Application of GA-Optimized ANNs to Predict the Water Content,CO2 and H2S Absorption Capacity of Diethanolamine (DEA) in Khangiran Gas Sweetening Plant

Theoretical Foundations of Chemical Engineering - In this work, with the aim of accurate prediction of water content, H2S and CO2 absorption capacity of diethanolamine (DEA) solvent in Khangiran...     

An experimental study of forced convective heat transfer for fully developed Al 2 O 3 –water nanofluid in an annulus tube

Nanofluids have been known as practical materials to ameliorate heat transfer within diverse industrial systems. The current work presents an empirical study on forced convection effects of Al₂O₃–water nanofluid within an annulus tube. A laminar flow regime has been considered to perform the experiment in high Reynolds number range using several concentrations of nanofluid. Also, the boundary conditions include a constant uniform heat flux applied on the outer shell and an adiabatic condition to the inner tube. Nanofluid particle is visualized with transmission electron microscopy to figure out the nanofluid particles. Additionally, the pressure drop is obtained by measuring the inlet and outlet pressure with respect to the ambient condition. The experimental results showed that adding nanoparticles to the base fluid will increase the heat transfer coefficient (HTC) and average Nusselt number. In addition, by increasing viscosity effects at maximum Reynolds number of 1140 and increasing nanofluid concentration from 1% to 4% (maximum performance at 4%), HTC increases by 18%.     

Adaptive stabilization of a class of nonlinear systems using high-gain feedback

This note presents a high-gain feedback stabilizing control algorithm in which the high-gain parameter is adapted on-line. The algorithm is developed for a class of nonlinear systems which can be viewed as the nonlinear counterpart of uniform rank systems. The system can be unknown except for a number of vital pieces of information. For single-input single-output linear systems such information is usually required in the traditional adaptive control literature.     

Complex formation of montmorillonite clay with polymers. Part 2: The use of montmorillonite clay–vinyl monomer complex as a comonomer in the copolymerization reaction of styrene–acrylonitrile monomers

The bulk copolymerization of styrene–acrylonitrile monomers using styrene‐N⁺–montmorillonite complex as a comonomer in the polymerization was studied. The X‐ray diffraction (XRD) analysis showed that part of the styrene‐N⁺–montmorillonite complex remained non‐dispersed (immiscible) and the copolymer was excluded from the interlayer of the immiscible part of the clay. The successive chemical extraction process revealed that a reasonable amount of the styrene–acrylonitrile copolymer was directly attached to the styrene‐N⁺–montmorillonite complex and enveloped the clay. Highly exfoliated clay lamella and nanospheres (3–5 nm) were observed by transmission electron microscopy (TEM). The montmorillonite clay assume two different morphologies, immiscible and exfoliated, on the basis of the XRD and TEM data. A simple method of calculation of the ratio of the exfoliated/immiscible amounts of the clay indicated that the amount of the styrene‐N⁺–montmorillonite complex exfoliated into separate lamella was 40 % (w/w) of the amount of the clay samples containing 2 % of the (styrene‐N⁺–montmorillonite complex) clay. This amount of exfoliated clay decreases with the increase of the concentration of the clay. The presence of the styrene‐N⁺–montmorillonite clay in the copolymerization reaction had a minor effect on both the copolymer composition and the molecular weight. Modification of the clay with the derivatized styrene monomer can achieve a nanocomposite using a percentage no more than 4 % (w/w) of complex in the copolymer. Copyright © 2004 Society of Chemical Industry     

Properties of poly(ethylene terephthalate)–poly(ethylene naphthalene 2,6‐dicarboxylate) blends with montmorillonite clay

