Electrophoretic deposition of graphene oxide on carbon brush as bioanode for microbial fuel cell operated with real wastewater

Microbial fuel cell (MFC) is a promising technology for simultaneous wastewater treatment and energy harvesting. The properties of the anode material play a critical role in the performance of the MFC. In this study, graphene oxide was prepared by a modified hummer's method. A thin layer of graphene oxide was incorporated on the carbon brush using an electrophoretic technique. The deoxygenated graphene oxide formed on the surface of the carbon brush (RGO-CB) was investigated as a bio-anode in MFC operated with real wastewater. The performance of the MFC using the RGO-CB was compared with that using plain carbon brush anode (PCB). Results showed that electrophoretic deposition of graphene oxide on the surface of carbon brush significantly enhanced the performance of the MFC, where the power density increased more than 10 times (from 33 mWm^?2 to 381 mWm^?2). Although the COD removal was nearly similar for the two MFCs, i.e., with PCB and RGO-CB; the columbic efficiency significantly increased in the case of RGO-CB anode. The improved performance in the case of the modified electrode was related to the role of the graphene in improving the electron transfer from the microorganism to the anode surface, as confirmed from the electrochemical impedance spectroscopy measurements.     

A novel driver assist stability system for all-wheel-drive electric vehicles

A novel driver-assist stability system for all-wheel-drive electric vehicles is introduced. The system helps drivers maintain control in the event of a driving emergency, including heavy braking or obstacle avoidance. The system comprises a fuzzy logic system that independently controls wheel torque to prevent vehicle spin. Another fuzzy wheel slip controller is used to enhance vehicle stability and safety. A neural network is trained to generate the required reference for yaw rate. Vehicle true speed is estimated by a sensor data fusion method. The intrinsic robustness of fuzzy controllers allows the system to operate in different road conditions successfully. Moreover, the ease of implementing fuzzy controllers gives a potential for vehicle stability enhancement.     

Prediction of ultrasonic wave velocity in particleboard and fiberboard

Ultrasonic wave velocities were determined at parallel and perpendicular to manufacturing direction and at the interval angles of 15° in clockwise and counterclockwise directions of particleboard and fiberboard. The experimental results were compared with the predicted values using some empirical formulae such as Hankinson and Jacoby equations. The results showed that the ultrasonic wave velocity were the highest in parallel direction in particleboard and fiberboard and decreases with increase of angle and the lowest values occurred in perpendicular direction. The predicted ultrasonic velocity using Hankinson and Jacoby equations are in close agreement with the measured values. Relationship between ultrasonic wave velocities and particles and fibers angle could be successfully presented by cubic and quadratic regression equations as well.     

Reliability assessment of an automated distribution system

Automation can greatly enhance distribution-network reliability by speeding up service restoration and thus significantly reduce customer-outage time. The paper presents an approach to assess quantitatively the adequacy of a particular automated distribution scheme designated as the `low interruption system' (LIS). Owing to the use of a high-speed communication system and line sensors, this automated scheme can reduce drastically the number of interruptions, the service interruption time and also the area affected by the fault. This scheme provides a simple and cost-effective way to automate distribution systems in which the remotely controlled switches speed up isolation of faulted sections and the restoration of healthy sections through alternative routes. The step-by-step calculation procedure is presented using a typical small automated distribution system. The proposed technique is then applied to a larger distribution system to examine the effectiveness of the technique and also to examine the level of reliability improvement achieved by automation     

Performance of the decorrelator receiver for DS-CDMA mobile radio system employing RAKE and diversity through Nakagami fading channel

Multiple-access interference (MAI) and multipath fading are two of the most significant factors limiting the capacity and performance of direct-sequence code-division multiple-access (DS-CDMA) systems. In this paper, synchronous multiuser receivers that combine antenna diversity, RAKE reception, and a multipath decorrelator for MAI cancellation are analyzed in a Nakagami faded environment using a maximal ratio combiner or a selection combiner. A coherent binary phase-shift keying employing DS-CDMA is considered. Arbitrary branch correlation is also considered for any diversity order in the case of identical severity fading on the branches.     

Pre-peritoneal bisaccular umbilical and subcutaneous abscess after laparoscopic appendectomy

Laparoscopic surgery has gained much interest since its advent the late eighties. A 36-year-old patient underwent laparoscopic appendicectomy via the transumbilical route. She was rehospitalized three times thereafter for subumblical pain. At day +48, an abscess was evacuated at the point of the umbilical trocar insertion. This hour-glass shaped abscess had a preperitoneal and subcutaneous localization, blocked by the epiploic reaction. The infection this patient developed is an unusual clinical finding as pain was localized at a distance. The umbilical site and the preperitoneal subcutaneous nature of the abscess are also unusual. This case emphasizes the gravity of post-operative abscess of the abdominal wall and the necessity for adequate prophylaxy.     

The putative tumor suppressor gene on chromosome 5q for hepatocellular carcinoma is distinct from the MCC and APC genes

We have previously shown that the tumor suppressor gene for hepatocellular carcinoma (HCC) without cirrhosis may be located on chromosome 5q35-qter. In this study, we analyzed nine cases of primary HCC without cirrhosis using probes from the MCC and APC genes, which are in the region 5q21-22. None of the informative cases had allele loss detected by these probes, whereas the probe lambda MS8 for the region 5q35-qter showed allele loss in six out of six informative cases. The results confirm that the putative tumor suppressor gene for HCC without cirrhosis on chromosome 5q is distinct from the MCC and APC genes.