A Broadband Dual Circularly Polarized Compact Printed Monopole Antenna

Wireless Personal Communications - Now-a-days the most common pretentious disease is the lung cancer, which has become more prevalent in the world that primarily infects the pulmonary nodules of...     

Agronomic performance of high oleic,low linolenic soybean in Tennessee

Soybean oil hydrogenation alters the linolenic acid molecule to prevent the oil from becoming rancid, however, health reports have indicated trans-fat caused by hydrogenation, is not generally regarded as safe. Typical soybeans contain approximately 80 g kg⁻¹ to 120 g kg⁻¹ linolenic acid and 240 g kg⁻¹ of oleic acid. In an effort to accommodate the need for high-quality oil, the United Soybean Board introduced an industry standard for a high oleic acid greater than 750 g kg⁻¹ and linolenic acid less than 30 g kg⁻¹ oil. By combing mutations in the soybean plant at four loci, FAD2-1A and FAD2-1B, oleate desaturase genes and FAD3A and FAD3C, linoleate desaturase genes, and seed oil will not require hydrogenation to prevent oxidation and produce high-quality oil. In 2017 and 2018, a study comparing four near-isogenic lines across multiple Tennessee locations was performed to identify agronomic traits associated with mutations in FAD3A and FAD3C loci, while holding FAD2-1A and FAD2-1B constant in the mutant (high oleic) state. Soybean lines were assessed for yield and oil quality based on mutations at FAD2-1 and FAD3 loci. Variations of wild-type and mutant genotypes were compared at FAD3A and FAD3C loci. Analysis using a generalized linear mixed model in SAS 9.4, indicated no yield drag or other negative agronomic traits associated with the high oleic and low linolenic acid genotype. All four mutations of fad2-1A, fad2-1B, fad3A, and fad3C were determined as necessary to produce a soybean with the new industry standard (>750 g kg⁻¹ oleic and <30 g kg⁻¹ linolenic acid) in a maturity group-IV-Late cultivar for Tennessee growers.     

Nutritional components as mitigators of cellular senescence in organismal aging: a comprehensive review

Food Science and Biotechnology - The process of cellular senescence is rapidly emerging as a modulator of organismal aging and disease. Targeting the development and removal of senescent cells is...     

A comparative study on hygroscopic and physiochemical properties of chicken powders obtained by different drying methods

Abstract

Different drying methods (spray drying (SD), vacuum drying (VD), microwave vacuum drying (MVD), and infrared vacuum drying (IFVD)) were applied in order to compare the hygroscopicity behavior of chicken powders. The hygroscopicity curves and glass transition temperature were used to evaluate the influence of ambient humidity and temperature on moisture absorption of powders. The results showed that the chicken powder dried by MVD had the lowest moisture absorption, followed by IFVD, VD, and SD. The hygroscopicity of SD chicken powders was different from other three kinds of chicken powders due to the physical properties of particles and the changes of protein secondary structure as detected by the Fourier transform-infrared spectrometer. For the three vacuum drying methods, the difference of protein secondary structure was the main reason of differences in hygroscopicity. Although MVD chicken powders were slightly inferior to SD chicken powders in taste, MVD chicken powders were the best in terms of smell and color as suggested by instrumental sensory parameter evaluations. It was found that MVD had a positive effect on reducing moisture absorption and maintaining sensory quality of chicken powders.     

Design,Synthesis, and Self-Assembly Studies of a Suite of Monodisperse,Facially Amphiphilic,Protein–Dendron Conjugates

The custom design of protein–dendron amphiphilic macromolecules is at the forefront of macromolecular engineering. Macromolecules with this architecture are very interesting because of their ability to self-assemble into various biomimetic nanoscopic structures. However, to date, there are no reports on this concept due to technical challenges associated with the chemical synthesis. Towards that end, herein, a new chemical methodology for the modular synthesis of a suite of monodisperse, facially amphiphilic, protein–dendron bioconjugates is reported. Benzyl ether dendrons of different generations (G1–G4) are coupled to monodisperse cetyl ethylene glycol to form macromolecular amphiphilic activity-based probes (AABPs) with a single protein reactive functionality. Micelle-assisted protein labeling technology is utilized for site-specific conjugation of macromolecular AABPs to globular proteins to make monodisperse, facially amphiphilic, protein–dendron bioconjugates. These biohybrid conjugates have the ability to self-assemble into supramolecular protein nanoassemblies. Self-assembly is primarily mediated by strong hydrophobic interactions of the benzyl ether dendron domain. The size, surface charge, and oligomeric state of protein nanoassemblies could be systematically tuned by choosing an appropriate dendron or protein of interest. This chemical method discloses a new way to custom-make monodisperse, facially amphiphilic, protein–dendron bioconjugates.     

