The wettability and infiltration of molten ZrSi2 and ZrSi2-Lu2O3 alloys into Cf/SiC and B4C-infiltrated Cf/SiC composites were investigated to understand the interfacial interactions that occur during the development of Cf/SiC-ZrC and Cf/SiC-ZrB2-ZrC-Lu2O3 materials. A significant evaporation of Si from the liquid affected the wetting behaviour of the alloy when tested in a vacuum at 1670 °C. The better wetting and spreading of the alloy over the surface was observed for the composites with lower overall porosity (12 %). On the other hand, the formation of an outer dense layer, followed up by the uniform infiltrated region up to ~ 1 mm was observed for the Cf/SiC with higher porosity (21 %). The infiltrated alloy reacted with SiC matrix to form ZrC or with B4C-infiltrated SiC matrix to form ZrB2-ZrC-SiC. The Lu2O3 particles were not wetted by the melt, and were pushed away of the reaction zone by the solidification front. 相似文献
The transformation of fertility and family behaviour in post-socialist countries was quick and the changes were striking. An account of the changes is the subject of dispute and the mechanisms have still not been explained in a fully satisfying manner. Relatively little attention has been paid to the changes in spatial aspects concerning the broadening of changes in family behaviour. The aim of this paper is to answer the question as to whether changes spread stochastically in post-socialist countries or if there are obvious spatial patterns. The study tries to answer the questions whether there are any cores of changes which may be understood as innovations, if there is any spatial clustering and if the extent is hierarchically arranged. 相似文献
The pyrolised polysilazanes poly(hydridomethyl)silazane NCP 200 and poly(urea)silazane CERASET derived Si–C–N amorphous powders were used for preparation of micro/nano Si3N4/SiC composites by hot pressing. Y2O3–Al2O3 and Y2O3–Yb2O3 were used, as sintering aids. The resulting ceramic composites of all compositions were dense and polycrystalline with fine microstructure of average grain size <1 μm of both Si3N4 and SiC phases. The fine SiC nano-inclusions were identified within the Si3N4 micrograins. Phase composition of both composites consist of , β modifications of Si3N4 and SiC. High weight loss was observed during the hot pressing cycle, 12 and 19 wt.% for NCP 200 and CERASET precursors, respectively. The fracture toughness of both nanocomposites (NCP 2000 and CERASET derived) was not different. Indentation method measured values are from 5 to 6 MPa m1/2, with respect to the sintering additive system. Fracture toughness is slightly sensitive to the SiC content of the nanocomposite. Hardness increases with the content of SiC in the nanocomposite. The highest hardness was achieved for pyrolysed CERASET precursor with 2 wt.% Y2O3 and 6 wt.% Yb2O3, HV 23 GPa. This is a consequence of the highest SiC content as well as the chemical composition of additives. 相似文献
The conducting polymers, polypyrrole and polyaniline, were synthesized by chemical oxidative polymerization of the corresponding monomers in 0.1 M sulfuric acid using cerium(IV) sulfate as the oxidant at mole ratios of oxidant-to-monomer ranging from 0.5 to 3. The yields of the oxidation products were determined, and the samples were characterized with respect to their elemental composition, molecular structure, and morphology. The conductivity of polypyrrole prepared in 0.1 M sulfuric acid, 10?1 to 100 S cm?1, was higher compared with the conductivity of polyaniline prepared under the same conditions, 10?3 to 10?1 S cm?1. The loss of mass after deprotonation with ammonium hydroxide is reported, and discussed in terms of the type of protonation as also reflected by FTIR spectroscopy. The conductivity of polypyrrole bases remained at relatively high level, 10?5 to 10?3 S cm?1, while PANI bases became non-conducting, 10?12 to 10?10 S cm?1. The polymers had a granular morphology in all cases. 相似文献
