Linear and nonlinear viscoelastic and viscoplastic analysis of asphalt binders with warm mix asphalt additives

Warm-Mix Asphalt (WMA) is a widely used product, which proved a contribution to the reduction in asphalt mixing and compaction temperatures. This reduction leads to lower fuel consumption and smoke emission in asphalt plants. Most of the characterisation of binders used in WMA has focused in the past on measuring linear viscoelastic properties and associated Superpave parameters. Several studies have shown that the average stresses and strains of the asphalt mixture remain mostly within the linear viscoelastic response. However, localised strains in the binder phase of the mixture could reach values high enough to induce nonlinear viscoelastic and viscoplastic deformations. Therefore, this study focuses on an experimental and analytical evaluation of linear, nonlinear viscoelastic and viscoplastic responses of selected binders modified for use in WMA. The first part of the paper analyses the linear viscoelastic material properties and their ability to evaluate permanent deformation resistance. Then, the non-recoverable creep compliance parameter obtained from the Multiple Stress Creep Recovery (MSCR) test is analysed to assess the nonlinear response and permanent deformation of asphalt binders. The paper utilises a nonlinear plasto-viscoelastic (NPVE) approach to assess and quantify the nonlinear plasto-viscoelastic response of binders by separating the recoverable and irrecoverable strains measured in the MSCR test. Two WMA additives were included in this study by mixing them with polymer-modified and unmodified asphalt binders. Analysis of results showed that the NPVE approach captured a higher percentage of recovery than the NLVE approach. However, binder’s performance evaluation and ranking did not change by adopting the NPVE approach. The nonlinear viscoelastic parameters provided insight on the behaviour of asphalt binders mixed with WMA additives during loading cycles. Sasobit showed higher influence than Advera on binders in resisting permanent deformation by increasing the recoverable strain during the unloading phase.     

An investigation of three novel nonionic surfactants as corrosion inhibitor for carbon steel in 0.5 M H2SO4

The inhibition effect of three novel nonionic surfactants, 2-((alkylimino)methyl)phenyl bis(53-hydroxy-3,6,9,12,15,18,21,24,27,30,33,36,39,42,45,48,51-heptadecaoxatripentacontyl) phosphate (I–III), on the corrosion of carbon steel in 0.5 M H₂SO₄ was studied by polarization, EIS and weight loss measurements. It was found that all the inhibitors were effective inhibitors and their inhibition efficiency was significantly increased with increasing both concentration and temperature. Polarization curves revealed that the used inhibitors represent mixed-type inhibitors. Adsorption of used inhibitors led to a reduction in the double layer capacitance and an increase in the charge transfer resistance. Adsorption of used compounds was found to obey Langmuir isotherm and showed a chemical mechanism.     

Hypocholesterolaemic effect of yoghurt containing Bifidobacterium pseudocatenulatum G4 or Bifidobacterium longum BB536

The effect of a yoghurt supplement containing Bifidobacterium pseudocatenulatum G4 or Bifidobacterium longum BB536 on plasma lipids, lipid peroxidation and the faecal excretion of bile acids was examined in rats fed a cholesterol-enriched diet. After 8 weeks, the rats in the positive control (PC) group who were fed the cholesterol-enriched diet showed significant increases in plasma total cholesterol (TC), low-density lipoprotein (LDL) cholesterol, and malondialdehyde (MDA). However, groups fed a cholesterol-enriched diet supplemented with yoghurt containing B. pseudocatenulatum G4 or B. longum BB536 had significantly lower plasma TC, LDL-C, very-low-density lipoprotein (VLDL) cholesterol, and MDA than had the PC group after 8 weeks of treatment. In addition, faecal excretion of bile acids was markedly increased in the rats fed the yoghurt containing B. pseudocatenulatum G4 or B. longum BB536 as compared to the PC and NC groups.     

