Monitoring of human enteric viruses and coliform bacteria in waters after urban flood in Jakarta, Indonesia.

Floodwaters in Kampung Melayu village, Jakarta, Indonesia, as well as river water and consumable water (including groundwater and tap water) samples in flooded and non-flooded areas, were quantitatively analysed to assess occurrence of viruses and total coliforms and E. coli as bacterial indicators after flooding event. High numbers of enterovirus, hepatitis A virus, norovirus (G1, G2) and adenovirus were detected at high concentration in floodwaters and waters sampled from Ciliwung River which runs across metropolitan Jakarta and is used widely for agriculture and domestic purposes by poor residents. One out of three groundwater wells in the flooded area was contaminated with all viruses tested while no viruses were found in groundwater samples in non-flooded areas and tap water samples. The results revealed that human enteric viruses, especially hepatitis A virus and adenovirus, were prevalent in Jakarta, Indonesia. This study suggested that flooding posed a higher risk of viral infection to the people through contamination of drinking water sources or direct contact with floodwaters.     

Quantification and genotyping of Cryptosporidium spp. in river water by quenching probe PCR and denaturing gradient gel electrophoresis.

A new detection method was developed for the simultaneous quantification and genotyping of Cryptosporidium spp. in river water. Several modifications made to the US EPA Method 1623 enabled high and stable recovery of Cryptosporidium from 40 L of river water (geometric mean = 35%, standard deviation = 8.7%). Quenching probe PCR (QProbe PCR) was used to quantify the 18S rRNA gene of Cryptosporidium spp. This method could successfully detect single oocysts in a sample, and the lower quantitation limit was as low as 2.5 oocysts/sample. In addition, denaturing gradient gel electrophoresis (DGGE) followed by DNA sequencing was used to identify the genotypes. These methods were applied to detect Cryptosporidium spp. in the Koyama River, Japan. The positive ratio was 69% (11/16) with the maximum concentration of 59 oocysts/100 L. Seven genotypes including two novel ones were identified. These results showed that this detection method could provide valuable information on Cryptosporidium in river water, both in the concentration and in the genotypes, which is essential for the precise assessment of waterborne risk to human health.     

Effects of highly hydrogenated soybean oil and cholesterol on plasma,liver cholesterol,and fecal steroids in rats

We investigated the relationship between dietary highly hydrogenated soybean oil (HSO) and cholesterol transport in rats. In the first study, to examine the effects of cholesterol transport of different concentrations of HSO in dietary oil, rats were given one of the three diets containing 0, 25, or 50% HSO in dietary oil with cholesterol (5 g/kg diet) or a diet without HSO and cholesterol for 22 d. Feeding the high concentration of HSO prevented the increase in plasma total cholesterol, hepatic total lipids, and cholesterol and the decrease in high-density lipoprotein-cholesterol, which were caused by dietary cholesterol. Moreover, HSO increased the fecal excretion, fecal lipids, and steroids in a dose-dependent manner. In the second study, to examine the effects on cholesterol transport of redistribution of stearic acid in the triacylglycerol species contained in HSO, rats were given one of the six diets containing HSO (distearoylmonoacylglycerol and tristearoylglycerol)-rich, monostearoylglycerol-rich, or palmitic acid-rich oil with/without cholesterol (5 g/kg diet), for 30 d. Whereas the accumulation of cholesterol in the body was reduced, cholesterol excretion was enhanced effectively in rats given the HSO-rich diet compared with rats given the monostearoylglycerol-rich diet. These results suggested that not only the high concentration of stearic acid but also its uneven distribution in HSO-triacylglycerol contributed to the reduction in intestinal cholesterol absorption in rats.     

Formation Mechanism and Synthesis of Apatite-Type Structure Ba2+xLa8−x(SiO4)6O2−δ

The formation process of Ba₂La₈(SiO₄)₆O₂ was clarified using thermogravimetry–differential thermal analysis (TG-DTA) and a high-temperature powder X-ray diffraction (HT-XRD) method. Phase changes identified from the HT-XRD data surprisingly corresponded to the weight loss and/or endothermic peaks observed in the TG-DTA curves. Raw material with the composition Ba₂La₈(SiO₄)₆O₂ was completely reacted at 1400°C and produced only an apatite-type compound without a secondary phase. Moreover, the synthesis of Ba_{2+ x} La_{8− x} (SiO₄)₆O_2−δ crystals with x = 0–2 was attempted using a solid-state reaction.     

Cryptosporidium monitoring system at a water treatment plant, based on waterborne risk assessment.

The water volume required for daily monitoring of Cryptosporidium (which can statistically ensure an annual risk of infection below 10(-4)), was assessed by evaluating the applicability of the Poisson lognormal (PLN) distribution in microbial risk assessment. PLN showed as good a fit to the observed data as to the negative binomial distribution. From the estimated PLN distributions for the source and finished water, the efficacy of the oocyst removal by the conventional water treatment process was estimated to follow log-normal distribution (median = 3.16 log10, 95% CI = 4.27-2.05 log10). The 365 consecutive negative results of daily monitoring for 180 L of finished water were found to be statistically equivalent to the annual risk of infection below 10(-4). This research also suggested the possibility of applying a qualitative detection method, such as CC-PCR, as a routine monitoring method for the quantitative risk management.     

