Varactor-Tuned Dual-Band Quadrature Hybrid Coupler

A tunable dual-band quadrature hybrid coupler for mobile GSM bands (900 and 1800MHz) is proposed and characterized. The structure is composed of four quarter-wavelength sections at a frequency located between the two operating frequencies and two pairs of open-ended stubs. Frequency tuning is achieved by modifying the electrical length of the open-ended stubs with varactor-diode capacitors. A dual-band tunability of 33% and 10% is obtained for the first and the second bands, respectively     

Properties of poly(ethylene terephthalate)–poly(ethylene naphthalene 2,6‐dicarboxylate) blends with montmorillonite clay

The production and properties of blends of poly(ethylene terephthalate) (PET) and poly(ethylene naphthalene 2,6‐dicarboxylate) (PEN) with three modified clays are reported. Octadecylammonium chloride and maleic anhydride (MAH) are used to modify the surface of the montmorillonite–Na⁺ clay particles (clay–Na⁺) to produce clay–C18 and clay–MAH, respectively, before they are mixed with the PET/PEN system. The transesterification degree, hydrophobicity and the effect of the clays on the mechanical, rheological and thermal properties are analysed. The PET–PEN/clay–C18 system does not show any improvements in the mechanical properties, which is attributed to poor exfoliation. On the other hand, in the PET–PEN/clay–MAH blends, the modified clay restricts crystallization of the matrix, as evidenced in the low value of the crystallization enthalpy. The process‐induced PET–PEN transesterification reaction is affected by the clay particles. Clay–C18 induces the largest proportion of naphthalate–ethylene–terephthalate (NET) blocks, as opposed to clay–Na⁺ which renders the lowest proportion. The clay readily incorporates in the bulk polymer, but receding contact‐angle measurements reveal a small influence of the particles on the surface properties of the sample. The clay–Na⁺ blend shows a predominant solid‐like behaviour, as evidenced by the magnitude of the storage modulus in the low‐frequency range, which reflects a high entanglement density and a substantial degree of polymer–particle interactions. Copyright © 2005 Society of Chemical Industry     

The impact of roasting on the ochratoxin A content of coffee

Roasting coffee led to a drop in the ochratoxin A (OTA) concentration, as measured by the reference method, especially for dark type roasts. The way the beverage was prepared also affected the OTA content, which could paradoxically be higher than that of the initial roasted coffee. Assays on the thermal stability of pure OTA showed that it ought to be found in larger quantities in roasted coffee. This suggested that OTA was masked by reactions with the substrate during roasting. The absence of OTA in green coffee is therefore the best guarantee of safety.     

Biosorption of Phenol onto Posidonia oceanica (L.) Seagrass in Batch System: Equilibrium and Kinetic Modelling

In this research, the biosorption of phenol using the fibres of a Mediterranean seagrass Posidonia oceanica (L.) was studied. Batch experimental procedures were made to investigate the ability of this novel marine biomass to remove phenol from aqueous phase. The influences of pH and contact time at different initial concentrations were evaluated. The results showed that biosorption capacity was enhanced using solution pH equal to 5.2. The modelling results showed that pseudo‐second‐order and Redlich‐Peterson models were found to be the most suitable to satisfactory describe the kinetic and equilibrium adsorption data, respectively.     

Very Long SiC‐Based Coaxial Nanocables with Tunable Chemical Composition

We present a simple process for the fabrication of very long SiC‐based coaxial nanocables (NCs). The versatility of this technique is confirmed by the ability to change the chemical composition of the NC outer layers from silica to carbon and boron nitride. The NCs consist of a SiC core approximately 30 nm in diameter with lengths up to several hundred of nanometers. The thickness of the coating is in the range 2–10 nm. The morphology and structural characterization of the NCs is investigated by scanning electron microscopy (SEM) and high‐resolution transmission electron microscopy (HRTEM), respectively, and their chemical composition is probed by electron energy loss spectroscopy (EELS). A vapor–solid growth mechanism is proposed to explain the growth of SiC‐based NCs of various chemical compositions, depending on the chemical nature of the vapor phase. Because of the large quantity of very long and interlaced NCs produced during the synthesis, the macroscopic aspect of the as‐grown material is like a self‐supported felt.     

