Measurement and modeling of the sidewall threshold voltage ofmesa-isolated SOI MOSFETs

Five-terminal silicon-on-insulator (SOI) MOSFETs have been characterized to determine the threshold voltage at the front, back, and sidewall as a function of the body bias. The threshold voltage shift with the body bias at the front and back interfaces can be explained by the standard bulk body effect equation. However, the threshold voltage shift at the sidewall is smaller than predicted by this equation and saturates at large body biases. This anomalous behavior is explained by two-dimensional charge sharing between the sidewall and the front and back interfaces. An analytical model that accounts for this charge sharing by a simple trapezoidal approximation of the depletion regions and correctly predicts the sidewall threshold voltage shift and its saturation is discussed. The model makes it possible to measure the sidewall threshold even when it is larger than the front threshold voltage     

Degradation of polyethylene terephthalate films in the presence of lubricants for HFC 134a: a critical issue for hermetic motor insulation systems

Earlier studies conducted in the use of sealed tubes with polyalkylene glycol lubricants and polyethylene terephthalete (PET) films revealed that the PET films exhibited embrittlement and (visual) degradation. This led to an investigation of PET embrittlement mechanisms with the new lubricants used with HFC 134a. The lubricants studied were three polypropylene glycols (the monol, the diol and the completely end-capped glycols), pentaerythritol ester and a blend of monol and ester. The effects of moisture content, temperature and lubricant structure were studied. All lubricants in this study were of viscosity grade ISO-32 (150 SUS). The results were compared to PET film embrittlement in the presence of CFC 12 and mineral oil. This study reconfirmed the earlier findings that the PET films must be dried to lower than 0.1 wt.% moisture content for use in hermetic systems. This paper discusses the effect of the moisture content of the lubricant and the effect of the lubricant structure on PET films. The dependence of the various mechanisms on temperature is shown. Esters and end-capped polyalkylene glycols are recommended for use with HFC 134a.     

Medium access control in ad hoc networks with MIMO links: optimization considerations and algorithms

we present a medium access control (MAC) protocol for ad hoc networks with multiple input multiple output (MIMO) links. MIMO links provide extremely high spectral efficiencies in multipath channels by simultaneously transmitting multiple independent data streams in the same channel. MAC protocols have been proposed in related work for ad hoc networks with other classes of smart antennas such as switched beam antennas. However, as we substantiate in the paper, the unique characteristics of MIMO links coupled with several key optimization considerations, necessitate an entirely new MAC protocol. We identify several advantages of MIMO links, and discuss key optimization considerations that can help in realizing an effective MAC protocol for such an environment. We present a centralized algorithm called stream-controlled medium access (SCMA) that has the key optimization considerations incorporated in its design. Finally, we present a distributed SCMA protocol that approximates the centralized algorithm and compare its performance against that of baseline protocols that are CSMA/CA variants.     

Process Technology for the Production of Micronutrient Rich Red Palm Olein

Crude palm oil (CPO) is the richest natural source of carotenes that are destroyed in the conventional processing. There is a growing demand for nutritional products containing bioactive constituents externally fortified or preserved through modified process. A commercially viable process for the production of red palm olein (RPOn) rich in carotenes, tocols and sterols has been developed at pilot scale. The process developed involved neutralization of CPO followed by crystallization at controlled rate of cooling and deodorization of the resultant neutralized and winterized palm olein (WPOn) under controlled conditions of temperature and high vacuum. Analytical data related to micronutrients at each process step was monitored. The RPOn thus produced had not more than 0.25% of free fatty acids (FFA) and it retained more than 80% of the carotenes, about 85% of tocols and 65% of sterols originally present in the CPO. The physico-chemical characteristics of RPOn revealed that it is nutritionally of superior quality compared to that of the commercial refined bleached deodorized (RBD) palm olein currently available in the market. The carotenes, tocols and sterols profile of RPOn by HPLC showed that they were retained in their natural forms.     

Silo music and silo quake: granular flow-induced vibration

Acceleration and sound measurements during granular discharge from silos are used to show that silo music is a sound resonance produced by silo quake. In tall and narrow silos, the latter is produced by stick-slip friction between the wall and the granular material. For the discharge rates studied, the occurrence of flow pulsations is determined primarily by the surface properties of the granular material and the silo wall. The measurements show that the pulsating motion of the granular material drives the oscillatory motion of the silo.     

