyclodextrin glucanotransferase (CGTase) as an antistaling enzyme, error-prone PCR was used to introduce random mutations into a CGTase cloned from alkalophilic Bacillus sp. I-5 (CGTase I-5). A mutant CGTase[3-18] with the three mutations M234T, F259I and V591A was selected by agar plate assay. Sequence alignment of various CGTases indicated that M234 and F259 are located in the vicinity of the catalytic sites of the enzyme and V591 in the starch binding domain E. The cyclization activity of CGTase[3-18] was dramatically decreased by 10-fold, while the hydrolyzing activity was increased by up to 15-fold. These mutations near subsite +1 (M234T) and at subsite +2 (F259I) are likely to alter the enzyme activity in a concerted manner, promoting hydrolysis of substrate while retarding cyclization. The addition of CGTase[3-18] reduced the retrogradation rate of bread by as much as did the commercial antistaling enzyme Novamyl during 7-day storage at 4 degrees C. No cyclodextrin (CD) was detected in bread treated with CGTase[3-18], whereas 21 mg of CD per 10 g of bread was produced in bread treated with wild-type CGTase.     

Synthesis and physicochemical characterization of amphiphilic block copolymer self‐aggregates formed by poly(ethylene glycol)‐block‐poly(ϵ‐caprolactone)

Diblock copolymers with different poly(ε‐caprolactone) (PCL) block lengths were synthesized by ring‐opening polymerization of ε‐caprolactone in the presence of monomethoxy poly(ethylene glycol) (mPEG‐OH, MW 2000) as initiator. The self‐aggregation behaviors and microscopic characteristics of the diblock copolymer self‐aggregates, prepared by the diafiltration method, were investigated by using ¹H NMR, dynamic light scattering (DLS), and fluorescence spectroscopy. The PEG–PCL block copolymers formed the self‐aggregate in an aqueous environment by intra‐ and/or intermolecular association between hydrophobic PCL chains. The critical aggregation concentrations of the block copolymer self‐aggregate became lower with increasing hydrophobic PCL block length. On the other hand, reverse trends of mean hydrodynamic diameters were measured by DLS owing to the increasing bulkiness of the hydrophobic chains and hydrophobic interaction between the PCL microdomains. The partition equilibrium constants (K_v) of pyrene, measured by fluorescence spectroscopy, revealed that the inner core hydrophobicity of the nanoparticles increased with increasing PCL chain length. The aggregation number of PCL chain per one hydrophobic microdomain, investigated by the fluorescence quenching method using cetylpyridinium chloride as a quencher, revealed that 4–20 block copolymer chains were needed to form a hydrophobic microdomain, depending on PCL block length. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 99: 3520–3527, 2006