On the reliability of Landsat TM for estimating forest variables byregression techniques: a methodological analysis

In order to build models that relate thematic mapper (TM) imagery to field forest variables, several regression techniques, such as the ones based on the Mallows' C_p and the adjusted R² statistics, were applied. Nevertheless, although the best created models had good fittings (R²>0.65) apparently supported by a clear statistical significance (p<0.0001), later trials tested with additional plots showed that these models were, in fact, nonrobust models (models with very low-predictive capabilities). Two factors were pointed out as causes of these inconsistencies between predicted and observed values: a relatively small number of available field plots and a relatively high number of possible independent variables. Actually, different trials suggested much lower fittings for the expected “really” predictive models. Some restrictions of TM satellite data, such as its radiometric, spectral, and spatial limitations, together with restrictions arising from gathering and processing of field data, might have led to these poor relations. This study shows the need for guarantees stronger than the usual ones before concluding that there is a clear possibility of using satellite information to estimate forest parameters by means of regression techniques     

Evaluation of the completion of influenza vaccination

OBJECTIVE: To find the reasons which determine failures to comply with anti-flu vaccinations, so that these can be corrected and the coverage of this preventive action be increased. DESIGN: Observational crossover study, done by means of a telephone survey of people over 65. A questionnaire with closed questions, composed after a pilot study and validated by Cronbach's alpha. SETTING: Primary Care Centre (PCC). PATIENTS: We calculated a population sample for qualitative variables (_ = 0.05; p = 0.60; e = 0.05) of 294 people over 65, chosen from the PCC records, by means of random sampling (K = 4) stratified for age and discounting the telephone selection bias. MEASUREMENTS AND RESULTS: The proportion of vaccinated patients (60.9%) obtained in our study did not significantly differ from that in the general population. The percentage of patients included in the programme for the first time was 14%. Level of satisfaction among those vaccinated was 89.4%, with 8.9% of problems detected being light. Main causes of non-vaccination were: thinking that they didn't need it (63.5%), ignorance of the campaign (35.7%), fear of the reaction (24.3%), forgetting (10.4%). The main form of access to the campaign information was from the PCC, both through individuals and posters. Lack of information was statistically significant (p < 0.00001) as a determinant of non-vaccination, without other factors (age, sex, associated pathologies...) explaining these differences. CONCLUSIONS: Individualised and on-going health education by the PCC is fundamental. This would enable the identification of the group not vaccinated due to their express refusal and the recovery of non-vaccinated patients.     

Shape memory properties of Ni-Ti based melt-spun ribbons

Shape-memory properties of equiatomic NiTi, Ni₄₅Ti₅₀Cu₅, and Ni₂₅Ti₅₀Cu₂₅ ribbons made by melt spinning have been studied by temperature inducing the martensitic transformation under constant tensile loads. Recoverable strains above 4 pct can be obtained under ∼100 MPa loads for the NiTi and Ni₄₅Ti₅₀Cu₅ ribbons, transforming to B19’ martensite. The B19 martensite is formed in the Ni₂₅Ti₅₀Cu₂₅ ribbon after crystallization, and according to the lowering in transformation strain as Cu content increases, the recoverable strain is close to 2.5 pct for ∼150 MPa load. The transformation temperatures exhibit a linear dependence on the applied stress, which can be quantitatively described by means of a Clausius-Clapeyron type equation. The NiTi and Ni₄₅Ti₅₀Cu₅ ribbons exhibited some degree of two-way shape-memory effect (TWSME) after thermomechanical cycling. Texture analyses performed on the different ribbons allow us to better understand the transformation strains obtained in each ribbon. The amounts of shape-memory effect (SME) and nonrecoverable strain shown by the studied ribbons are of the same order as those already observed in bulk materials, which makes melt spinning an ideal substitute to complicated manufacturing processes if really thin samples are needed. However, applicable stresses in melt-spun ribbons are limited by a relatively “premature” brittle fracture caused by irregularities in ribbon thickness.     

Relative involvement of protein kinase C and of the estrogen receptor in the cytotoxic action of a population of triphenylethylenes on MCF7 cells as revealed by correspondence factorial (CF) analysis

A multivariate statistical method, correspondence factorial (CF) analysis, was used to examine the correlations among the protein binding and cell proliferation effects of a series of 36 di- and triphenylethylenes (DPEs and TPEs). The analysis was applied to a study which measured their competition for estradiol binding to cytosol estrogen receptor (ER), their influence on protein kinase C (PKC) activity under different conditions of enzyme activation, their ability to promote the growth of a breast cancer cell line and to inhibit growth at high concentrations (cytotoxicity). The CF analysis revealed several levels of correlation. First, it distinguished those molecules within the population that stimulated rather than inhibited PKC activity. Second, it made apparent a strong correlation between cytotoxicity and inhibition of Ca++ and phosphatidylserine-dependent PKC activity, which was most marked when the enzyme had been activated by diacylglycerol indicating that PKC inhibition under physiological conditions might contribute to the overall cytotoxicity of these compounds. Third, a lower level of correlation was established between competition for ER binding and cytotoxicity. Taken together, the results suggest that MCF7 cells might be most sensitive to a cytotoxic effect of TPEs (via PKC and other targets) when they at the same time decrease estrogen-stimulated proliferation via an ER-mediated antiestrogenic effect.     