Effect of 100 KeV Ar+ ion beam irradiation on ZnO thin films – Influence of morphology vis-a-vis electrode/electrolyte interface and its impact on photoelectrochemical water splitting

The present study attempts quantitative determination of changes in the morphological surface features viz. fractal dimension, lower and upper cut off length scale through Power Spectral Density analysis prior to and after irradiation of 100 KeV Ar⁺ ion beam at incidence angles of 0°, 40° and 60° on ZnO thin films. All the unirradiated and irradiated samples are subjected to photoelectrochemical characterization and a correlation between photoelectrochemical performance and morphological parameters is established. Sample irradiated at 40° angle at the fluence of 5 × 10¹⁶ ions/cm² is found to possess maximum fractal dimension of 2.72, lower and upper cut off length scale of 3.16 nm and 63.00 nm respectively. This sample exhibits maximum photocurrent density of 3.19 mA/cm² and applied bias photon-to-current efficiency of 1.12% at 1.23 V/RHE. Hydrogen gas collected for duration of 1 h for the same sample was ~4.83 mLcm^?2.     

Effects of DEM Source,Spatial Resolution and Drainage Area Threshold Values on Hydrological Modeling

Water Resources Management - Automated computation of hydrological and morphometric parameters of any watershed are not only depended on Digital Elevation Model (DEM) resolution but also affected...     

Physical Aging of Amorphous Fructose

ABSTRACT: Physical aging of amorphous anhydrous fructose at temperature 5 °C and at 22 °C was studied using differential scanning calorimetry (DSC). The dynamic glass transition temperature, T_g0 for unaged samples was 16 °C and 13.3 °C for heating rate of 10 °C/min and 1 °C/min, respectively. The fictive temperature, T_f0 for unaged samples calculated by Richardson and Savill method was 12 °C, which is close to the dynamic value obtained from the lower DSC heating rate. The fictive temperature T_f of the aged fructose glasses at temperatures both below and above the transition region was fitted well by a non-exponential decay function (Williams-Watts form). Aging above the transition region (22 °C) for 18 d increased both the dynamic glass transition temperature T_g and the fictive temperature T_f. However, aging below the transition region (5 °C) for 1 d increased the dynamic glass transition temperature T_g but decreased the fictive temperature T_f.     

Fuzzy Multiobjective and Linear Programming Based Management Models for Optimal Land-Water-Crop System Planning

In this article, linear programming and fuzzy optimization models are developed for planning and management of available land-water-crop system of Mahanadi-Kathajodi delta in eastern India. The models are used to optimize the economic return, production and labour utilization, and to search the related cropping patterns and intensities with specified land, water, fertilizer and labour availability, and water use pattern constraints. Due to extreme backwardness of the study area, it has been decided to keep all the three objectives of the linear programming models at the same priority level to obtain the compromised solution in a fuzzy environment that incorporates the imprecision in fuzzy goals and fuzzy constraints. These non-structural models facilitate the conjunctive use of available surface water and groundwater resources. A comparative evaluation along with the benefit-cost ratios of the existing and proposed farming systems is also presented.     

Comparison of the periodic solution method with TRNSYS and SUNCODE for thermal building simulation

Based on periodic solutions of the governing heat conduction equations in a single zone building, computer software ADMIT has been developed for thermal simulation of buildings. Standard computer software, namely TRNSYS and SUNCODE, have also been used to simulate the same building under similar conditions. Simulations have been performed for three different climatic zones in India for light and heavy constructions under conditions of glazed/unglazed areas and ventilation rates. The results are presented in terms of the hourly variation of the room temperature. For insulated heavy construction, the results of different models are significantly different. This difference is due to the use of different approaches to solve the heat conduction equations. SUNCODE depends on the RC network approach and underestimates the heat losses. TRNSYS uses the transfer function approach, which is sensitive to the initially assumed value of the room temperature. ADMIT represents a quasi-steady-state periodic variation and is not suitable for transient variations. For insulated light buildings, the heat transfer mechanisms used in the mathematical models are not the governing factors. The models also differ in treating the penetration of solar radiation through a glazed window and the subsequent heat-transfer mechanism. For a south window and air changes in an insulated building, the results obtained by SUNCODE and ADMIT are in good agreement, but the results obtained by TRNSYS are considerably different. The reason for this needs detailed analysis.