Structural phase transitions of methane+ethane mixed-gas hydrate induced by 1,1-dimethylcyclohexane

Methane+ethane+1,1-dimethylcyclohexane+water system was investigated by using Raman spectroscopy and isothermal phase equilibrium measurements under four-phase (gas+aqueous+large guest species+hydrate phases) equilibrium conditions at 288.15 K. The results suggest that three kinds of hydrate structures emerge at 288.15 K in the methane+ethane+1,1-dimethylcyclohexane+water system. The hydrate structure for this system changed from structure-H to structure-I via structure-II with increase in the mole ratio of ethane to methane.     

Effects of low- or medium-pressure ultraviolet lamp irradiation on Microcystis aeruginosa and Anabaena variabilis

A pure culture of Microcystis aeruginosa or Anabaena variabilis, the representatives of water blooming algae, was exposed to low-pressure (LP) or medium-pressure (MP) UV lamps. Irradiated pure culture suspension was subsequently incubated for 7d under white light fluorescent lamps. During incubation, profiles of the number of cells, DNA damage and photosynthetic activity were determined. When UV fluence was 600mJ/cm(2), M. aeruginosa cell numbers decreased throughout the 7-d incubation period, to produce 1.5log reduction (LP) or 1.2log reduction (MP) compared with control. The amount of DNA damage was 2.02x10(-4) ESS/base (LP) and 3.42x10(-4) ESS/base (MP) just after UV irradiation, which became 0.05x10(-4) ESS/base and 0.23x10(-4) ESS/base, respectively, after 3d incubation. However, cell number kept decreasing, even after DNA repair. Photosynthetic activity decreased by 1.5log within 1d (LP) or 3d (MP). Thus, reduction in photosynthetic activity could contribute to the reduction in M. aeruginosa cell numbers. A. variabilis cell numbers reduced by 2.3log (LP) or 2.2log (MP) during the 7-d incubation period; however, after DNA damage repair, cell number began to increase. The amount of DNA damage was 6.07x10(-4) ESS/base (LP) and 4.48x10(-4) ESS/base (MP) just after UV irradiation, which became 0.23x10(-4) ESS/base and 0.40x10(-4) ESS/base, respectively, after 3d incubation. No reduction was observed in photosynthetic activity/cell. Therefore, DNA damage is the main contributor of the reduction in cell number of A. variabilis.     

Studies on the contents of water-soluble chlorides and water-soluble sulfates in food color aluminum lakes

Japan's Specifications and Standards for Food Additives, 7th Edition (JSFA-VII) does not set limits for total contents of water-soluble chlorides and water-soluble sulfates (water-soluble inorganic salts) in food color aluminum lakes (FC-Als). However, the regulatory limit is 2% in JECFA and CFR. We used column switching suppressor-type ion chromatography (CSS-IC) for determination of anions. The total contents of water-soluble inorganic salts in FC-Als (112 qualified samples) were determined using the modified CSS-IC from fiscal year 1998 to fiscal year 2003. Total contents of water-soluble inorganic salts in four samples exceeded 2%. From an international point of view, it is desirable that the total content of water-soluble inorganic salts in FC-Al should again be regulated in Japan.     

Fabrication of dense β-calcium orthophosphate with submicrometer-sized grains and its high-temperature superplastic deformation

High-density β-calcium orthophosphate (β-Ca₃(PO₄)₂, also called β-tricalcium phosphate: β-TCP) ceramics with submicrometer-sized grains were fabricated using a pulse-current pressure firing route. The maximum relative density of the β-TCP compacts was 98.7% at 1050 °C and this was accompanied by a translucent appearance. The mean grain size of the β-TCP compacts increased slightly with temperature to reach 0.78 μm at 1000 °C. However, upon further increasing the firing temperature to 1050 °C the mean grain size increased significantly to 1.6 μm. The extent of plastic deformation during tensile testing was examined at temperatures between 900 and 1100 °C using a strain rate in the range 9.26 × 10⁻⁵ to 4.44 × 10⁻⁴ s⁻¹. The maximum tensile strain achieved was 145% for a test temperature of 1000 °C and strain rate of 1.48 × 10⁻⁴ s⁻¹ and this was attributed to the relatively high density and small grain size.     

Preparation of Polymethylmethacrylate-Reinforced Functionally Graded Hydroxyapatite Composites

A functionally graded hybridization approach has been used in the formation of polymer-ceramic composites of polymethylmethacrylate (PMMA) and hydroxyapatite (HAp). HAp was successfully reinforced by sedimentary HAp distributions on a PMMA matrix using a centrifuge to avoid stress convergence on the interface. The stress-strain curves of the functionally graded PMMA-HAp composite showed sufficient mechanical strength with reduced brittleness. Scanning electron micrographs also showed evidence of exposed HAp on the surface of the composites.