Towards an integrated neonatal brain and cardiac examination capability at 7 T: electromagnetic field simulations and early phantom experiments using an 8-channel dipole array

Objective

Neonatal brain and cardiac imaging would benefit from the increased signal-to-noise ratio levels at 7 T compared to lower field. Optimal performance might be achieved using purpose designed RF coil arrays. In this study, we introduce an 8-channel dipole array and investigate, using simulations, its RF performances for neonatal applications at 7 T.

Methods

The 8-channel dipole array was designed and evaluated for neonatal brain/cardiac configurations in terms of SAR efficiency (ratio between transmit-field and maximum specific-absorption-rate level) using adjusted dielectric properties for neonate. A birdcage coil operating in circularly polarized mode was simulated for comparison. Validation of the simulation model was performed on phantom for the coil array.

Results

The 8-channel dipole array demonstrated up to 46% higher SAR efficiency levels compared to the birdcage coil in neonatal configurations, as the specific-absorption-rate levels were alleviated. An averaged normalized root-mean-square-error of 6.7% was found between measured and simulated transmit field maps on phantom.

Conclusion

The 8-channel dipole array design integrated for neonatal brain and cardiac MR was successfully demonstrated, in simulation with coverage of the baby and increased SAR efficiency levels compared to the birdcage. We conclude that the 8Tx-dipole array promises safe operating procedures for MR imaging of neonatal brain and heart at 7 T.

     

Zinc oxide-decorated multiwalled carbon nanotubes: a selective electrochemical sensor for the detection of Pb(II) ion in aqueous media

Journal of Materials Science: Materials in Electronics - Multiwalled carbon nanotubes, due to high conductivity, stability, and large specific surface area, have a potential ability to promote...     

A hybrid knowledge and ensemble classification approach for prediction of venous thromboembolism

Clinical narratives such as progress summaries, lab reports, surgical reports, and other narrative texts contain key biomarkers about a patient's health. Evidence-based preventive medicine needs accurate semantic and sentiment analysis to extract and classify medical features as the input to appropriate machine learning classifiers. However, the traditional approach of using single classifiers is limited by the need for dimensionality reduction techniques, statistical feature correlation, a faster learning rate, and the lack of consideration of the semantic relations among features. Hence, extracting semantic and sentiment-based features from clinical text and combining multiple classifiers to create an ensemble intelligent system overcomes many limitations and provides a more robust prediction outcome. The selection of an appropriate approach and its interparameter dependency becomes key for the success of the ensemble method. This paper proposes a hybrid knowledge and ensemble learning framework for prediction of venous thromboembolism (VTE) diagnosis consisting of the following components: a VTE ontology, semantic extraction and sentiment assessment of risk factor framework, and an ensemble classifier. Therefore, a component-based analysis approach was adopted for evaluation using a data set of 250 clinical narratives where knowledge and ensemble achieved the following results with and without semantic extraction and sentiment assessment of risk factor, respectively: a precision of 81.8% and 62.9%, a recall of 81.8% and 57.6%, an F measure of 81.8% and 53.8%, and a receiving operating characteristic of 80.1% and 58.5% in identifying cases of VTE.     

Can social media usage of scientific literature predict journal indices of AJG,SNIP and JCR? An altmetric study of economics

Scientometrics - Altmetrics are often praised as an alternative or complement to classic bibliometric metrics, especially in the social sciences discipline. However, empirical investigations of...     

Experimental investigation of Co and Fe-Doped CuO nanostructured electrode material for remarkable electrochemical performance

The current research work presents a facile and cost–effective co-precipitation method to prepare doped (Co & Fe) CuO and undoped CuO nanostructures without usage of any type of surfactant or capping agents. The structural analysis reveals monoclinic crystal structure of synthesized pure CuO and doped-CuO nanostructures. The effect of different morphologies on the performance of supercapacitors has been found in CV (cyclic voltammetry) and GCD (galvanic charge discharge) investigations. The specific capacitances have been obtained 156 (±5) Fg^?1, 168(±5) Fg^?1 and 186 (±5) Fg^?1 for CuO, Co-doped CuO and Fe-doped CuO electrodes, respectively at scan rate of 5 mVs^?1, while it is found to be 114 (±5) Fg^?1, 136 (±5) Fg^?1 and 170 (±5) Fg^?1 for CuO, Co–CuO and Fe–CuO, respectively at 0.5 Ag^-1 as calculated from the GCD. The super capacitive performance of the Fe–CuO nanorods is mainly attributed to the synergism that evolves between CuO and Fe metal ion. The Fe-doped CuO with its nanorods like morphology provides superior specific capacitance value and excellent cyclic stability among all studied nanostructured electrodes. Consequently, it motivates to the use of Fe-doped CuO nanostructures as electrode material in the next generation energy storage devices.     

