Photoinduced Formation of Small Gold Particles in Silica Gels

AuCl⁻₄ ions in sol-gel-derived silica gels (Au/silica gels) were photoreduced by ultraviolet light irradiation at room temperature. In the presence of ethylene glycol in the silica gels, small Au particles were effectively formed by the irradiation. When the storage temperature of the gels was increased in the dark after the irradiation, the surface plas-mon resonance absorption peak of the Au particles was shifted to longer wavelengths, indicating that the Au particles became large. At a storage temperature below 9°C, Au particles could not be observed in the silica gels. The apparent activation energy of Au particle formation was estimated to be 17. 3 kcal·tmol⁻¹.     

Effects of vasodilators and perfusion pressure on coronary flow and simultaneous release of nitric oxide from guinea pig isolated hearts

OBJECTIVE: The aims were to validate the use of a direct reading NO electrode, to compare the effects of diverse acting drugs on altering coronary flow (CF) and NO release, and to examine the effects of altered perfusion pressure on flow-induced changes in NO concentration [NO] in the hemoglobin free effluent of guinea pig isolated hearts. METHODS: Hearts were isolated and perfused initially at a constant perfusion pressure (55 mmHg) with a modified Krebs-Ringer's solution equilibrated with 97% O2 and 3% CO2 at 37 degrees C. Heart rate, left ventricular pressure, CF, and effluent pH, pCO2, pO2, and NO generated current were monitored continuously on-line. Effluent was sampled for L-citrulline. Percent O2 extraction and O2 consumption were calculated. [NO] was quantitated with a sensitive amperometric sensor (sensitivity > or = 1 nmol/l approximately 3 pA) and a selective gas permeable membrane. RESULTS: The electrode was not sensitive to changes in solution pO2, flow, or pressure. The electrode was sensitive to pCO2 (-0.50 nmol/l/mmHg) and temperature (+24.5 nmol/l/degree C), so coronary effluent pCO2 was measured to compensate for a small decrease in pCO2 that occurred with an increase in coronary flow, and effluent temperature was rigidly controlled. Serotonin, bradykinin, and nitroprusside increased NO release along with CF, whereas nifedipine, butanedione monoxime, zaprinast, and bimakalim comparably increased CF but did not increase [NO] or NO release. Increases in CF (ml/g/min) and NO release (pmol/g/min), respectively, were 5.0 +/- 1 and 100 +/- 17 for 1 mumol/l serotonin, 7.5 +/- 1 and 148 +/- 18 for 100 nmol/l bradykinin, and 7.8 +/- 1 and 173 +/- 28 for 100 mumol/l nitroprusside. The increases in effluent NO by bradykinin were proportional to the increases in L-citrulline. Tetraethylammonium decreased CF, but did not change NO release, indomethacin changed neither CF nor NO release, and NG-nitro-L-arginine methyl ester (L-NAME) reduced CF by 2.6 +/- 1 ml/g/min and NO release by 25 +/- 8 pmol/g/min. An increase of CF of 8.0 +/- 0.3 ml/g/min, produced by increasing perfusion pressure from 25 to 90 mmHg, increased [NO] by 30 +/- 4 nmol/l; L-NAME but did not reduce the pressure-induced increase in CF, but reduced the increase in [NO] to 10 +/- 5 nmol/l. CONCLUSIONS: This study demonstrates in intact hearts real-time release of NO by several vasodilator drugs and by pressure-induced increases in flow (shear stress) and attenuation of these effects by L-NAME.     

Augmentation of boiling heat transfer from horizontal cylinder to liquid by movable particles

This paper presents a series of experimental results on a passive augmentation technique of boiling heat transfer by supplying solid particles in liquid. A cylindrical heater 0.88 mm in diameter is placed in saturated water, in which a lot of mobile particles exist, and the nucleate and film boiling heat transfer characteristics are measured. Particle materials used were alumina, glass, and porous alumina, and the diameter ranged from 0.3 mm to 2.5 mm. Particles are fluidized by the occurrence of boiling without any additive power, and the heat transfer is augmented. The maximum augmentation ratio obtained in this experiment reaches about ten times the heat transfer coefficient obtained in liquid alone. The augmentation ratio is mainly affected by the particle material, diameter, and the height of the particle bed set at no boiling condition. The augmentation mechanism is discussed on the basis of the experimental results. © 2001 Scripta Technica, Heat Trans Asian Res, 31(1): 28–41, 2002     

Breakdown characteristics of oil and paper insulation for a very fast transient voltage

This paper describes the dielectric breakdown characteristics of oil and oil‐impregnated paper for very fast transient (VFT) voltages. Blumlein circuits generate VFT voltages of 60 and 300 ns in a pulse width that simulates disconnecting switching surges in gas‐insulated switch gears. We measured the breakdown voltages of needle‐to‐plane, plane‐to‐plane oil gaps and several pieces of paper between plane electrodes for VFT and lightning impulse voltages. The measured data were formulated in V‐t characteristics and Weibull probability distributions. The inclination n of V‐t characteristics of insulating paper is 150, which is less than n = 13.7 of the plane‐to‐plane oil gap in the VFT time range. The shape parameters of Weibull distribution obtained in this study show that the scattering of breakdown voltages of paper is much less than that of oil. © 2002 Wiley Periodicals, Inc. Electr Eng Jpn, 141(4): 16–24, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10043     

Simulation of Strength Distribution in Ground Ceramics by Incorporating Residual Stress Effect

Strength of ground ceramics may be affected by residual stress as well as surface flaws induced by grinding. Strength prediction for ground ceramics is convenient for mechanical design of ceramic components. In this article, a numerical procedure based on fracture mechanics was proposed to estimate strength distribution of ground ceramics by considering grinding-induced residual stress. Bending strength and residual stress of ground ceramics were measured for three grinding-conditions. By comparison of simulated results with experimental ones, it was revealed that strength characteristics in experiments were well simulated by using the proposed procedure.     

Radiation detector made of a high-quality polycrystalline diamond

Radiation detector was made of a high-quality CVD polycrystalline diamond composed of frost column like structure diamond grains, and induced charge distribution spectra and drift velocities were measured by using alpha particles. As a result, the CVD polycrystalline achieved maximum induced charge of 83% of HP/HT type IIa diamond. Moreover, the CVD crystal had lower charge loss on electrons compared with the HP/HT type IIa diamond. Drift velocities of electrons and holes were v_e = 7.7 × 10⁴ and v_h = 7.3 × 10⁴cm/s at an electric field of 20 kV/cm, respectively. In addition, response function measurement for 14 MeV neutrons was carried out.     

Phase diagrams calculated for Fe-rich Fe-Si-Co and Fe-Si-Al ordering alloy systems

Theoretical analysis based on the calculation of phase diagrams was employed for Fe-Si-Co and Fe-Si-Al ordering systems to clarify the necessity for the occurrence of phase separation in Fe-base ternary ordering systems. The free energy of Fe-base ternary ordering alloys where B2 and D0₃ ordered structures are formed is evaluated statistically using a pairwise interaction approximation up to second nearest neighbours, taking into account not only the atomic interaction but also the magnetic interaction, based on the Bragg-Williams-Gorsky model. The calculated phase diagrams are consistent with the experimentally obtained ones. The phase diagram calculation in this work is useful to predict the equilibrium states of the ternary ordering systems. The phase separation in ordering alloys is caused by the contribution of excess free energies due to ordering. The influences of ferromagnetism on the two-phase regions are also demonstrated.