Evaluating the processability of film blowing resins

A key factor that limits the production rate in film blowing is bubble instability. Although processing conditions play an important role, it is well known that some resins are more resistant to instabilities than others. It is clear that long‐chain branching enhances stability, but it is not currently possible to model the process with sufficient accuracy to establish a quantitative relationship between rheological properties and blown film processability. It would thus be useful to be able to compare the processabilities of film resins by means of a laboratory measurement. We compared two laboratory tests that may be helpful in evaluating the ability of a resin to resist instabilities in the film blowing process. One of these was a film resin tester designed to simulate some aspects of the film blowing process, and the other was an extensional rheometer. We used a set of polyethylene resins that had been used previously in an extensive study of blown film stability. The extensional rheometer clearly shows the superiority of low‐density polyethylene but is not able to distinguish among polymers of other types. The melt tester, on the other hand, is sensitive to differences among linear polymers. POLYM. ENG. SCI., 2009. © 2009 Society of Plastics Engineers     

Mixed Broadcast Techniques of Leisure Information in Vehicular Ad-Hoc Networks

Telecommunication Systems - Vehicle-to-vehicle communication and probabilistic broadcast are important means for information dissemination in vehicular ad-hoc networks (VANETs). In contrast to...     

Cobalt Recovery by the Chlorination-Volatilization Method

Metallurgical and Materials Transactions B - This communication presented the chlorination-volatilization of cobalt using calcium chloride. Effects of variables on the cobalt volatilization rate...     

Shear‐induced crystallization of isotactic polypropylene studied by simultaneous light intensity and rheological measurements

We investigate the effects of high shear rate and a melt‐insensitive, organophosphate nucleating agent on shear‐induced crystallization of four isotactic polypropylenes using a sliding plate rheometer under isothermal, low‐supercooling conditions. We used a bifurcated optical fiber probe to measure light intensity and a shear stress transducer to monitor the simultaneous viscoelastic response to small‐amplitude oscillatory shear. The two techniques complement each other; at early times of crystallization, large attenuation in the light intensity is observed, whereas during the later stages, a major change in the viscoelastic response occurs due to the growing volume fraction of spherulites. In contrast to quiescent crystallization, the nucleation pathway of nucleated polymers after a brief, strong shear is little influenced by the nucleating agent but strongly affected by molecular weight. The early kinetics of non‐nucleated polymers is more strongly enhanced by shear than that of nucleated polymers. Increasing either shear rate or strain accelerates crystallization, and we found the product of shear rate and strain to be useful for correlating our data. POLYM. ENG. SCI., 2011. © 2011 Society of Plastics Engineers     

An energy-aware routing protocol for wireless sensor network based on genetic algorithm

Energy saving and effective utilization are an essential issue for wireless sensor network. Most previous cluster based routing protocols only care the relationship of cluster heads and sensor nodes but ignore the huge difference costs between them. In this paper, we present a routing protocol based on genetic algorithm for a middle layer oriented network in which the network consists of several stations that are responsible for receiving data and forwarding the data to the sink. The amount of stations should be not too many and not too few. Both cases will cause either too much construction cost or extra transmission energy consumption. We implement five methods to compare the performance and test the stability of our presented methods. Experimental results demonstrate that our proposed scheme reduces the amount of stations by 36.8 and 20% compared with FF and HL in 100-node network. Furthermore, three methods are introduced to improve our proposed scheme for effective cope with the expansion of network scale problem.     

Viscosity of CaO–MgO–Al2O3–SiO2 melts containing SiC particles

The influence of SiC particle on viscosity of CaO–MgO–Al₂O₃–SiO₂ melts was investigated by the rotating-cylinder method. It was found that temperature dependence of viscosity could be described by the Arrhenius law for systems with or without SiC particle addition. The activation energies of liquid–solid mixtures were mainly determined by liquid phase. Temperature had little influence on the relative viscosity (defined as the viscosity ratio of solid–liquid mixture to pure liquid). Viscosity and relative viscosity increased as decreasing rotation speed and increasing volume fraction of SiC solid particle. For the same volume fraction of SiC particle, relative viscosity was affected by the liquid slag compositions. The relative viscosity was smaller when composition of liquid slag had a larger CaO/SiO₂ ratio or MgO/Al₂O₃ ratio. Meanwhile, it was found that the smaller SiC particle will lead to a larger relative viscosity.     

Role of GDF15/MAPK14 Axis in Chondrocyte Senescence as a Novel Senomorphic Agent in Osteoarthritis

Osteoarthritis (OA) is most prevalent in older individuals and exerts a heavy social and economic burden. However, an effective and noninvasive approach to OA treatment is currently not available. Chondrocyte senescence has recently been proposed as a key pathogenic mechanism in the etiology of OA. Furthermore, senescent chondrocytes (SnCCs) can release various proinflammatory cytokines, proteolytic enzymes, and other substances known as the senescence-associated secretory phenotype (SASP), allowing them to connect with surrounding cells and induce senesce. Studies have shown that the pharmacological elimination of SnCCs slows the progression of OA and promotes regeneration. Growth differentiation factor 15 (GDF15), a member of the tumor growth factor (TGF) superfamily, has recently been identified as a possible aging biomarker and has been linked to a variety of clinical conditions, including coronary artery disease, diabetes, and multiple cancer types. Thus, we obtained data from a publicly available single-cell sequencing RNA database and observed that GDF15, a critical protein in cellular senescence, is highly expressed in early OA. In addition, GDF15 is implicated in the senescence and modulation of MAPK14 in OA. Tissue and synovial fluid samples obtained from OA patients showed overexpression of GDF15. Next, we treated C20A4 cell lines with interleukin (IL)-1β with or without shGDF15 then removed the conditioned medium, and cultured C20A4 and HUVEC cell lines with the aforementioned media. We observed that C20A4 cells treated with IL-1β exhibited increased GDF15 secretion and that chondrocytes cultured with media derived from IL-1β–treated C20A4 exhibited senescence. HUVEC cell migration and tube formation were enhanced after culturing with IL-1β-treated chondrocyte media; however, decreased HUVEC cell migration and tube formation were noted in HUVEC cells cultured with GDF15-loss media. We tested the potential of inhibiting GDF15 by using a GDF15 neutralizing antibody, GDF15-nAb. GDF15-nAb exerted a similar effect, resulting in the molecular silencing of GDF15 in vivo and in vitro. Our results reveal that GDF15 is a driver of SnCCs and can contribute to OA progression by inducing angiogenesis.