Effect of Boronizing on Operating Stability of Steel AISI 304L under Erosion Impact of Hard Particles

Metal Science and Heat Treatment - The effect of solid boronizing at 950°C for 2 and 4 h on the phase composition, microstructure, hardness and abrasive wear of steel AISI 304L is studied...     

Influence of Different Additives on the Interaction of Quinolone Antibiotic Drug with Surfactant: Conductivity and Cloud Point Measurement Study

Conductometric and cloud point (CP) measurement studies have been performed to investigate the interaction of tetradecyltrimethylammonium bromide (TTAB) and Triton® X-100 (TX-100) with ciprofloxacin hydrochloride (CFH) in different solvents over the temperature range of 295.15–315.15 K. CFH is used for the treatment of various bacterial infections. The observed critical micelle concentration (CMC) values of TTAB were found to be reduced in the presence of electrolytes (Na₂SO₄/Na₃PO₄), and this reduction proceeds with the elevation of salt concentration. The order of the CMC of TTAB follows the trend: > >. The observed CMC values of TTAB were found to increase with increasing temperature and decrease with increasing concentration of CFH in aqueous medium. The values of Gibbs free energy of micellization () for the TTAB/TTAB + CFH mixture were found to be negative, implying spontaneous micellization. The estimated CP of TX-100 decreases with increasing concentration of TX-100 in aqueous medium. The CP values first decrease with increasing concentration of CFH and then increase at higher concentration of CFH almost in all cases investigated. The values of free energy of clouding were found to be positive in all cases studied implying that phase separation of TX-100 was nonspontaneous. The other thermodynamic parameters associated with the micellization of TTAB and the phase separation of TX-100 were estimated and explained.     

Second harmonic generation from a ferroelectric film

We derive an expression for transmittivity (T_SHG) of second harmonic generation (SHG) signals from a ferroelectric (FE) film. Intensities of up and down fields in the medium are investigated in relation to T_SHG. The derivations are made based on undepletion of input fields and nonlinear wave equation derived from the Maxwell equations. We present two cases: film without mirrors and with partial mirrors. Expressions for the newly derived nonlinear susceptibility coefficients of SHG for real crystal symmetry [J. Opt. Soc. Am. B 19 (2002) 2007] are used to get more realistic results. Variations in T_SHG with respect to film thickness are illustrated.     

Synthesis of heterocyclic metal complexes and their evaluation as marine antifoulants

4-Amino-3-thio-1,24-triazolidine (L₁) and 4-amino-5-thio-1,3,4-thiadiazole (L_II) as well as their metal complexes of the general formulae ML_I·2H₂O and ML_IICl (M; Pb(II), Cd(II) and Zn(II)) were prepared. With Sn(II), we obtained Sn(L_I)₂·2H₂O and SnL_IICl, respectively. The structures of the compounds were identified through elemental analysis, and IR and UV spectra measurements, in addition to thermal analysis in case of the metal complexes. The antifouling properties of the compounds were tested by their incorporation into paint formulations which were applied to PVC substrates and tested in water from Alexandria western harbour. When the compounds were added at 17·5% by volume, the coated panels were fouled after 3 months of immersion. The addition of 6·7% by volume of tributyltin oxide to 15·8% of the prepared compounds in one formulation elevated the paint efficiency and prevented fouling for 11 months. Paint containing solely tributyltin oxide at the same concentration was inactive against algae.     

Studies on the interactions of metal oxides and Na2 SO4 at 1100 and 1200 K in oxygen

The interaction of different metal oxides such as Co₃O₄, NiO, Al₂O₃, Cr₂O₃, Fe₂O₃ and SiO₂ with Na₂SO₄ at a temperature of 1100 and 1200 K in flowing oxygen has been studied. The thermogravimetric studies for each system were carried out as a function of Na₂SO₄ in the mixture. The presence of different constituents in the reaction products were identified by X-ray diffraction analysis and the morphologies of the reaction products were characterized using metallography and scanning electron microscopy (SEM). The formation of products was also investigated by thermodynamic computation of free energies of the reactions and the study of relevant equilibrium phase diagrams. The soluble species in the aqueous solutions of the reaction products were determined quantitatively using atomic absorption spectrophotometry. The high temperature interaction products usually contain a 3-phase structure namely, Na₂O·M₂O _x , M₂O _x and metal sulphide and/or metal sulphate. The formation of Na₂O·M₂O _x depends upon the solid state solubility of metal oxide in the molten salt at high temperatures. Under limited solubility conditions Na₂O·M₂O _x is invariably formed, but as soon as this condition is relaxed the oxide. M₂O _x , precipitates and forms a separate phase.