Rapid tamoxifen-induced inactivation of an estrogenic response is accompanied by a localized epigenetic modification but not by mutations

Ethidium was found to be efficiently cross-linked to DNA by glyoxal. Kinetic studies showed that the rate of the cross-linking reaction is strongly dependent on the glyoxal concentration. Comparative studies using a series of phenanthridines and acridines showed that NH2 groups at both the 2 and 7 positions on the phenanthridine ring are necessary for efficient cross-linking. Studies using synthetic polydeoxynucleotides showed that the 2-amino group of guanine is absolutely required for cross-linking. Fluorescence contact energy transfer and relative viscosity experiments showed that the cross-linked drug remains intercalated into DNA. DNA gel electrophoresis and melting studies demonstrated that cross-linked ethidium does not dissociate the DNA double helix to single strands.     

A Methionine Chemical Shift Based Order Parameter Characterizing Global Protein Dynamics

Coupling of side chain dynamics over long distances is an important component of allostery. Methionine side chains show the largest intrinsic flexibility among methyl-containing residues but the actual degree of conformational averaging depends on the proximity and mobility of neighboring residues. The ¹³C NMR chemical shifts of the methyl groups of methionine residues located at long distances in the same protein show a similar scaling with respect to the values predicted from the static X-ray structure by quantum methods. This results in a good linear correlation between calculated and observed chemical shifts. The slope is protein dependent and ranges from zero for the highly flexible calmodulin to 0.7 for the much more rigid calcineurin catalytic domain. The linear correlation is indicative of a similar level of side-chain conformational averaging over long distances, and the slope of the correlation line can be interpreted as an order parameter of the global side-chain flexibility.     

RF MEMS continuous reversible variable inductor based on a microfluidic network

In this work, RF MEMS continuous reversible variable inductor has been fabricated by using microelectronic technology and lamination process. We review, evaluate and compare this variable inductor with other work. The proposed inductor is a dual circular coil and has an inductance of few nH. The fundamental idea is to place a liquid droplet between the metal turns of a coil in order to modify the capacitive/resistive coupling between metal tracks and hence to change the stored magnetic energy. The SU-8 resin was used to realize the microfluidic channels and Au as metallic tracks. To prove the reversibility of the inductor, two cases were studied: filling and emptying of channels. The tuning range of the inductance is approximately 107 % at 1.6 GHz, making these devices very suitable as building blocks in many RF applications.     

Contribution of a disulfide bridge to the stability of 1,3-1,4-P-D-glucan 4-glucanohydrolase from Bacillus licheniformis

Bacillus 1,3-1,4-ß-glucanases possess a highly conserveddisulfide bridge connecting a ß-strand with a solventexposedloop lying on top of the extended binding site cleft The contributionof the disulfide bond and of both individual cysteines (Cys61and Cys90) in the Bacillus licheniformis enzyme to stabilityand activity has been evaluated by protein engineering methods.Reduction of the disulfide bond has no effect on kinetic parameters,has only a minor effect on the activity-temperature profileat high temperatures, and destabilizes the protein by less than0.7 kcal/mol as measured by equilibrium urea denatu ration at37°C. Replacing either of the Cys residues with Ala destabilizesthe protein and lowers the specific activity. C90A retains 70%of wild-type (wt) activity (in terms of Vmax), whereas C61Aand the double mutant C61A–C90A have 10% of wt V_max. Alarger change in free energy of unfolding is seen by equilibriumurea denaturation for the C61A mutation (loop residue, 3.2 kcal/molrelative to reduced wt) as compared with the C90A mutation (ß-strandresidue, 1.8 kcal/mol relative to reduced wt), while the doublemutant C61A–C90A is 0.8 kcal/mol less stable than thesingle C61A mutant. The effects on stability are interpretedas a result of the change in hydrophobic packing that occursupon removal of the sulfur atoms in the Cys to Ala mutations     

Spectrophotometric characterization of human impacted surface waters in the Moselle watershed

In order to characterize the pollution discharged into the Moselle River and some of its tributaries, spectroscopic techniques, namely UV-vis spectroscopy and synchronous fluorescence spectroscopy, have been combined. UV-visible spectra were analysed using the maximum of the second derivative at 225 nm (related to nitrates), the SUVA254 and E2/E3 indices (related to the nature of organic matter). Synchronous fluorescence spectra (delta lambda = 50 nm) presented different shapes depending upon the type of pollution. The pollution results from anthropogenic activities: untreated domestic sewage due to misconnections in a periurban river, effluent from urban WWTPS, agricultural runoff (nitrates) in several streams, discharge from a paper mill (humic-like substances due to wood processing) and from steel mills (PAHs).