THE ROLE OF LATTICE OXYGEN IN THE DYNAMIC BEHAVIOR OF OXIDE CATALYSTS

The lattice of an oxide catalyst used for oxidation reactions can act as a reservoir for oxygen, storing and releasing it for reactions at the catalyst surface under appropriate conditions. The implication of this oxygen storage property of an oxide catalyst on its dynamic response characteristics has been investigated through an experimental study of 2-butene oxidation over vanadium oxide as a model reaction. Isothermal reaction rate measurements in a differential reactor and nonisothermal studies in a single pellet reactor have been carried out. Following a step increase in the feed butene concentration, isothermal reaction rate overshoot and pellet temperature overshoot were observed. These observations could be modelled in a qualitatively correct way by a very simple model accounting for the participation of lattice oxygen in the catalytic reactions under dynamic conditions. It is demonstrated through model simulations that the ignition characteristics of a catalyst pellet are significantly affected by the participation of the lattice oxygen, when steady state multiplicity is present.     

Zero-<Emphasis Type="Italic">trans</Emphasis> shortening using palm stearin and rice bran oil

Several pilot-scale trials reported in this paper, using palm stearin-rice bran oil (PS-RBO) blends, obviously did not contain trans FA (TFA), whereas the commercial products were found to contain 18–27% TFA. The effects of processing conditions such as rate of agitation, crystallization temperature, and composition of the blends on the crystal structure of shortenings were studied. The products were evaluated for their physicochemical characteristics using DSC, X-ray diffraction (XRD), HPLC, and FTIR techniques. The formulation containing 50% PS and 50% RBO showed melting and cooling characteristics similar to those of hydrogenated commercial “vanaspati” samples. Analysis of the FA composition revealed that the formulated shortenings contained 15–19% C_18∶2 PUFA. Tocopherol and tocotrienol contents of the experimental shortenings were in the range of 850–1000 ppm with oryzanol content up to 0.6%. XRD studies demonstrated that the crystal form in the shortenings was predominantly the most stable β′ form, and there was less of the undesirable β form.     

Mullitization of Diphasic Aluminosilicate Gels

Recent studies have shown that the mullitization of diphasic aluminosilicate matrices comprising transitional alumina and amorphous silica occurs via a nucleation and growth process. Nucleation is preceded by a temperature-dependent incubation period. Following this incubation period, rapid nucleation of mullite occurs, producing about 1.8 × 10¹¹ nuclei/cm³, which remains constant throughout the rest of the transformation. Both incubation and mullite growth are thermally activated processes with apparent activation energies of 987 ± 63 and 1070 ± 200 kJ/mol, respectively. The growth rate of mullite grains under isothermal conditions is time dependent. An interpretation of these results is proposed on the basis of the nucleation and growth concepts of LaMer and Dinegar which supports the concept that the growth rate of mullite grains is controlled by the dissolution of transitional alumina into the amorphous matrix.     

Lobectomy combined with volume reduction for patients with lung cancer and advanced emphysema

Methanol-induced conformational transitions of hen egg white lysozyme were investigated with a combined use of far- and near-UV CD and NMR spectroscopies, ANS binding and small-angle X-ray scattering. Addition of methanol induced no global change in the native conformation itself, but induced a transition from the native state to the denatured state which was highly cooperative, as shown by the coincidence of transition curves monitored by the far- and near-UV CD spectroscopy, by isodichroic points in the far- and near-UV CD spectra and by the concomitant disappearance of individual 1H NMR signals of the native state. The ANS binding experiments could detect no intermediate conformer similar to the molten globule state in the process of the methanol denaturation. However, at high concentration of methanol, e.g., 60% (v/v) methanol/water, a highly helical state (H) was realized. The H state had a helical content much higher than the native state, monitored by far-UV CD spectroscopy, and had no specific tertiary structure, monitored both by near-UV CD and NMR spectroscopy. The radius of gyration in the H state, 24.9 angstroms, was significantly larger than that in the native state (15.7 angstroms). The Kratky plot for the H state did not show a clear peak and was quite similar to that for the urea-denatured state, indicating a complete lack of globularity. Thus we conclude that the H state has a considerably expanded, flexible broken rod-like conformation which is clearly distinguishable from the "molten globule" state. The stability of both N and H states depends on pH and methanol concentration. Thus a phase diagram involving N and H was constructed.     

A small country in a world of big science a preliminary bibliometric study of science in Singapore

An analysis of 258 papers published from Singapore and covered inScience Citation Index (SCI) 1979 and 1980 indicates that (1) much of R&D in Singapore pertains to medical research, (2) almost all the papers are published in English language periodicals published from the western world, (3) nearly two-thirds of Singapore's publication output is accounted for by the University of Singapore, and (4) by and large papers from Singapore are rarely cited, even if many of them have appeared in journals having impact factor greater than one.