The production and properties of blends of poly(ethylene terephthalate) (PET) and poly(ethylene naphthalene 2,6‐dicarboxylate) (PEN) with three modified clays are reported. Octadecylammonium chloride and maleic anhydride (MAH) are used to modify the surface of the montmorillonite–Na⁺ clay particles (clay–Na⁺) to produce clay–C18 and clay–MAH, respectively, before they are mixed with the PET/PEN system. The transesterification degree, hydrophobicity and the effect of the clays on the mechanical, rheological and thermal properties are analysed. The PET–PEN/clay–C18 system does not show any improvements in the mechanical properties, which is attributed to poor exfoliation. On the other hand, in the PET–PEN/clay–MAH blends, the modified clay restricts crystallization of the matrix, as evidenced in the low value of the crystallization enthalpy. The process‐induced PET–PEN transesterification reaction is affected by the clay particles. Clay–C18 induces the largest proportion of naphthalate–ethylene–terephthalate (NET) blocks, as opposed to clay–Na⁺ which renders the lowest proportion. The clay readily incorporates in the bulk polymer, but receding contact‐angle measurements reveal a small influence of the particles on the surface properties of the sample. The clay–Na⁺ blend shows a predominant solid‐like behaviour, as evidenced by the magnitude of the storage modulus in the low‐frequency range, which reflects a high entanglement density and a substantial degree of polymer–particle interactions. Copyright © 2005 Society of Chemical Industry     

The development and application of a multiple wavelength illumination technique for the vision-based process monitoring of aero-structure riveting

Airframe riveting is a critical process that requires high levels of process monitoring and quality assurance due to the very high risk associated with the failure of such joints. This paper describes the development of the enabling technology developed for a machine vision-based process monitoring system. One of the key factors affecting the performance of a machine vision system is the quality of the lighting. In the application described in this paper the available lighting was severely limited by the confined space in which the system had to operate. The problem was also compounded by the reflective nature of the objects to be examined. The initial images obtained were not suitable for further processing due to the presence of significant shadows and specular reflections. A novel solution to this problem based on multiple wavelength illumination and signal processing is presented along with results from experimental trials of the approach.     

The impact of roasting on the ochratoxin A content of coffee

Roasting coffee led to a drop in the ochratoxin A (OTA) concentration, as measured by the reference method, especially for dark type roasts. The way the beverage was prepared also affected the OTA content, which could paradoxically be higher than that of the initial roasted coffee. Assays on the thermal stability of pure OTA showed that it ought to be found in larger quantities in roasted coffee. This suggested that OTA was masked by reactions with the substrate during roasting. The absence of OTA in green coffee is therefore the best guarantee of safety.     

General Solution for the Dynamic Modeling of Parallel Robots

In this paper, we present a general method to calculate the inverse and direct dynamic models of parallel robots. The models are expressed in a closed form by a single equation in which all the elements needed are expressed. The solution is given in terms of the dynamic models of the legs, the dynamics of the platform and some Jacobian matrices. The proposed method is applied in this paper on two parallel robots with different structures. Categories (2), (3).     

Diazepam alters caffeine-induced effects on beta-endorphin levels in specific rat brain regions

The present study was conducted to evaluate the effects of caffeine and the benzodiazepine agonist diazepam, and a combination of both on beta-endorphin (beta-EN) levels in specific rat brain regions. Male Sprague-Dawley rats (150-200 g) adapted to a 12-hour light: 12-hour dark illumination cycle were used in this study. Caffeine (10 mg/kg), diazepam (2 mg/kg) or a combination of caffeine (10 mg/kg) and diazepam (2 mg/kg) were administered intraperitoneally to rats at 11:00 hr. Control animals were injected with saline. Animals were sacrificed by decapitation 1 h after injection, the brains were immediately removed; the cortex, hippocampus, hypothalamus and midbrain were dissected and their B-EN levels measured by radioimmunoassay. Caffeine administration significantly increased B-EN levels in the cortex. Similarly, administration of diazepam alone resulted in a significant increase of B-EN levels in cortex. However, concurrent administration of diazepam and caffeine resulted in higher increase of B-EN levels in cortex. No significant changes in B-EN levels were detected in hippocampus and midbrain after administration of either caffeine or diazepam alone. On the other hand, when diazepam and caffeine were concurrently administered a significant increase of B-EN levels were observed in the midbrain. Moreover, administration of diazepam alone resulted in a significant increase of B-EN levels in hypothalamus. This increase was still observed following concurrent administration of diazepam and caffeine. These results clearly indicate that diazepam alters caffeine-induced effects on B-EN in specific rat brain regions.