Practical method for generation expansion planning based on dynamic programming

This paper presents an efficient method which provides the optimal generation mix and the optimal generation construction process. The approximation method in which the dynamic programming technique and gradient method are combined is applied to determine the optimal generation mix with hydropower generation technologies. The successive approximations dynamic programming (SADP) technique, which is very suitable for high-dimensional multistage decision process problems, is used for obtaining the optimal generation construction process. The effectiveness and feasibility of the developed technique are demonstrated on a practical power system model which has five types of generation technologies including a hydropower generation technology.     

Effects of nondensifying inclusions on the densification and microstructure of zinc oxide matrix composites

The densification and microstructure development of ZnO containing Zn₇Sb₂O₁₂, ZrO₂, and aggregated ZnO were investigated to elucidate the effect of nondensifying inclusions on the sintering of ceramic/ceramic composites. The inclusion retarded the densification, and the degree of retardation was found to depend on the chemical species of inclusion; Zn₇Sb₂O₁₂ had the largest effect, followed by ZrO₂ and then aggregated ZnO last. The experimental results for aggregated ZnO was explained by the theory which predicts the generation of backstresses. The backstresses give a less significant effect on the densification. For Zn₇Sb₂O₁₂ and ZrO₂, the microstructure of the matrix varied with distance from an inclusion particle; much porosity was observed in the region surrounding the inclusion. Circumferential voids, which are responsible for the suppression of densification, form during the initial stage of sintering. Inclusion particles generate an anchoring effect which retards the densification of the matrix immediately surrounding the inclusion particle during the intermediate stage.Supported by the Inamori Foundation.     

Gel chromism and anomalous luminescence in poly(3-alkylthiophene)

The absorption spectrum of poly(3-alkylthiophene) gel changes drastically in association with a volume instability upon changing the solvent composition and also the temperature. In the expanded state in chloroform and at high temperature, the photoluminescence is much enhanced compared with the shrunken state in ethanol and at low temperature. This gel chromism and anomalous luminescence are discussed in terms of the change of effective conjugation length induced by the steric hindrance and the dynamics of the photoexcited species.     

Interconnected power systems with superconducting magnetic energy storage

The objective of this work is to discuss the concept of back‐to‐back interconnection systems with energy storage, especially with a Superconducting Magnetic Energy Storage (SMES) incorporated into a back‐to‐back DC link. In this case, each converter of the back‐to‐back system is used as a power conditioning system for the SMES coils. Since the AC–DC converter can be designed independently of the frequency of the power system, a two‐way switch is connected to the AC side of each converter. This two‐way switch can select the interconnected power systems. By using the two‐way switches, this system can provide the stored energy in the SMES system to each interconnected power system through two AC–DC converters. For instance, lower‐cost power of each power network can be stored through two converters during the off‐peak hours and made available for dispatch to each power network during periods of demand peak. Then this system increases the reliability of electric power networks and enables the economical operations depending on the power demand. This paper describes the unique operations of the back‐to‐back interconnection with SMES and discuses the optimal SMES configuration for a 300‐MW‐class back‐to‐back interconnection. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 164(2): 37–43, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20482     

Dietary effect of a symmetrical triacylglycerol, 1,3-biseicosapentaenoyl-2-γ-linolenoyl glycerol, on fatty acid composition of guinea pigs

The dietary effect of 1,3-biseicosapentaenoyl-2-γ-linolenoyl glycerol (STG) on the fatty acid composition of guinea pigs was examined and compared with that of an eicosapentaenoic acid ethyl ester (EPA-F) and of a soybean oil (SBO) diet. In terms of content of plasma lipid, EPA-E had a greater hypolipidemic effect than STG. On the other hand, in terms of EPA incorporation, contents of EPA in liver lipid were almost the same in the STG and EPA-E groups. Considering that the amount of EPA administered in the EPA-E group was almost 1.5 times that of the STG group, FPA may be absorbed more effectively as the glycerol ester than as the ethyl ester in guinea pigs. In all the tissue lipids, the STG group had a higher unsaturation index (UI) than the EPA-E group even though there is a lower UI in the STG diet than the EPA-E diet. These results suggest that greater amounts of desaturase products as a whole were synthesized in the STG group than in the other two groups. The dihomo-γ-linolenic acid/arachidonic acid (DGLA/AA) ratio in plasma total lipids in the STG group was 3.5 times that of SBO group, and the DGLA/AA ratio in the EPA-E group was half that of the SBO group. In liver lipid, the ratios of DGLA/AA and EPA/AA in the STG group were 0.687 and 0.488 (phosphatidylcholine fraction) and 0.237 and 0.752 (phosphatidylethanolamine fraction), respectively. The ratio of DGLA/AA as well as the high EPA/AA ratio obtained in the present study with the STG diet may lead to physiological alterations, including enhanced synthesis of 1-and 3-series eicosanoids.     