Modelling diffusion and adsorption of As species in Fe/GAC adsorbent beds

BACKGROUND: Arsenic decontamination of drinking water by adsorption is a simple and robust operation. When designing packed bed adsorbers for arsenic, the main problems are the slow diffusion kinetics of As in microporous media and the lack of simple equations for predicting the performance of the equipment. Commercial iron‐doped granular activated carbon adsorbents (Fe/GAC) for groundwater arsenic abatement were studied in this work. Basic parameters for arsenate (As^V) adsorption were measured and their performance at larger scale was simulated with an approximate analytical model. RESULTS: In the 0–300 µg_As L^?1 range, the As^V adsorption isotherm on Fe/GAC was found to be approximately linear. Assuming Henry's law for adsorption and homogeneous surface diffusion with constant diffusivity for intrapellet mass transfer, an approximate model for flow and adsorption of arsenate inside packed bed adsorbers was developed, and reduced to an analytic compact solution using the quasi‐lognormal distribution (Q‐LND) approximation. The use of this model with fitted and reported parameters enabled the approximate simulation of industrial adsorbers and home point‐of‐use filters. Results show that industrial adsorbers meet the breakthrough condition with incomplete utilization of the adsorbent unless convenient process configurations are used. In point‐of‐use systems with short residence times intraparticle diffusion would drastically reduce the adsorbent performance. CONCLUSION: Assuming linear adsorption of As^V over Fe/GAC, an analytical approximate solution for flow and adsorption in packed beds can be obtained. The model seems to represent correctly the main features of industrial and home filters, however, more experimental data is necessary for scale‐up purposes. Copyright © 2011 Society of Chemical Industry     

Polyaniline‐modified cellulose nanofibrils as reinforcement of a smart polyurethane

Segmented polyurethanes exhibiting shape memory properties were modified by the addition of polyaniline (PANI)‐coated cellulose nanofibrils (CNFs). The two‐phase structure of the polymer is responsible for the material's ability to ‘remember’ and autonomously recover its original shape after being deformed in response to an external thermal stimulus. PANI was grown on the surface of the CNFs via in situ polymerization. Modified nanocrystals were added to the segmented polyurethane in concentrations ranging from 0 to 15 wt%. The changes in the material properties associated with the percolation of the coated fibrils appear at higher concentrations than previously observed for non‐modified CNFs, which suggests that fibril agglomeration is occurring due to the PANI coating. The shape memory behavior of the composites is maintained at about the same level as that of the unfilled polyurethane only up to 4 wt% of fibrils. At higher concentrations, the rigidity of the nanofibrils as well as their interaction with the hard‐segment phase and the increasing difficulty of dispersing them in the polymer collaborate to produce early breakage of the specimens when stretched at temperatures above the melting point of the soft segments. Copyright © 2010 Society of Chemical Industry     

Can Brazil replace 5% of the 2025 gasoline world demand with ethanol?

Increasing use of petroleum, coupled with concern for global warming, demands the development and institution of CO₂ reducing, non-fossil fuel-based alternative energy-generating strategies. Ethanol is a potential alternative, particularly when produced in a sustainable way as is envisioned for sugarcane in Brazil. We consider the expansion of sugarcane-derived ethanol to displace 5% of projected gasoline use worldwide in 2025. With existing technology, 21 million hectares of land will be required to produce the necessary ethanol. This is less than 7% of current Brazilian agricultural land and equivalent to current soybean land use. New production lands come from pasture made available through improving pasture management in the cattle industry. With the continued introduction of new cane varieties (annual yield increases of about 1.6%) and new ethanol production technologies, namely the hydrolysis of bagasse to sugars for ethanol production and sugarcane trash collection providing renewable process energy production, this could reduce these modest land requirements by 29–38%.     

Mental health professionals' adaptive responses to racial microaggressions: An exploratory study.

This study examines adaptive responses that mental health professionals of color use to cope with racial microaggressions in their professional lives. Twenty-four mental health professionals from diverse ethnic backgrounds in the United States and Canada participated in focus groups discussing their experiences with racial microagressions and how they cope with them. Results of the analysis indicated that 8 primary coping themes illustrated strategies used by the participants. These include: identifying key issues in responding to racial microaggressions, self-care, spirituality, confrontation, support, documentation, mentoring, and collective organizing. Suggestions for mentoring professionals of color are offered. (PsycINFO Database Record (c) 2010 APA, all rights reserved)