Safety assessment of Lactobacillus strains: presence of putative risk factors in faecal, blood and probiotic isolates

The widespread use of immunosuppressive therapy and antimicrobial agents as well as novel probiotics without a long history of safe use has increased requirements for safety assessment of probiotic lactobacilli. In this study 44 faecal, 52 blood and 15 probiotic isolates (including 3 dairy strains) of Lactobacillus were assayed for their adhesion properties to extracellular matrix proteins and mucus, hemolysis, ability to avoid the induction of respiratory burst in peripheral blood mononucleocytes (PMN) and resistance to human serum. Among tested strains adhesion to collagen, fibrinogen and mucus was isolate-specific and no statistically significant differences were obtained between faecal, blood and probiotic isolates. However, blood isolates showed a trend for higher adhesion to mucus than probiotic strains (P=0.07). Probiotic strains induced lower respiratory burst in PMN when compared to the blood isolates (P<0.05). Moreover, there was a positive correlation between adhesion to collagen and induction of respiratory burst for faecal isolates (P<0.05). In the determination of serum resistance, probiotic strains showed a trend for lower sensitivity to human serum-mediated killing when compared to the faecal isolates (P=0.07). None of the measurable virulence factors were found to be present at statistically higher level in clinical blood isolates when compared to faecal and/or probiotic isolates indicating that these factors do not cause risk when safety of probiotics is considered. However, the significance of adhesion to mucus, low induction of respiratory burst in PMN and resistance to human serum-mediated killing may need further evaluation in experimental animal models and in epidemiological data.     

Polyacrylamides revisited: flocculation of kaolin suspensions and mature fine tailings

A series of acrylamide‐based water‐soluble (co)polymers was synthesized and they were investigated as flocculants of model kaolin suspensions and mature fine tailings of oil sands. The effects of molar mass, charge density, and polymer concentration on flocculation efficiency were studied by monitoring the initial settling rate during sedimentation. Hydrolyzed polyacrylamide (HPAM) with high molar mass and intermediate acrylic acid contents (0.14–0.41 mol/mol (14–41 mol%)) performed better in flocculation tests on kaolin suspensions requiring lower dose for maximum initial settling rate than native polyacrylamide (PAM). Surface force measurements showed that at low polymer concentrations (1 ppm), the partially‐adsorbed polymer induced a bridging attraction between the mica surfaces. Increasing the polymer concentration to 10 and 50 ppm caused purely repulsive forces. The presence of anionic groups in HPAM led to stronger repulsion, which was also demonstrated by the higher viscosity and larger hydrodynamic radius of the charged polymer. The charge‐induced increase in the viscosity of polymer solutions was suppressed by the screening effect of salts in a buffer solution and reducing the viscosity is desirable in the injection of flocculants in the industrial process.     

Triboelectric charging of fungal spores during resuspension and rebound

The triboelectric charging of fungal spores was experimentally characterized during rebound and resuspension. A fungal spore source strength tester (FSSST) was used as a primary aerosol generator for spores of three fungal species and two powders (silicon carbide and silver). The critical velocity of rebound was determined using a variable nozzle area impactor (VNAI), and the charging state of particles after resuspension and rebound was measured using the FSSST, different impactor setups, electrometers, and optical particle counters. In the impactor setups and the FSSST, five different surface materials relevant for indoor environments were used (steel, glass, polystyrene, paper, and polytetrafluoroethylene). The critical velocity of rebound was determined to be 0.57 m/s for fungal spores, which is relatively low compared to silicon carbide and previous results for micron-sized aerosol particles. Based on the rebound impactor measurements, we were able to define the crucial parameters of charge transfer for different particle–surface material pairs. A contact charge parameter, which describes the triboelectric charging during rebound, was found to have a negative correlation with the charging state of the particles after the resuspension from an impactor. This connects the triboelectric charging during rebound and resuspension to each other. Based on the contact charge parameter values, quantified triboelectric series could be formed. The results of this work show that fungal spores can be charged both positively and negatively during rebound and resuspension depending on the fungal species and surface material.