Effect of Doping of Zn and Ca into ErBa2Cu3O7?δ Superconductor Prepared via Co-precipitation Method

Zn- and Ca-doped ErBa₂Cu₃O_7−δ were successfully prepared via coprecipitation method using metal acetates as the starting salts. The precipitated samples were calcined for 20 h at 900 °C and sintered at 920 °C for 24 h. All heat treatments were carried out under oxygen environment. Results show that there is a selectivity of the doping site depending on the ionic radius of the dopant. Furthermore, increase in the critical temperature, T _c , was observed in 0.05 mole of calcium and zinc doped samples. The difference in ionic radius of the dopant led to the increase in porosity as the ionic radius decreases. On the other hand, structural distortion increased as the difference of ionic radius became larger.     

Fault localization algorithm in computer networks by employing a genetic algorithm

Abstract

Fault localization is an important part in communication networks. Faults are unwanted and unavoidable in communication systems, and hence, their quick detection and localization is essential for sustaining the health of the network. This paper proposes an end-to-end approach that uses passive measurements for fault localization in communication networks. We formulate the fault localisation issue as an optimisation problem and then employ the genetic algorithm technique to solve it. Extensive simulation results show that although our algorithm needs to test only a small set of network components to localise all faults, it can infer the faulty nodes in at least 97% of cases. This simulation shows that the proposed algorithm, called genetic algorithm-based fault localisation is superior to the other approaches to localise all faults in a network.     

Impact of bismuth oxide on the structure,optical features and ligand field parameters of borosilicate glasses doped with nickel oxide

Understanding the impact of bismuth cations on the optical properties of borosilicate glass is significant for manipulating borate glass applications. In this paper, the influence of bismuth cations on both structural and optical properties of borosilicate glass doped with NiO was investigated. Different glass samples, containing different amounts of Bi₂O₃ and a constant amount of NiO, were prepared and studied. Infrared (IR) analysis was carried out to study the internal structure within the investigated glass samples. Optical absorption studies were performed to investigate the impact of Bi₂O₃ content on optical properties of the BiBaNiB-glasses. Astonishingly, with Bi₂O₃ addition, an absorption band at 380 nm has appeared. Moreover, this band is overlapped with the Urbach edge; which regularly produced an artificial edge-like feature at ~450 nm. A detailed deconvolution protocol has been implemented for an appropriate understanding of these spectra and unraveling the hidden Urbach edge. Optical band gap energy, linear and nonlinear refractive index for each BiBaNiB sample were calculated. Furthermore, the metallization criterion was calculated to examine the metallic or insulating nature of the BiBaNiB-glasses. The values of the nonlinear third-order susceptibility and nonlinear refractive index were increased with Bi₂O₃ doping. The BiBaNiB-glasses exhibited outstanding stability and optical band gap than the pristine glass sample, which makes it possible for practical applications.     

Mangrove Oyster (Crassostrea belcheri) as a Biomonitor Species for Bioavailability of Polycyclic Aromatic Hydrocarbons (PAHs) from Sediment of the West Coast of Peninsular Malaysia

ABSTRACT

Rapid industrialization and urbanization in the west coast of Peninsular Malaysia has caused increasing pollution particularly of petroleum and petroleum by-products. Surface sediment and mangrove oyster (Crassostrea belcheri) were collected from five mangrove ecosystems in the west coast of Peninsular Malaysia and investigated for bioavailability of polycyclic aromatic hydrocarbons (PAHs). Sampling locations were selected from both remote areas with few or no previous records of petroleum pollution such as Pulau Merambong and polluted areas that are under international attention such as Klang mangrove ecosystem. PAH fractions were obtained through soxhlet extraction and two-step column chromatography and the fractions were injected to gas chromatography-mass spectrometry (GC-MS) for analysis. The concentrations of PAHs ranged from 151 to 4973 ng g^?1 dw in the sediments, while from 309 to 2225 ng g^?1 dw in the oysters. When tested for diagnostic ratios, a predominance of pyrogenic source PAHs was detected in the sediments, whereas PAHs in the oysters had mixed petrogenic and pyrogenic sources. A significant correlation (p < 0.05) was found between high molecular weight (HMW) PAHs in the sediments and oysters and biota accumulation factors (BAFs) of PAHs were approaching or exceeding unity indicating the ability of mangrove oyster in bioaccumulation of PAHs. Overall, this study indicates that mangrove oyster (C. belcheri) can be used as a biomonitor species for PAHs in an aquatic environment.