In the present work, we studied the microstructure, phase constitution, and corrosion performance of Al88Pd12, Al77Pd23, Al72Pd28, and Al67Pd33 alloys (metal concentrations are given in at.%). The alloys were prepared by repeated arc melting of Al and Pd granules in argon atmosphere. The as-solidified samples were further annealed at 700 °C for 500 h. The microstructure and phase constitution of the as-solidified and as-annealed alloys were studied by scanning electron microscopy, energy-dispersive x-ray spectroscopy, and x-ray diffraction. The alloys were found to consist of (Al), εn (~ Al3Pd), and δ (Al3Pd2) in various fractions. The corrosion testing of the alloys was performed in aqueous NaCl (0.6 M) using a standard 3-electrode cell monitored by potentiostat. The corrosion current densities and corrosion potentials were determined by Tafel extrapolation. The corrosion potentials of the alloys were found between ? 763 and ? 841 mV versus Ag/AgCl. An active alloy dissolution has been observed, and it has been found that (Al) was excavated, whereas Al in εn was de-alloyed. The effects of bulk chemical composition, phase occurrence and microstructure on the corrosion behavior are evaluated. The local nobilities of εn and δ are discussed. Finally, the conclusions about the alloy’s corrosion resistance in saline solutions are provided. 相似文献
Introduction of oxygen and nitrogen into organic molecules is one of the fundamental strategies for their functionalization. Traditional approaches rely on the formation of an activated intermediate, which is then modified in a subsequent step. Here we report a simple direct oxidative α‐acetoxylation and azidation of α‐C−H bonds in Tröger's base analogues promoted by N‐bromosuccinimide (NBS) and palladium(II)acetate [Pd(OAc)2] under mild conditions. This approach is pivotal on NBS oxidizing the carbon atoms next to the nitrogen atoms in the presence of Pd(OAc)2 followed by a reaction with oxygen‐ or nitrogen‐centred nucleophiles such as KOAc or NaN3 to yield either the mono‐ and bisacetoxylated or azidated Tröger's base derivatives in a stereo‐ and chemoselective manner. The obtained products can be efficiently modified to access synthetically meaningful structures.
Oxidative stress, oxidative DNA damage and resulting mutations play a role in colorectal carcinogenesis. Impaired equilibrium between DNA damage formation, antioxidant status, and DNA repair capacity is responsible for the accumulation of genetic mutations and genomic instability. The lesion-specific DNA glycosylases, e.g., hOGG1 and MUTYH, initiate the repair of oxidative DNA damage. Hereditary syndromes (MUTYH-associated polyposis, NTHL1-associated tumor syndrome) with germline mutations causing a loss-of-function in base excision repair glycosylases, serve as straight forward evidence on the role of oxidative DNA damage and its repair. Altered or inhibited function of above glycosylases result in an accumulation of oxidative DNA damage and contribute to the adenoma-adenocarcinoma transition. Oxidative DNA damage, unless repaired, often gives rise G:C > T:A mutations in tumor suppressor genes and proto-oncogenes with subsequent occurrence of chromosomal copy-neutral loss of heterozygosity. For instance, G>T transversions in position c.34 of a KRAS gene serves as a pre-screening tool for MUTYH-associated polyposis diagnosis. Since sporadic colorectal cancer represents more complex and heterogenous disease, the situation is more complicated. In the present study we focused on the roles of base excision repair glycosylases (hOGG1, MUTYH) in colorectal cancer patients by investigating tumor and adjacent mucosa tissues. Although we found downregulation of both glycosylases and significantly lower expression of hOGG1 in tumor tissues, accompanied with G>T mutations in KRAS gene, oxidative DNA damage and its repair cannot solely explain the onset of sporadic colorectal cancer. In this respect, other factors (especially microenvironment) per se or in combination with oxidative DNA damage warrant further attention. Base excision repair characteristics determined in colorectal cancer tissues and their association with disease prognosis have been discussed as well. 相似文献
Neutron diffraction data of α-sialon and complementary phases were collected on the neutron powder diffraction (NPD) diffractometer installed in the NFL Studsvik, at a wavelength of 1.470 Å. Calculations were carried out by using the FullProf 2000 utilizing the crystal structure of the yttrium α-sialon phase. Selected profile and structure parameters were refined in the calculations. The calculated data showed that either La or Nd were also present in the α-sialon crystal structure in the presence of Y. The comparison of the present phases' weight contents, which were determined by the qualitative phase analysis between NPD and X-ray diffraction data, was carried out. 相似文献