精轧油膜轴承密封失效机理的初步分析

对油膜轴承密封出现的进水、漏油现象作了大量的调查、测量和统计分析，找出了产生质量事故的根本原因，提出了解决措施。     

等离子炉炭热法冶炼钼铁

等离子炉炭热法冶炼钼铁是利用炭在高温下的强还原性，以炭热和等离子热代替金属热．直接得到优质钼铁。     

用添加剂改善柴油的颜色稳定性

利用实验室筛选出的一种柴油安定性改进剂改善柴油的颜色稳定性。贮存实验表明：成品柴油(催化裂化柴油组分占30％)中加入该剂300～400μg/g，可改善比色0．5-1．5个号，同时可抑制柴油氧化沉渣的生成，改善柴油的氧化安定性和颜色稳定性。     

厌氧氨氧化研究进展

厌氧氨氧化是近年来发现的新型生物脱氮途径。综述了厌氧氨氧化反应的由来、可能的反应机理、厌氧氨氧化微生物、厌氧氨氧化工艺的研究及应用并指出了今后的研究方向。     

High temperature swelling of coal/tetralin mixtures in a high pressure microdilatometer

High pressure microdilatometer experiments were performed on a subbituminous (Wyodak) and a bituminous (Illinois no. 6) coal in helium and hydrogen atmospheres with and without added tetralin. Wyodak coal samples showed no swelling but contractions ranging between 24 and 40 vol% upon heating at 20 and 100 °C min^{− 1} under helium or hydrogen pressures between 150 and 1000 psig (˜1.0–6.9 MPa). Under the same conditions, Illinois no. 6 coals displayed contractions (25–60 vol%) prior to swelling up to 117 vol%. Upon tetralin addition (at 35–190 wt% of the coal), Wyodak coal samples did not swell but showed an increasing contraction with increasing helium or hydrogen pressure due to a slight softening and fusion of the coal particles. In contrast, addition of tetralin at much lower concentrations (5–35 wt%) had a marked effect on the contraction and swelling behaviour of Illinois no. 6. A maximum swelling of 200 vol% was obtained at a tetralin addition of 30 wt%. The increased swelling results from more extensive softening and fusion of coal particles in the presence of tetralin. Both coals showed a decreasing char yield with increasing tetralin concentration. The substantially lower extent of interaction observed between Wyodak coal samples and tetralin compared to Illinois no. 6 coal can be attributed to the differences in pore structure and/or chemical constitution of the two coal samples. Examination of the resultant solids by optical microscopy revealed the microstructural changes produced by thermal treatment in dilatometer experiments.     

简谐激励下一类干摩擦振子的响应计算

本文提出了计算简谐激励下一类干摩擦振子系统响应的解析方法,振子系统的摩擦力用含有限个Jenkins单元的Iwan模型描述。针对力-位移之间的分段线性关系,对振子运动逐段进行分析,并给出了各阶段内的系统的振动方程,最后通过变量代换,获得了方程的解析解. 由于每个阶段解的初值均由位移和速度的连续性条件得到,因此顺次求得各线性阶段中响应便获得了整个时域上的响应. 仿真结果表明,随着外激励量级的递增,接触面出现滑移,使得接触刚度减小,因而系统幅频曲线峰值明显左移;另一方面,系统的等效粘性阻尼会随着激励量级的递增而先增大后减小.     

A framework for reviewing domain specific conceptual models

Conceptual models are used in understanding and communicating the domain of interest during analysis phase of system development. As they are used in early phases, errors and omissions may propagate to later phases and may be very costly to correct. This paper proposes a framework for evaluating conceptual models when represented in a domain specific language based on UML constructs. The framework describes the main aspects to be considered when conceptual models are represented in a domain specific language, presents a classification of semantic issues and some evaluation indicators. The indicators can, in principle, identify situations in the models where inconsistencies or incompleteness might occur. Whether these are real concerns might depend on domain semantics, hence these are semantic, not syntactic checks. The use of the proposed review framework is illustrated in the context of two conceptual models in a domain specific notation, KAMA. With reviews based on the framework, it is possible to spot semantic issues which are not noticed by case tools and help the analyst to identify more information about the domain.     

Use of center of gravity with the common vector approach in isolated word recognition

In this paper, the subspace based classifier, common vector approach (CVA), with the center of gravity (COG) method is used for isolated word recognition. Since the CVA classifier is sensitive to shifts through the time axis, endpoint detection becomes extremely important for the recognition of isolated words. The COG method eliminates the need for endpoint detection. The effects of the COG method and a classical endpoint detection algorithm on the recognition rates of isolated words are investigated. The experimental results show that the COG method yields slightly higher recognition rates than the endpoint detection method in the TI-digit database when CVA is used.     

圆柱体出筒过程头型对流体动力的影响

针对圆柱体出筒过程头型对流体动力特性的影响,采用多相流Mixture模型、Singhal空化模型和标准的k-ε湍流模型的方法,并结合动网格技术,求解混合介质RANS方程,实现了圆柱体运动的动边界与流场的流体-固体耦合求解.以此为基础,对有重力影响下的3种头型的圆柱体出筒过程和流体动力特性进行了数值模拟,分析了头型对圆柱体出筒过程中水弹道及其流体动力特性的影响,以及圆柱体压差系数、粘性系数和总力系数变化规律及波动原因.得到模型Ⅲ出筒过程中流体动力变化较小和水弹道比较稳定的结论,为工程实际应用提供有意义的理论指导.     

灰乳的陈化

<正> 明胶生产要用石灰乳浸泡处理骨素。那么,石灰乳应该如何配制才能充分得到利用,这是笔者关注的一个问题。为此我们做了下面的实验。