Copyright © 2016 American Association for Aerosol Research     

Drought Stress Alters the Concentration of Wood Terpenoids in Scots Pine and Norway Spruce Seedlings

Drought is known to have an impact on the resistance of conifers to various pests, for example, by affecting resin flow in trees. Little is known, however, about the quantitative and qualitative changes in resin when trees are growing in low moisture conditions. We exposed Scots pine (Pinus sylvestris L.) and Norway spruce (Picea abies (L.) Karst.) seedlings to medium and severe drought stress for two growing seasons and analyzed the monoterpenes and resin acids in the main stem wood after two years of treatment. In addition to secondary chemistry, we measured the level of nutrients in the needles and the growth response of seedlings. After the first year of treatment, drought stress did not affect the growth of seedlings, but in the second year, shoot growth was retarded, especially in Scots pine. In both conifer species, severe drought increased the concentrations of several individual monoterpenes and resin acids. Total monoterpenes and resin acids were 39 and 32% higher in severe drought-treated Scots pine seedlings than in the controls, and 35 and 45% higher in Norway spruce seedlings. In Scots pine needles, the concentrations of nitrogen and phosphorus increased, while magnesium and calcium decreased compared to controls. In Norway spruce needles, nutrient concentrations were not affected. The results suggest that drought stress substantially affects both the growth of conifers and the chemical quality of the wood. We discuss the potential trade-off in growth and defense of small conifer seedlings.     

Efficacy and environmental acceptability of two ballast water treatment chemicals and an alkylamine based-biocide

Ship's ballast waters transport large numbers of organisms which may become invasive in coastal regions. One option to address this problem is the use of biocides as ballast water treatment (BWT). Efficacy and environmental acceptability of three commercial active substances (the BWT biocides Peraclean^® Ocean and Seakleen^®, and alkylamine-based biocide Mexel^® 432/336) were tested against three bacteria species, two vegetative microalgae and one zooplanktonic larva, in 10 and 30 Practical Salinity Unit (PSU) waters. In both salinities, PeraClean^® Ocean was the most effective biocide against bacteria causing > 90% mortality at 20 mg/l, compared with 50 mg/l for Mexel^® 432/336 and > 500 mg/l for Seakleen^®. Regarding zooplankton, Seakleen^® was the most effective chemical causing 90% mortality in 24 h at concentrations < 6 mg/l (LC90_24 h) in both salinities, compared with 23 and 26 mg/l for Mexel^® 432/336 and 370 and 480 mg/l for PeraClean^® Ocean in 10 and 30 PSU, respectively. Similar pattern of efficacy was obtained for microalgae in 30 PSU: effective concentrations inducing 50% growth inhibition in 4 days were ≤ 1.6 mg/l for Seakleen^®, ≤ 10.1 mg/l for Mexel^® 432/336 and ≤ 30.9 mg/l for PeraClean^® Ocean. Our work highlighted that treated waters displayed residual toxicity after 24 h still inducing mortality depending on the organism and biocide. However Mexel^® 432/336 is the only biocide which had no impact on oyster larvae development at effective concentration. Altogether our data showed that Mexel^® 432/336 was the only biocide displaying a broad spectrum efficacy in concentrations < 50 mg/l and not toxic for oyster larvae development at this concentration. However residual toxicity of treated waters for any organism should be taken into account in BWT systems utilising biocides.     

Culturable and Total Fungi in Dust Accumulated in Air Ducts in Single-Family Houses

Abstract Fungal spore content in dust accumulated in air ducts was investigated in 24 mechanically ventilated single-family houses of which 15 had also a central air heating system. Dust was collected from the ducts simultaneously with cleaning of the ventilation systems. Besides spore concentrations and flora of culturable fungi, total fungal spore concentrations were determined in dust samples by the aqueous two-phase technique and spore counting with epifluorescence microscopy. Culturable spore concentrations in the dust varied from 10⁴ to 10⁷ CFU/g and total spore concentrations from 107 to 108 spores/g. Total spore concentrations in the duct dust were significantly higher in the air heated houses than in the other mechanically ventilated houses. The difference resulted mainly from a higher proportion of recirculation air and a higher age of the air heated houses. Cladosporium, Penicillium, Aspergillus and yeasts consisted of >90% of fungal flora in the dust. Although total spore concentrations were at the same level both in the exhaust and in the supply ducts in both types of house, culturable fungal spore concentrations were slightly higher in the exhaust ducts than in the supply ducts. The proportion of culturable spores was <5% of total spores in dust accumulated in the ducts.     

