Over 2000 electrocution deaths were identified among U.S. construction workers from 1980 to 1991, with the highest mean annual crude mortality rate (2.5 per 100,000 people), and second highest mean age-adjusted rate (2.7 per 100,000 people) of all industries. Although the crude fatality rates showed a downward trend, construction workers are still about four times more likely to be electrocuted at work than are workers in all industries combined. Nearly 40% of the 5083 fatal electrocutions in all industries combined occurred in construction, and 80% were associated with industrial wiring, appliances, and transmission lines. Electrocutions ranked as the second leading cause of death among construction workers, accounting for an average of 15% of traumatic deaths in the industry from 1980 to 1991. The study indicates that the workers most at risk of electrical injury are male, young, nonwhite, and electricians, structural metal workers, and laborers. The most likely time of injury is 11 a.m. to 3 p.m. from June to August. Focusing prevention on these populations and characteristics through better methods of worker and supervisor electrical safety training, use of adequate protective clothing, and compliance with established procedures could minimize the average annual loss of 168 U.S. construction workers. 相似文献
This paper describes a brushless dc motor system without position or speed sensor. The brushless motor consists of a permanent magnet synchronous motor and a voltage-source inverter capable of controlling the amplitude and frequency of voltage. The rectangular-shaped stator current with a conducting interval of 120° (electrical) is controlled to be in phase with the trapezoidal back electromotive force. This results in producing maximum torque. Variable speed is achieved by adjusting the average motor voltage similarly to chopper control of dc motors. In this paper, two sensorless position detecting methods, i.e., an “indirect method” suited for the lower-speed range and a “direct method” suited for the higher-speed range are proposed. The combination of the two makes it possible to detect the rotor position over a wide-speed range. Furthermore, a speed-sen-sorless PLL control is proposed in applying the principle of the direct method. Experimental results obtained from a prototype brushless dc motor are shown to confirm the validity of the sensorless drive. The starting procedure of the motor also is discussed because it is impossible to detect the rotor position at a standstill. 相似文献
Local orientations of superconducting YBa2Cu3Ox (123) and embedded Y2BaCuO5 (211) particles within bulk, melt-textured 123 samples are studied on a local scale by means of electron backscatter diffraction
(EBSD). The embedded Y2BaCuO5 (211) particles do not show any preferred texture, but their presence within the 123-matrix alters the growth of the 123-phase,
independent of the orientation. EBSD enables to analyse the interactions between the 123- and 211-phases in detail. 相似文献
The asymptotic correlations among maximum likelihood (ML) and various least squares (LS) estimators in factor analysis are derived. The LS estimators include the unweighted (ULS) and weighted estimators for unstandardized variables and the ULS estimators for standardized variables. The derived formulas cover the cases with restrictions on parameters. Numerical examples with simulations are provided to confirm the accuracy of the formulas and the influence of scales on the asymptotic correlations.
The thermal response and oxidation of Tyranno™ Lox-M fiber-reinforced Si-Ti-C-O matrix composites in high-enthalpy dissociated air was investigated in an arc jet facility (an arc wind tunnel). The maximum surface temperature reached 1310–1670°C. Catalytic recombination of oxygen and nitrogen on the composite surface under dissociated air was not significant. Surface recession was insignificant below 1600°C surface temperatures and above 5 kPa of oxygen partial pressure at the stagnation point. Passive-to-active oxidation transition of the composite agreed with Balat's theory for monolithic silicon carbide. A glass sealant prevented active oxidation of the composite for short-time exposures. 相似文献
Helium gas permeability of silicate clay (montmorillonite) particles/epoxy nanocomposites was examined. The incorporation of increasing amounts of montmorillonite particles reduced the helium gas permeability. Based on Fick’s law, gas permeation behavior of the nanocomposite was evaluated. With the increase of montmorillonite loading, gas diffusivity decreased, while gas solubility increased. Helium diffusion behavior is in agreement to the numerical results based on the Hatta–Taya–Eshelby theory. It has been revealed that dispersion of nanoscale platelets in polymer is effective in improving gas barrier property. 相似文献
An in situ diffuse reflectance FT-IR technique was employed to investigate the active surface species and the reaction mechanism of the oxygenate formation in the vapor phase hydroformylation of ethene on Co/SiO2 promoted with various noble metals such as Ir, Rh, Pt, Re, Ru, and Pd. Co(A)/SiO2 and Ir(CO)/SiO2 which were derived from cobalt(II) acetate and Ir4(CO)12, respectively, were quite inactive in the reaction, and showed only quite small peaks of adsorbed CO under the conditions of 1.1 MPa of C2H4/CO/H2 at 298 K. In contrast, Co(A)-Ir(CO)/SiO2, which were very active in the reaction, exhibited strong absorption bands of linear and bridged CO species. At 423–463 K, propanal adsorbed on the catalyst and acyl species which is suggested as the intermediate for the formation of propanal were also observed on this catalyst. By exposing CO preadsorbed on this catalyst to C2H4/H2 at 289 K and 0.1 MPa, the intensity of the linear CO band decreased, and the bands of propanal and acyl species emerged simultaneously, whereas that of the bridged CO band remained constant after the initial drop. These results suggested that the oxygenates are formed via the CO insertion into adsorbed ethyl species, and linear CO species plays a major role in the CO insertion on these noble metal-promoted cobalt catalysts. 相似文献
A method for estimation of ability using pseudocounts in dichotomous item response models is given when associated item parameters are known or estimated by a separate calibration sample of examinees with the size of an appropriate order. The pseudocount minimizing the asymptotic mean square error is algebraically obtained. Though the pseudocount depends on unknown ability, a fixed lower bound for the pseudocount is derived under the logistic model with equivalent items. The lower bound is numerically shown to be reasonable under the 3-parameter logistic model with and without model misspecification.
The purpose of the present study was to determine whether cerebral hyperperfusion after revascularization inhibits development of cerebral ischemic lesions due to artery-to-artery emboli during exposure of the carotid arteries in carotid endarterectomy (CEA). In patients undergoing CEA for internal carotid artery stenosis (≥70%), cerebral blood flow (CBF) was measured using single-photon emission computed tomography (SPECT) before and immediately after CEA. Microembolic signals (MES) were identified using transcranial Doppler during carotid exposure. Diffusion-weighted magnetic resonance imaging (DWI) was performed within 24 h after surgery. Of 32 patients with a combination of reduced cerebrovascular reactivity to acetazolamide on preoperative brain perfusion SPECT and MES during carotid exposure, 14 (44%) showed cerebral hyperperfusion (defined as postoperative CBF increase ≥100% compared with preoperative values), and 16 (50%) developed DWI-characterized postoperative cerebral ischemic lesions. Postoperative cerebral hyperperfusion was significantly associated with the absence of DWI-characterized postoperative cerebral ischemic lesions (95% confidence interval, 0.001–0.179; p = 0.0009). These data suggest that cerebral hyperperfusion after revascularization inhibits development of cerebral ischemic lesions due to artery-to-artery emboli during carotid exposure in CEA, supporting the “impaired clearance of emboli” concept. Blood pressure elevation following carotid declamping would be effective when embolism not accompanied by cerebral hyperperfusion occurs during CEA. 相似文献