Mapping evapotranspiration using MODIS and MM5 Four-Dimensional Data Assimilation

Evapotranspiration (ET), the sum of evaporation from soil and transpiration from vegetation, is of vital importance in the hydrologic cycle and must be taken into consideration in assessments of the water resources of any region. The MODerate resolution Imaging Spectroradiometer (MODIS) sensor offers a promising opportunity for estimating daily ET with a 1 km spatial resolution, but is hampered by frequent cloud contamination or data gaps from other factors. In this study, 1) a stand-alone ET model was applied and tested during clear or partial cloudy sky conditions using MODIS-based inputs of land surface and atmospheric data and 2) meteorological simulations by using Four-Dimensional Data Assimilation (FDDA) system between MODIS and the 5th Generation Meso-scale Meteorological Model (MM5) was used in cloudy conditions to facilitate continuous daily ET estimates. The MODIS ET algorithm modified from Mu et al. (2007) is based on the Penman-Monteith equation and was applied to predict ET at flux measurement sites. This algorithm considers both the effects of surface energy partitioning processes and environmental constraints on ET. We devised gap-filling approaches for MODIS aerosol and albedo data that were identified as bottlenecks to determine retrieval rates of insolation and ET. MODIS-derived input variables (i.e., meteorological variables and radiation components) for estimating ET showed a good agreement with flux tower observations at each site. The retrieval rate of MODIS ET doubled at four flux measurement sites after gap-filling with negligible compensation was undertaken for accuracy. In spite of the high accuracy of MODIS-derived input variables, MODIS ET showed meaningful errors at the four flux measurement sites. These errors were mainly associated with errors in the estimated canopy conductance. During clear sky conditions, MODIS was used to calculate ET, while the MODIS-MM5 FDDA system provided input variables for the calculation of ET under cloudy sky conditions. The performance of the MODIS-MM5 FDDA system was evaluated by comparing ET based on MODIS, which showed a good agreement with the MODIS ET for various land cover types. Our results indicate that MODIS can be applied to monitor the land surface energy budget and ET with reasonable accuracy and that MODIS-MM5 FDDA has the potential to provide reasonable input data of ET estimation under cloudy conditions.     

Effects of heated seat and foot heater on thermal comfort and heater energy consumption in vehicle

Subjective experiments involving 12 different conditions were conducted to investigate the effects of heated seats and foot heaters in vehicles on thermal sensation and thermal comfort. The experimental conditions involved various combinations of the operative temperature in the test room (10 or 20°C), a heated seat (on/off) and a foot heater (room operative temperature?+10 or?+20°C). The heated seat and foot heater improved the occupant's thermal sensation and comfort in cool environments. The room operative temperature at which the occupants felt a 'neutral' overall thermal sensation was decreased by about 3°C by using the heated seat or foot heater and by about 6°C when both devices were used. Moreover, the effects of these devices on vehicle heater energy consumption were investigated using simulations. As a result, it was revealed that heated seats and foot heaters can reduce the total heater energy consumption of vehicles. Statement of Relevance: Subjective experiments were conducted to investigate the effects of heated seats and foot heaters in vehicles on thermal comfort. The heated seat and foot heater improved the occupant's thermal sensation and comfort in cool environments. These devices can reduce the total heater energy consumption in vehicles.     

The convex-concave characteristics of Gaussian channel capacity functions

In this correspondence, we give several inherent properties of the capacity function of a Gaussian channel with and without feedback by using some operator inequalities and matrix analysis. We give a new proof method which is different from the method appearing in: K. Yanagi and H. W. Chen, "Operator inequality and its application to information theory," Taiwanese J. Math., vol. 4, no. 3, pp. 407-416, Sep. 2000. We obtain the following results: C/sub n,Z/(P) and C/sub n,FB,Z/(P) are both concave functions of P, C/sub n,Z/(P) is a convex function of the noise covariance matrix and C/sub n,FB,Z/(P) is a convex-like function of the noise covariance matrix. This new proof method is very elementary and the results shall help study the capacity of Gaussian channel. Finally, we state a conjecture concerning the convexity of C/sub n,FB,/spl middot//(P).     

Condensation of organic binary mixtures flowing horizontally in a horizontal tube bundle

Both heat and mass transfer in the gas phase and heat transfer in the liquid phase are examined experimentally for film condensation of organic binary mixtures such as ethanol-water and methanol-water. Experimental results on the average heat flux, vapor-liquid interface temperature and liquid-phase Nusselt number are compared with analytical solutions based on stagnant film theory and heat-transfer relationships for film condensation from a pure vapor. Experimental heat transfer results agree well with the analytical solutions, except that the experimental liquid-phase Nusselt numbers under conditions of low mass fraction of water are considerably higher than predicted by the analytical solutions. This high value of the liquid-phase Nusselt number is considered to be caused by dropwise condensation in the liquid phase. However, its effect on the tube bundle is not so remarkable compared with that in gravity-controlled condensation on a vertical surface. This is considered to be caused by the condensate inundation effect. © 1997 Scripta Technica, Inc. Heat Trans Jpn Res, 25(6): 342–361, 1996     

Contamination levels of PCDDs, PCDFs and Co-PCBs in commercial baby foods in Japan

To examine dioxin contamination in commercial baby foods in Japan, congener analyses of polychlorinated dibenzo-p-dioxins (PCDDs), polychlorinated dibenzofurans (PCDFs) and coplanar polychlorinated biphenyls (Co-PCBs) were performed on 102 varieties of baby foods obtained from supermarkets in 2001-2002. The toxic equivalent quantity (TEQ) levels for dioxins in samples ranged from < 0.001 to 0.135 pg-TEQ/g wet weight when undetected or trace levels of congeners were taken as zero. Among 102 samples tested, 26 samples exceeded 0.010 pg-TEQ/g. The highest TEQ value was for "sardine, vegetables" (0.135 pg-TEQ/g), followed by "Japanese radish (daikon), sardine" (0.080 pg-TEQ/g). Thus, dioxins were detected at low levels in baby foods containing animal products such as fishes and/or dairy products.