Water Condensation Promotes Fungal Growth In Ventilation Ducts

In a subarctic climate the diurnal variation in temperature may cause water condensation in ducts placed in the unheated spaces of a building. In this study, germination time and sporulation of a fungus, Penicillium verrucosum , were studied on dusty, galvanized steel sheet under different moisture conditions at room temperature. The effect of condensed water in a supply air duct on spore amplification was studied in an experimental ventilation set-up. In the field, air temperatures and the dew point temperature of air in the duct were monitored continuously for a week. P. verrucosum germinated on steel surfaces during five-hour incubation of the surface under humid conditions; when the surface had been moist for half an hour, germ tubes appeared within 17 hours. During 24-hour incubation under moist conditions, P. verrucosum produced hypae and spores. In the experimental set-up the airborne spore counts increased when the air passed through a water-condensingsection of the duct. Penicillium was the most abundant fungus sporulated on the moist duct surface. In the field, during humid weather, the surface temperature on the air stream surface decreased to the dew point temperature of the air in the duct. Thus water condensation in air ducts may promote fungal growth.     

Tissue and sex-dependent differences in CYP2A activities in hamsters

Three enzymatic activities of the CYP2A subfamily, coumarin 7-hydroxylase (COH), testosterone 15 alpha-hydroxylase (T15 alpha OH) and testosterone 7 alpha-hydroxylase (T7 alpha OH), were characterized in liver, kidney and lung microsomes from control, pyrazole (PYR), 3-methylcholanthrene (MC) and phenobarbital (PB) treated female and male Syrian golden hamsters. Sex-dependent changes in the enzymatic activities were found. Among control animals COH and T15 alpha OH activities were higher in males. T7 alpha OH activity was five times higher in female kidneys than in males. Inducers changed this metabolic profile. MC and PB were potent CYP2A inducers in extrahepatic tissues: significant increases were found in COH (5-fold) and T15 alpha OH (12-fold) activities in female MC lung microsomes and T7 alpha OH (7-fold) in MC male kidney microsomes. PB increased significantly activities of COH (5-fold), T15 alpha OH (3-fold) and T7 alpha OH (10-fold) in male kidney microsomes. All inducers significantly increased T7 alpha OH activity in male kidney microsomes but decreased hepatic T7 alpha OH activity in both sexes. PYR treatment decreased hepatic CYP2A activities. Anti-mouse CYP2A4/5 antibody inhibited COH activity by a variable extent depending on the tissue and pretreatment and recognised three 52-, 49-, 48-kDa bands in liver and two major bands in kidney (48 and 49 kDa) and lung (49 and 52 kDa) microsomes. COH and T15 alpha OH activities correlated well with 49 kDa protein (r = 0.95 and r = 0.99, respectively) in lung microsomes.(ABSTRACT TRUNCATED AT 250 WORDS)     

A microbiological screening method for the indication of irradiation of frozen poultry meat

A microbiological screening method for the detection of irradiation of frozen poultry meat was developed on the basis of the combined use of total cell count by the direct epifluorescent filter technique (DEFT) and viable cell count by the aerobic plate count method (APC). Samples of ground, deboned poultry leg were irradiated or not with dose levels of 3, 5 and 7 kGy using an electron beam accelerator. All samples were frozen before the irradiation treatment. The average values of the differences between DEFT and APC counts in control samples and those irradiated with doses of 3, 5 and 7 kGy were 1.14 log units for control samples, and 3.16, 3.68 and 3.79 log units for the irradiated samples. A difference of at least 2 log units can therefore be considered as a limit value indicating probable irradiation treatment necessitating further investigations.

---

Anwendung eines mikrobiologischen Unterscheidungsverfahrens zum Nachweis der Bestrahlung von gefrorenem Hühnerfleisch

Zusammenfassung Es wurde ein mikrobiologisches Verfahren zum Nachweis der Bestrahlung von tiefgefrorenem Hühnerfleisch auf der Basis kombinierten Einsatzes direkter Epifluoreszenzfiltertechnik (DEFT) und Kolonieauszählung (APC) entwickelt. Die Proben - knochenfreie, zerkleinerte Hühnerschenkel - waren entweder unbestrahlt oder mit einem Elektronenbeschleuninger mit Dosen von 3, 5 bzw. 7 kGy bestrahlt worden. Alle Proben waren vor der Bestrahlung eingefroren worden. Die Mittelwerte der Differenzen zwischen den DEFT- und den APC-Ergebnissen betrugen bei den unbestrahlten Proben 1,14 logarithmische Einheiten und bei den mit 3, 5 bzw. 7 kGy bestrahlten Proben 3,16, 3,68 bzw. 3,79 logarithmische Einheiten. Die Differenz von wenigstens zwei logarithmischen Einheiten kann als Grenze für die Möglichkeit eines Nachweises eventueller Bestrahlung betrachtet werden und macht weitere Untersuchungen erforderlich.